• Journal of Environmental Science International
• /
• v.10 no.2
• /
• pp.105-111
• /
• 2001

Improvement of water quality and Investigation of bacterial characteristics have been conducted in a pilot plant using biological activated carbon (BAC) in water treatment process at the downstream of the Nakdong River. Most of water control parameters were highly improved after passing through BAC. Approximately 54% of dissolved organic carbon was removed in coal-based BAC process. Bacterial biomass and bacterial production appeared $9.8{\times}10^8 CFU/g and 7.1mg-C/m^3$.hr in coal-based BAC, respectively. Predominant bacteria species grown in BAC were identified as Pseudomonas, Flavobacterium, Alcaligenes, Acinetobacter and Aeromonas species. Particularly Pseudomonas vesicularis was dominant in both coal-based and coconut-based BACs, while Pseudomonas cepacia was dominant in wood-based BAC.

• Journal of Environmental Impact Assessment
• /
• v.18 no.3
• /
• pp.171-183
• /
• 2009

This study aims to analyze the sedimentary environment change in mid-channel bar of the lower Geum river basin after the construction of the estuary barrage using multi-temporal satellite data and GIS. The sedimentary environment changes were observed in mid-channel bar areas. The mid-channel bar F was found to have been newly formed for 10 years(1996-2006), whereas the mid-channel bar B located between mid-channel bar A and C has disappeared by erosion during the same periods. When examined by section, the areas of the mid-channel bar in the upper stream section from the Yipo's reference point generally increased due to the prevailing sedimentary environments, and those of the downstream section decreased where corrosive environments are dominant. In ternms of the centroid movement, the mid-channel bars grew up toward the downstream by switching erosion and accumulation, as sedimentation was prevailing in the downstream area of mid-channel bars and corrosion was dominant in the upper stream. Through grain size analysis, the study areas are divided into three sections according to the average grain size. In Section I, the mid-channel bars were formed as a result of sedimentary process of tides in the past. In Section II, the mid-channel bars were formed partly through the sedimentary process of rivers although the sedimentary process of tides is prevailing. In Section III, the mid-channel bars were formed mainly through the sedimentary process of rivers, even if it showed the sedimentary process of tides in the past.

• Journal of the korean society of oceanography
• /
• v.38 no.2
• /
• pp.45-51
• /
• 2003

Recent observations reveal that the Tsushima Current has a double-cored structure downstream of the Tsushima Island. To explain this, a simple analytical model is proposed based on the assumption of small lateral eddy viscosity. This model suggests that an otherwise uniform current becomes to have a stream core immediately after it enters a channel due to the action of lateral friction. The core is initially broad but becomes sharper downstream. The speed at which the core develops depends on the intensity of lateral eddy viscosity. Likewise, a single-cored stream changes rapidly to a double-cored stream when it passes through an island located in the center of the channel. When the stream leaves the island behind, the reverse process from the double-to single-cored structures takes place. In this case, however, the double-cored structure is retained for a significant distance from the island. Overall, this model suggests that the double-cored structure of the Tsushima Current observed downstream of the Tsushima Island Is created by the lateral friction exerted by the Tsushima Island.

• Journal of Microbiology and Biotechnology
• /
• v.9 no.2
• /
• pp.179-183
• /
• 1999

A recombinant form of hirudin, a potent thrombin-specific inhibitor derived from the bloodsucking leech, was expressed as a secretory product in Saccharomyces cerevisiae under the control of GALl0 promoter and the mating factor $\alpha$pre-pro leader sequence. In an attempt to produce recombinant hirudin (r-Hir) of therapeutic purity in large quantities, the fed-batch fermentation was carried out by using this recombinant yeast, and subsequently downstream processing was developed with the preparative-scale column chromatography systems. About 234 mg/l of biologically active r-Hir was produced as a secretory product by the fed-batch fermentation strategy developed for an efficient downstream processing. Using a two-step chromatography process (an anion exchange chromatography followed by the reverse phase HPLC), the r-Hir was purified to>98% with an overall recovery yield of 84%. According to the N-terminal amino acid sequencing, the purified r-Hir was found to have the predicted N-terminal amino acid sequence. The biological activity of the purified r-Hir to inhibit thrombin was also identical to that of the commercial hirudin.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.12B
• /
• pp.1535-1541
• /
• 2009

In this paper, we suggest an efficient path searching algorithm that reduces the hop count when each node sends a data in ZigBee networks. As the hop count reduces, the network traffic is also reduces and leads to less energy consumption. This enables the sensor network live longer with limited node power. The proposed path searching algorithm consists of two sub-algorithms. One for upstream process and the other for downstream process. When a node selects its proper routing path, the node not only uses the information of the parent and child node, but it also uses the neighbor nodes for each node. In the simulation, we changed various network environment factors such as network parameters, number of nodes, and number of neighbor nodes and observed their performances. We compare the performance to the previous ZigBee Tree routing algorithm with separate two algorithms, the upstream and the downstream, and then compare the performance when all two algorithms are applied.

• Korea-Australia Rheology Journal
• /
• v.13 no.1
• /
• pp.37-45
• /
• 2001

Numerical simulation of coextrusion process of viscoelastic fluids within a die has been carried out. In the coextrusion process velocity profile at the outflow boundary is not known a priori, which makes it difficult to impose the proper boundary condition at the outflow boundary. This difficulty has been avoided by using the open boundary condition (OBC) method. In this study, elastic viscous stress splitting (EVSS) formulation with streamline upwind (SU) method has been used in the finite element method. In order to test the validity of the OBC method, comparison between the results of fully developed condition at the outlet and those of OBC has been made for a Newtonian fluid. In the case of upper convected Maxwell (UCM) fluid, the effect of outflow boundary condition on the interface position has been investigated by using two meshes having different downstream lengths. In both cases, the results with the OBC method showed reasonable interface shape. In particular, for the UCM fluid the interface shape calculated with OBC was independent of the downstream length, while the results with the zero traction condition showed oscillation of interface position close to the outlet. Viscosity difference was found to be more important than elasticity difference in determining the final interface position. However, the overshoot of interface position near the con-fluent point increased with elasticity.

• International journal of advanced smart convergence
• /
• v.4 no.1
• /
• pp.154-161
• /
• 2015

A novel process has successfully been developed by overcoming major difficulties through the elimination of number of process steps involved in the Classical Transesterification reaction during the preparation of Fatty Acid Methyl/Ethyl Ester (FAME.FAEE) called biodiesel. The Classical process with cost intensive process steps such as the utilization of excess alcohol, needing downstream distillation for the recovery and reutilization of excess alcohol/cosolvent, unrecoverable homogenous catalyst which consumes vast quantity of fresh distilled water during the purification of the product and downstream waste water treatment before its safe disposal to the surface water body. The Novel Process FAME/FAEE is produced from any vegetable oil irrespective of edible or inedible variety using sonication energy. The novelty of the finding is the use of only theoretical quantity of alcohol along with a co-solvent and reduced quantity of homogeneous catalyst. Under this condition neither the homogeneous catalyst goes to the FAME layer nor is the distillation needed. The same ester also has been prepared in high pressure high temperature reactor without using catalyst at sub critical temperature. The quality of prepared biodiesel without involving any purification step meets the ASTM standards. Blended Biodiesel with Common Diesel Fuel (CDF) and FAME is prepared, characterized and used as fuel in the Kirloskar make CI Engines. The evaluation of the engine performance result of pure CDF, B05 biodiesel, B10 biodiesel of all types of biodiesel prepared by using the feedstock of Soybean (Glycine max) and Karanja (Pongamia pinnate) oil along with their mixed oil provides useful information such as brake power, brake thermal efficiency, brake specific fuel consumption, etc, and established it as ideal fuel for unmodified CI engine.

• Journal of Distribution Science
• /
• v.13 no.12
• /
• pp.105-111
• /
• 2015

Purpose - Many global companies across industries are paying significant attention to co-creation activities, which enable consumers to participate in firms' value creation process, as a main model of new product development processes. In this study, we aim to examine different types of co-creation activities and their effects on consumer attitudes. We focus on upstream co-creation, downstream co-creation, autonomous co-creation, and sponsored co-creation. Upstream co-creation includes firms' control and management in the initial stage of new product development and prototype testing. Downstream co-creation indicates that consumers participate in firms-initiative activities at a later stage in new product development, such as public relations and marketing communications. Autonomous co-creation includes consumers' commitment activities in the absence of firms' rewards. However, under the sponsored co-creation, consumers can return monetary and social rewards from firms through their co-creation activities. The hypotheses regarding the effect of co-creation on consumer attitudes are as follows. (H1, H2, H3, H4) Upstream, downward, autonomous, and sponsored co-creation has positive effects on consumer attitude. (H5, H6) As intrinsic motivation increases, the positive effect of upstream and autonomous co-creation increases. (H7, H8) As extrinsic motivation increases, the positive effect of downward and sponsored co-creation increases. Research design, data, and methodology - To achieve our research goals, we analyzed responses from 246 samples from Korean consumers and verified the proposed hypotheses using a linear regression model. The samples include Korean consumers who experienced upstream, downstream, autonomous, and sponsored co-creation by firms. Results - First, both upstream co-creation and downstream co-creation with firms and consumers are found to have positive effects on consumer attitudes. Second, autonomous co-creation and sponsored co-creation are found to positively affect consumer attitudes. Third, consumers' intrinsic motivation has a fit-effect between upstream co-creation and autonomous co-creation, and their extrinsic motivation has a fit-effect between downstream co-creation and sponsored co-creation. Consumers who have strong intrinsic motivation are affected by upstream co-creation and autonomous co-creation. However, consumers who have strong extrinsic motivation are affected by downstream co-creation and sponsored co-creation. Conclusion - These results indicate that the fit between consumers' co-creation participation types and consumers'motivations is a significant factor in determining consumer attitudes. The results of this study imply that various types of consumer participation actually improve consumers' attitudes toward products and brands. In addition, our study also suggests that firms should consider the fit between co-creation types and consumers' motivations when they initiate co-creation activities. In this study, we survey consumers who participated in firms' co-creation activities. Future studies can compare different types of consumers. For instance, we can examine the different in different test by comparing experienced versus inexperienced consumers. Finally, we expand this research to user-generated content topics. This attending issue focuses on the mechanism that breaks down the boundaries and barriers between consumers and producers.

• Ecology and Resilient Infrastructure
• /
• v.2 no.4
• /
• pp.317-323
• /
• 2015

This study investigated the impact of the morphological change on a physical fish habitat in the downstream reach of a dam using long-term mobile bed simulation. The quasi-steady model was used for hydraulic simulation and the habitat suitability index model was applied for physical habitat simulation. For simulating long-term morphological change of the stream bed, The Exner equation was used. Sorting of bed material was also considered. The results of simulation showed that erosion and armoring process occurred in a reach downstream of the dam and change of physical habitat for Zacco platypus followed. These results indicate that channel morphology and substrate conditions effected the physical habitat for considering long-term investigation.

• KDI Journal of Economic Policy
• /
• v.42 no.2
• /
• pp.1-30
• /
• 2020

This paper analyzes how injunctions relate to patent hold-up problems. To this end, we present a simple model of licensing negotiations between a patent holder and a downstream firm in the shadow of litigation. More specifically, we consider the situation in which an injunction is granted as a matter of course if a patent is found valid and infringed upon in litigation, but the patent holder may be under-compensated due to aspects of the patent remedy system other than injunctions. We show that if the downstream user is unaware of the patent before any investment in initially designing its product, the patent hold-up problems created by injunction threats are worrisome when (i) the redesign process is costly, (ii) the degree of patent protection (by aspects of the patent remedy system other than injunctions) is sufficiently strong and (iii) the injunction is requested not to practice the patented technology exclusively but to collect excessive patent royalties. Even if the downstream user is aware of the patent before the initial investment, the patent hold-up problems do not disappear. The findings here imply that a discretionary approach is required towards denying injunctions against patent infringement. If the degree of patent protection is not sufficiently strong, denying injunctions can exacerbate the under-compensation problem. However, once patent protection improves enough (not necessarily perfectly), we may see a surge of patent hold-up problems, and it would be better to apply alternative patent remedies in place of injunctions when necessary. Lastly, we discuss several possible alternatives to injunctions and their pros and cons.