• The Journal of Korean Academy of Prosthodontics
• /
• v.46 no.3
• /
• pp.290-297
• /
• 2008

STATEMENT OF PROBLEM: Implant-supported fixed cantilever prostheses are influenced by various biomechanical factors. The information that shows the effect of implant number and position of cantilever on stress in the supporting bone is limited. PURPOSE: The purpose of this study was to investigate the effect of implant number variation and the effect of 2 different cantilever types on stress distribution in the supporting bone, using 3-dimensional finite element analysis. MATERIAL AND METHODS: A 3-D FE model of a mandibular section of bone with a missing second premolar, first molar, and second molar was developed. $4.1{\times}10$ mm screw-type dental implant was selected. 4.0 mm height solid abutments were fixed over all implant fixtures. Type III gold alloy was selected for implant-supported fixed prostheses. For mesial cantilever test, model 1-1 which has three $4.1{\times}10$ mm implants and fixed prosthesis with no pontic, model 1-2 which has two $4.1{\times}10$ mm implants and fixed prosthesis with a central pontic and model 1-3 which has two $4.1{\times}10$ mm implants and fixed prosthesis with mesial cantilever were simulated. And then, 155N oblique force was applied to the buccal cusp of second premolar. For distal cantilever test, model 2-1 which has three $4.1{\times}10$ mm implants and fixed prosthesis with no pontic, model 2-2 which has two $4.1{\times}10$ mm implants and fixed prosthesis with a central pontic and model 2-3 which has two $4.1{\times}10$ mm implants and fixed prosthesis with distal cantilever were simulated. And then, 206N oblique force was applied to the buccal cusp of second premolar. The implant and superstructure were simulated in finite element software(Pro/Engineer wildfire 2.0). The stress values were observed with the maximum von Mises stresses. RESULTS: Among the models without a cantilever, model 1-1 and 2-1 which had three implants, showed lower stress than model 1-2 and 2-2 which had two implants. Although model 2-1 was applied with 206N, it showed lower stress than model 1-2 which was applied with 155N. In models that implant positions of models were same, the amount of applied occlusal load largely influenced the maximum von Mises stress. Model 1-1, 1-2 and 1-3, which were loaded with 155N, showed less stress than corresponding model 2-1, 2-2 and 2- 3 which were loaded with 206N. For the same number of implants, the existence of a cantilever induced the obvious increase of maximum stress. Model 1-3 and 2-3 which had a cantilever, showed much higher stress than the others which had no cantilever. In all models, the von Mises stresses were concentrated at the cortical bone around the cervical region of the implants. Meanwhile, in model 1-1, 1-2 and 1-3, which were loaded on second premolar position, the first premolar participated in stress distribution. First premolars of model 2-1, 2-2 and 2-3 did not participate in stress distribution. CONCLUSION: 1. The more implants supported, the less stress was induced, regardless of applied occlusal loads. 2. The maximum von Mises stress in the bone of the implant-supported three unit fixed dental prosthesis with a mesial cantilever was 1.38 times that with a central pontic. The maximum von Mises stress in the bone of the implant-supported three-unit fixed dental prosthesis with a distal cantilever was 1.59 times that with a central pontic. 3. A distal cantilever induced larger stress in the bone than a mesial cantilever. 4. A adjacent tooth which contacts implant-supported fixed prosthesis participated in the stress distribution.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.03a
• /
• pp.1250-1253
• /
• 2008

As a reinforcement technique, the application of removable soil nailing has been extended to solve the public grievance of typical soil nailing such as the geotechnical environmental problem and invasion of adjacent land. In the case of removable soil nailing, pullout capacity of the nail depends on the adhesive strength of a fixed socket. Because the existing fixed socket is made from a plastic product, the strength of a socket is less than a steel bar and then the yield failure by abrasion and deformation is occurred on the steel bar-socket contact surface. In this study, therefore, experimental analysis from laboratory test of a removable soil nail equipped with steel socket, improving the adhesive strength of steel bar-socket connection is performed to estimate the increase effect of pullout capacity of a soil nail.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.16 no.1
• /
• pp.40-47
• /
• 2013

By virtue of Rec. ITU-R P.1546 and geography information system, interference analysis for the fixed wireless system and radar has been presented based upon the frequency-distance rules with minimum coupling loss, and a comprehensive methodology for assessing interoperability between systems was examined in terms of received signal, protection ratio, frequency dependent rejection. Also to find the antenna gain from a discrimination angle, a useful S-I plane was introduced based on signal and interference vectors derived from the real map with geographic information. To show some computational results, geography information on the map was taken for the given area, and field strength and path profile were illustrated for the radar and fixed wireless system operating at 2.7 GHz, for convenience. In addition the interference effect of receiver was also checked as a function of radar beam direction including protection ratio and frequency dependent rejection. The developed interference analysis can be actually applied to evaluate interoperability for wireless systems in the VHF and UHF bands.

• Communications for Statistical Applications and Methods
• /
• v.15 no.6
• /
• pp.1003-1011
• /
• 2008

Mixed-effect Poisson regression models are widely used for analysis of correlated count data such as those found in longitudinal studies. In this paper, we consider kernel extensions with semiparametric fixed effects and parametric random effects. The estimation is through the penalized likelihood method based on kernel trick and our focus is on the efficient computation and the effective hyperparameter selection. For the selection of hyperparameters, cross-validation techniques are employed. Examples illustrating usage and features of the proposed method are provided.

• International Area Studies Review
• /
• v.14 no.1
• /
• pp.203-219
• /
• 2010

Nowadays an instability of the exchange rate on accounts of global finance crisis brings on a lot of an economic damage such as recession, decreasing of total trade and so on. However some countries which belong to be membership of the eurozone could escape economic slump shortly and easier than others. The reason for this is that they share with the Euro as a their own currency which is the second vehicle currency all of the world. This paper analyzes the correlation of joining the Euro zone and trade with pooled OLS, random effect estimation, and fixed effect estimation. A membership of the Euro zone are able to increase trade 11.3% ~ 25.3% one another on average since some country belongs to the Euro zone. It is very important for some countries which have a plan to affiliate the Euro zone sooner or later to realize economic effect because of a protection of the Euro zone as well as political power.

• Journal of Korean Society of Environmental Engineers
• /
• v.35 no.6
• /
• pp.449-455
• /
• 2013

The effect of recycling ratio and fixed media on nitrate and phosphate removal was investigated in a pilot-scale wastewater treatment unit using synthetic wastewater. Addition of fixed media increased nitrate removal from 45 to 58% while no noticeable change was observed for Chemical Oxygen Demand (COD) and phosphate removal (<5%). Nitrate removal efficiency also enhanced (Ca 7%) when the influent wastewater flow was doubled (2Q), however phosphate removal was decreased from 40.9 to 26.6% with the increasing recycling rate. The attached biomass analysis showed the presence of bacteria (73.4 $mg/cm^2$) on the surface of added media in anoxic reactor. Pseudomonas aeruginosa a common denitrifying bacterium dominated the bacterial growth (58%) in the anoxic reactor which was determined using Fluorescence In Situ Hybridization (FISH) analysis.

• Journal of Advanced Navigation Technology
• /
• v.21 no.5
• /
• pp.428-434
• /
• 2017

In recent years, owing to the growing user demand for the two-way internet service based on the mobile global broadband communications, a new type of satellite terminal has been developed, known as ESIM(Earth Station in Motion). This service was required by Resolution 158(WRC-15) to study on the coexistence with the co-primary FS(Fixed Service) in 27.5-29.5 GHz as a FSS(Fixed Satellite Service) uplink. In this paper, the average received power on ESIM within -10 dB of beam width of FS and its outage probability was analyzed theoretically and also simulated to account for the azimuth angle with uniform distribution. From the results, it can be concluded that this theoretical analysis is very useful to analyze the interference from ESIM into FS based on the statistical and probabilistic method. Therefore, it is necessary to control the azimuth angle due to a moving terminal as well as the inclination angle of moving path, the operation hours, and the speed of ESIM to protect the co-primary FS.

• Korea Journal of Hospital Management
• /
• v.9 no.2
• /
• pp.102-127
• /
• 2004

The objective of this study is to analyze a current trend of and relating factors on profitability of the Korean Public Corporation Medical Centers(KPCMCs, hereinafter, hospitals) in Korea. There are 34 hospitals in Korea as of 2004. Among these hospitals some are red ink hospitals, others are black inks in terms of profitability. Data were collected by Korea Health Industry Development Institute(KHIDI) Statistics for Hospital Management 2000-2002 and Ministry of Health and Welfare(MOHW) financial data of public hospitals which was planned to coordinate public health care services roadmap in the long run. The samples are 32 hospitals. Profitability was measured in the aspect of profit rate with normal profit to total assets, and normal profit to gross revenues as dependent variables in respective. Independent variables were classified by general factors, i.e., location, intern/resident training, period of opening, number of beds, and managerial factors(current ratio, fixed ratio, liability to total assets, total assets turnover, personnel costs, materials cost, administrative cost), and finally factors related to patient treatment(average length of stay, bed occupancy rate, admission ratio of outpatients). The methods of analysis are correlation and multiple regression analysis. This study shows firstly, a lot of hospitals are optimal current ratio. Hospitals in upper 100% current ratio are 81.2%. And the personnel cost in total costs are high. Secondly, the trend of normal profit to gross revenues of hospitals are deteriorating gradually. And lastly, as a result of multiple regression analysis, the factors had on significant effect on normal profit to total assets are fixed ratio(+), liability to total assets(-), bed occupancy rate(+), admissions of outpatients(+), etc. And the factors had on significant effect on normal profit to gross revenues are current ration(+), fixed ratio(+), personnel cost(-), administrative expenses(-), admissions of outpatients(+), etc. In conclusion, to improve the profitability of hospitals, the efforts to reduce personnel cost and average length of stay might be needed. And also beds utilization rate need to be increased.

• Computers and Concrete
• /
• v.25 no.3
• /
• pp.255-266
• /
• 2020

This study presents comparation of fixed and viscos boundary condition effects on three-dimensional earthquake response and performance of a RCC dam considering linear and non-linear response. For this purpose, Cine RCC dam constructed in Aydın, Turkey, is selected in applications. The Drucker-Prager material model is considered for concrete and foundation rock in the nonlinear time-history analyses. Besides, hydrodynamic effect was considered in linear and non-linear dynamic analyses for both conditions. The hydrodynamic pressure of the reservoir water is modeled with the fluid finite elements based on the Lagrangian approach. The contact-target element pairs were used to model the dam-foundation-reservoir interaction system. The interface between dam and foundation is modeled with welded contact for both fixed and viscos boundary conditions. The displacements and principle stress components obtained from the linear and non-linear analyses are compared each other for empty and full reservoir cases. Seismic performance analyses considering demand-capacity ratio criteria were also performed for each case. According to numerical analyses, the total displacements and besides seismic performance of the dam increase by the effect of the viscous boundary conditions. Besides, hydrodynamic pressure obviously decreases the performance of the dam.

• Clinical and Experimental Reproductive Medicine
• /
• v.20 no.1
• /
• pp.65-70
• /
• 1993

To maintain a good sperm motility is one of the key factors for the successful artificial insemination in retrograde ejaculation, and the sperm motility has been shown to be affected by various environmental factors, including change in pH and osmolarity. Herein we have analyzed the effect of change in pH and osmolarity in urine and normal saline on sperm motility by Sperm Quality Analyzer and Makler counting chamber. Semen, which sampled by masturbation from a 28 year old male and showed normal finding on semen analysis, was used for this study. The results were as follows: 1. When osmolarity was fixed to 300mOsm, pH did not show a definite effect on the sperm moility. However, the motility was generally a bit better in alkaline urine and saline than in acid, particularly than in pH 5.0. 2. When pH was fixed to 7.5, sperm motility was best in urine and saline of 300mOsm. Hyperosmolarity had more adverse.effect on the motility than hypoosmolarity. 3. The sperm motility was worse in the urine than in saline under the same pH and osmolarity. In conclusion, osmolarity has a definite effect on sperm motility, where as pH has relatively little effect. And certain components of urine other than pH and osmolarity might affect the sperm motility.