• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.10 no.6
• /
• pp.44-52
• /
• 2007

Recently, oystershell wastes cause serious environmental problem and the need for the researches on the recycling of oystershell have been increased and various methods are already in operation. Field plate bearing tests and numerical analysis were performed to investigate the bearing capacity of oystershell filled geotextile gabion which utilized the waste oystershell at the coastal oyster farm site. The waste oystershell mixed soil specimens were prepared for the laboratory test and field test in terms of varying blending ratio of granite soil and oystershell. Based on the cyclic plate load test results, the spring constant, subgrade modulus of ground, and the reinforcing parameters were determined. The field plate load test results indicate that the bearing capacity of the soil ground with the oystershell mixed ratio of 20% is greater than that of the original ground. Two-dimensional numerical analysis was evaluated the expected deformation in the given conditions. Analysis results show a similar characteristics on bearing capacity with the results of the field plate load test. These findings suggest that the oystershells are very promising construction materials for landfill and earth embankment in coastal area.

• Nuclear Engineering and Technology
• /
• v.53 no.4
• /
• pp.1331-1344
• /
• 2021

This study is to evaluate the seismic capacity of the fire-damaged cabinet facility in a nuclear power plant (NPP). A prototype of an electrical cabinet is modeled using OpenSees for the numerical simulation. To capture the nonlinear behavior of the cabinet, the constitutive law of the material model under the fire environment is considered. The experimental record from the impact hammer test is extracted trough the frequency-domain decomposition (FDD) method, which is used to verify the effectiveness of the numerical model through modal assurance criteria (MAC). Assuming different temperatures, the nonlinear time history analysis is conducted using a set of fifty earthquakes and the seismic outputs are investigated by the fragility analysis. To get a threshold of intensity measure, the Monte Carlo Simulation (MCS) is adopted for uncertainty reduction purposes. Finally, a capacity estimation model has been proposed through the investigation, which will be helpful for the engineer or NPP operator to evaluate the fire-damaged cabinet strength under seismic excitation. This capacity model is presented in terms of the High Confidence of Low Probability of Failure (HCLPF) point. The results are validated by the proper judgment and can be used to analyze the influences of fire on the electrical cabinet.

• Journal of the Korean GEO-environmental Society
• /
• v.7 no.5
• /
• pp.67-77
• /
• 2006

Bearing capacity of soil can be improved by several conventional ground improvement techniques like stabilization and compaction. Recently, the necessity on the reseaches for the bearing capacity of footing reinforced by Geotextile is being significantly increased. In this paper, a series of model tests on sandy ground reinforced by a layer of Geotextile were performed under plane strain condition, and the effects of bearing capacity improvement and behaviour of sandy ground were observed through tests for position and horizontal length, material strength of reinforcement.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2004.03b
• /
• pp.74-81
• /
• 2004

In this study, static end loading tests with load transfer measurement were accomplished for large diameter drilled shaft constructed in fault zone. Yield pile capacity (or ultimate pile capacity) from load-settlement curve was determined and axial load transfer behavior was measurd. The end bearing capacity was increased 2 times due to grouting the toe ground under pile base.

• Journal of Environmental Science International
• /
• v.4 no.5
• /
• pp.527-534
• /
• 1995

The waste biomass of Sacchromyces uvarum, used in fermentation industries to produce ethanol, were studied for their ability to absorb various heavy metal ions. Heavy metal ions studied in this research were Cd, Co, Cr, Cu, Ni and Pb. The order of the sorption capacity was Pb>Cu>Co=Cr=Cd>Ni. The living Sacchromyces uvarum exhibited higher metal-uptake capacity than the dead Sacchromyces uvarum. After we compare the uptake capacity of the Sacchromyces uvarum for individual metal ions with for a mixture of them, the following was observed: in the mixed heavy metal solution the uptake capacity was decreased than the one heavy metal solution. The selective uptake was observed when all . the heavy metal ions were dissolved in a mixed solution. The adsorption isotherm modelling was decribed with the Langmuir and Freundlich model. The results were in good agreement with the Langmuir model.

• Structural Engineering and Mechanics
• /
• v.35 no.5
• /
• pp.593-616
• /
• 2010

The seismic performance of reinforced concrete (RC) bridge columns is a significant issue because the interaction of flexural ductility and shear capacity of such columns with varied amounts of lateral reinforcement is not well established. Several relationships between flexural ductility and shear capacity have been proposed by various researchers in the past. In this paper, a parametric study on RC bridge columns is conducted using a nonlinear finite element program, "Simulation of Concrete Structures (SCS)", developed at the University of Houston. SCS has been previously used to predict the seismic behavior of such columns. The predicted results were compared with the test results obtained from experiments available in literature. Based on the results of the parametric study performed in this paper, a set of new relationships between flexural ductility and shear capacity of RC columns is proposed for seismic design.

• Journal of Environmental Health Sciences
• /
• v.19 no.4
• /
• pp.25-32
• /
• 1993

Granular activated carbon is commonly used in fixed-bed adsorbers to remove organic chemicals. In this experiment organic chemical solutions were prepared by adding the reagent grade organic chemical to distilled water. Isotherm adsorption tests of volatile organic chemicals were conducted using bottle-point technique and column test. Organic chemicals after passing through the column were extracted with hexane and analyzed with gas chromatography (Hewlett-Packard 5890) to check the adsorption capacity and breakthrough curve. The result were as follows: 1. The BET surface area of coconut activated carbon was 658~1,010 m$^2$/g where as coconut shell carbon was 6.6 m$^2$/g. Coconut activated carbon increased the BET surface area and adsorption capacity in bottle-point isotherm. 2. The adsorption capacity of coconut activated carbon for trichloroethylene (TCE) was reduced in the presence of humic substance. 3. A decrease in particle size of activated carbon resulted in higher adsorption capacity and lower intraparticle diffusion coefficient. It is reflected not only as a decrease in Freudlich adsorption capacity value (K) but also as an increase in Freudlich exponenent value (1/n).

• Journal of Environmental Health Sciences
• /
• v.37 no.1
• /
• pp.50-56
• /
• 2011

The adsorption capacity of charcoal is a function of the airborne concentration of the target chemical. To evaluate the adsorption capacity of charcoal packed in the cartridges of air purifying respirators, breakthrough tests were conducted with carbon tetrachloride for three commercial cartridges (3M models #7251, #6000 and AX) at 25, 50, 100, 250 and 500 ppm. Adsorption capacities were calculated using a mass transfer balance equation derived from the curve fitting to the breakthrough curves obtained experimentally. Carbon micropore volumes were estimated by iteration to fit the Dubinin/Radushkevich (D/R) adsorption isotherm. They were 0.6566, 0.5727 and 0.3087 g/cc for #7251, #6000 and the AX cartridge, respectively. Above 100 ppm (at high challenge concentrations), #7251 and #6000 showed higher adsorption capacities. However, as the challenge concentration decreased, the adsorption capacities of #7251 and #6000 sharply dropped. On the other hand, the adsorption capacity of the AX cartridge showed little change with the decrease of the challenge concentration. Thus, the AX showed a higher adsorption capacity than #7251 and #6000 at the 5-50 ppm level. It is concluded that service-life tests of cartridges and adsorption capacity tests of charcoal should be conducted at challenge concentration levels reflecting actual working environmental conditions. Alternatively, it is recommended to use the D/R adsorption isotherm to extrapolate adsorption capacity at low concentration levels from the high concentration levels at which breakthrough tests are conducted, at a minimum of two different concentration levels.

• Physical Therapy Korea
• /
• v.24 no.3
• /
• pp.1-9
• /
• 2017

Background: The method of measuring the walking function of patients with chronic stroke differs depending on patients walking capability and environmental conditions. Objects: This study aimed to demonstrate the influences of walking capacity and environmental conditions on the results of short- and long-distance walk tests in patients with chronic stroke. Methods: Forty patients with chronic stroke volunteered for this study, and allocated to group-1 (<.4m/s, household walking, $n_1=13$), group-2 (.4~.8m/s, limited community ambulation, $n_2=16$), and group-3 (>.8m/s, community ambulation, $n_3=11$) according to their walking capacity. The 10-meter walk test (10MWT) and 6-min walk tests, (6MWT) were used to compare the short- and long-distance walk tests results, which were randomly performed under indoor and outdoor environmental conditions. Results: The comparison of the results obtained under the indoor and outdoor conditions revealed statistically significant differences between the groups in the 6MWT and 10MWT (p<.05). Post-hoc tests' results showed significant differences between groups-1 and -2 and between groups-1 and -3 in the 10MWT, and between group-1 and -3 in the 6MWT. Furthermore, in group-2 the 10MWT and 6MWT results significantly differed between the indoor and outdoor conditions, and the values measured under the indoor and outdoor conditions significantly differed between 10MWT and 6MWT (p<.05). Group-3 showed a significant difference in 10MWT results between the indoor and outdoor conditions (p<.05). Conclusion: These findings suggest that the results of the short- and long-distance walk tests may differ depending on the walking capacity of patients with chronic stroke and the environmental condition under which the measurement is made, and these effects were greatest for the patients with the limited community ambulation capacity.

• Journal of the Korean Regional Science Association
• /
• v.33 no.4
• /
• pp.29-42
• /
• 2017

This study aims to analyze the effect of local government capacities on the improvement of air pollution. For this purpose, we construct a dynamic panel model using a data set for air pollutants such as $SO_2$, $CO_2$, and particulate matters and the local governments' capacities for Chinese Provinces in the period of 2007 - 2014. The results show that of the three types of capacities, the organizational capacity measured by environmental personnel, environmental expenditures, and average size of environmental institutions is very important, while the institutional capacity and social capacity have a insignificant impact on the air quality improvement. Among the local government capacities, other than the organizational capacity, only the activity of environmental organizations, which is a social capacity, partially affects the improvement of air pollution. Regarding local conditions, vertical dependence of financial resources, GRDP per capita, and population density have a negative impact on improving air pollution. These findings provide implications for local governments in China as to what capacities they should improve to improve air pollution.