• Korea-Australia Rheology Journal
• /
• 제20권2호
• /
• pp.73-77
• /
• 2008

The rheological properties of polar solutions are very sensitive to preparative methods as well as measuring conditions. The effects of dissolution temperature on the rheological properties of the solutions of polyvinyl alcohol (PVA) in dimethyl sulfoxide were investigated over the range of dissolution temperatures $70-130^{\circ}C$. Viscosity was increased as dissolution temperature was increased. PVA solutions prepared at 120 and $130^{\circ}C$ showed Bingham behavior, which became less noticeable with decreasing dissolution temperature. The modified Cole-Cole plot of the solutions gave slope less than 2, suggesting the solutions were a heterogeneous system irrespective of optical transparency. Further, the slope was decreased with increasing dissolution temperature, indicating that the solid character got more prominent as dissolution temperature was increased. However, the relaxation time of the solutions was little dependent on dissolution temperature.

• 지질공학
• /
• 제25권1호
• /
• pp.1-8
• /
• 2015

Deep geological disposal is the preferred storage method for high-level radioactive waste, because it ensures stable long-term storage with minimal potential for human disruption. Because of the risk of groundwater contamination, a buffer of steel and bentonite layers has been proposed to prevent the leaching of radionuclides into groundwater. Quartz is one of the most common minerals in earth's crust. To understand how deformation and dissolution phenomena affect waste disposal, here we study quartz samples at pressure, temperature, and pH conditions typical of deep geological disposal sites. We perform a dissolution experiment for single quartz crystals under different pressure and temperature conditions. Solution samples are collected and the dissolution rate is calculated by analyzing Si concentrations in a solution excited by inductively coupled plasma-atomic emission spectroscopy (ICP-AES). After completing the dissolution experiment, deformation of the quartz sample surfaces is investigated with a confocal laser scanning microscope (CLSM). An empirical formula is introduced that describes the relationship between dissolution rate, pressure, and temperature. These results suggest that bentonite layers in engineering barrier systems may be vulnerable to thermal deformation, even when exposed to higher temperatures on relatively short timescales.

• International Journal of Industrial Entomology and Biomaterials
• /
• 제20권2호
• /
• pp.99-105
• /
• 2010

In this paper, the regenerated silk fibroins were dissolved in LiBr aqueous solution with different dissolution temperature and time, and the effects of the dissolution condition on the regeneration yield, molecular weight, wet spinnability, and electrospinnability of regenerated silk fibroin were investigated. The regeneration yield, molecular weight distribution, and wet spinnability of regenerated silk fibroin were nearly affected by the dissolution temperature and time. However, the electrospinning performance of silk fibroin was influenced by the dissolution condition implying the electrospinning of silk fibroin is more sensitive process than the wet spinning in the range tested in this study. While $25^{\circ}C$ of dissolution temperature resulted in a good electrospinnability of regenerated silk fibroin, the electrospinnability was slightly deteriorated when silk fibroin was dissolved at $60^{\circ}C$ for 6 hours. Also, though the fiber diameters of electrospun silk fibroin produced by the dissolution at $25^{\circ}C$ for 6 hours and 24 hours were 443 and 451 nm, respectively, that at $60^{\circ}C$ for 5 min was reduced to 411 nm. The fiber diameter was more decreased to 393 nm when the dissolution time increased up to 6 hours at $60^{\circ}C$.

• International Journal of Industrial Entomology and Biomaterials
• /
• 제34권1호
• /
• pp.6-10
• /
• 2017

Dissolution of Antheraea yamamai silkworm cocoon was carried out in various solvent systems with various dissolving conditions including dissolution salts, salt concentration, dissolving temperature, and time. General chaotropic salt for Bombyx mori silk fibroin does not work for A. yamamai silkworm cocoon. Lithium bromide 9.3 M at $100^{\circ}C$ also does not work to dissolve wild silkworm cocoon. However, 9 M of lithium thiocyanate treatment at $100^{\circ}C$ induced 100% dissolution of wild silkworm cocoon. But it could not be dissolved lower than $60^{\circ}C$. Like lithium thiocyanate, less than $60^{\circ}C$ treatment with molten calcium nitrate 4 hydrate could not dissolve wild silkworm cocoon. As the dissolution temperature increased up to $100^{\circ}C$, the solubility of wild one was reached over 90%. SDS-PAGE showed broad tailing stream pattern that means the molecule of wild silk was depolymerized with dissolution temperature and time. From the above results, the best chaotropic salt for A.yamamai silkworm cocoon is calcium nitrate 4 hydrate.

• Advances in environmental research
• /
• 제4권1호
• /
• pp.17-24
• /
• 2015

In this study, we numerically investigated the effect of pressure (100-250 bar), temperature (274-288 K), and salinity (3.5% w/w electrolytes) on $CO_2$ hydrate dissolution rates in the ocean. Mass transfer equations and $CO_2$ solubility data were used to estimate the $CO_2$ hydrate dissolution rates. The higher pressure and lower temperature significantly reduced the $CO_2$ hydrate dissolution rates due to the increase of $CO_2$ particle density. In the high salinity condition, the rates of $CO_2$ hydrate dissolution were decreased compared to pure water control. This is due to decrease of $CO_2$ solubility in surrounding water, thus reducing the mass transfer of $CO_2$ from the hydrate particle to $CO_2$ under-saturated water. The results obtained from this study could provide fundamental knowledge to slow down or prevent the $CO_2$ hydrate dissolution for long-term stable $CO_2$ storage in the ocean as a form of $CO_2$ hydrate.

• Journal of Pharmaceutical Investigation
• /
• 제40권5호
• /
• pp.277-283
• /
• 2010

CoQ with low melting temperature was exploited to improve its solubility by preparing its solid dispersions (SDs) with a meltable polymer, poloxamer 407 (P 407). P407 can be utilized for a relatively simple, quick, inexpensive, reproducible and potentially scalable manner in the low temperature melting method. CoQ 10 solubility and dissolution increased with increasing concentrations of P 407 in SDs. Comparison of the enhanced dissolution of CoQ 10 from different poloxamers suggested that the preparation of CoQ 10 SDs using P 407 as a meltable hydrophilic polymer carrier could be a promising approach to improve its dissolution.

• 자원환경지질
• /
• 제50권6호
• /
• pp.509-515
• /
• 2017

일반적으로 석영은 지각을 구성하는 광물 가운데 가장 많은 부분을 차지하고 있으며, 이러한 석영의 용해와 침전에 대한 이해는 암석의 풍화 매커니즘과 열수작용 및 변성환경에서의 암석과 물의 관계를 규명하는데 매우 중요한 역할을 한다. 본 논문에서는 석영의 용해와 침전에 영향을 미치는 다양한 물리화학적 환경을 수식을 이용해 재정리하였으며, 이전의 연구자들이 발표한 연구결과를 바탕으로 물리화학적 조건하에서의 석영 용해에 대해 이론적 접근을 실시하였다. 본 논문을 통해서 석영의 용해 및 침전이 다양한 환경에 영향을 받으며, 특히 이론적 접근을 통해서 석영에 작용된 압력보다는 주변의 pH 및 온도 조건에 더 큰 영향을 받는다는 것을 확인하였다.

• 한국표면공학회지
• /
• 제36권5호
• /
• pp.364-372
• /
• 2003

In continuous galvanizing process, dissolution of iron into molten zinc results in a fairly great amount of dross. In order to decrease dross, the amount of dissolved iron of strip in molten zinc was investigated in the range of 0∼0.22%Al content, 440∼$470^{\circ}C$ strip temperature and 3∼60 sec dipping time. Uniform Fe-Al-Zn inhibition layer was formed in the coating layer/strip interface not only in the grain boundary but also in the grain of substrate with the increase of Al content in the zinc pot, while the amount of iron dissolution was decreased. Inhibition layer was unstable as the dipping time and strip temperature increased and the amount of iron dissolution increased.

• 환경위생공학
• /
• 제14권3호
• /
• pp.116-122
• /
• 1999

The purpose of this study is to develop new process named "hydrogen peroxide dissolution method". This process used hydrogen peroxide, which is harmless to human body and oxidize molybdenum wire selectively.The advantages of hydrogen peroxide dissolution method were no discharge of noxious matter when dissolution of molybdenum wire which used as the center supporter, reactions occur in room temperature and easy to recover dissolved molybdenum. This study was aimed at gathering the basic data of molybdenum wire dissolution-recovery process and proposes the reaction condition of molybdenum wire dissolution-recovery process and the factors influencing those reactions. The results were as follows:1. In the dissolution of molybdenum wire, the early condition of reaction was $15^{\circ}C$, and the temperature condition of state was $32^{\circ}C$. 2. 1) In the GSL-60W type, P.W.(Piece weight) was 11.89mg, C.R. was $65.6\Omega$. 2) In the FL-20W type, P.W. was 11.60mg, C.R. was $4.6\Omega$. 3. The molybdenum of process water was treated of a precipitation after dry and after stagnation in the one day, the molybdenum of upper water was treated of precipitation after dry and after congelation.

• 자원리싸이클링
• /
• 제12권4호
• /
• pp.30-37
• /
• 2003

황산 용액에서 Zinc-ferrite의 용해에 대한 반응속도론을 황산 용액의 반응온도와 농도 변화에 대해 조사하였다. 반응율(R)과 겉보기 반응 속도상수(K)는 황산 용액의 온도와 농도가 클수록 증가한다. Zinc-ferrite의 반응속도는 반응초기에서 $1-(1-K)^{1/3}=Kt$와 같은 속도식을 적용할 수 있다. 용해에 대한 활성화 에너지는 황산 용액의 농도에 관계없이 약 16.3kcal/mole 이다. Zinc-ferrite가 황산 용액에서 용해할 때는 Zinc-ferrite의 화학 양론적 조성으로 용해되며, Fe 또는 Zn의 단독으로는 용해되지 않는다.