• Journal of Biomedical Engineering Research
• /
• v.38 no.4
• /
• pp.183-189
• /
• 2017

Electrosurgical Unit(ESU) is medical equipment that cut or coag tissues using electrical energy. It is used in hospitals' outpatient clinic room and operating room. Improper use of an ESU may cause fatal injuries to the patient, such as burns. So, before using an ESU, make sure that it is supplying enough energy for cut and coag by measuring the output power and checking the output power cable. In this study, we developed a simple ESU power measurement system PW100 that allows anyone to check the basic output power. And PW100 can check the state of the cable associated with the output power before using ESU. Then, we compared the measured output power of the PW100 with an ESU Analyzer which was commercialized, and compared the performance. In the experiment, the output power measured by the PW100 was lower value than an ESU Analyzer's that. However, the PW100's output power measured in the 5% error range and showed stable reproducibility by a low %RSD value.

• Journal of Biomedical Engineering Research
• /
• v.20 no.2
• /
• pp.205-212
• /
• 1999

When we want to observe and record a patient's EEG in an operating room, the operation of electrosurgical unit(ESU) causes undesirable artifacts with high frequency and high voltage. These artifacts make the amplifiers of the conventional EEG system saturated and prevent the system from measuring the EEG signal. This paper describes a high-performance bipolar EEG amplifier for a CSA (compressed spectral array ) system with reduced ESU artifacts. The designed EEG amplifier uses a balanced filter to reduce the ESU artifacts, and isolates the power supply and the signal source of the preamplifier from the ground to cut off the current from the ESU to the amplifier ground. To cancel the common mode noise in high frequency, a high CMRR(common mode rejection ratio) diffferential amplifier is used. Since the developed bipolar EEG amplifier shows high gain, low noise, high CMRR, high input impedance, and low thermal drift, it is possible to observe and record more clean EEG signals in spite of ESU operation. Therefore the amplifier may be applicable to a high-fidelity CSA system.

• Journal of the Korean earth science society
• /
• v.31 no.1
• /
• pp.71-87
• /
• 2010

The purpose of this study was to explore 8th-grade students' imageries of the Earth. We analyzed the middle school students' imageries about the Earth represented with words and drawings in Earth Systems Understanding (ESU, hereafter) framework. The students' imageries about 'the Earth' are vary by their experiences and prior-knowledge, which significantly impacts their imagery construction. Especially, the students' ESU were characterized into two aspects: One is a macroscopic view point based on full-objects of the Earth by indirect experiences and the other is everyday view point based on scene of the Earth surface and environment by direct experiences. Results revealed students' imageries about the Earth were impacted by visual experiences and those students' ESU were more represented by drawing as visual imagery than by words, formal language. The negative imageries were mainly represented through interactions of the Earth subsystems.

• Korean Journal of Optics and Photonics
• /
• v.9 no.3
• /
• pp.168-174
• /
• 1998

We have measured nonlinear refractive index and nonlinear absorption coefficient of optical materials by using a far-field phase modulation technique. The phase variation of the probe beam in the nonlinear material is transformed into the spatial phase modulation in the far-field so that the spatial distribution of the optical intensity in conjunction with the computer simulation analysis can give the nonlinear optical constants. We have obtained the nonlinear refractive indices and nonlinear absorption coefficient of $CS_2$ and $BaF_2$ by fitting the experimental values and numerical simulation analysis of far-field measurements. The nonlinear refractive indices of $CS_2$ and $BaF_2$were obtained as $1.2{\times}10^{-11}$ esu and $1.0{\times}10^{-13}$ esu, respectively at 616 nm, and the nonlinear absorption coefficient of BaF$_2$as $5.0{\times}10^{-11}$cm/W at 308nm. These measured values were in good agreement with previous reports.

• Proceedings of the KIPE Conference
• /
• 2010.07a
• /
• pp.184-185
• /
• 2010

This paper deals with a ride-through technique of doubly-fed induction generator (DFIG) wind turbine systems using energy storage unit (ESU). By increasing the machine speed, some portion of the turbine power can be stored in the system inertia during grid faults. Also keeping the operation of rotor-side converter (RSC) and grid-side converter (GSC), the rotor current and DC-link voltage can be limited. The effectiveness of the proposed method is verified by simulation results for 2[MW] DFIG wind turbine system.

• Korean Journal of Optics and Photonics
• /
• v.10 no.4
• /
• pp.289-293
• /
• 1999

The nonlinear susceptibilities of the porous silicon surface were determined from the second harmonic generation. The value of nonlinear susceptibility, ${\chi}^{(2)}_{zzz}$ was $1.04{\times}10_{-7}$ esu which had an intensity of two orders of magnitude greater than that of silicon crystal wafers. The orientation angle of absorbed molecules on the porous silicon surface was ${16.8}^{\circ}$.

• Journal of the Korean Society for Aviation and Aeronautics
• /
• v.17 no.4
• /
• pp.25-31
• /
• 2009

In development phase of the Aircraft Systems, the reliability prediction of electronic equipments are usually performed using MIL-HDBK-217. The reliability of fielded electronic systems, however, used to be underestimated with MIL-HDBK-217. To solve this problem, some alternatives are suggested and Telcordia SR-332 is among them. In this case study, the reliability of ESU which controls gas turbine engine is predicted using Telcordia SR-332 along with the development test data. The predicted reliabilities of ESU using Telcordia SR-332 and MIL-HDBK-217 are also compared. As a result this case study showed that the predicted reliability using Telcordia SR-332 was better close to field(operation) reliability than MIL-HDBK-217.

• Bulletin of the Korean Chemical Society
• /
• v.15 no.1
• /
• pp.25-28
• /
• 1994

Weakly electron withdrawing bromine substituted poly(2-bromo-1,4-phenylenevinylene) (PBrPV) was synthesized th-rough water-soluble precursor method. The linear and nonlinear optical properties of PBrPV were compared with those of poly(1,4-phenylenevinylene) (PPV). The third-order nonlinear optical susceptibility, X^{(3)}$, was measured by using third-harmonic generation (THG) technique at 1907 nm, fundamental wavelength. The calculated $X^{(3)}$ values of PPV and PBrPV were 3${\times}$ 10$^{-12}$ esu and 2${\times}$10$^{-12}$ esu, respectively.

• Bulletin of the Korean Chemical Society
• /
• v.17 no.7
• /
• pp.607-612
• /
• 1996

A series of new NLO-active poly(4-nitrophenylallylamine) derivatives was synthesized by the nucleophilic substitution reaction of several substituted 4-nitrohalobenzenes and poly(allylamine hydrochloride). All polymers obtained were amorphous and their glass transition temperatures (Tg) were observed around 148-160 ℃. For each of these polymers, their specific Tg values were dependent on characteristic electronic structures. UV-visible absorption spectra showed maximum absorption intensity at 355-393 nm for π-π* transition of alkylaminonitrophenyl groups. The χ(2)value of poly(4-nitrophenylallylamine), as determined by the second harmonic generation at 1064 nm, for a thin polymer film poled at an elevated temperature, was 1.4x10-8esu. The third-order NLO properties of poly(4-nitrophenylallylamine) derivatives were evaluated through measurement of degenerate four-wave mixing technique and χ(3) coefficient in the range of 2.7~3.2x10-12 esu at 602 nm was found with 400 fs laser pulses.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.7 no.3
• /
• pp.514-520
• /
• 1997

A single component of $Sb_2O_3$ glass has been obtained by a rapid quenching method in vacuum. The linear refractive indices were measured as a function of wavelength from 500 nm to 1060 nm. The refractive index at $n_{3{\omega}}$/(633 nm) was as high as 2.00. The optical band gap was estimated as 3.38 eV from the optical absorption spectrum. The third-order nonlinear optical intensity was determined by the third harmonic generation (THG) method. The $\chi^{(3)}$value was as high as $5.68{\times}10^{-13}$esu, about 20 times larger than that of $SiO_2$ glass.