• Journal of Advanced Marine Engineering and Technology
• /
• 제24권4호
• /
• pp.441-445
• /
• 2000

Considering international status of our country as world class ship builder and geographical characteristics encircled by sea in three facets, controlling of air pollutants emission from marine engines becomes more and more important issue in recent days. Implementation of immediate pollutants emission control regulation and standardization of test and certification procedure are required to reduce air pollution from marine engines. But cost increments due to additional equipment of emission control device and development and certification test expenses as well as depreciation of fuel economy should be considered. To satisfy those air pollution reduction and economic requirements, we should make our own interpretation of IMO standard and implementation schedule depending on our country's status. For this purpose we measured NOx emission from small and middle class marine engines to calculate emission factor and total pollutant emission in our country. With the comparison and analysis of other countries emission control regulation we proposed basic data of total emission from marine engine and future emission control standard in our country. According to our estimation, 62% of total NOx emission of marine engines comes from fishing boat and 38% from commercial vessels. The portion of NOx emission from marine engine is 18.6% of whole country NOx emission. Due to the voyage characteristics of middle and large vessel and necessity of international harmonization of marine engine pollutants emission control standard, it is inevitable to adopt IMO standard for middle and large marine engines. But considering technological and cost effect of fishing boat operating in near sea, it is resonable to set a standard within 80% of measured value at the moment and gradually implement the same IMO standard in near future.

• 한국연소학회지
• /
• 제19권4호
• /
• pp.42-48
• /
• 2014

The emission standard of diesel engine on the construction equipment has been rapidly enhanced in advanced countries, because most of air pollutions was caused by construction equipment. So, all of the construction equipments will be tested for emission with standard measurement mode. But, the standard measurement mode of construction equipment is different for non-road and one for the road in korea. This study was conducted to measure emission characteristics of the construction equipment with changed standard measurement mode and to improvement the emissions experimentally.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2014년도 제49회 KOSCO SYMPOSIUM 초록집
• /
• pp.143-144
• /
• 2014

The demand of diesel engine on the construction equipment has been rapidly increased because of thermal efficiency and power. But some of the construction equipment is imported from other country, since the their demands are not so large as compared with the other construction equipment. The imported construction equipments will be tested for emission with standard measurement mode. This study was conducted to measure emission characteristics of the construction equipment with changed standard measurement experimentally.

• 분석과학
• /
• 제23권2호
• /
• pp.109-118
• /
• 2010

이 연구에서는 2008년에 개정된 "다중이용시설 등의 실내 공기 질 관리법"의 시행규칙 중에서 페인트와 퍼티의 시험방법과 개정된 시험방법을 비교하고 변경된 관리기준의 변화 방향에 대해서 알아보았다. 페인트의 경우 개정된 시험방법은 시험기간의 변경으로 인하여 원래 시험방법에 의한 방출강도 보다 약 45% 감소하였으며, 건조시간의 변화에 따른 방출강도의 영향은 없었다. 또한 도포량의 변화에 따른 방출강도의 변화는 $5\;mg/m^2h$ 이상의 높은 방출 강도를 가지는 제품은 방출강도의 변화가 크나 그 이외의 제품들에서는 방출강도의 변화가 없었다. 퍼티의 경우 개정된 시험방법은 시험기간의 변경으로 원래 시험방법에 의한 방출강도 보다 평균 61% 감소하였고, 건조시간의 변화에 따른 방출강도의 영향은 없었다. 그러나 퍼티의 도포량의 변화로 인하여 원 시험방법에 의한 방출강도보다 약 164% 증가 하였다. 개정된 시험방법에 따른 변경된 TVOCs의 관리기준은 페인트와 퍼티 모두 원래 시험방법에 의한 과거의 관리기준 보다 각각 1.8배 및 5.8배 완화된 것으로 나타났다.

• 품질경영학회지
• /
• 제17권1호
• /
• pp.48-59
• /
• 1989

The motor vehicle emission is expected to be constrained strongly in the future in accordance with the current policy as to prevention of air pollution. This paper establishes a sequential rectifying inspection plan which satisfies the standard motor vehicle emission for the automobile producers who are currently producting the automobiles with catalytic converts. This plan also considered the constraint of the effective motor vehicle emission by way of rectifying the certification test in the past. In order to evaluate the performance of the inspection plan, the recent certification test data have also been applied. The result of the application has proved that the rectified sequential inspection plan presented in this paper satisfies the standard motor vehicle emission and can be the optimal economic inspection plan. As a result the inspection plan given in this paper will be contributed to constrain the motor vehicle emission most effectively.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2003년도 추계학술대회논문집
• /
• pp.845-850
• /
• 2003

Noise caused by water installations may lead to annoyance in adjacent rooms, for example in dwellings. hospitals and hotels. This part of standard describes a method of measurement allowing comparable results to be obtained in laboratory measurements. The test conditions described herein constitute the standard reference conditions essential for comparisons between laboratories.

• 한국대기환경학회지
• /
• 제33권4호
• /
• pp.342-350
• /
• 2017

We report mass concentration and size fraction of TPM, $PM_{10}$ and $PM_{2.5}$ according to Korea standard test method (ES 01301.1 and ES 01317.1) and ISO 23210 methods. Particulate matters were sampled in large stationary emission sources such as a coal power plant and B-C oil refinery. The Korea standard test method PM mass concentrations showed 3~3.5 times larger than the cascade impactor method. On the other hand, the size fraction results showed less than 5% difference (i.e. $PM_{2.5}/PM_{10}$) between two methods. Moreover, the correlation coefficient ($r^2$) is 0.84 between TPM results of the Korea standard test method and CleanSYS. These results suggested not only improvement of current test criteria in terms of technical and theoretical aspects. Further, additional measurements are required in various large stationary sources to compare current field data.

• 한국대기환경학회지
• /
• 제1권1호
• /
• pp.83-92
• /
• 1985

In odrder to survey the emission level of air pollutants from diesel vehicles, was measured CO, HC, NOx and smoke of 4 types of domestic-use diesel engines under various conditions. The emission of CO, HC and NOx tested by 6-Mode test method and smoke emission by full load test met the permissible vehicle emission standard. Pollutant emission rates of diesel engines were different according to engine operating conditions, that is, engine load and engine speed. Generally, CO and HC was emitted more at low load and NOx at high load but the trend was quite different by the type of engines. In exhaust gas, $NO_2$ portion of NOx emission was high, specially at low speed and low load. The correlation equation between CLD(NOx) and NDIR(NO) method of nitrogen of nitrogen oxides analysis was y = 1.10x - 3.48 (y: CLD method) as a result of 6-mode test.

• ETRI Journal
• /
• 제17권3호
• /
• pp.45-63
• /
• 1995

This paper proposes an algorithm to improve the correlation between giga-hertz transverse electromagnetic (GTEM) cell and open area test site (OATS). It is based on the dipole modeling process of an unknown source object in a GTEM cell and on the evaluation of the approximate far field equations correlated with measured GTEM powers at output port of the GTEM cell. In this algorithm, the relative phase differences between dipole moments play an important part in modeling the test object as a set of dipoles and offer stable calculation of emission values. The radiated emission test using this algorithm requires fifteen orientations of equipment under test, but the increased orientations as compared with the previous method have little effect on the time needed for testing. Radiation from a notebook computer has been tested for statistical analysis of the correlation between GTEM data and OATS data. The emission test results of the notebook computer show that the mean, the standard deviation, and the correlation coefficient are -0.62, 1.99, and +0.85, respectively. These figures indicate that this algorithm provides improved accuracy in the measurement of electromagnetic emissions over the previous method.

• 설비공학논문집
• /
• 제18권7호
• /
• pp.563-570
• /
• 2006

We investigated the emission characteristics of gaseous organic contaminants from building materials and newly constructed apartments. The emission test for building materials was done with small chamber method, and field measurements in newly constructed apartment were carried out by Korea Standard Test Method for Indoor Air Quality. First, the emission test by small chamber showed that the TVOC emission from building materials was much higher than formaldehyde. On the other hand, as expected, considerably high concentration of both TVOC and HCHO was detected in the new apartment.