• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.19 no.6
• /
• pp.596-605
• /
• 2007

The behavior of a non-buoyant turbulent round jet discharging horizontally was investigated experimentally. The instantaneous velocity field of the jet was obtained using the particle image velocimetry (PIV) method and used to calculate the mean velocity field by phase-averaging. This study tested regular waves with a relatively small wave height for a wavy environmental flow. The centerline and cross-sectional velocity profiles were reported to demonstrate the effect of the waves on the jet diffusion in respect of wave height and wave phase. The wave phase effect was studied for three phases: zero-upcrossing point, zero-downcrossing point, trough. From the results, it is found that the centerline velocity decreases and width of the cross-sectional profile increases as the wave height increases. In addition, the self-similarity of the cross-sectional profile appears to break down although the width of each case along the axial distance does not vary significantly. The phase effect is found to be relatively small compared to the wave height effect.

• Fire Science and Engineering
• /
• v.23 no.6
• /
• pp.111-115
• /
• 2009

Acetone LIF and Rayleigh scattering measurements were performed to identify the entrainment of ambient air in the buoyant jet qualitatively. The air entrainment near nozzle exit was enhanced with increasing both an axial distance and Reynolds number. The results supported that the air entrainment had to be considered in isothermal model for the development of its accuracy. Also, this paper provided an isothermal model based on the ideal plume, of which radiative heat loss fraction was assumed to 0.35 and the entainment of isothermal jet was considered. This simple model could be used in compartment or semi-enclosure fires such as tunnel, and it is more reliable because of introducing entrainment effect in isothermal jet.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.6 no.1
• /
• pp.34-39
• /
• 1994

The dilution and the shore attachment of buoyant effluent into a crossflow are investigated experimentally. The effluent is produced by discharging warm water through a side channel into an open channel crossflow with the same depth to the side channel flow. Buoyancy causes the effluent to lift off the bottom, spreads across the crossflow and stays as the surface layer. The geometry of the recirculating region and the dilution of the effluent depend mainly on the buoyancy. The condition of the shore attachment can be specified by the ratios of velocities and Froude numbers.

• Journal of Korean Society of Water and Wastewater
• /
• v.22 no.3
• /
• pp.389-396
• /
• 2008

The hybrid model can be used to predict the initial near field mixing and the far field transport of the buoyant jets, which are discharged from the submerged wastewater ocean outfall. In the near field, the jet integral model can be used for single port diffusers while the ${\sigma}$ transformed particle tracking model was used in the far field. In this study, the experimental study was performed to verify the developed hybrid model in the previous research. The developed hybrid model properly predict the surface and vertical concentration distribution of the single buoyant jets with various effluent and ambient conditions. The hybrid model can also simulate the surface concentration distribution of the rosette diffuser except for the parallel diffuser with the higher densimetric Froude number due to the assumption that dynamic effects of the effluent plumes are negligible in the far field. The application of the hybrid model to rosette diffusers can predict the concentration near the diffuser more accurately when the line-plume approximation is used.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2005.09b
• /
• pp.943-944
• /
• 2005

• Journal of Korea Water Resources Association
• /
• v.33 no.2
• /
• pp.207-217
• /
• 2000

A numerical model is applied to analyze the mixing characteristics of an axisymmetric turbulent buoyant jet discharged into flowing stratified ambients. The numerical model is a Gaussian-vortex model which incorporates the effects of the vortex pair known as the representative characteristics of far-field in flowing ambients. Six ocean outfalls that have field data for the initial dilution at the water surface are selected for testing the applicability of the developed numerical model. The comparisons of the observed initial dilutions and the simulated ones show that the developed numerical model could be used for the analyses of the initial mixings induced by the sewage diffuser discharged into the ocean.

• Water for future
• /
• v.29 no.2
• /
• pp.221-233
• /
• 1996

To investigate the hydrodynamic characteristics of a two-dimensional buoyant surface jet, the most important factors of the numerical analysis are the evaluation of the free surface and the turbulence transportation under the stratification. In present study, a numeriacal simulation model used with the semi-implicit method for pressure-linked equations (SIMPLE), the non-hydrostatic approximation and the algebraic stress model (ASM) is applied to investigate the vertical structure of internal flow hydrodynamically. The ASM enables to take account of anisotropy of turbulence, the damping effects of the density interface, and the free surface on the turbulence structure accurately. The ASM tested produces better agreement than the $\kappa-\varepsilon$ model with measurements by Nakatsuji (1984) on the flow development and turbulence structure. Applicability of the ASM to a two-dimensional buoyant surface jet is examined through comparison with experimental data.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.17 no.3
• /
• pp.166-177
• /
• 2005

This study developed the jet integral model to analyze the behavior of the wastewater discharge in the near field using the fourth order Runge-Kutta method in order to numerically solve the problems of six ordinary differential equations and six unknowns. This jet integral model used the entrainment hypothesis and the manipulation of sonle shape constant. This study also conducted the hydraulic experiments fnr single horizontal buoyant Jet using LIF through the calibration procedure. The results calculated by the previous models, CORMIX 1 and VISJET, and the proposed jet integral model were compared to the hydraulic experimental results. The centerline trajectories predicted by the proposed model were in good agreements with the experimental results in the transition region whereas the trajectories calculated by the VISJET model agreed well with the measured data in the momentum and buoyancy-dominated regions. The centerline dilution calculated by the proposed model agreed generally with the measured dilution in the intial and transition regions while the centerline dilution predicted by the CORMIX 1 was in good agreements with the experimental results in the momentum and buoyancy-dominated regions.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.23 no.3
• /
• pp.342-351
• /
• 1999

A jet injected normally into a cross flow has been found to have the cross section of a horseshoe shape. It occurs by a twin vortex motion in the region downstream of the jet injection. Such a flow is inherently and highly three-dimensional and numerical calculations should play an important role. The three-dimensional momentum equations with buoyancy effect and energy equation are solved to obtain the velocity distributions, center-line trajectories, cross sectional shape and entrainment. The density difference is sufficiently small, so that the Boussinesq approximation is considered to be valid. The SIMPLE algorithm is applied in a staggered grid system of a calculational domain for the numerical method.

• Proceedings of the Korea Institute of Fire Science and Engineering Conference
• /
• 2008.04a
• /
• pp.15-18
• /
• 2008

A study on the fire and smoke behavior on experiments and analysis through STAR-CD in using about behavior analysis of the smoke. Kerosene of 3L in using on the experimental garden of 30cm in diameter same applies to heat release rate(HRR), buoyant force by Plume can be calculated at a rate of 1m/s. The result of experiment in average of velocity were 0.29m/s, and interpreted result were 0.28m/s. Besides, it is proved by interpreted that behavior of smoke movement can be not observed in the experiment. After smoke is Plume increased, ceiling-jet in formation being descend in smoke layer will be more thick smoke layer, and then vertical wall is collapsed in formation of wall-jet being descend. It is defined that smoke layer is more thick through descending course in wall-jet and ceiling-jet.