• Nuclear Engineering and Technology
• /
• v.51 no.2
• /
• pp.432-438
• /
• 2019

In the study of nuclear structure, the fast timing technique can be used to measure the lifetime of excited states. In the paper, we have developed a new fast timing system, which is made up of two $LaBr_3:Ce$ detectors and a set of waveform sampling system. The sampling system based on domino ring sampler version 4 chip (DRS4) can digitize and store the waveform information of detector signal, with a smaller volume and higher timing accuracy, and the waveform data are performed by means of digital waveform analysis methods. The coincidence time resolution of the fast timing system for two annihilation 511 keV ${\gamma}$ photon is 200ps (FWHM), the energy resolution is 3.5%@511 keV, and the energy linear response in the large dynamic range is perfect. Meanwhile, to verify the fast timing performance of the system, the $^{152}Gd-2_1^+$ state form ${\beta}^+$ decay of $^{152}Eu$ source is measured. The measured lifetime is $45.3({\pm}5.0)ps$, very close to the value of the National Nuclear Data Center (NNDC: $46.2({\pm}3.9)ps$). The experimental results indicate that the fast timing system is capable of measuring the lifetime of dozens of ps. Therefore, the system can be widely used in the research of the fast timing technology.

• Journal of Positioning, Navigation, and Timing
• /
• v.11 no.1
• /
• pp.11-21
• /
• 2022

Fast Fourier transform (FFT)-based parallel acquisition techniques with reduced computational complexity have been widely used for the acquisition of binary phase shift keying (BPSK) global positioning system (GPS) signals. In this paper, we propose a low computational FFT-based fine acquisition technique, for binary offset carrier (BOC) modulated BPSK signals, that depending on the subcarrier-to-code chip rate ratio (SCR) selectively utilizes the computationally efficient frequency-domain realization of the BPSK-like technique and two-dimensional compressed correlator (BOC-TDCC) technique in the first stage in order to achieve a fast coarse acquisition and accomplishes a fine acquisition in the second stage. It is analyzed and demonstrated that the proposed technique requires much smaller mean fine acquisition computation (MFAC) than the conventional FFT-based BOC acquisition techniques. The proposed technique is one of the first techniques that achieves a fast FFT-based fine acquisition of BOC signals with a slight loss of detection probability. Therefore, the proposed technique is beneficial for the receivers to make a quick position fix when there are plenty of strong (i.e., line-of-sight) GNSS satellites to be searched.

• Journal of Positioning, Navigation, and Timing
• /
• v.4 no.4
• /
• pp.151-160
• /
• 2015

GPS L2C signal is a recently added civil signal to L2 frequency and is constructed by time division multiplexing of civil moderate (L2-CM) and civil long (L2-CL) code signals. While the L2-CM code is 20 ms-periodic and modulates satellite navigation message, the L2-CL code is 1.5s-periodic with 767,250 chips long code sequence and carries no data. Therefore, the L2-CL code signal allows receivers to perform a very long coherent integration. However, due to the length of the L2-CL code, the acquisition of the L2-CL code signal may take too long or require too much hardware resources. In this paper, we propose a three-step ultra-fast L2-CL code acquisition (TSCLA) technique for dual band GPS receivers. In the proposed TSCLA technique, a dual band GPS receiver sequentially acquires the coarse/acquisition (C/A) code signal at L1 frequency, the L2-CM code signal, and the L2-CL code signal to minimize mean acquisition time (MAT). The theoretical performance analysis and numerous Monte Carlo simulations show the significant advantage of the proposed TSCLA technique over conventional techniques introduced in the literature.

• Journal of Positioning, Navigation, and Timing
• /
• v.4 no.4
• /
• pp.161-171
• /
• 2015

Alternative binary offset carrier (AltBOC) signals can be approximated by four synchronized direct sequence spread spectrum (DSSS) signals, each pair of which is a quadrature phase shift keyed (QPSK) signal at a different frequency. Therefore, depending on the strength of an incoming AltBOC signal, an acquisition technique can reduce the mean acquisition time (MAT) by searching the four DSSS signals asynchronously; the search for each of the four DSSS signals can start at one of the evenly separated hypotheses on the two-dimensional hypothesis space. And detection sensitivity can be improved by multiple levels when different numbers of search results for the same hypothesis are combined. In this paper, we propose a fast AltBOC acquisition technique that has an asynchronous search strategy and efficiently utilizes the output of the four search results to increase the sensitivity level when sensitivity improvement is needed. We provide a complete theoretical analysis and demonstrate with numerous Monte Carlo simulations that the MAT of the proposed technique is much smaller than conventional AltBOC acquisition techniques.

• Proceedings of the IEEK Conference
• /
• 2008.06a
• /
• pp.453-454
• /
• 2008

Modern VLSI designs get increasingly complex and time-to-market constraints get tighter. Using high level languages is one of the most promising solutions for improving design productivity by raising the level of abstraction. In high level synthesis process, most important step is scheduling. In this paper, we propose fast and efficient scheduling method under timing constraint based on list scheduling. Experimental results on well known data path intensive designs show fast execution times (less than 0.5 sec) and similar results when compared to optimal solutions [1].

• Korean Journal of Applied Biomechanics
• /
• v.28 no.2
• /
• pp.93-100
• /
• 2018

Objective: The purpose of this study is to analyze the kinematic characteristics of the national speed skaters in the curve phase of 500-m race. Method: Seven national skaters participated in the study. Race images were acquired using a high - speed camera, and the three-dimensional motion was analyzed. Results: For skaters, whose average velocity in the curve phase is high, the velocity of entry into the straight phase was also fast. The fast skaters showed a larger maximum angle of extension of the knee joints than the relatively slow skaters, and the trunk ROM was smaller. Fast skaters tended to match the timing of the movement of the lower limb with the pelvis, while slow skaters tended to rotate the left pelvis backward. The velocity of the curve phase did not show a clear relationship with stroke time, average trunk angle, and lap time. Conclusion: It is important to skate close to the inner line, keep the trunk ROM below 10 degrees, extend the knee angle to over 160 degrees, and match the movement of the pelvis and lower limb to accelerate in the curve phase. The average velocity of the curves was fast for many athletes, but the competition rankings were low. Therefore, it is possible to improve the performance by optimizing the start technique, the running characteristics of the straight phase, and the physical factors.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.53 no.4
• /
• pp.200-207
• /
• 2004

This paper presents a simple and fast delay metric RC-class interconnects under saturated ramp inputs. The RC delay metric under saturated ramp inputs, called FDM(Fast Delay Metric), can estimate delay times at an arbitrary node using a simple closed-form expression and is extended from delay metric under step input easily As compared with similar techniques proposed in previous researches, it is shown that the FDM technique complexity for a similar accuracy. As the number of circuit nodes increases, there will be a significant difference in estimation times of RC delay between the previous techniques based on two circuit moments and the FDM which do not depend on circuit moments.

• KSCI Review
• /
• v.15 no.1
• /
• pp.53-64
• /
• 2007

Avoid at damage systems in order to avoid own IP address exposure, and an invader does not attack directly a system in recent hacking accidents at these papers, and use Stepping stone and carry out a roundabout attack. Use network audit Policy and use a CIS, AIAA technique and algorithm, the Sleep Watermark Tracking technique that used Thumbprints Algorithm, Timing based Algorithm, TCP Sequence number at network bases, and Presented a traceback system at TCP bases at log bases, and be at these papers Use the existing algorithm that is not one module in a system one harm for responding to invasion technology develop day by day in order to supplement the disadvantage where is physical logical complexity of configuration of present Internet network is large, and to have a fast technology development speed, and presentation will do an effective traceback system.

• Journal of Positioning, Navigation, and Timing
• /
• v.7 no.4
• /
• pp.235-243
• /
• 2018

Conventional Real Time Kinematics (RTK) collect measurements in stationary state for several minutes to resolve the integer ambiguity in the carrier phase measurement or resolve the integer ambiguity on the move assuming low maneuvering movement. In this paper, an On The Move-RTK (OTM-RTK) technique that resolves the integer ambiguity on the move for fast and precise positioning of ground vehicles such as high maneuvering vehicles was proposed. The OTM-RTK estimates the precise amount of movement between epochs using the carrier phase measurements acquired on the move, and by using this, resolves the integer ambiguity within a short period of time by evaluating the integer ambiguity candidates for each epoch. This study analyzed the integer ambiguity resolution performance using field driving experiment data in order to verify the performance of the proposed method. The results of the experiment showed that the precise trajectory including the initial position bias can be obtained prior to resolving the integer ambiguity, and after resolving the integer ambiguity on the move, it was possible to obtain the bias-corrected precise position solution. It was confirmed that the integer ambiguity can be resolved by collecting measurements of about 10 epochs from the moving vehicle using a dual frequency receiver.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2004.08a
• /
• pp.1053-1056
• /
• 2004

Chunghwa Picture Tubes, LTD. (CPT) has developed a Novel TFT-LCD Driving Techniquel. This new technique is developed in combination with other state-of-the-art image processing solutions such as image compression / decompression, motion detection, and noise reduction. By applying the Novel Driving Technique to the high resolution TFT-LCD, it was found that the response time can be effectively reduced with a lower overall system cost by smaller frame memory requirement, lower EMI by less memory band-width. Likewise, higher display quality can also be achieved in that the unexpected noises generated by over-drive can be eliminated. The Novel TFT-LCD Driving Technique has been successfully implemented to the 30 inch WXGA (1280${\times}$768) resolution TFT LCD commercial TV module. It was found that the quality of moving picture was better improved compared with that of the conventional fast response driving method.