• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.6 no.3
• /
• pp.135-140
• /
• 2013

In this paper, novel PWM generation method for cascaded H-bridge PWM converter is proposed. The proposed method can solve the unvalancing problem between H-bridges which consist cascade PWM converter without any injection of redundancy switching pattern for solving the load of switches forced from voltage reference of controller.

• Proceedings of the KIEE Conference
• /
• 1996.07a
• /
• pp.388-391
• /
• 1996

The conventional high frequency phase-shifted full bridge DC-DC converter has a disadavantage that a circulating current flows through transformer and switching devices during the freewheeling interval Due to this circulating current, RMS current stress, conduction losses of transformer and switching devices are increased. To alleviate this problem, this study provides a novel circulating current free type high frequency soft switching phase-shifted full bridge DC-DC converter which applies the energy recovery snubber(ERS) attached at the secondary side of transformer. The ERS adopted in this study is consisted of three fast recovery diode($Ds_1$, $Ds_2$, $Ds_3$), two resonant capacitor($Cs_1$, $Cs_2$) and a small resonant inductor [(Lr) : It can be ignored because the transformer leakage inductance(Ll) is able to use in stead of inserting the resonant inductor(Lr)]

• Journal of Electrical Engineering and Technology
• /
• v.13 no.1
• /
• pp.240-249
• /
• 2018

Individual DC voltage balance problem is an inherent issue for cascaded H-bridge (CHB) based converter. When the CHB-based static synchronous compensator (STATCOM) is operating at zero current mode, the software-based individual DC voltage balancing control techniques may not work because of the infinitesimal output current. However, the different power losses of each cell would lead to the individual DC voltages unbalance. The uneven power losses on the local supplied cell-controllers (including the control circuit and drive circuit) would especially cause the divergence of individual DC voltages, due to their characteristic as constant power loads. To solve this problem, this paper proposes an adaptive voltage balancing module which is designed in the cell-controller board with small size and low cost circuits. It is controlled to make the power loss of the cell a constant resistance load, thus the DC voltages are balanced in zero current mode. Field test in a 10kV STATCOM confirms the performance of the proposed method.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.4
• /
• pp.19-27
• /
• 2007

This paper presents a novel soft-switching PWM utility frequency AC to high frequency AC power conversion circuit incorporating boost H-bridge inverter topology, which is more suitable and acceptable for cost effective consumer induction heating applications. The operating principle and the operation modes are presented using the switch mode equivalent circuits and the operating voltage and current waveforms. The performances of this high-frequency inverter using the latest IGBTs are illustrated, which includes high frequency power regulation and actual efficiency characteristics based on zero voltage soft-switching(ZVS) operation ranges, and the power dissipation as compared with those of the conventional type high frequency inverter. In addition, a dual mode control scheme of this high frequency inverter based on asymmetrical pulse width modulation(PWM) and pulse density modulation(PDM) control scheme is discussed in this paper in order to extend the soft switching operation ranges and to improve the power conversion efficiency at the low power settings. The power converter practical effectiveness is substantially proved based on experimental results from practical design example.

• Proceedings of the KIPE Conference
• /
• 2003.07b
• /
• pp.981-986
• /
• 2003

Recently, a fuel cell is remarkable for new generation system. The fuel cell generation system converts the chemical energy of a fuel directly into electrical energy. The fuel cell generation is characterized by low voltage and high current. For connecting to utility, it needs both a step up converter and an inverter. The step up converter makes DC link and the inverter changes D.C to A.C. In this paper, full bridge converter and the single phase inverter are designed and installed for fuel cell. Simulation and experiment verify that fuel cell generation system could be applied for the distributed generation.

• Proceedings of the KIPE Conference
• /
• 2016.11a
• /
• pp.73-74
• /
• 2016

본 논문은 포워드-플라이백 컨버터와 태양광 단일 전원 비대칭 다단식 H-bridge 다중 레벨 인버터를 적용한 태양광 전력 조절 시스템에 관한 논문이다. 이는 기존에 연구되었던 대칭형 다단식 H-Brdige 다중 레벨 인버터나 플라이백 컨버터를 사용한 태양광 전력 조절 시스템의 단점을 보완 한 것이다. 대칭형 다단식 멀티 레벨 인버터는 각 H-Bridge 구조 마다 독립된 전원이 필요하지만, 포워드-플라이백(Foward-Flyback) 컨버터를 접목시켜 단일 태양광 전원으로 하나의 다단식 H-Brdige 인버터를 구성 할 수 있고, 또한 기존의 플라이백 컨버터를 포워드-플라이백 컨버터로 대체 하면서 기존 대비 대용량 설비가 용이하고 효율적인 태양광 전력 조절 시스템을 설계 할 수 있다. 제안한 시스템의 가능성을 확인하기 위하여, PSIM 시뮬레이션을 통해 계통 연계형 1kW급 태양광 시스템의 최대 전력 추종 제어(Maximum Power Point Tracking)와 인버터의 $V_{dc}$ 전압 제어를 확인하였다.

• Proceedings of the KIPE Conference
• /
• 2017.11a
• /
• pp.123-124
• /
• 2017

Cascaded NPC/H-Bridge(CNHB) 컨버터는 전압 레벨 증가의 용이성 및 고효율 양방향 토폴로지로써 대전력 및 고전압 전력변환장치에 널리 사용되고 있다. 하지만 과도상태 및 정상상태에서의 단상으로 구성된 각 DC-link의 전압변동은 DC-link의 커패시턴스 증가 및 출력 전력의 품질을 저하시킨다. 이에 본 논문은 CNHB 컨버터의 정상상태 특성과 동특성 개선을 위하여 PI제어와 모델예측제어를 혼합한 제어기법을 제안한다. 제안한 기법의 타당성은 PSIM 9.1.4 시뮬레이션을 이용하여 검증한다.

• Proceedings of the KIPE Conference
• /
• 2011.07a
• /
• pp.453-454
• /
• 2011

본 논문에서는 벅-부스트와 포워드 컨버터의 기능을 갖는 컨버터를 제안한다. 제안하는 컨버터는 Cascaded H-bridge 멀티레벨인버터와 같이 다수의 독립된 전원을 요구하는 회로 구조를 단일 입력 전원단으로 구성할 수 있는 특징을 가진다. 벅-부스트 컨버터의 입력 인덕터는 변압기로 대체되며 컨버터 스위치의 ON 동작시 포워드 동작에 의해 변압기 2차측으로 전력전달이 이루어지며, 스위치 OFF시 변압기 1차측 자화인덕턴스에 저장된 에너지가 비절연된 벅-부스트 컨버터의 출력 커패시터로 전달된다. 제안된 컨버터의 동작 모드에 따른 이론적 분석을 시행하고 시뮬레이션을 통해 타당성을 검증한다.

• Proceedings of the KIPE Conference
• /
• 2011.07a
• /
• pp.455-456
• /
• 2011

본 논문에서는 Boost 컨버터와 Forward 컨버터를 조합한 컨버터를 제안한다. 제안하는 컨버터는 시스템 구성상 다수의 독립된 전원을 요구하는 Cascaded H-bridge 멀티레벨인버터와 같은 회로구조에 있어 다수의 독립전원의 확보가 곤란한 경우 단일 입력 전원단으로 시스템을 구성할 수 있는 특징을 가진다. Boost 컨버터의 입력 인덕터는 변압기로 대체되며 컨버터 스위치의 ON 동작시 변압기 일차측 자화인덕턴스에 저장된 에너지가 변압기 이차측과 비절연된 Boost 컨버터의 출력 커패시터로 전달된다. 제안된 컨버터의 동작 모드에 따른 이론적 분석을 시행하고 시뮬레이션을 통해 타당성을 검증한다.

• Journal of Power Electronics
• /
• v.16 no.2
• /
• pp.399-413
• /
• 2016

This paper presents a topology for a modular power electronic transformer (PET) and a control scheme. The proposed PET consists of a cascaded H-Bridge rectifier on the primary side, a high-frequency DC/DC conversion cell in the center, and a cascaded H-Bridge inverter on the secondary side. It is practical to use PETs in power systems to reduce the cost, weight and size. A detailed analysis of the structure is carried out by using equivalent circuit. An algorithm to control the voltages of each capacitor and to maintain the power flow in the PET is established. The merits are analyzed and verified in theory, including the bi-directional power flow, variable voltage/frequency and high power factor on the primary side. The experimental results validated the propose structure and algorithm.