• Journal of Power Electronics
• /
• 제7권4호
• /
• pp.343-352
• /
• 2007

This paper proposes a modularized charge equalization converter for hybrid electric vehicle (HEV) lithium-ion battery cells, in which the intra-module and the inter-module equalizer are Implemented. Considering the high voltage HEV battery pack, over approximately 300V, the proposed equalization circuit modularizes the entire $M^*N$ cells; in other words, M modules in the string and N cells in each module. With this modularization, low voltage stress on all the electronic devices, below roughly 64V, can be obtained. In the intra-module equalization, a current-fed DC/DC converter with cell selection switches is employed. By conducting these selection switches, concentrated charging of the specific under charged cells can be performed. On the other hand, the inter-module equalizer makes use of a voltage-fed DC/DC converter for bi-directional equalization. In the proposed circuit, these two converters can share the MOSFET switch so that low cost and small size can be achieved. In addition, the absence of any additional reset circuitry in the inter-module equalizer allows for further size reduction, concurrently conducting the multiple cell selection switches allows for shorter equalization time, and employing the optimal power rating design rule allows fur high power density to be obtained. Experimental results of an implemented prototype show that the proposed equalization scheme has the promised cell balancing performance for the 7Ah HEV lithium-ion battery string while maintaining low voltage stress, low cost, small size, and short equalization time.

• 한국통신학회논문지
• /
• 제35권3A호
• /
• pp.217-224
• /
• 2010

본 논문에서는 3GPP의 LTE시스템에서 자동화기술 중의 하나인 기지국 구성 자동 설정 (Self-Optimization)을 위한 하드 핸드오버 알고리즘을 제안한다. 제안하는 알고리즘은 먼저 주변 셀로부터의 수신신호세기와 X2인터페이스를 통해 eNB(evolved Node-B)간의 정보 교환으로 수집된 후보 목표 셀들의 셀 부하 정보를 이용하여, 최적의 목표 셀을 선택하는 혼합형 목표 셀 선택방식과 핸드오버 성능에 영향을 주는 다양한 환경 요소들의 비용함수들에 의해서 최적의 핸드오버 히스테리시스(Hysteresis) 값을 선택하는 다중 요소 기반 능동 히스테리시스 방식으로 구성되어 있다. 본 논문에서 제안하는 알고리즘은 핸드오버 성능에 영향을 주는 요소들에 대한 정보를 바탕으로 LTE시스템에서의 기지국 운용 자동 최적화을 위한 최적화된 목표 셀과 히스테리시스 값을 선택하는 동작을 수행함으로써 핸드오버의 가장 중요한 성능인 핸드오버 실패율과 부하균형 측면에서 우수한 성능을 얻게 한다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2001년도 Proceedings ICPE 01 2001 International Conference on Power Electronics
• /
• pp.369-373
• /
• 2001

Multilevel inverter has attracted great interest in high-voltage high-power field because of its less distorted output. In this paper, a direct torque control (DTC) technique based on a three-level neutral-point-clamped (NPC) inverter is presented. In order to solve the intrinsic neutral-point voltage-balancing problem and to obtain a high performance DTC, a special vector selection method is introduced and the concept of virtual vector is developed. By using the proposed PWM strategy, a MRAS speed sensor-less DTC drive can be achieved without sensing the neutral-point voltage, The strategy can be verified by simulation and experimental results.

• 한국주거학회논문집
• /
• 제17권2호
• /
• pp.11-18
• /
• 2006

For the more comfortable thermal environment in residential buildings, it was necessary for variable components like as automatic flow limiting valves and/or balancing valves in hydronic system. And, these components had an effect on flow-rate and pressure inside pipe. In this case, the incompatibility between the design for the heating system and the selection of equipment was the causes of several problems in heating pipe network. In this study, we peformed measurements and analyses of flow rate and pressure inside pipe for radiant floor heating in residential buildings through field surveys and experiments in order to find out the actual conditions and problems. On the basis of this, we suggested the approach for the optimal flow-rate and pressure maintaining inside pipe in individual heating system.

• Journal of the Korean Data and Information Science Society
• /
• 제26권1호
• /
• pp.217-227
• /
• 2015

In observational study, handling confounders is a primary issue in measuring treatment effect of interest. Historically, a regression with covariate adjustment (covariate-adjusted regression) has been the typical approach to estimate treatment effect incorporating potential confounders into model. However, ever since the introduction of the propensity score, covariate-adjusted regression has been gradually replaced in medical literatures with various balancing methods based on propensity score. On the other hand, there is only a paucity of researches assessing propensity score methods compared with the covariate-adjusted regression. This paper examined the performance of propensity score methods in estimating risk difference and compare their performance with the covariate-adjusted regression by a Monte Carlo study. The study demonstrated in general the covariate-adjusted regression with variable selection procedure outperformed propensity-score-based methods in terms both of bias and MSE, suggesting that the classical regression method needs to be considered, rather than the propensity score methods, if a performance is a primary concern.

• 전기의세계
• /
• 제31권2호
• /
• pp.132-140
• /
• 1982

Designing the capacitor-run motor for balanced operation is accompanied with the excessive capacitor value and low capacitor terminal voltage of condenser. As a solution for this problems, It was reported the design by equal volt-ampere method. The running characteristics of capacitor-run motor by this method due to the balancing point selection, however, has a room to be studied further. This paper deals with the determination of the winding ratio and capacitor value of a permarient-split capacitor motor by balanced operation and equal volt-ampere method at the different load points. The analysis of the running characteristics of a motor and its designing method also presented for both cases. It concluded that the running characteristics due to the equal volt-ampere operation are very close to the balanced operation.

• 설비공학논문집
• /
• 제20권3호
• /
• pp.175-180
• /
• 2008

Flow quantity to supply to a coil in floor heating system is important to achieve comfortable indoor air condition in the winter season. The hot water header is used to distribute the water into the coil. Experimental study has been performed using the water header that have 5 branches consisted of flow control valves and automatic shut-off valves. Each branch line connected it with X-L pipe. Experimental tests accomplished it to investigate the flow distribution characteristics of the hot water header. Experimental results show that the selection of the pump head and differential pressure are very important to save running energy of the system, and high differential pressure needs more friction loss in the case of suitable differential pressure for balancing of the header.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제8권12호
• /
• pp.4293-4304
• /
• 2014

In order to ensure the wireless connectivity and seamless service to mobile users, the next generation network system will be an integration of multiple wireless access networks. In a heterogeneous wireless access system, bandwidth allocation becomes crucial for load balancing to avoid network congestion and improve system utilization efficiency. In this article, we propose a new dynamic bandwidth allocation scheme for hierarchical wireless network systems. First, we derive a multi-objective decision criterion for each access point. Second, a bargaining strategy selection algorithm is developed for the dynamic bandwidth re-allocation. Based on the intervenient Stackelberg game model, the proposed scheme effectively formulates the competitive interaction situation between several access points. The system performance of proposed scheme is evaluated by using extensive simulations. With a simulation study, it is confirmed that the proposed scheme can achieve better performance than other existing schemes under widely diverse network environments.

• Journal of Information Technology Applications and Management
• /
• 제25권2호
• /
• pp.73-90
• /
• 2018

Despite of increasing studies for product recommendation, the recommendation of product repurchase timing has not yet been studied actively. This study aims to propose deep neural network models usingsimple purchase history data to predict the repurchase timing of each customer and compare performances of the models from the perspective of prediction quality, including expected ROI of promotion, variability of precision and recall, and diversity of target selection for promotion. As an experiment result, a recurrent neural network (RNN) model showed higher promotion ROI and the smaller variability compared to MLP and other models. The proposed model can be used to develop a CRM system that can offer SMS or app-based promotionsto the customer at the right time. This model can also be used to increase sales for product repurchase businesses by balancing the level of ordersas well as inducing repurchases by customers.

• Journal of Power Electronics
• /
• 제16권1호
• /
• pp.133-141
• /
• 2016

This paper focuses on the development of a Five-Level Flying-Capacitor Dual Buck Inverter (FLFCDBI) based on the main circuit of dual buck inverters. This topology has been described as not having any shoot-through problems, no body-diode reverse recovery problems and the half-cycle work mode found in the traditional Multi-Level Flying-Capacitor Inverter (MLFCI). It has been shown that the flying-capacitor voltages of this inverter can be regulated by the redundant state selection within one pole. The voltage balance of the flying-capacitors can be achieved by charging or discharging in the positive (negative) half cycles by choosing the proper logical algorithms. This system has a simple structure but demonstrates improved performance and reliability. The validity of this inverter is conformed through computer-aided simulation and experimental investigations.