• ETRI Journal
• /
• v.27 no.4
• /
• pp.446-448
• /
• 2005

Using tightly focused femtosecond laser pulses, we produce an optical waveguide and devices in transparent materials. This technique has the potential to generate not only channel waveguides, but also three-dimensional optical devices. In this paper, an optical splitter and U-grooves, which are used for fiber alignment, are simultaneously fabricated in a fused silica glass using near-IR femtosecond laser pulses. The fiber- aligned optical splitter has a low insertion loss, less than 4 dB, including an intrinsic splitting loss of 3 dB and excess loss due to the passive alignment of a single-mode fiber. Finally, we present an output field pattern, demonstrating that the splitting ratio of the optical splitter becomes approximately 1:1.

• Korean Journal of Optics and Photonics
• /
• v.11 no.1
• /
• pp.43-46
• /
• 2000

We generated 9-fs pulses from a Kerr-lens mode-locked Ti:sapphire laser only using commercial optical components. Two sets of prisms pair made of fused silica were used to compensate group delay dispersion inside and outside the laser oscillator respectively, and broadband mirrors were used to obtain a broad spectrum. By comparison between reflectance curves of the broadband mirrors and those of previous ones, broadband mirrors which have high reflectance bandwidth of over 180 nm were found to be essential to produce sub-IO-fs pulses. ulses.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.55 no.1
• /
• pp.11-15
• /
• 2006

We propose an optical and an electrical detection methods for detecting various bio-molecules effectively with microcantilevers. The microcantilevers were fabricated employing surface micromachining technique that has attractive advantages in terms of cost efficiency, simplicity and ability of fabricating in array. The fluid cell system for injection of bio-molecular solution is fabricated using polydimethylsiloxane (PDMS) and a fused silica glass. The microcantilever is deflected with respect to the difference of the surface stress caused by the formation of self-assembled bio-molecules on the gold coated side of the microcantilever. It detected cystamine dihydrochloride and glutaraldehyde molecules and analyzed individual concentrations of the cystamine dihydrochloride solution. We confirm that the deflections of bending-up or bending-down are occurred by the bio-molecule adsorption and microcantilever can be widely used to a ${\mu}-TAS$ and a lab-on-a-chip for a potential detection of various bio-molecules.

• Analytical Science and Technology
• /
• v.17 no.2
• /
• pp.192-197
• /
• 2004

The discrimination of bracken (Korean vs. Chinese) has been attempted using capillary electrophoresis (CE). Bracken (Pteridium aquilinum) was extracted with 30% methanol and separated on a uncoated fused-silica ($50{\mu}m{\times}27cm$) capillary. Conditions for optimal analysis include: temperature, $40^{\circ}C$; voltage, 8 kV; and pressure injection time, 5 sec. The optimal separation buffer was 0.3 M borate buffer (pH 8.5) containing 40 mM CHAPS with 30% ethylene glycol. Under the optimal conditions established for CE, the ratio of specific peak area (peak PA-1) to other peak area (peak PA-2) was effective in discrimination of Korean and Chinese bracken. The mean accuracy for discrimination of Korean and Chinese brackens were 80% and 86%, respectively.

• Bulletin of the Korean Chemical Society
• /
• v.12 no.1
• /
• pp.87-92
• /
• 1991

A dual capillary column system is described for the simultaneous measurement of retention index (RI) and area ratio (AR) values of each peak on two capillary columns of different polarity, DB-5 & DB-1701. Both capillary columns were connected to a common splitless injector via a deactivated fused-silica capillary tubing of 1 m length and a 'Y' splitter, the dead volume effect of which was found to be negligible. RI and AR were measured with high reproducibility(${\leq}$0.05% RSD) and with high accuracy (<10% RE), respectively. When applied to the test samples of the organic acid mixture, each acid was positively identified by the combined computer RI library search-AR comparison.

• Bulletin of the Korean Chemical Society
• /
• v.15 no.11
• /
• pp.945-949
• /
• 1994

Mixtures of cyano complexes of palladium(II) and platinum(II) were separated by capillary electrophoresis using a fused silica capillary as a separation column and 30 mM phosphate buffer (pH 7) containing 15 wt. % acetonitrile as a running buffer. By virtue of the high ionic mobilities of the negatively charged cyano complexes of Pd(II) and Pt(II), they were separated using a cathodic injection and anodic detection scheme. The metal complexes eluted through the capillary were detected by direct UV absorption at 214 nm. A linear relationship between peak area and concentration was obtained for both ions and the detection limit was lower than $10^{-14}$ mole. The proposed method was applied to real sample, e.g., anode slime obtained from an electrolytic copper refinary, as a method for the simultaneous determination of palladium and platinum.

• Bulletin of the Korean Chemical Society
• /
• v.20 no.12
• /
• pp.1483-1486
• /
• 1999

The contents of pentachlorophenol (PCP) and 2,3,5,6-tetrachlorophenol (TeCP) in textile products are regulated for safety. Since an organic solvent such as 2-methoxyethanol is needed to extract chlorinated phenols from textile samples, nonaqueous capillary electrophoresis has been applied to achieve the separation of PCP and isomers of TeCP. The run buffer was 100 mM Tris/acetate in methanol whose pH was adjusted to 8.0. All of the analytes were negatively charged at pH 8.0 and their electrophoretic velocities were higher than the electroosmotic flow of the methanol buffer. A reverse voltage of -20 kV was applied along a 27-cm fused silica capillary with ID of 50 μm, and PCP and 3 TeCP isomers were separated based on the difference in $pK_a$ values in less than 4 min. The limits of detection (S/N = 3) were about 0.02 μM. By varying pH of the methanol run buffer, $pK_a$ values of the 4 chlorinated phenols were also estimated.

• Bulletin of the Korean Chemical Society
• /
• v.14 no.2
• /
• pp.250-255
• /
• 1993

A dual capillary column system is described for the simultaneous analysis of a given sample and measurement of retention index (RI) and area ratio (AR) values of each peak on two capillary columns of different polarity, DB-5 & DB-1701 from a single injection. Both capillary columns were connected to either a splitless injector or an on-column injector via a deactivated fused-silica capillary tubing of 1 m length and a 'Y' splitter. Both injection modes allowed to measure RI and AR values with high reproducibility (<0.01% RSD) and high accuracy (<10% RE), respectively with the exception that the trace and high boiling solutes required the on-column mode for the accurate quantification and AR comparison. When the dual capillary column system in on-column injection mode was applied to the blind samples containing organic acids, each acid was positively indentified by the combined computer RI library search-AR comparison.

• Applied Biological Chemistry
• /
• v.32 no.4
• /
• pp.350-356
• /
• 1989

The determinabilities of several lignan compounds by capillary-GC (F1D) were studied. The lignan compounds used were deoxyschizandrin, gomisin N, schizandrin, wuweizisu C, gomisin A, angeloylgomisin H and tigloylgomisin H which were isolated from fruits of Schisandra chinensis BAILLON and identified with GC/MS(EI, 70eV), 1H-NMR(300MHz) and IR. The GC column used was SPB-1 fused silica capillary$(0.25mm\;ID{\times}30m,\;Supelco)$, and the column oven temperature was programmed from $200^{\circ}C$ to $300^{\circ}C$ at the rate of $4^{\circ}C$ per minute. The linearities between concentration and FID response were maintained in $2{\sim}500ppm$ of deoxyschizandrin and wuweizisu C and in $5{\sim}500ppm$ of gomisin N, schizandrin, gomisin A, angeloylgomisin H and tigloylgomisin H. The contents of lignan compounds in fruits of S. chinensis BAILLON produced at Moo-ju area were analyzed by the GC method: the values obtained of schizandrin and gomisin N were 6.5 and 5.9mg/g respectively, and those of gomisin A, wuweizisu C, angeloylgomisin H, deoxyschizandrin and tigloylgomisin H were $0.5{\sim}1.6mg/g$.

• Applied Biological Chemistry
• /
• v.46 no.4
• /
• pp.380-384
• /
• 2003

Optimal extraction, separation and capillary rinsing conditions for capillary electrophoresis (CE) were established to discriminate the geographical origin of ligusticum root (Ligusticum wallichii) using 113 samples (domestic sample n = 62, foreign sample n = 51). Ligusticum root was extracted with 30% ethanol and separated on a uncoated fused-silica $(50\;{\mu}m{\times}27\;cm)$ capillary. Conditions for optimal analysis include: temperature, $40^{\circ}C$; voltage, 10 kV; and pressure injection time, domestic and foreign samples were 5 sec and 2 sec, respectively. The optimal separation buffer was 0.1 M phosphate buffer (pH 2.5) containing 15 mM iminodiacetic acid with 40% methanol. Under the optimal conditions established for CE, the ratio of specific peak area (peak LW-1) to other peak area (peak LW-5) was effective in discrimination geographical origin of ligusticum root. The mean accuracy for correct discrimination of geographical origin of domestic and foreign ligusticum roots were 65% and 63%, respectively.