• 한국자동차공학회논문집
• /
• 제15권2호
• /
• pp.50-57
• /
• 2007

Shocks are excited by impulsive forces and cause discomfort in vehicles. Current standards define means of evaluating shocks and predicting their discomfort, but the methods are based on research with a restricted range of shocks. This experimental study was designed to investigate the discomfort of seated subjects exposed to a wide range of vertical shocks. Shocks were produced from the responses of one degree-of-freedom models, with 16 natural frequencies (from 0.5 to 16 Hz) and four damping ratios (0.05 0.1, 0.2 and 0.4), to a hanning-windowed half-sine force inputs. Each type of shock was presented at five vibration dose values in the range $0.35\;ms^{-1.75}$ to $2.89\;ms^{-1.75}$. Fifteen subjects used magnitude estimation method to judge the discomfort of all shocks. The exponent in Stevens' power law, indicating the rate of growth in discomfort with shock magnitude, decreased with increasing fundamental frequency of the shocks. At all magnitudes, the equivalent comfort contours showed greatest sensitivity to shocks having fundamental frequencies in the range 4 to 12.5 Hz. At low magnitudes the variations in discomfort with the shock fundamental frequency were similar to the frequency weighting $W_b$ in BS 6841, but low frequency high magnitudes shocks produced greater discomfort than predicted by this weighting. At some frequencies, for the same unweighted vibration dose value, there were small but significant differences in discomfort caused by shocks having different damping ratios. The rate of increase in discomfort with increasing shock magnitude depends on the fundamental frequency of the shock. In consequence, the frequency-dependence of discomfort produced by vertical shocks depends on shock magnitude. For shocks of low and moderate discomfort, the current methods seem reasonable, but the response to higher magnitude shocks needs further investigation.

• 한국지반공학회논문집
• /
• 제34권2호
• /
• pp.33-42
• /
• 2018

본 연구에서는 소형 압전소자의 전기-역학적 임피던스를 이용하여 모래의 단위중량이나 강도를 평가하였다. 다짐 몰드 내 크기가 다른 세 종류의 미고결 낙동강모래를 느슨하거나 조밀하게 성형한 다음 내부에 직경 20mm 원형모양의 납작한 압전소자를 설치하고 임피던스를 측정하였다. 또한, 가는 낙동강모래에 시멘트비 4, 8, 12, 16%로 직경 50mm, 높이 100mm의 고결 공시체를 6층으로 다져서 제작하였다. 고결 공시체의 3층 내부에 압전소자를 수평방향으로 설치한 다음 3일 동안 임피던스 신호를 측정하였으며, 측정 후 일축압축시험을 실시하였다. 미고결 모래의 단위중량이 증가함에 따라 공진주파수는 102kHz에서 105kHz까지 약간 증가하였으며, 공진주파수 발생 시 컨덕턴스는 감소하였다. 고결 모래의 양생시간과 시멘트비가 증가함에 따라 공진주파수는 129kHz에서 266kHz까지 크게 증가하였으며, 공진주파수 발생 시 컨덕턴스는 반대로 감소하는 경향을 보였다. 고결 모래의 일축압축강도는 시멘트비에 따라 289-1,390kPa 정도이며, 공진주파수와는 뚜렷한 정비례 관계를 보이지만 공진주파수 발생 시 컨덕턴스와는 반비례 관계를 보였다.

• 오토저널
• /
• 제3권1호
• /
• pp.61-68
• /
• 1981

There are three types in frequency response accelerometer; one is lightly damped piezp type, another is oil damping stainguage type and the third is electro induction type accelerometer within electromagnetic damping. The usable frequency range of lightly damped accelerometers is limited to 0.2 of their mounted natural frequency for amplitude distortion of less than 5 percents. There have been situation where the measured motion contains unforeseen high - frequency components, which are regarded as such due to the accelerometer transfer function. There are several way to overcome amplitude distortion of the higher than anticipated frequency components; (I) to make use of the accelerometer with natural frequency three times and more as high as the measured frequency, (II) to establish data-analysis techniques which will account for the amplitude distortion, (III) to set up a notch filter circuit which has a transfer function that is the reciprocal of the accelerometer transfer function, and so on. This paper makes a report of the method as to(III), i. e., set up a few notch filter circuits, it is discussed what happens when the transfer functions, are in discord as to natural frequency of the filter and accelerometer damping vs. filter damping. And especially as for the cantilever strain gauge type accelerometer made by oneself with ease, it was compared and discussed between the ideological value and the experimental value of actual designed circuit in case of the mismatching of the transfer functions, and it was considered whether to be practicable or not, the result of which was as following; the useful frequency range of the accelerometer can be extended to near resonance if (a) the accelerometer mounted natural frequency and the filter center frequency are matched within .+-. 2 percent and (b) the damping ratios are matched within two factors. Therefore, we obtained the good result in improvement for extending frequency response characteristics of accelerometer.

• 대한조선학회논문집
• /
• 제55권4호
• /
• pp.281-288
• /
• 2018

Acoustic radiation efficiency is a crucial factor to estimate Underwater Radiated Noise (URN) of ships accurately. This paper describes a numerical method to analyse acoustic radiation efficiency of one side-wetted rectangular Mindlin plate with simply supported boundaries excited by a harmonic point force. Transverse displacements of plate and acoustic radiation pressures are evaluated by the mode superposition method. The acoustic radiation efficiencies analyzed by both Mindlin and thin plate theories show little differences at monopole and corner modes of low frequency regions but relatively large differences at edge and critical modes of high frequency regions. Especially, the critical frequency with the highest acoustic radiation efficiency evaluated by the Mindlin plate theory is higher than that of thin plate theory. In addition, the acoustic loading effect of fluid also increases bending wave-number of plate and its critical frequency. Finally, the acoustic radiation characteristics of plates with different aspect ratios and thicknesses through numerical analyses are investigated and discussed.

• 대한조선학회논문집
• /
• 제43권3호
• /
• pp.322-330
• /
• 2006

Numerical calculations are carried out for flow past a circular cylinder forced oscillating normal to the free-stream flow at a fixed Reynolds number equal to 185. The cylinder oscillation frequency ranged from 0.8 to 1.2 of the natural vortex-shedding frequency, and the oscillation amplitude extended up to 20% of the cylinder diameter. IBM (Immersed Boundary Method) with direct momentum forcing was adopted to handle both of a stationary and an oscillating cylinder Present results such as time histories of drag and lift coefficients for both stationary and oscillating cases are in good agreement with previous numerical and experimental results. The instantaneous wake patterns of oscillating cylinder with different oscillating frequency ratios showed the synchronized wakes pattern in the lock-in region and vortex switching phenomenon at higher frequency ratio than the critical frequency ratio.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 1998년도 추계종합학술대회 논문집
• /
• pp.609-612
• /
• 1998

Pyroelectric properties of rhombohedral $Pb(ZrxTi_1-x)O_3ceramics$ with various Zr/Ti ratios of 84/16, 87/13, 90/10, and 93/7 are investigated using dynamic method. The response characteristics of PZT samples are examined by considering frequency dispersion. Since the reorientation of the grain does not the influence on the increase of frequency at low frequency (2~200Hz), the maximum pyroelectric response can be obtained with the change of spontaneous polarization. However, the pyroelectric response of PZT samples could be reduced as the spontaneous polarization decreases due to the restrain of the reorientation of the grain with the increasing of requency at high frequency (200~2000Hz). We have obtained the good pyroelectric response in the PZT sample having 84/16 Zr/Ti ratio, then the pyroelectric coefficient (${\gamma}$) and the figure of merit (FV) were $17.3nC/\textrm{cm}^2K$ and 2.28$\times$10-11Ccm/J, respectively. The noise equivalent power (NEP), the detectivity (D*) were 1.21$\times$10-7W/Hz$\frac{1}{2}$ and 8.26$\times$106cmHz$\frac{1}{2}$/W, respectively.

• 한국소음진동공학회논문집
• /
• 제17권2호
• /
• pp.121-129
• /
• 2007

There has been much effort to find suitable methods for structural analysis in the mid-frequency region where traditional low frequency methods have increasing uncertainties whilst statistical energy analysis is not strictly applicable. Systems consisting of relatively stiff beams coupled to flexible plates have a particularly broad mid-frequency region where the beams support only a few modes whilst the plate has a high modal density and modal overlap. A system of two parallel beams coupled to a plate is investigated based on the wave method, which is an approximate method. Muller's method is utilised for obtaining complex roots of a dispersion wave equation, which does not converge in the conventional wave method based on a simple iteration. The wave model is extended from a single-beam-plate system, to a plate with two identical beams which is modelled using a symmetric-antisymmetric technique. The important hypothesis that the coupled beam wavenumber is sufficiently smaller than the plate free wavenumber is experimentally verified. Finally, experimental results such as powers and energy ratios show the validity of the analytical wave models.

• 설비공학논문집
• /
• 제22권11호
• /
• pp.767-772
• /
• 2010

The incompressible viscous flow past a sphere under forced oscillation is numerically investigated at a Reynolds number of 300. The immersed boundary method is used to handle the sphere oscillating vertically to the streamwise direction. There are two important variables to characterize the oscillating state of a sphere. One is an oscillating amplitude normalized by the sphere diameter is set as a fixed number of 0.2. Another is the frequency ratio which is defined by $f_e/f_o$, where fe and fo are the excited frequency and the natural frequency of vortex shedding for the stationary sphere. In this study, three different frequency ratios of 0.8, 1.0 and 1.2 are considered. The results show a periodic flow with hairpin vortices shedding from upper and lower positions as well as vortical legs obliquely extended by oscillating motion of sphere. The enveloping vortical structure experience rupture twice in one period of oscillation. As the frequency of oscillation is increased, the vortical legs are getting shorter and eventually the hairpin vortices are much closer to the adjacent one.

• 한국산학기술학회논문지
• /
• 제8권5호
• /
• pp.1047-1056
• /
• 2007

기본적으로 초음파 영상 시스템은 반사 계수를 보는 B-모드와 혈류의 속도를 구하는 도플러 영상 모드를 구비하고 있다. 본 논문에서는 도플러 영상 모드에서 혈류의 속도를 나타내는 도플러 주파수가 펄스반복주파수의 1/2을 초과하는 경우 발생하는 에일리어싱 현상을 검출해 보상하는 새로운 방법을 제시하고 컴퓨터 시뮬레이션을 통하여 타당성을 보여준다. 본 논문에서 제안하는 방법은 추정 가능한 도플러 주파수를 확장시켜 줄 뿐만 아니라 잡음에 대해서도 강인한 특성을 가진다. 시뮬레이션 결과 신호 대 잡음비가 약 20dB로 낮은 경우에도 에일리어싱을 제대로 보상할 수 있음을 알 수 있었다.

• 대한전기학회논문지:시스템및제어부문D
• /
• 제55권4호
• /
• pp.181-188
• /
• 2006

The purpose of this study is to predict the defibrillation success of a ventricular Fibrillation ECG signal using time-frequency analysis. During CPR, coronary perfusion pressure and electrocardiogram were measured. Parameters extracted from time-frequency domain were served as predictor of resuscitation success. Time frequency distribution(TFD) of ECG signals was estimated from the smoothed pseudo Wigner-Ville distribution(SPWVD). Median frequency, peak frequency, 1/f slope, frequency band ratios$(2{\sim}4Hz,\;4{\sim}6Hz,\;6{\sim}8Hz,\;8{\sim}10Hz,\;10{\sim}12Hz,\;12{\sim}15Hz)$ were extracted from each TFD as function of time. Paired t-test was used to determine the differences in ROSC and non-ROSC groups. In the statistical results, we selected four significant parameters - median frequency, 1/f slope, $2{\sim}4Hz$ band ratio, $8{\sim}10Hz$ band ratio. We made an attempt to predict defibrillation success by combining features extracted from time frequency distribution. Independent t-test was used to determine the differences ROSC and non-ROSC groups. Consequently, we selected four significant parameters-median frequency, 1/f slope, $2{\sim}4Hz$ band ratio, $8{\sim}10Hz$ band ratio. The relationship between coronary perfusion pressure and ECG parameters was analyzed with linear regression analysis. R-square value was 55%. 1/f slope and $8{\sim}10Hz$ band ratio had the significant relationship with coronary perfusion pressure.