• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.44 no.6
• /
• pp.57-65
• /
• 2007

This paper presents the design of single phase PFC(Power Factor Correction) using a DSP(TMS320F2812). In order to realize the proposed boost PFC converter in average current mode control, the DSP requires the A/D sampling values for a line input voltage, a inductor current, and the output voltage of the converter. Because of a FET switching noise, these sampling values contain a high frequency noise and switching ripple. The solution of A/D sampling keeps away from the switching point. Because the PWM duty is changed from 5% to 95%, we can#t decide a fixed sampling time. In this paper, the three A/D converters of the DSP are started using the prediction algorithm for the FET ON/OFF time at every sampling cycle(40 KHz). Implemented A/D sampling algorithm with only one timer of the DSP is very simple and gives the autostart of these A/D converters. From the experimental result, it was shown that the power factor was about 0.99 at wide input voltage, and the output ripple voltage was smaller than 5 Vpp at 80 Vdc output. Finally the parameters and gains of PI controllers are controlled by serial communication with Windows Xp based PC. Also it was shown that the implemented PFC converter can achieve the feasibility and the usefulness.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.40 no.11
• /
• pp.51-62
• /
• 2003

This paper presents a novel survivor memeory management and decoding techniques with sequential backward state transition control in the trace back Viterbi decoder. The Viterbi algorithm is an maximum likelihood decoding scheme to estimate the likelihood of encoder state for channel error detection and correction. This scheme is applied to a broad range of digital communication such as intersymbol interference removing and channel equalization. In order to achieve the area-efficiency VLSI chip design with high throughput in the Viterbi decoder in which recursive operation is implied, more research is required to obtain a simple systematic parallel ACS architecture and surviver memory management. As a method of solution to the problem, this paper addresses a progressive decoding algorithm with sequential backward state transition control in the trace back Viterbi decoder. Compared to the conventional trace back decoding techniques, the required total memory can be greatly reduced in the proposed method. Furthermore, the proposed method can be implemented with a simple pipelined structure with systolic array type architecture. The implementation of the peripheral logic circuit for the control of memory access is not required, and memory access bandwidth can be reduced Therefore, the proposed method has characteristics of high area-efficiency and low power consumption with high throughput. Finally, the examples of decoding results for the received data with channel noise and application result are provided to evaluate the efficiency of the proposed method.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.37 no.1
• /
• pp.13-23
• /
• 2010

This study was performed to compare the quality of image processing between the newly developed prototype using light emitting diode(LED) and the conventional $DIFOTI^{TM}$ system(EOS Inc., USA). To estimate the optimal light emitting power for the improved images, primary enamel surfaces treated under Carbopol 907 de-mineralizing solution were taken daily during 20 days of experimental periods by both DIFOTI systems. The results of comparative analyses on the images obtained from both systems with polarized image as gold standard can be summarized as follows: 1. Trans-illumination indices of images taken from primary enamel surfaces were decreased with time in both systems. 2. The differences of intensity of luminance between sound and de-mineralized enamel surface in prototype DIFOTI system was shown to be relatively smaller than conventional $DIFOTI^{TM}$ system. 3. From the comparative analysis of images from both DIFOTI system with polarized images as gold standard, the difference between sound and de-mineralized enamel surface of intensity of luminance of $DIFOTI^{TM}$ system was more correlated to polarized images than prototype of DIFOTI system. With the optimal LED emitting power, the control of aperture of digital camera is considered as the another key factor to improve the DIFOTI images. For the best image quality and analysis, the development of the improved image processing software is required.

• Journal of the Institute of Convergence Signal Processing
• /
• v.16 no.2
• /
• pp.56-62
• /
• 2015

In this study, we implemented an unconstraint ECG monitoring system on a chair. Nowadays, modern people spend most of their time sitting on the chair. Therefore, it is necessary to have an unconstraint ECG monitoring system that can be used for a long time. The implemented system can perform measurement even with clothes on and it has great advantage on motion artifacts. A pair of unconstraint electrodes are placed on the back of the chair. Amplifier and filters are designed to remove motion artifacts, The baseline noise and power line noise are filtered and very low level of bio-signal is amplified to give a final measurement. Control unit and wireless transmission unit are implemented. Analog signal is converted into digital signal and transmits biological signal to the PC and the smart phone. Therefore continuous ECG monitoring in daily life is made possible. A comparison experiment between Ag / AgCl electrode and unconstraint electrode is conducted to evaluate the performance of the implemented system. As a result, we confirm our unconstraint system can be used for daily life ECG monitoring.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.7
• /
• pp.56-63
• /
• 2016

This paper presents a novel method for detecting a ghost key at the membrane type keyboard, which has additional resistive coating to the membrane film. Also, the optimal ratio of resistances for detecting a ghost key was designed based on the characteristics of the membrane film. The optimal ratio of resistances was considered to be able to detect the worst case (i.e., difference voltage between normal key and ghost key is minimum). The ability of the proposed methods are evaluated by simulation studies in this paper. In order to verify the proposed method, the experiment was carried out with a designed circuit and A/D (analog to digital) in MCU (micro controller unit). The proposed method is implemented into the membrane type keyboard and is verified by experimental results.

• Physical Therapy Rehabilitation Science
• /
• v.6 no.3
• /
• pp.120-126
• /
• 2017

Objective: The purpose of this study was to investigate the effects of backward treadmill gait training between underwater and ground environments on strength, proprioception, and walking ability in persons with stroke. Design: Randomized control trial. Methods: Twenty eight subjects participated in the study in which they were randomly assigned to either the underwater backward treadmill training (UBTT) group (n=13) or the BTT group (n=15). In both groups, forward gait training was performed for 20 minutes on the ground treadmill. The UBTT group performed backward gait on an underwater treadmill for 20 minutes while the BTT group performed backward gait on a ground treadmill for 20 minutes. The gait training in each group was performed twice a week for a total of six weeks. Muscle strength, proprioception, and gait ability was assessed using a digital power meter, joint angle recurrence method using the smartphone protractor application, the Figure-of-Eight walk test (F8W) and the functional gait assessment (FGA) respectively. Results: Both groups showed significant improvement in strength, F8W and FGA scores after training (p<0.05). However, there was no statistically significant difference between the two groups. Both groups showed significant improvement in proprioception after training (p<0.05). In the comparison between the two groups, there was a greater significant change in the UBTT group for joint proprioception (p<0.05). Conclusions: In this study, it was found that both backward treadmill gait training programs were effective on strength, proprioception, and gait ability, and that underwater training was particularly effective on proprioception compared to ground training.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.28 no.7
• /
• pp.571-575
• /
• 2017

This paper presents a C-band bi-directional T/R chipset in $0.13{\mu}m$ TSMC CMOS technology for phased array antenna. The T/R chipset, which is a key component of phased array antenna, consists of a 6 bit phase shifter, a 6 bit step attenuator, and three bi-directional gain amplifiers. The phase shifter is controlled up to $354^{\circ}$ with $5.625^{\circ}$ phase step for precise beam steering. The step attenuator is also controlled up to 31.5 dB with 0.5 dB attenuation step for the side lobe level rejection. The LDO(Low Drop Output) regulator for stable 1.2 V DC power and the SPI(Serial Peripheral Interface) for digital control are integrated in the chipset. The chip size is $2.5{\times}1.5mm^2$ including pads.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.11C
• /
• pp.1083-1090
• /
• 2005

This paper presents the design of a video encoder for the device of need TV-OUT function. The designed video encoder satisfies the standard conditions of International Telecommunication Union-Radiocommunication (ITU-R) BT.470. ITU-R BT.470 can be classified as NTSC, PAL or SECAM. NTSC and PAL use Amplitude Modulation (AM) to transmit color difference signals and SECAM uses Frequency Modulation (FM). SECAM must have an antic-cloche filter but the filter recommended by ITU-R BT.470 is not easy to design due to sharpness of the frequency response. So formerly the filter was designed as analog. This paper proposes that the filter is designed as digital and the special quality of the filter is transformed easy to design. And the modulation method is modified to be identical with the result required at standard. The encoder can control power consumption by output mode to apply mobile phone, mobile devices, etc. The proposed encoder is experimentally demonstrated with ALTERA FPGA APEX20KE EP20K1000EBC652-3 device and SAMSUNG LCD-TV.

• Journal of the Korea Society of Computer and Information
• /
• v.12 no.6
• /
• pp.31-39
• /
• 2007

To perform on-line cyber education, it is indispensable to delivery contents file to participant users. When users' requests occur simultaneously in a shot period, server falls into overload phase. A common to avoid overload is a software solution based on P2P, which does no cost any additional expense. But, in this solution, it yields many problems such as service delay and system failure because of peer self-control. In this paper we propose an efficient load balancing policy based on P2P system. which is the contents delivery system for cyber education system using idle computing power in the proposed solution, we present server selection scheme called P2P-Pattern method, which results in minimum service delay. we can see that our scheme outperforms previous scheme.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.2
• /
• pp.24-30
• /
• 2009

In this paper, the FPGA modem platform complying with 3GPP Release 7 eHSPA specifications and its regularized verification flow are proposed. The FFGA platform consists of modem board supporting physical layer requirements, MCU and DSP core embedded control board to drive the modem board, and peripheral boards for RF interfacing and various equipment interfaces. On the other hand, the proposed verification flow has been regularized into three categories according to the correlation degrees of hardware-software inter-operation, such as simple function test, scenario test call processing and system-level performance test. When it comes to real implementations, the emulation verification strategy for low power mobile SoC is also introduced.