• Proceedings of the Korea Concrete Institute Conference
• /
• 1993.10a
• /
• pp.138-143
• /
• 1993

The objective of this report is to investigate the effect of factors like the fineness modulus of sand , content of fly ash and slaked lime, binder/sand ratio, admixture dosage on the physical properties of mortar for finishing. The analysis was performed with design of experiment and air content, water retention and compressive strength were measured.

• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2000.11a
• /
• pp.247-248
• /
• 2000

산업규모의 급속한 팽창과 더불어 에너지원의 확보에 석탄이 차지하는 비중이 커지고, 산업경제의 부산물인 쓰레기의 처리가 매립에서 소각방식으로 바뀌어가고 있는 시점에서 산업연료사용량과 난방부분의 에너지 사용량이 급속히 증가하고 있다. 이러한 인간의 생산활동으로 인해 대기 중으로 배출되는 가스는 크게 연소가스와 소각가스로 분리할 수 있는데 대표적인 연소가스로써는 SO$_2$가 있으며, 소각가스로는 HCl이 있다. (중략)

• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2002.11a
• /
• pp.278-279
• /
• 2002

소각시설에서 다이옥신 배출문제가 사회문제화 되면서 대부분의 소각시설이 소석회 슬러리 분무의 반건식세정기와 백필터가 연결된 공정에 분말활성탄을 분무하는 시스템으로 운영하고 있다 원래, 다이옥신이 사회문제화 되기 이전부터 소석회 슬러리 분무의 반건식 세정기가 소각시설에서 사용되었는데 이는 주로 산성가스 제거 및 백필터 보호차원의 온도조절기능이었다. 백필터의 경우도 전기집진기와 더불어 먼지를 제거하는 기능을 담당하는 방지시설이었다. (중략)

• Journal of architectural history
• /
• v.22 no.6
• /
• pp.59-66
• /
• 2013

This study progressed an investigation on the cause of the efflorescence phenomenon of bricks in Suwon Hwaseong Fortress, which is designated as a UNESCO World Heritage by using diverse scientific analyses. The samples were taken in Hwaseong and analyzed using XRD and SEM-EDS for the material identification of efflorescence. We observed under a polarizing microscope and measured absorption factors for the basic investigation for traditional bricks. As a result of material identification, soluble salt($Na_2SO_4$, $KNO_3$) and insoluble salt($CaCO_3$) were detected. There was no big difference between original bricks and repaired bricks under the polarizing microscope. However, in terms of the water absorption rate, bricks which were used for repair nowadays showed low water absorption rate(1%). In conclusion, soluble salt and insoluble salt appeared due to an effect of an air pollution and joint mortar. Soluble salt was removed in the rainy season, but insoluble salt was not removed. As a result of the efficiency and safety tests for chemicals removing efflorescence, chemical E is likely to be the suitable chemicals for the efflorescence phenomenon of traditional bricks in Suwon Hwaseong Fortress. In the future, consideration whether the use of lime is available or not should be studied through comprehensive researches including repair work, construction work and the environment factor with lime. Also, physical, chemical identifications of repairing bricks will be required.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.3 no.1
• /
• pp.72-79
• /
• 2007

This study investigates the engineering properties of concrete incorporating lime stone crushed fine aggregate(Ls), which has been abandoned about 20% of total production due to the low purity. Test results showed that increase of Ls had favorable fluidity and slightly decreased air content. Bleeding capacity of all specimens was not appeared as those were high strength mixture proportion, but the specimens using more Ls accelerated initial and final setting. For the mechanical properties, specimens incorporating higher ratio of Ls, overall, resulted in increase of compressive strength, and exhibited very small inclined tendency in a dynamic elasticity modulus test In addition, for the durability properties, specimens incorporating higher Ls dramatically decreased a drying shrinkage and showed similar tendency in a frost & thaw test, as well as showing no more change in an accelerated neutralization test from the beginning. In conclusion, as it was confirmed in the experimental test, the high strength concrete applying Ls did not showed any problems in the aspects of engineering properties and mostly exhibited even more excellent quality than the specimens using natural fine aggregate.

• Korean Journal of Soil Science and Fertilizer
• /
• v.27 no.4
• /
• pp.290-295
• /
• 1994

Soil $CO_2$ evolution was measured using the soda-lime method for 20-year-old L. tulipifera, P. albaglandulosa, and Q. rubra plantations planted on a similar soil type in the Kwangneung Experimental Forest during the growing season of 1994. Soil $CO_2$ evolution ranged from $0.21g/m^2/hr$ for Q. rubra to $0.33g/m^2/hr$ for L. tulipifera. and was significantly different among species. We found positive correlations between soil $CO_2$ evolution and air(p<0.001, r=0.39) and soil temperatures(p<0.001, r=0.49). Peaks in seasonal soil $CO_2$ evolution occurred in July and August. Seasonal soil $CO_2$evolution did not necessarily follow changes in air and soil temperatures. This study implies that more work is needed to clarify the influence of other factors on soil $CO_2$evolution.

• Asian Journal of Atmospheric Environment
• /
• v.2 no.2
• /
• pp.102-108
• /
• 2008

In China, energy and environmental problems are becoming serious owing to rapid economic development. Coal is the most problematic energy source because it causes indoor and outdoor air pollution, acid rain, and global warming. One type of clean coal technology that has been developed is the coal-biomass briquette (or bio-briquette, BB) technique. BBs, which are produced from pulverized coal, biomass (typically, agricultural waste), and a sulfur fixation agent (slaked lime, $Ca(OH)_2$) under high pressure without any binder, have a high sulfur-fixation effect. In addition, BB combustion ash, that is, the waste material, can be used as a neutralization agent for acidic soil because of its high alkalinity, which originates from the added slaked lime. In this study, we evaluated the suitability of alternative biomass sources, namely, aquatic plants, as a BB constituent from the perspective of their use as a source of energy. We selected three types of aquatic plants for use in BB preparation and compared the fuel, handling, and environmental characteristics of the new BBs with those of conventional BBs. Our results showed that air-dried aquatic plants had a higher calorific value, which was in proportion to their carbon content, than agricultural waste biomass; the compressive strength of the new BBs, which depends on the lignin content of the biomass, was high enough to bear long-range intracontinental transport in China; and the new BBs had the same emission control capacity as the conventional BBs.

• Korean Journal of Metals and Materials
• /
• v.50 no.10
• /
• pp.753-761
• /
• 2012

The reduction behavior of low level oxides such as (T.Fe), (MnO) and ($P_2O_5$) in molten EAF slag was investigated using commercial reductants. In an air atmosphere, the slag volume increased and the reduction rate of the slag was very low due to the oxidation loss of reductants by oxygen in the air. The reduction rate of the slag was also low when a commercial reductant was used alone in an Ar gas atmosphere. The reason is probably because the material transfer through the interface between the slag and reductant is difficult due to the formation of high melting point oxide. When reductants were mixed with burnt lime in order to form low melting point reaction products, the reduction rate of the slag increased up to the range of 45-70%. By using the mixtures of reductants and burnt lime so as to form a low melting point slag at the reaction end, the reduction rate of the slag was improved up to 60-85%.

• Journal of Korean Society for Atmospheric Environment
• /
• v.16 no.4
• /
• pp.389-398
• /
• 2000

Photocatalytic removal of benzene from air was examined using titanium dioxide photocatalyst films prepared on soda lime glass(50$\times$50$\times$2 mm) by spin coating and chemical vapor deposition. For the measurement of photocatalytic reactivity titanium dioxide coated glass was placed into a batch reactor and concentration of benzene in the reactor was set to abuot 100 ppm, and then illuminated with UV. It was found that catalytic reactivity of titanium dioxide films increased with the increase of titanium dioxide film thickness and then level off beyond a certain film thickness. UV absorption by the films showed the similar trend. The formation of stoichiometric amount of carbon dioxide was confirmed by measurement of carbon dioxide concentration in the reactor. In general spin coated films revealed better photocatalytic reactivity than chemically deposited one within the experimental ranges covered in this study. Morphology and crystal structure of prepared films were investigated by XRD and SEM and they showed significant difference between spin coated films and CVD films. Highest quantum efficiency of prepared titanium dioxide photocatalyst was close to 50%.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.66-66
• /
• 2008

Most of the properties of ITO films depend on their substrate nature, deposition techniques and ITO film composition. For the display panel application, it is normally deposited on the glass substrate which has high strain point (>575 degree) and must be deposited at a temperature higher than $250^{\circ}C$ and then annealed at a temperature higher than $300^{\circ}C$ in order to high optical transmittance in the visible region, low reactivity and chemical duration. But the high strain point glass (HSPG) used as FPDs is blocking popularization of large sizes FPDs because it is more expensive than a soda lime glass (SLG). If the SLG could be used as substrate for FPDs, then diffusion of Na ion from the substrate occurs into the ITO films during annealing or heat treatment on manufacturing process and it affects the properties. Therefore proper care should be followed to minimize Na ion diffusion. In this study, we investigate the electrical, optical and structural properties of ITO films deposited on the SLG and the Asahi glass(PD200) substrate by rf magnetron sputtering using a ceramic target ($In_2O_3:SnO_2$, 90:10wt.%). These films were annealed in $N_2$ and air atmosphere at $400^{\circ}C$ for 20min, 1hr, and 2hrs. ITO films deposited on the SLG show a high electrical resistivity and structural defect as compared with those deposited on the PD200 due to the Na ion from the SLG on diffuse to the ITO film by annealing. However these properties can be improved by introducing a barrier layer of $SiO_2$ or $Al_2O_3$ between ITO film and the SLG substrate. The characteristics of films were examined by the 4-point probe, FE-SEM, UV-VIS spectrometer, and X-ray diffraction. SIMS analysis confirmed that barrier layer inhibited Na ion diffusion from the SLG.