• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.30 no.1
• /
• pp.76-83
• /
• 1985

A hypothesis that artificial reforming of corn canopy could improve solar light penetration and dry matter production was tested in corn fields (var. Suwon 19) with three planting densities; low (60 ${\times}$ 40cm), medium (60 ${\times}$ 24cm) and high (60 ${\times}$ 16cm). Natural canopy was found that leaf orientations were even over all azimuth but somewhat inclined toward north-south direction and leaf angle ranged 38$^{\circ}$ to 71$^{\circ}$ from horizontal surface. Reforming corn canopy included following treatments: 1) natural canopy planted in north-south rows (natural canopy), 2)east-west plane canopy planted in north-south rows (E-W canopy), 3)east-west plane canopy and upright leaves in north-south rows, 4)north-south plane canopy (N-S canopy) in east-west rows. After corn plots were installed with training system by supporting poles and connecting wires, corn leaves were induced to a reforming direction and tied on wire. Average light intensity at the mid-point of plant height showed 5-10% increases in E-W canopy and in E-W canopy plus upright leaves, but a 2-10% decrease in N-S canopy from natural canopy. At yellow ripe stage, total dry wt. was increased in E-W canopy but not in N-S canopy. The E-W canopy produced 3-10% more grain yield than natural canopy. Though E-W canopy plus upright leaves yielded less at low density, it yielded up to 10% more at higher density. The N-S canopy yielded similar to low compared with natural canopy. These results suggests that reforming canopy toward solar incident direction increases light penetration into lower canopy, photosynthetic efficiency and grain yield, especially at high planting density in corn.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.19 no.1
• /
• pp.6-10
• /
• 2009

In this paper, a selective area growth (SAG) of a GaN/AlGaN double heterostructure (DH) has been performed on r-plane sapphire substrate by using the mixed-source hydride vapor phase epitaxy (HVPE) with multi-sliding boat system. The SAG-GaN/AlGaN DH consists of GaN buffer layer, Te-doped AlGaN n-cladding layer, GaN active layer, Mg-doped AlGaN p-cladding layer, and Mg-doped GaN p-capping layer. The electroluminescence (EL) characteristics show an emission peak of wavelength, 439 nm with a full width at half maximum (FWHM) of approximately 0.64 eV at 20 mA. The I-V measurements show that the turn-on voltage of the SAG-GaN/AlGaN DH is 3.4 V at room temperature. We found that the mixed-source HVPE method with a multi-sliding boat system was one of promising growth methods for III-Nitride LEDs.

• Proceedings of the KIEE Conference
• /
• 1997.07d
• /
• pp.1478-1480
• /
• 1997

We investigated the breakdown characteristic of mineral oil according to applied voltage and tip radius. In this experiment, electrode system was point-plane geometry. The tip radius of needle was 5, 10, 20 and $25{\mu}m$, respectively. Applied voltage was AC and DC. We measured breakdown voltage for each tip radius with increasing electrode gap, 2mm to 10mm. Under nonuniform electric field, breakdown strength was higher when needle was negative than when needle was positive. Because it is polarity effects due to space charge. And the more sharp tip radius, whether we applied AC or DC, the higher breakdown strength. As tip radius increase, breakdown strength decreases exponentially.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.6 s.121
• /
• pp.656-663
• /
• 2007

In this paper, when a E-polarized plane wave is incident on the grating consisting of tapered resistive strips, electromagnetic scattering is analyzed using the method of moments(MoM). The induced current density of each resistive strip in a grounded double dielectric layer is expected to blow up at both edges. To satisfy this, the induced surface current density is expanded in a series of Chebyshev polynomials of the second kind. The scattered electromagnetic fields are expanded in a series of Floquet mode functions. The boundary conditions are applied to obtain the unknown current coefficients. According to the variation of the involving parameters such as strip width and spacing and angle of the incident field, numerical simulations are performed by applying the Fourier-Galerkin moment method. The numerical results of the normalized reflected power for resistive strips case for several resistivities are obtained.

• Journal of the Korean Ceramic Society
• /
• v.22 no.6
• /
• pp.53-57
• /
• 1985

Korean montmorillonite from Youngil district was characterized by Alkylammonium derivatives. This method was very sensitive to the basal plane spacing d and the charge in the layer charge. The result include the values of average layer charge, charge distribution, equivalent area. interlayer cationic exchange capacity (C, E, C) and total C. E. C.

• Bulletin of the Korean Mathematical Society
• /
• v.52 no.1
• /
• pp.301-312
• /
• 2015

In this paper, we study a class of spacelike rotational surfaces in the Minkowski 4-space $\mathbb{E}^4_1$ with meridian curves lying in 2-dimensional spacelike planes and having pointwise 1-type Gauss map. We obtain all such surfaces with pointwise 1-type Gauss map of the first kind. Then we prove that the spacelike rotational surface with flat normal bundle and pointwise 1-type Gauss map of the second kind is an open part of a spacelike 2-plane in $\mathbb{E}^4_1$.

• Bulletin of the Korean Mathematical Society
• /
• v.50 no.3
• /
• pp.885-899
• /
• 2013

In this paper, we study null helices, null slant helices and Cartan slant helices in $\mathb{E}^3_1$. Using some associated curves, we characterize the null helices and the Cartan slant helices and construct them. Also, we study a space-like curve with the principal normal vector field which is a degenerate plane curve.

• Journal of the Chungcheong Mathematical Society
• /
• v.18 no.2
• /
• pp.145-159
• /
• 2005

In this paper we introduced the concept of perfect folding defined on $E^2$ which equipped by perfect k-coloring of r-monohedral tillings. Then we studied the different cases of perfect foldings of 4-monohedral and 3-monohedral tillings of $E^2$. Also the permutations describe each folding are obtained.

• Honam Mathematical Journal
• /
• v.40 no.4
• /
• pp.701-718
• /
• 2018

In this paper, we will study the constant mean curvature (CMC) surfaces foliated by ellipses in three dimensional Euclidean space $E^3$. We prove that: (1): Surfaces foliated by ellipses are CMC surfaces if and only if it is a part of generalized cylinder. (2): All surfaces foliated by ellipses are not minimal surfaces. (3): CMC surfaces foliated by ellipses are developable surfaces. (4): CMC surfaces foliated by ellipses are translation surfaces generated by a straight line and plane curve.

• International Journal of Computer Science & Network Security
• /
• v.23 no.1
• /
• pp.120-124
• /
• 2023

Strong surface waves among collinearly arranged patch antenna arrays pose unwanted inter element coupling particularly when high permittivity dielectric materials are used. In order to avert those waves, a novel Defected Ground Structure (DGS) is carved out systematically between two E-plane patch antenna elements. The introduced low profile μ shaped structure consequently improves impedance bandwidth and reflection coefficient by suppressing surface waves considerably. Parametric simulation results are analyzed and discussed.