• Bulletin of the Korean Chemical Society
• /
• v.34 no.7
• /
• pp.2073-2080
• /
• 2013

In this study the effects of adding alkaline-earth (IIA) metal oxides to NiZr-loaded Zeolite Y catalysts were investigated on hydrogen rich production by ethanol steam reforming (ESR). Four kinds of alkaline-earth metal (Mg, Ca, Sr, or Ba) oxides of 3.0% by weight were loaded between the $Ni_6Zr_4O_{14}$ main catalytic species and the microporous Zeolite Y support. The characterizations of these catalysts were examined by XRD, TEM, $H_2$-TPR, $NH_3$-TPD, and XPS. Catalytic performances during ESR were found to depend on the basicity of the added alkaline-earth metal oxides and $H_2$ production and ethanol conversion were maximized to 82% and 98% respectively in 27($Ni_6Zr_4O_{14}$)3MgO/70Zeolite Y catalyst at $600^{\circ}C$. Many carbon deposits and carbon nano fibers were seen on the surface of $30Ni_6Zr_4O_{14}$/70Zeolite Y catalyst but lesser amounts were observed on alkaline-earth metal oxide-loaded 27($Ni_6Zr_4O_{14}$)3MO/70Zeolite Y catalysts in TEM photos after ESR. This study demonstrates that hydrogen yields from ESR are closely related to the acidities of catalysts and that alkaline-earth metal oxides reduce the acidities of 27($Ni_6Zr_4O_{14}$)3MO/70Zeolite Y catalysts and promote hydrogen evolution by preventing progression to hydrocarbons.

• Korean Journal of Materials Research
• /
• v.9 no.5
• /
• pp.441-445
• /
• 1999

Alkaline earth metal oxides were added to the conventional MgO films as a protective layer for dielectric materials to have lower firing voltage(Vf) of the plasma display panel(PDP). Panels with various protective layers of MgO-alkaline earth metal oxides were prepared on glass by using e-beam evaporation and its effect on firing voltage characteristics were investigated. (Ba-Mg)O films had poor voltage characteristics because of higher activation energy of BaO. But, (Sr-Mg)O, (Ca-Mg)O and (Ca-Sr-Mg) O had better voltage characteristics than the conventional MgO. A mixture film of (Mg-Ca-Sr)O show the lowest firing voltage which is less than that of MgO by 20V. The chemical composition to have lowest firing voltage is MgO:SrO:CaO ratio of 6:2:2. The mixture of MgO-Alkaline earth metal oxides films showed good transmittance properties within the visual range.

• Journal of the Korean Ceramic Society
• /
• v.52 no.3
• /
• pp.180-185
• /
• 2015

Low-cost ceramic membrane supports with pore sizes in the range of $0.52-0.62{\mu}m$ were successfully prepared by uniaxial dry compaction method using inexpensive raw materials including kaolin, bentonite, talc, sodium borate, and alkaline-earth oxides in carbonate forms (e.g., $MgCO_3$, $CaCO_3$, and $SrCO_3$). The prepared green supports were sintered at $1000^{\circ}C$ for 8 hr in air. The effect of alkaline-earth oxide additives on the flexural strength of clay-based membrane supports was investigated. The porosity of the clay-based membrane supports was found to be in the range of 33-34%. The flexural strength of the clay-based membrane supports with 1% alkaline-earth carbonates was found to be in the range of 42.8-52.7 MPa. The addition of alkaline-earth carbonates to clay-based membrane supports resulted in large increases (47-80%) in the flexural strength of the membrane supports, compared to that of membrane supports without alkaline-earth carbonates. The typical flexural strength of the clay-based membrane support with 1% $SrCO_3$ was 52.7 MPa at 33.8% porosity.

• Journal of the Korean Ceramic Society
• /
• v.18 no.3
• /
• pp.171-181
• /
• 1981

Alkaline-earth porcelains have been prepared from mixture of kaolin, quartz, and synthetic calcines obtained by calcining a mixture of kaolin and more than two different kinds of alkaline-earth carbonates. They were magnesium, calcium and barium carbonates which are inexpensive and readily available. The vitrification behavior of the batch mixes was investigated in the firing range of 1240$^{\circ}$to 1380$^{\circ}$, in relation to the body compositions. It appeared that the density and the firing temperature depended largely on the content of alkaline-earth oxides in the body. These porcelains posses excellant dielectric properties, and are especially valuable as bases for deposited carbon resistors for which they were developed. An illustrative composition is 50% Dong Hwa kaolin, 22.4% Chang Shin quartz, 27.6% calcine. The composition of the calcine is 70% Dong Hwa kaolin, 10.7% BaCO3, 13.5% CaCO3, 5.8% MgCO3. The specific resistance of this body is $1.2{\times}10^{15}$ ohm-cm at 5$0^{\circ}C$, $2.5{\times}10^{14}$ ohm-cm 10$0^{\circ}C$, $2.5{\times}10^{13}$ ohm-cm at 15$0^{\circ}C$, $1.8{\times}10^{12}$ohm-cm at 20$0^{\circ}C$.

• Journal of the Korean Ceramic Society
• /
• v.19 no.2
• /
• pp.145-151
• /
• 1982

Many materials such as silica gel, metallic oxide, activated alumina and alkaline earth metal carbonates were employed as filter media for gaseous oxides of ruthenium volatilized during high level radioactive waste processing. The adsorption efficiency of ruthenium on these materials was evaluated. For the purpose of observing behavior of ruthenium oxides, thermogravimetric analysis of ruthenium oxide in a stream of oxygen was carried out. The rate of volatilization was proportional to the square root of oxygen partial pressure, and increased exponentially with temperature. At $650^{\circ}C$, gaseous ruthenium oxides showed a strongly marked effect of deposition. Of all the materials available, calcium oxide proved to be the best that could be used to adsorb ruthenium.

• Transactions of the Korean hydrogen and new energy society
• /
• v.17 no.4
• /
• pp.425-433
• /
• 2006

Sepiolite was selected as a mineral carbonation candidate ore for carbon dioxide sequestration. Carbonation salt formation from alkaline earth metal ingredient needs to dehydroxylation of sepiolite at high temperature. An evident dehydroxylation was observed over $800^{\circ}C$ and the variations of sepiolite characteristics after high temperature treatment was synthetically evaluated. Remarkable weight loss were measured after high temperature thermochemical reaction then crystallographic and spectroscopic changes were analyzed. The resulted alkaline earth metal oxides could explained by dehydroxylation based on thermochemical reaction.

• Journal of the Korean Ceramic Society
• /
• v.55 no.2
• /
• pp.160-165
• /
• 2018

This paper investigates the reaction rate of $CO_2$ storing carbonation hybrid reaction by comparing the behavior of carbonation between $Ca(OH)_2$ and fly ash with that of CFBC (Circulating Fluidized Bed Combustion) containing plenty of Free-CaO. Because fly ash with CFBC contains a lot of unreacted CaO, it cannot be used as a raw material for concrete admixtures and its usages are limited. To reuse such material, we stabilized unreacted CaO by carbonation and investigated the carbonation rate. We used a pH meter and a thermometer to check the rate of the carbonization. Also, we set the contents of fly ash with CFBC, $Ca(OH)_2$, flow and fluid of $CO_2$, respectively, to 100 g, 50 g, 100 ~ 1000 cc/min and 400 g based on the content of Free-CaO. We used carbonated water instead of water, and added an alkaline activator to promote the carbonation rate. As a result, the addition of the alkaline activator and carbonated water promoted the rate of carbonation via a hybrid reaction.

• Economic and Environmental Geology
• /
• v.20 no.2
• /
• pp.85-95
• /
• 1987

The host rocks of titaniferous magnetite deposits in Gonamsan are alkaline gabbros, which are typical of undersaturated alkaline rocks in terms of the lack of normative quartz. According to field occurrences and petrographic features, these alkaline gabbros are divided into 3 rock types: coarse-grained and pegmatitic rock, medium-grained rock with equigranular texture, and layered cumulate rock. All these rocks mainly contain clinopyroxene(salite), plagioclase(An 43-66), pargasite, and ilmenite. The accessory minerals are apatite, sphene, quartz, and sometimes titaniferous magnetite. Pargasite, sphene, and quartz are considered to be secondary minerals formed by the reaction among clinopyroxene, plagioclase and Fe-Ti oxide at deuteric stage. Fe-Ti oxides generally occur as ilmenite in the alkaline rocks, and titaniferous magnetite in the ore deposits. Layered cumulate rocks are characterized by a recurrence of discontinuous thin mesolayer of clinopyroxene-pargasite within leucolayer mainly composed of plagioclase. Clinopyroxene is cumulus mineral whereas plagioclase, ilmenite and apatite occur as intercumulus minerals. According to the variation diagrams of oxide and trace element contents against the differentiation index, incompatible elements, such as Na, Ba and Sr, show positive correlations whereas compatible elements, such as Mg and Cr, show negative correlations. However some compatible elements, such as Co, Ni and V show irregular variations, reflecting relative cumulate status of cumulus and intercumulus minerals. On the de la Roche multicationic diagram, these alkaline gabbros are distributed along the differentiation curve of undersaturated alkaline series from alkaline basaltic composition through basanitic composition to tephritic composition. Layered cumulate rocks, which are distributed between basanitic composition and tephritic composition, reflect their cumulate character, slightly scattering away from the curve. The medium-grained rock shows higher contents in Ba, Sr and light rare earch elements than the coarse-grained and pegmatitic rock. The former shows two times higher contents of total rare earth elements than the latter, $while(La/Lu)_{cn}$ ratios maintain fairly constant values of 5.08~5.06 in these two rocks. This means that coarse-grained and pegmatitic rock, as compared with the medium-grained rock, was formed by the earlier differentiated magma but rare-earth element distribution pattern remained almost parallel during differentiation. From the data the above mentioned, these alkaline gabbros are considered to be comagmatic and to be formed by intrusions of differentiated magmas in its reservoir.

• Proceedings of the KIEE Conference
• /
• 1992.07b
• /
• pp.737-739
• /
• 1992

The microstructure and humidity sensitive characteristics of $V_2O_5$ doped $CaTiO_3$ were studied. Sensing elements were prepared in bulk form. This element exhibits a porous structure. The grain grows and electrical conductivity increases as doping amount of $V_2O_5$ increases. The change of impedance and capacitance under different r.h is remarkable, and the conduction carriers of this element were ions.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.19 no.2
• /
• pp.255-266
• /
• 2021

Solid-state mechanochemical reduction combined with subsequent melting consolidation was suggested as a technical option for the oxide reduction in pyroprocessing. Ni ingot was produced from NiO as a starting material through this technique while Li metal was used as a reducing agent. To determine the technical feasibility of this approach for pyroprocessing, which handles spent nuclear fuels, thermodynamic calculations of the phase stabilities of various metal oxides of U and other fission elements were made when several alkaline and alkali-earth metals were used as reducing agents. This technique is expected to be beneficial, not only for oxide reduction but also for other unit processes involved in pyroprocessing.