• Journal of the Korean Ceramic Society
• /
• v.35 no.2
• /
• pp.196-200
• /
• 1998

Effect of diffusion induced recrystallization(DIR) on mechanical properties of hot-pressed TiC was in-vestigated. The TiC specimen was electroplated with Cr and then heat-treated at 1550. Through the DIR process a new set of (Ti, Cr) C mixed carbide grains with uniform and small size was formed at the surface. As a consequence the scattering in fracture strength decreased and the toughness increased.

• Bulletin of the Korean Chemical Society
• /
• v.17 no.4
• /
• pp.365-373
• /
• 1996

Time profile of the transient grating signal induced by a nanosecond pulsed laser excitation of methyl red is investigated in alcohols and toluene at several solvent temperatures. The signal decays biexponentially with well-separated time constants; the faster decay is identified as due to thermal diffusion of the solvents and the slower one as mainly due to translational diffusion of the solute. The measured translational diffusion constants of methyl red in toluene are close to a hydrodynamic prediction with a slip boundary condition while those in alcohols are larger by 30% and increase slightly with the size of alcohols. We compare the results with modified hydrodynamic models.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.14 no.2
• /
• pp.152-157
• /
• 2001

For the fabrication of YBa$_2$Cu$_3$O$_{x}$ thick film using diffusion process between $Y_3$BaCuO$_{5}$ and BaO+CuO, each material was selected as substrate and doping material. In this paper, we investigated the characteristic of YBa$_2$Cu$_3$O$_{x}$ thick film due to both addition of CeO$_2$into substrate and initial particle size of doping material. Through X-ray diffraction patterns and SEM photographs, the variation of composition and thickness of the formed phase was observed. It was from the experiment obtained that the addition of CeO$_2$into $Y_2$BaCuO$_{5}$ substrate and the initial particle size of doping material play important part in promoting the reaction between substrate and doping material.aterial.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.7
• /
• pp.557-564
• /
• 1998

A low loss x-cut $LiNbO_3$optical waveguide was fabricated by Yi in-diffusion, and the properties of guided-mode and the total insertion loss of the pigtailed waveguide with polarization maintaining fiber(PMF) were measured at optical wavelength 1550nm. for forming the waveguides, the parameters of diffusion, Ti thickness, waveguide line-width, length, diffusion temperature, time and atmosphere were set $1400{\AA}$, $8{\mu}m$, 3.3cm, $1050^{\circ}C$, 8 hours and wet bubbled oxygen, respectively. And then after the polishing and piatailing, it showed that the total insertion loss was -4.1dB for TM mode, -5.5dB for TE mode, and mode size, that is, the horizontal/ vertical size were $13.8{\mu}m/18{\mu}m$ for TM mode, $9.6{\mu}m/6.5{\mu}m$ for TE mode.

• Journal of the Korean Society of Combustion
• /
• v.17 no.1
• /
• pp.58-65
• /
• 2012

The influence of magnetic field on propane and acetylene diffusion flames have been experimentally investigated using an electromagnetic system. Periodically induced magnetic field having various frequencies and duty ratios was established in square wave form. The maximum intensity and gradient of magnetic field were 1.3 T and 0.27 T/mm, respectively. The width of a propane flame was reduced up to 4.5% and the brightness was enhanced up to 25% when the magnetic field was induced. The soot emission from an acetylene flame was ceased when magnetic field was induced. The alteration of flow field, which is due to the paramagnetic characteristics of oxygen molecule, is most likely to be responsible for the change in flame size and brightness. The effect of magnetic field on diffusion flames, which competes with the gravitational effect, was more apparent from a smaller size flame. The magnetic field effect, therefore, could be important under microgravity conditions. Since the time required to alter the flow field must be finite, the magnetic field effect is likely to be less significant for a periodically oscillating magnetic field at a high frequency or having a small duty ratio.

• Tunnel and Underground Space
• /
• v.8 no.3
• /
• pp.194-199
• /
• 1998

This research was aimed to figure out the trend of dust diffusion at open pit limestone mine for assessing the environmental impacts on the high voltage power transmission line. It is rather easy to assess the dust generation and size distribution of limestone dust at the blasting site, but it is very hard to assess the expected area of dust diffusion and amount of dust fall by the distances from the dust source. In this research, a 3-dimensional fluid dynamic simulation software (3D-Flow) was used for analysing the above mentioned matters to assess the impacts to the insulators on the transmission tower by the blasting dust. It was verfied that the 3D-Flow is reliable tool for simulating dust movement, and the limestone dust is not much hazardous to the power transmission line.

• Particle and aerosol research
• /
• v.8 no.1
• /
• pp.29-35
• /
• 2012

The Faraday cup electrode of different size has been developed and evaluated to investigate the diffusion effect of particles by Brownian motion in a particle beam mass spectrometer(PBMS). Particles which focused and accelerated by aerodynamic lens are charged to saturation in an electron beam, and then deflected electrostatically into a Faraday cup detector for measurement of the particle current. The concentration of particles is converted from currents detected by Faraday cup. Measurements of particle current as a function of deflection voltage are combined with measured relationships between particle velocity and diameter, charge and diameter, and mass and diameter, to determine the particle size distribution. The particle currents were measured using 5, 10, 20, 40 mm sized Faraday cup that can be move to one direction by motion shaft. The current difference for each sizes as a function of position was compared to figure out diffusion effect during transport. Polystyrene latex(PSL) 100, 200 nm sized standard particles were used for evaluation. The measurement using 5 mm sized Faraday cup has the highest resolution in a diffusion distance and the smaller particles had widely diffused.

• Magazine of the Korea Concrete Institute
• /
• v.8 no.5
• /
• pp.145-154
• /
• 1996

Polymer-modified mortars have an excellent water proofness and water retentivity. Therefore, the study on the moisture diffusion behavior- is very important. The purpose of' this study is to investigate the effects of relative humidity and moisture content in mortars on the moisture diffusion, and the relationship between the shrinkage and moisture diffusion coefficient of polymer-modified mortars cured at $20{\circ}C$ 50% R.H and 80% R.H. The pore size distribution of the polymer-modified mortars was also measured. From the test results, the relative humidity and moisture content in mortars influenced on the moisture diffusion of polymer-modified mortars. The shrinkage and moisture diffusion coefficient of polymer-modified mortars cured at $20{\circ}C$ 50% R.H. was bigger than that cured at $20{\circ}C$ 80% R.H.. and decreased with increasing polymer-cement ratio regardless of polymer type.

• Journal of Korean Society for Quality Management
• /
• v.51 no.4
• /
• pp.691-700
• /
• 2023

Purpose: This study aims to analyze the diffusion pattern of the Mongolian mobile phone market. In particular, we used a generalized diffusion model to explore the factors affecting market potenial. Methods: We used three diffusion models to estimate the number of mobile subscribers in Mongolia. Based on the Logistic model with the best fitness, we introduced time-varying market potential and explored the influence of various independent variables such as GDP and inflation. Results: Among the basic diffusion models, the Logistic model was the best in terms of estimation performance and statistical significance. The estimation results of the Generalized Logistic model confirm that investment in the telecommunication sector has a significant positive effect on market potential. The estimation of the Generalized Logistic model effectively describes the continuous growth of the Mongolian telecommunications market until recently. Conclusion: We have analyzed the diffusion pattern of the Mongolian telecommunications market and found that the amount of investment in the sector leads to the growth of the market size. This study is original in terms of its subject - Mongolian telecommunications market and methodology - time-varying market potential.

• Proceedings of the KSME Conference
• /
• 2007.05b
• /
• pp.2366-2371
• /
• 2007

Spray combustion characteristics of a conducting fuel electrospray have been studied for clean combustion technology. The multiplexing system which can retain the characteristics of the cone-jet mode is inevitable for the electrospray application. Charged micro droplets can be obtained in almost uniform size during operating the electrospray in the cone-jet mode. This experiment device set up the multiplexed grooved nozzle system with the extractor. Using the grooved nozzle, the stable cone-jet mode can be achieved at the each groove in the grooved mode. This electrospray system was applied to the diffusion combustion. It is the first step to discover the diffusion combustion characteristics of the electrospray. In case of the single grooved nozzle electrospray, the diffusion flames are occurred at each jet of grooved mode and they are quite stable. The exhaust gas analysis was indicated that there is the critical point which can make very stable diffusion combustion.