• Proceedings of the Korean Fiber Society Conference
• /
• 1996.04a
• /
• pp.72-75
• /
• 1996

• Bulletin of the Korean Chemical Society
• /
• v.17 no.4
• /
• pp.309-311
• /
• 1996

• Korean Chemical Engineering Research
• /
• v.47 no.1
• /
• pp.105-110
• /
• 2009

IZO thin films have been deposited on poly(ethylene terephthalate) flexible substrate under varying radio frequency (rf) power, process pressure and thickness of IZO films using rf magnetron sputtering under $Ar/O_2$ gas mix. As the process pressure increased, the deposition rate was slightly increased and the transmittance showed little change, but the resistivity was increased. With increasing rf power, the great increase in deposition rate was observed but the transmittance showed a slight change only, and the resistivity was decreased. In addition, an attempt was made to find the optimal thickness of IZO films under varying the thickness of IZO films at the process conditions of 1 mTorr pressure and 90 W rf power, which showed lowest resistivity. IZO thin films with the thickness of $1,500{\AA}$ showed lowest resistivity and also showed highest transmittance around the wavelength zone of the maximum absorption. The power conversion efficiency of solar cells fabricated using various transparent electrodes with different thicknesses were measured and the solar cell with IZO electrode of $1,500{\AA}$ showed the maximum conversion-efficiency of 2.88 %.

• Applied Chemistry for Engineering
• /
• v.5 no.3
• /
• pp.524-536
• /
• 1994

Chitosan is known to be a good biocompatible natural polymer. Polyethyleneglycol monomethacrylates(PEGM) were grafted onto chitosan and their reaction conditions and properties of the graft polymers obtained were estimated. Using ceric ammonium nitrate(CAN) as the initiator, the optimum condition for graft polymerization was determined amount of the initiator and monomer concentrations and reaction time. Grafting yields such as total conversion, the percentage of grafting and the efficiency of grafting were calculated and examined the optimum reaction condition for high grafting yields. The percentage of grafting and total conversion were maximum at condition that the concentration of initiator was $4{\sim}5{\times}10^{-3}M$, the concentration of monomer was 0.5~0.6M, the reaction time was 2~3 hours and the reaction temperature was about $40^{\circ}C$. Thermal characteristics, solubility for chitosan solvents and inherent viscosity of synthesized graft copolymers were investigated. In high initiator concentration, characteristics of chitosan were greatly diminshed. In case of inherent viscosities, chitosan-g-PE-90 was 2.81 dl/g, chitosan-g-PE-200, 3.01dl/g and chitosan-g-PE-350, 4.93dl/g. And a tendency of viscosity increase depending on the length of ethylene oxide residue was confirmed. Degree of swelling, tensile strength, elongation of membrane prepared from graft copolymers were determined. Properties of graft copolymers were affected by percentage of grafting and length of ethylene oxides residue in polyethylene glycol monomethacrylates. Tensile strength, elongation and degree of swelling of graft copolymers were remarkably improved than chitosan. As percentage of grafting increased, the amount of drug permeation was also increased.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2006.04a
• /
• pp.54-56
• /
• 2006

Single-well-gas-sparging tests were developed and evaluated for assessing the feasibility of in-situ aerobic cometabolism of trichloroethylene (TCE), using propane as a growth substrate. To evaluate transport characteristics of dissolved solutes [sulfur hexafluoride (SF6) or bromide (non-reactive tracers), propane (a growth substrate), ethylene, propylene (nontoxic surrogates to probe for CAH transformation activity), and DO], push-pull transport tests were performed. Mass balance showed about 90% of the injected bromide and about 80% of the injected SF6 were recovered, and the recoveries of other solutes were comparable with bromide and slightly higher than SF6. A series of Gas-Sparging Biostimulation tests were performed by sparging propane/oxygen/argon/SF6 gas mixtures, and temporal ground water samples were obtained from the injection well under natural gradient 'drift' conditions. The decreased time for propane depletion and the longer time to deplete SF6 as a conservative tracer indicate the progress of biostimulation. Gas-Sparging Activity tests were performed. .Propane utilization, DO consumption, and ethylene and propylene cometabolism were well demonstrated. The stimulated propane-utilizers cometabolized ethylene and propylene to produce ethylene oxide and propylene oxide, as cometabolic by-products, respectively. Gas-Sparging Acetylene Blocking tests were performed by sparging gas mixtures including acetylene to demonstrate the involvement of monooxygenase enzymes. Gas substrate degradation was essentially completely Inhibited in the presence of acetylene, and no production of the corresponding oxides was also observed. The Gas-Sparging tests supports the evidences that the successive stimulation of propane-oxidizing microorganisms, cometabolic transformation of ethylene and propylene by the enzyme responsible for methane and propane degradation.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.19 no.1
• /
• pp.71-74
• /
• 2006

In this paper, we investigated the characterization of silicon oxide(SiOx) thin film on Ethylene Terephthalate(PET) substrates by e-beam deposition for transparent barrier application. The temperature of chamber increases from $30^{\circ}C$ to $110^{\circ}C$, the roughness increase while the Water vapor transmission rate (WVTR) decreases. Under these conditions, the WVTR for PET can be reduced from a level of $0.57 g/m^2/day$ (bare subtrate) to $0.05 g/m^2/day$ after application of a 200-nm-thick $SiO_2$ coating at 110 C. A more efficient way to improve permeation of PET was carried out by using a double side coating of a 5-${\mu}m$-thick parylene film. It was found that the WVTR can be reduced to a level of $-0.2 g/m^2/day$. The double side parylene coating on PET could contribute to the lower stress of oxide film, which greatly improves the WVTR data. These results indicates that the $SiO_2$ /Parylene/PET barrier coatings have high potential for flexible organic light-emitting diode(OLED) applications.

• Proceedings of the Korean Environmental Health Society Conference
• /
• 2005.11a
• /
• pp.150-153
• /
• 2005

A gas chromatography/electron impact mass spectrometric assay method was developed for the determination of Hb-adduct, 2-(hydroxyethyl)valine (HEVal), of ethylene oxide(EO). Globin was separated from hemoglobin by acid iso-propanol and ethyl acetate, then HEVal was isolated as PFPITH-HEVal by Edman degradation. PFPITH-HEVal was silylated with N-methyl-N-(tert-butyl-dimethylsilyl)trifluoroacetamide(MTBDMSTFA)-NH4I (1000:4) under catalysis of dithioerythritol. The detection limit of the assay was 5.8 pmol/g based upon assayed hemoglobin of 0.1g. Two groups of mice were exposed to EO for 0.5 and 1.0 hr/day, respectively at 400ppm during 4 weeks. As the result, the adduct levels increased according to the exposure time with the linearity of 0.7011 and 0.8914, respectively, HEVal was very valuable as biomarker for the exposure of EO. In human, HEVal was analyzed until 8.33 pmol/mg.

• Journal of Environmental Health Sciences
• /
• v.8 no.1
• /
• pp.25-30
• /
• 1982

The incidence of hospital infection has been seriously increased in the general hospital in recent years. This study was performed on hospital air and materials in a General Hospital in Seoul from June to December in 1980. The results were as follows: 1. Air sampling was done in multiple strategic areas by exposing standard petridishes for 5 minutes. There was a significant difference of airborne microbe between places. ($F._{99}$ = 3.2, p < 0.01). 2. The mean colony count was 8.6$\pm$6.2 colonies / plate / 5 minutes. 3. Gram stains of colony in air sampling were Gram (+) cocci 66.5%. Gram (+) rod 18.4%, Gram (-) cocci 1.3%, Gram (-) rod 8.7% Fungus 4.5%. 4. For the evaluation of sterilization of steam sterilizer and ethylene oxide gas sterilizer, biological monitoring were done by commercial spore strip. Positive culture was obtained in 2 out of 41 tests on 3 steam sterilizers, and in 3 out of 13 tests on ethylene oxide gas sterilizer. 5. Product sampling and culture were done for 2 kinds of disinfectants and 30 sets of various operation package or dressing materials. Positive culture was obtained in one disinfectants.

• The Korean Journal of Rheology
• /
• v.3 no.1
• /
• pp.76-85
• /
• 1991

적은양의 분자량이 큰선형 고부자를 수용액에 첨가함으로서 얻어지는 마찰저항가소 연구가 rotating disk 장치를 이용해 수행되었다. 마찰저항 감소제로 poly(ethylene oxide)와 poly(acrylamide)를 사용하였으며 고분자 분자량 고분자 농도, disk 의 회전속도 및 온도 등 여러 가지 인자에 대한 마찰정항감소의 의존성을 연구하였다. 또한 마찰저항 감소 효과와 고분자 용액의 점도평균 분자량을 동시에 측정함으로서 고분자 퇴화에 대한 연구도 수행하 였다. 마찰저항감소는 고분자 농도가 증가함에 따라 임계농도에 도달할때까지 증가하였고 낮은 농도에서는 분자량이 큰 고분자일수록 더욱 큰 마찰저항 감소효과를 나타내었다. 마찰 감소 진행 중의 높은 전단력에 기인하는 고분자의 분해는 고분자 농도가 낮은데에서 더욱두 드러지게 나타났으며 온도 효과의 연구로부터 poly(acrylamide)가 poly(ethylene oxide)보다 열적으로 안정함을 알수 있었다.

• Applied Chemistry for Engineering
• /
• v.9 no.4
• /
• pp.603-607
• /
• 1998

Cellulose was reacted with ethylene oxide to get hydroxyethylcellulose. Quaternary ammonium salt was produced by reaction of epichlorohydrin and trialkylamine. The epoxide ring was opened by acid addition to 3-chloro-2-hydroxypropyltrialkylammonium chloride. Previously unreported two compounds, hydroxyethylcellulose-2-hydroxypropylammonium chloride ether and hydroxyethylcellulose-2-hydroxypropyltriethylammonium chloride ether were synthesized by substitution reaction of hydroxyethylcellulose with glycidyltrialkylammonium chloride or 3-chloro-2-hydroxypropyl-glycidyltrialkylammonium trialkylammonium chloride. All of the compounds including starting materials and reaction intermediates were characterized by $^1H$-NMR and FT-IR spectroscopy.