• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.53 no.8
• /
• pp.454-460
• /
• 2004

The effects of surge arresters for protection of transmission systems against direct lightning strokes have already been reviewed using Electromagnetic Transients Program(EMTP). Distribution lines are spanned in much larger area than transmission lines, and therefore, are more susceptible to lightning strokes. We have modelled the 22.9kV underground distribution cable systems that have arresters and grounding wires. And this paper analyzes the overvoltages on underground distribution cable systems when direct lightning strokes strike on the overhead grounding wire using EMTP. Then we investigated that (1) the effects of lightning stroke according to underground distribution cable length (2) voltages at the riser pole and at the cable terminal according to installation of arrester. This study will provide insulation coordination methods for reasonable systems design in 22.9kV underground distribution cable systems.

• Proceedings of the KIEE Conference
• /
• 1996.07b
• /
• pp.731-733
• /
• 1996

In this paper, a new time-domain reduction method for unbalanced 3 phase power systems will be represented. The impulse response of the system is used to identify a discrete-time equivalent filter model. The model is formulated directly in the phase domain. Each phase has a self-mode equivalent model and two mutual-mode equivalent models. The equivalent model is determined by the transfer function identification technique based on the Prony analysis. The model is implemented in EMTDC and tested with an unbalanced 3 phase network. The result of test showed that the equivalent model is accurate.

• Proceedings of the KIEE Conference
• /
• 1996.07b
• /
• pp.850-852
• /
• 1996

High impedance fault (HIF) is defined as fault that general overcurrent relay can't detect or interrupt, Especially when HIF occur under 15 kV, energized high voltage conductor results in fire hazard, equipment damage or personal threat. Because most HIF occur arc, HIF detection using arc is to increase. Numerical arc model can be applied in an electromagnetic transients program (EMTP) to reproduce the dynamic and random characteristic of arcs for any insulator arrangement, current and system voltage. It allows the representation of any network configuration to be investigated, so the digital simulation of arc faults through air can be substitute for demanding power arc test.

• Proceedings of the KIPE Conference
• /
• 2014.07a
• /
• pp.389-390
• /
• 2014

고압직류송전 (High Voltage Direct Current, HVDC) 시스템의 모듈형 멀티레벨 컨버터 (Modular Multilevel Converter, MMC)는 EMT (Electromagnetic Transients) 시뮬레이션으로 구현 시 많은 연산시간을 요구하므로 시간 단축을 위한 가속설계가 반드시 필요하다. 본 논문에서는 스위칭 함수를 이용한 등가 모델을 이용하여 각 암을 하나의 전압원으로 단순화하였다. 본 가속모델의 유효성을 검증하기 위해 PSCAD/EMTDC에서 제공하는 반도체 스위치를 이용한 모델과 비교하여 시뮬레이션 수행시간을 비교하였다.

• Proceedings of the KIEE Conference
• /
• 1994.11a
• /
• pp.75-77
• /
• 1994

This paper presents a method of obtaining transmission network equivalents from the network's driving-point admittance characteristic. Proposed method is based on modal decomposition representation for the large-scale interconnected system. As a result, Norton-type of discrete-time filter model can be generated. It can reproduce the driving-point admittance characteristic of the network. Furthermore proposed model can be implemented into the EMTP in a direct manner. The simulation results with the full system representation and the developed equivalent system showed a good agreement.

• Proceedings of the KIEE Conference
• /
• 1995.07a
• /
• pp.434-436
• /
• 1995

This paper was to determine the feasibility of controlling subsynchronous resonance(SSR) by the fast modulation of series compensation capacitors. The presence of subsynchronous currents in the system was detected by a subsynchronous relay which was modeled by the transient analysis of control systems (TACS) in the electromagnetic transients program (EMTP). The capacitor segments were switched by bi-directional thyristor swtiches. The paper proved that effective control of SSR can be obtained only by the detuning of the system and the removal or blocking of subsynchronous energy from the system.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.29 no.6 s.237
• /
• pp.671-686
• /
• 2005

The transient nature and complex geometries of two-phase gas-liquid flows cause fundamental difficulties when measuring flow velocity using an electromagnetic flowmeter. Recently, a current-sensing flowmeter was introduced to obtain measurements with high temporal resolution (Ahn et al.). In this study, current-sensing flowmeter theory was applied to measure the fast velocity transients in slug flows. The velocity fields of axisymmetric gas-liquid slug flow in a vertical pipe were obtained using Volume-of-Fluid (VOF) method, and the virtual potential distributions for the electrodes of finite size were also computed using the finite volume method for simulating slug flow. The output signal prediction for slug flow was carried out from the velocity and virtual potential (or weight function) fields. The flowmeter was numerically calibrated to obtain the cross-sectional liquid mean velocity at an electrode plane from the predicted output signal. Two calibration parameters are proposed for this procedure: a flow pattern coefficient and a localization parameter. The flow pattern coefficient was defined by the ratio of the liquid resistance between the electrodes for two-phase flow with respect to that for single-phase flow, and the localization parameter was introduced to avoid errors in the flowmeter readings caused by liquid acceleration or deceleration around the electrodes. These parameters were also calculated from the computed velocity and virtual potential fields. The results can be used to obtain the liquid mean velocity from the slug flow signal measured by a current-sensing flowmeter.

• Proceedings of the KSME Conference
• /
• 2004.04a
• /
• pp.1951-1956
• /
• 2004

The transient nature and complex flow geometries of two-phase gas-liquid flows cause fundamental difficulties when measuring flow velocity using an electromagnetic flowmeter. Recently, a current-sensing flowmeter was introduced to obtain measurements with high temporal resolution (Ahn et $al.^{(1)}$). In this study, current-sensing flowmeter theory was applied to measure the fast velocity transients in slug flows. To do this, the velocity fields of axisymmetric gas-liquid slug flow in a vertical pipe were obtained using Volume-of-Fluid (VOF) method and the virtual potential distributions for the electrodes of finite size were also computed using the finite volume method for the simulated slug flow. The output signal prediction for slug flow was carried out from the velocity and virtual potential (or weight function) fields. The flowmeter was numerically calibrated to obtain the cross-sectional liquid mean velocity at an electrode plane from the predicted output signal. Two calibration parameters are required for this procedure: a flow pattern coefficient and a localization parameter. The flow pattern coefficient was defined by the ratio of the liquid resistance between the electrodes for two-phase flow with respect to that for single-phase flow, and the localization parameter was introduced to avoid errors in the flowmeter readings caused by liquid acceleration or deceleration around the electrodes. These parameters were also calculated from the computed velocity and virtual potential fields. The results can be used to obtain the liquid mean velocity from the slug flow signal measured by a current-sensing flowmeter.

• The Bulletin of The Korean Astronomical Society
• /
• v.46 no.2
• /
• pp.53.4-54
• /
• 2021

Although the era of very large telescopes has come, small telescopes still have advantages for fast follow-up and long-term monitoring observation. Intensive monitoring survey of nearby galaxies (IMSNG) aims to understand the nature of the supernovae (SNe) by catching the early light curve from them with the network of small telescopes from 0.4-m to 1.0-m all around the world. To achieve the scientific goals with heterogeneous facilities, three factors are important. First, automatic processes as soon as data is uploaded will increase efficiency and shorten the time. Second, searching for transients is necessary to deal with newly emerged transients for fast follow-up observation. Finally, the Integrated process for different telescopes gives a homogeneous output, which will eventually make connections with the database easy. Here, we introduce the integrated pipeline, 'gppy' based on Python, for more than 10 facilities having various configurations and its performance. Processes consist of image pre-process, photometry, image align, image combine, photometry, and transient search. In the connected database, homogeneous output is summarized and analyzed additionally to filter transient candidates with light curves. This talk will suggest the future work to improve the performance and usability on the other projects, gravitational wave electromagnetic wave counterpart in Korea Observatory (GECKO), and small telescope network of Korea (SOMANGNET).

• Journal of the Korean Institute of Telematics and Electronics T
• /
• v.36T no.3
• /
• pp.79-84
• /
• 1999

The existing EMTP(Electromagnetic Transients Program) is writted by FORTRAN-77, has a closed architecture and uses a large number of code lines to satisfy requirements ranging from low level data manipulation to the actual solution mathematics which eventually become diluted and almost impossible to visualize. Thus has a difficulty in the development and maintenenace of its program module. This paper proposes a new design idea suitable (or a re-development of EMTP using the MATLAB and VISUAL-C++, which presents the development of the new EMTP package is operated in the window environment. The package has the GUI(Graphic User Interface) ability, and the MATLAB computation engine for an analysis of a transient state in an electric circuit.