• Journal of the Korean GEO-environmental Society
• /
• v.1 no.1
• /
• pp.27-33
• /
• 2000

Stone columns is ground improvement method which is composed of compacted gravel or crushed stone inserted into the soft ground consisting of loose sand and clay by replacement method. Generally stone columns are constructed in silty clay, above 70% replacement rate for increasing the bearing capacity and shear strength. Low replacement stone columns method is limited below 30% at replacement rate-premising strength increase of clay ground is estimated efficiently. This study, laboratory model tests were conducted to investigate the consolidation drainage promotion and shear strength increase effect in soft ground with replacement rate by stone columns. The settlement reduction effect and settlement reduction coefficients increase with increasing the replacement rate in composite ground. The results of model tests indicate that consolidation promotion effect is proved. The increasing strength of composite ground was verified by vane shear tests.

• Geomechanics and Engineering
• /
• v.10 no.3
• /
• pp.335-355
• /
• 2016

Most laboratory test research has focused on grouting efficiency in homogeneous reconstituted soft clay. However, the natural sedimentary soils generally behave differently from reconstituted soils due to the effect of soil structure. A series of laboratory grouting tests were conducted to research the effect of soil structure on the performance of compensation grouting. The effects of grouting volume, overlying load and grouting location on the performance of compensation grouting under different soil structures were also studied. Reconstituted soil was altered with added cement to simulate artificial structured soil. The results showed that the final grouting efficiency was positive and significantly increased with the increase of stress ratio within a certain range when grouting in normally consolidated structured clay. However, in the same low yield stress situation, the artificial structured soil had a lower final grouting efficiency than the overconsolidated reconstituted soil. The larger of normalized grouting volume could increase the final grouting efficiency for both reconstituted and artificial structured soils. Whereas, the effect of the overlying load on final grouting efficiencies was unfavourable, and was independent of the stress ratio. As for the layered soil specimens, grouting in the artificial structured soil layer was the most efficient. In addition, the peak grouting pressure was affected by the stress ratio and the overlying load, and it could be predicted with an empirical equation when the overlying load was less than the yield stress. The end time of primary consolidation and the proportion of secondary consolidation settlement varied with the different soil structures, grouting volumes, overlying loads and grouting locations.

• Journal of the Korean Geotechnical Society
• /
• v.23 no.12
• /
• pp.95-107
• /
• 2007

This study describes compressive characteristics of marine clay at southwestern coast in Korea by large block and piston samples. Through the analysis of disturbance effect and various consolidation test, consolidation result shows that volumetric strain from large block samples is lower than piston samples and compression index of large block samples is larger than piston samples value. We suggest new empirical equation of compression index by the effect of compression index following sampling method. If consolidation settlement is presumed using empirical equation of compression index, the resort will be more reasonable in predicting settlement than that obtained by the decision of compressibility characteristics from piston samples.

• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• v.27 no.6
• /
• pp.498-510
• /
• 2001

Distraction osteogenesis refers to the biological process responsible for new bone formation between bone segments by gradual distraction after osteotomy. For the past several years, various inconveniences including a protracted consolidation period that requires patients to wear a distractor frame longer, as well as higher medical costs, have not been remedied by improvements in osteotomy, distraction rate and monitoring system. Furthermore, side effects such as pin tract infections and soft tissue swelling may arise due to the long treatment period. These drawbacks form the rationale of this study which purports to seek a method by which the consolidation period can be reduced. This paper examines how platelet-rich plasma(PRP), known to facilitate osteogenesis, influences bone formation when applied in distracted area. Ten mongrel dogs, which were made to wear external distractor frames after osteotomy in both sides of the mandible, were used as subjects. After a 7day period of latency, distraction was carried out at a rate of 1mm/day for 14 consecutive days. After the onset of distraction, 2ml of PRP and a mixture of calcium gluconate and thrombine were injected into the center of the distracted callus on the left side of the mandible. The left was injected with PRP while the right side was set as the control site without PRP treatment. Execution at the onset of distraction and in 2 weeks, 4 weeks and 8 weeks after the consolidation period, clinical and radiographic tests, bone mineral density examination, histological examination and histomorphometric analysis were conducted to compare both sides. The results are summarized as follows: 1. Based on the clinical examination at two weeks, more remarkable cortical bone formation was found on the buccal and lingual side of the distracted area in the PRP treatment site than in the control site. No visual difference was found between the PRP treatment site and the control site at four eight weeks. 2. Based on the radiological examination, a distinct increase in the radiopaque appearance of the PRP treatment site was revealed at two weeks, but this increase appeared to slow down at four and eight weeks. 3. Examination of bone mineral density revealed a significant difference at two weeks with the PRP treatment site yielding density two times higher than the control site. This difference lessened after four weeks, and disappeared at eight weeks. 4. The histomorphometric examination revealed that about 20% more bony trabeculae area(20%, higher) was formed in the PRP treatment site than in the control site. In conclusion, it can be said that PRPs effect on stimulating bone formation in the PRP treatment site manifest as early as two weeks. Trabeculae formation likewise increased throughout the whole period. If this result can be applied to humans, the consolidation period can be reduced by injecting PRP into the distracted area.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.6C
• /
• pp.339-347
• /
• 2008

The penetration of the probe produces the excess pore pressure due to the disturbance. The objective of this study is to evaluate the disturbance zone by using the dissipation of the excess pore water pressure, which was generated due to the penetration of the penetrometer with different size. The CPT, DMT and FVP (Field Velocity Probe) are adopted for in-situ tests. The tests are carried out in the construction site of north container pier of Busan new port, Korea where is accelerating the consolidation settlement using plastic board drains (PBD) and surcharges by crushed gravels. The coefficient of consolidation $(C_h)$ and soil properties are deduced by the laboratory test. The in-site tests are performed after the predrilling the surcharge zone at the point of 90% degree of consolidation. To minimize the penetration effect, the horizontal distance between penetration tests is 3m, the change of the pore pressure is monitored at the fixed depth of 24m. The coefficient of consolidation $(C_h)$ and the $t_{50}s$ are calculated based on the laboratory test and the in-situ data, respectively. The equvalent radi based on the $t_{50}$ shows that the FVP and the DMT produce the smallest and the greatest equivalent radi, respectively.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.02a
• /
• pp.71-78
• /
• 2000

SHANSEP method involves the consolidation to stresses in excess of the preconsolidation pressure in order to overcome sample disturbance effect. The concept of SHANSEP is based on an approach to laboratory test which attempts to reproduce the in-situ conditions more closely than is possible in routine tests and evaluates normalized strength parameters for the soil as a function of OCR. But SHANSEP method can be applied only to fairly uniform clay deposits, and is unsuitable for a random deposit. In this study, CK/sub o/U triaxial compression test and incremental loading consolidation test were performed for the application of SHANSEP method on Yangsan clay. During the K/sub o/-consolidation, triaxial specimens were consolidated to stress equal to two times the in-situ vertical effective stress. And for overconsolidated condition, the specimens were swelled to a known vertical effective stress in order to have the desired OCR. With the results of CK/sub o/U triaxial compression test using the block samples, the relationship between c/sub u//σ/sub vc/' and OCR on Yangsan clay was established. For evaluating the undrained shear strength of Yangsan clay with depth, CK/sub o/U triaxial compression test was performed using the piston samples taken from Yangsan site. And also undrained shear strength was analyzed from the in-situ test such as Cone Penetration Test(CPT), Dilatometer Test(DMT), and Field Vane Test(FVT) and was compared with that of CK/sub o/U triaxial compression test.

• Journal of the Korea Society of Computer and Information
• /
• v.6 no.1
• /
• pp.119-129
• /
• 2001

The purpose of this study is to make an experiment survey of what local public official in the city of Yeosu, where recently achieved city-county consolidation about the improvement of treatment, as the organization was being rearranging effectively by reducing its size and personnels to follow the trend of the times toward globalization and open-door policy. The evaluation criteria used in this study is the opinion of consolidation, the degree to which merit rating was done impartially, the assignment of working place, pay, allowance, social position guarantee, promotion, the will to work. role conflict, the level of cohesion, and the extent of involvement in decision-making According to the survey, there appeared some positive effect even in such a short period that administrative expense decreased owing to the downsizing. Concerning the treatment, however, many officials considered it get worse in general, Especially. the treatment of promotion, social position guarantee, pay and allowance was found to be below the average.

• The Journal of Engineering Geology
• /
• v.29 no.4
• /
• pp.427-437
• /
• 2019

The purpose of this study is to improve construction cost, time, and field management when constructing a road on soft soil foundation by eliminating extra-banking of subgrade layer after completion of the consolidation process. The subgrade layer was pre-constructed before the soft ground improvement. And then it was confirmed by the field test that the compaction effect was maintained or not after consolidation settlement. As a result of the experiment, all subgrade layers were kept constant except for the top subgrade layer. So it would be advantageous to secure economical and practical in road construction if subgrade layers were constructed exclusive of the top subgrade layer.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2004.03b
• /
• pp.173-180
• /
• 2004

In this study, a consolidometer for radially inward drainage under constant rate of strain (CRS) loading was developed. Theoretical solutions for determining the effective vertical stress and the coefficient of consolidation from the test result were also proposed. Reconstituted kaolinite samples which were consolidated up to 130 kPa were used to verify the developed consolidometer and the theory. Comparative experiments with CRS loading and incremental loading (IL) were carried out in radially in ward drainage as well as vertical and radially outward drainage. The results obtained from the developed CRS loading test agreed consistently with those of the conventional incremental loading test according to drainage directions. And the effect of drainage direction and drain diameter to consolidation characteristics was also evaluated. From the test results the applicability and the reliability of the suggested method were verified.

• Journal of Powder Materials
• /
• v.14 no.1 s.60
• /
• pp.26-31
• /
• 2007

Manufacturing bulk nanostructured materials with least grain growth from initial powders is challenging because of the bottle neck of bottom-up methods using the conventional powder metallurgy of compaction and sintering. In this study, bottom-up type powder metallurgy processing and top-down type SPD (Severe Plastic Deformation) approaches were combined in order to achieve both real density and grain refinement of metallic powders. ECAP (Equal Channel Angular Pressing), one of the most promising processes in SPD, was used for the powder consolidation method. For understanding the ECAP process, investigating the powder density as well as internal stress, strain distribution is crucial. We investigated the consolidation and plastic deformation of the metallic powders during ECAP using the finite element simulations. Almost independent behavior of powder densification in the entry channel and shear deformation in the main deformation zone was found by the finite element method. Effects of processing parameters on densification and density distributions were investigated.