• Journal of the Korean Association of Geographic Information Studies
• /
• v.20 no.3
• /
• pp.104-124
• /
• 2017

This study aimed to validate the ASTER surface temperature using field measurements over various land use types in the urban area of Changwon City, South Korea. The ASTER surface temperature was measured by collecting eight images during daytime and nighttime in June and September from 2012 to 2014, and field measurements were conducted over the same period when the satellite images were taken. The analyses showed that the surface temperature measured in the field during the daytime was higher than that of satellite imageries by $5{\sim}10^{\circ}C$, and the gap was higher in built-up areas. The calibration models of surface temperature showed a 60% explanatory power in areas other than parks, indicating that the models are reliable. During nighttime, except for the summer month of August, ASTER surface temperature was determined to be approximately $2^{\circ}C$ higher in contrast to daytime.

• Journal of the Korean GEO-environmental Society
• /
• v.8 no.6
• /
• pp.53-60
• /
• 2007

L/EPS, manufactured in the shape of block and used for civil engineering, is a lightweight material with an excellent resistance to compression, and provides a superb self-sufficient stability. EPS is a suitable material capable of resolving the problem of settlement and lateral flow if it is applied as the soil on soft ground. The Korean Standards (KS) has not yet proposed any testing method for use of EPS as an engineering banking material. Only its testing and quality ordinance as a heat insulation material has been standardized. The design criteria for EPS has been established and applied through the trial construction of KHC (Korea Highway Corporation) and quality test of manufacturer, but most studies on them have been confined to factory products. This study is focused on comparing and analyzing long-term durability by conducting cyclic load test, freezing and thawing test, absorption rate test and others. EPS used in the test was chosen from construction sites and factory products, focusing on the long-term durability of EPS depending on the passage of time. Unconfined compression test results indicated that the strength of collected samples was lower than factory products. While the triaxial compression test results indicated that the shear strength increased in proportion to the increase of confining pressure, and factory products had declining shear strength as the confining pressure rose.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.5 no.3
• /
• pp.97-103
• /
• 1972

In this paper, the effects of some additives to the quality of fish cake such as salt, polyphosphate, and starch were tested. Besides, that of washing and alterative heating procedure were also discussed. From the result of quality test by measuring jelly strength and sensory evaluation the product was quite palatable to common, and the addition of salt and starch as 3 and 5 to 15 percent respectively, resulted in the best jelly strength of the product, it was markedly enforced when a small amount of polyphosphate ($0.3\%$) was added. It is suggested for a processing method of carp meat fish cake that meat is to be bleached by wasing at least 8 times repeatedly with tenfold tap water by volume of meat, and that the meat is previously chilled at 2 to $3^{\circ}C$ for so minutes and ground thoroughly with addition of 3 percent of salt, 5 to 15 percent starch, and 0.3 percent polyphosphate, and finally heat processed by two stages: at first, heated for 1 hour at $35^{\circ}C$ and alteratively heated for 30 minutes at $90^{\circ}C$ as the final.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.45 no.11
• /
• pp.914-921
• /
• 2017

The experimental research on a high-altitude environment simulation of space launch vehicle is important for securing independent technologies with launching space vehicles and completing missions. This study selected an altitude of 65 km for the experiment environment where it exceeded Mach number of 6 after the launch of Korean Space Launch Vehicle(KSLV-II). Shock tunnel was used to replicate the flight condition. After flow establishment, in order to confirm aerodynamic characteristics and normal and oblique shockwaves, the flow verification was carried out by measuring stagnation pressure and heat flux of a forebody model, and shockwave stand-off distance of a hemispherical model. In addition, a shock-free technique to recover free-stream condition has been developed and verified. From the results of the three verification tests, it was confirmed that the flow was replicated with the error of about ${\pm}3%$. The error between the slope angle of inclined shockwave of the scaled down transition section model using the shock-free shape and the slope angle of the horizontal plate model, and between the theoretical and the experimental value of the static pressure of the model were confirmed to be 2% and 1%, respectively. As a result, the efficiency of the shockwave cancellation technique has been verified.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.33 no.5 s.112
• /
• pp.69-82
• /
• 2005

These studies were carried out (1) to investigate the growth characteristics of Sedum album L. in the field, (2) to propose a suitable shallow peen roof system for this plant, and (3) to evaluate plant growth in the proposed system over the long term. The growth characteristics, such as morphological properties, growth habit, shade tolerance, and flowering, were surveyed. In experimental shallow green-roof systems, the effects of drainage type, substrate type, and soil depth on plant growth were investigated. Then drought tolerance was investigated. After planting Sedum album L. in the proposed system survival rate, cover, and resistance to insects, heal and cold were evaluated for about 2 years. The results of these studies are summarized below. 1. In the field, the aboveground part of Sedum album L. did not die back during the winter. Plant height was 4$\sim$7 cm. Roots were distributed to a depth of 5$\sim$7 cm. Sedum album L. is a compact ground-cover plant that spreads vigorously. Shading condition of less than $30\%$ of full sunlight didn't cause any trouble, but shading conditions above $87\%$ made the shape of the shoots and leaves abnormal. The plant bloomed from June to August and had a rather large compound umbel of white, star-shaped flowers. 2. Two systems, a drainage-blend-10 cm soil depth and a reservoir$\cdot$drainage-blend-15 cm soil depth, performed best in terms of cover, fresh weight, and dry weight. The first has an advantage for green roofs because it is lighter than the latter. 3. In drainage-blend-10 m soil depth and modified reservoir · drainage-blend-10 cm soil depth system no plants died for about 4 months after stopping the irrigation. The visual quality of the latter system was above 5 for 4 months and that of the former was under 5 after 2 months. In the field, however, the drought tolerance of Sedum album L. grown in the former would be enough to withstand the dry season. Considering the urban ecosystem and the importance of healthy growth the modified reservoir $\cdot$ drainage-blend-10 cm soil depth system was finally recommended. This system was composed of a 4 cm thick drainage layer and drain outlets placed at a height of 2.5 cm. 4. In the proposed system, the survival rate was $100\%$, and there was no injury induced by insects and heat. The leaf density decreased a little in winter. Cover increased throughout the year. Sedum album L. was planted with a cover of 72$cm^{2}$ on 3 April 2003; on 16 June 2003 and 15 June 2004, cover was $132.66\pm$5.87 $cm^{2}$(1.8 times) and $886.98\pm$63.51 $cm^{2}$(12.3 times), respectively.

• Journal of Korea Water Resources Association
• /
• v.49 no.11
• /
• pp.903-912
• /
• 2016

Accurate understanding and estimating Evapotranspiration (ET) is essential for understanding the mechanism of water cycle and water budget. ET has been analyzed by many researchers in worldwide while Ground-based ET has limiation in analyzing the spatio-temporal pattrens of ET. Thus, many researches have been conducted to represent the spatio-temporal variation of ET by using hydrometeorological variables estimated from remote sensing datasets. Previous remote sensing based ET algorithms, however, have disadvantage in that various hydrometeological input datasets were required. In this study, actual ET was estimated by MODIS-based Rn and MS-PT algorithm requiring relatively less input data than previous method. The result confirmed that the observed $R_N$ and latent heat flux from the eddy-covariance based fluxtowers located at CFK and SMK showed high correlation with the estimated $R_N$ and ET. The average determination coefficients ($R^2$) of ET estimated from satellite dataset over study periods were 0.77 (0.72-0.81) in Cheongmi (CFK) and 0.70 (0.67-0.78) in Sulma (SMK), respectively. Comparing with the actual ET of two flux tower sites, however, SMK showed more overestimated patterns than CFK due to the vegetation and radiation related errors.

• Korean Chemical Engineering Research
• /
• v.54 no.6
• /
• pp.746-752
• /
• 2016

In this study, soft carbon was prepared by carbonization of carbon precursor (pitch) obtained from PFO (pyrolysis fuel oil) heat treatment. Three carbon precursors prepared by the thermal reaction were 3903 (at $390^{\circ}C$ for 3 h), 4001 (at $400^{\circ}C$ for 1 h) and 4002 (at $400^{\circ}C$ for 2 h). After the prepared soft carbon was ground to a particle size of $25{\sim}35^{\circ}C$, the soft carbon was synthesised by the chemical treatment with boric acid ($H_3BO_3$). The prepared soft carbon were analysed by XRD, FE-SEM and XPS. Also, the electrochemical performances of soft carbon were investigated by constant current charge/discharge test, cyclic voltammetry and impedance tests in the electrolyte of $LiPF_6$ dissolved inorganic solvents (EC:DMC=1:1 vol%+VC 3 wt%). The coin cell using soft carbon of $25{\sim}35^{\circ}C$ with 3903 soft carbon ($H_3BO_3$/Pitch=3:100 in weight) has better initial capacity and efficiency (330 mAh/g, 82%) than those of other coin cells. Also, it was found that the retention rate capability of 2C/0.1C was 90% after 30 cycles.

• Journal of Life Science
• /
• v.20 no.2
• /
• pp.314-320
• /
• 2010

As the nature of triathlons is competition in three successive sports, triathletes experience elevated levels of stress on the body that are absent in single-sport athletic events, and consequently there are more potential medical problems to prepare for. Triathletes can also experience problems such as hypothermia, heat illness, excessive exposure to ultraviolet radiation, musculoskeletal injuries and trauma, immunosuppression, and haemolysis. Depending on the potentiality of such above-listed problems occurring in any given race, race organizers will prepare preventative measures and treatments accordingly. Olympic distance is not the only triathlon racing distance. Sprints, which are normally around half the Olympic distance, are common distances, as well as Long (2 km swim, 80 km bike, 20 km run), Ironman (3.8 km swim, 180 km bike, 42 km run), and ultra-distance events varying in length. Races of longer duration normally result in a higher percentage of athletes experiencing the above-mentioned medical problems, as well as inducing additional health risks such as hyponatraemia. Minimizing the occurrences of serious health issues is possible through the following means: carefully preparing for the probable race-day weather conditions; proper management and organization of the race; preparing an extensive water-safety and ground-course safety plan; distributing necessary nutrition along the course; and stressing the importance for athletes to have proper knowledge concerning race nutrition, biomechanical technique, physical preparation, and utilization of safe equipment. While risks of competing in triathlon are many, the instances of such medical problems are not excessive, and the triathlon has a reputation of being a reasonably safe sport as long as athletes with high risk take added precautions.

• Korean Journal of Agricultural Science
• /
• v.40 no.4
• /
• pp.333-338
• /
• 2013

Sources of energy and rumen undegradable protein (RUP) have been used to meet nutrient requirements for high producing dairy cows. However studies for manipulation the levels of energy and RUP in diets have been mainly achieved using dairy cows at early-lactation period. The objective of this study thus, was to investigate the effects of different energy and rumen undegradable protein (RUP) levels on dry matter intake and milk yield in Holstein cows at mid-lactation period. Basal diet was prepared as TMR to meet nutrient requirements for dairy cows at mid-lactation according to NRC recommendation. Cows of control group (Con) were fed only basal diets while ground corn (0.5 kg/d), heat-treated soybean meal (0.5 kg/d), and their mixture (0.25 kg of each supplements/d) were added to diets for cows of treatment groups (T1, T2, and T3 respectively) to modulate the level of energy and RUP contents in diets. Addition of energy or RUP source in basal TMR did not affect in total DMI while TMR intake tended to be higher in Con compared to T3. Cows fed T3 diets tended to show increased milk yield and MUN content than those of Con. Cows for T2 as well as T3 had lower ADG (P<0.05) compared with those of Con. We concluded that the addition of RUP source in diets for dairy cows on mid-lactation period might cause the decrement of DMI and ADG.

• Applied Chemistry for Engineering
• /
• v.24 no.3
• /
• pp.227-230
• /
• 2013

The phase change of $(U_{1-x}Nd_x)_3O_8$ powder produced by oxidation of Nd-doped $UO_2$ pellet at $500^{\circ}C$ was investigated by high temperature oxidation heat treatment at $900{\sim}1500^{\circ}C$ under an air atmosphere. The XRD analysis results showed that the formation of $(U_{1-y}Nd_y)O_{2+z}$ phase and $U_3O_8$ phase from metastable $(U,Nd)_3O_8$ phase initiated at a temperature of $1000^{\circ}C$. The relative integrated intensity of $(U_{1-y}Nd_y)O_{2+z}$ phase to $U_3O_8$ phase increased with increasing of the oxidation temperature from 1100 to $1500^{\circ}C$. And also, it was found from the SEM observation that the particle size of $(U_{1-y}Nd_y)O_{2+z}$ phase increased with increasing of the oxidation temperature. However, electrone probe X-ray microanalyzer (EPMA) analysis results showed that Nd contents in $(U_{1-y}Nd_y)O_{2+z}$ phase decreased with increasing of the oxidation temperature. This behavior on the ground of XRD, SEM, and EPMA analysis data could be interpreted in terms of the transportation of U ions from $U_3O_8$ phase into $(U_{1-y}Nd_y)O_{2+z}$ phase through the interface of two phases during high temperature oxidation.