• Journal of the Korean Institute of Telematics and Electronics
• /
• v.8 no.5
• /
• pp.20-26
• /
• 1971

A function relationship between the envlope rise time and Q v91ue of band pass filter is studied by using the time response to the step and sinusodal inputs. It is discovered that the above relationship is linear in the very low frequency band. The filter was constructed by the Analog computer so as to do the function of 2nd order RC active band pass.

• Journal of Power Electronics
• /
• v.10 no.4
• /
• pp.412-418
• /
• 2010

This paper proposes a new algorithm to generate a reference signal for an active power filter using a sliding-window FFT operation to improve the steady-state performance of the active power filter. In the proposed algorithm the sliding-window FFT operation is applied to the load current to generate the reference value for the compensating current. The magnitude and phase-angle for each order of harmonics are respectively averaged for 14 periods. Furthermore, the phase-angle delay for each order of harmonics passing through the controller is corrected in advance to improve the compensation performance. The steady-state and transient performance of the proposed algorithm was verified through computer simulations and experimental work with a hardware prototype. A single-phase active power filter with the proposed algorithm can offer a reduction in THD from 75% to 4% when it is applied to a non-linear load composed of a diode bridge and a RC circuit. The active power filter with the proposed reference generation method shows accurate harmonic compensation performance compared with previously developed methods, in which the THD of source current is higher than 5%.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.11 no.3
• /
• pp.172-178
• /
• 1986

The recent interest in the design of filters is motivatied by the fact that such filter can be fully integrated using standard metal-oxide-semiconductor processing technology. This is due to replacing all the resistors in the active RC filter network by the switched capacitors. The voltage gain of a SC filter depends only on the rations of capacitance and these ratios can be obtained and maintained to high accuracy. Therefore, it is known that a switched capacitor is much better than a resistor in temperature and linearity characteristics. This paper proposed a programmable SC filter and proved the fact that ${omega}_0$ Q and G of this circuit can be controlled by digital signal. Experiments show that SC filter remains the low sensitivities but it can't avoid little influence of parasitic capacitance. As the transfer characteristic of the SC filter is varied with sampling frequency and resistor array, SC filtering technigue can be applied for digital processing, speech analysis and synthesis and so on.

• Journal of Korean Association for Spatial Structures
• /
• v.7 no.1 s.23
• /
• pp.79-85
• /
• 2007

Steel plate bonding method with epoxy is common applied to repair and strengthen RC structures, but Steel is apt to corrode quickly, hard to manufacture and heavy. To overcome these defects, it is carried out research on strengthening RC structures with FRP(Fibre Reinforced Polyrner/Plastic) FRP is generally used in the shape of Plate or Sheet, but it has weak point such as premature failure, difficult work. To cope with these problem, NSMR(Near Surface Mounted Reinforcement) which uses CFRP in the shape of Rod is proposed and carried out active research on strengthening effect of variables such as quantity, anchorage length and space of CFRP-Rod. Strengthening with CFRP-Rod is carried out under loading to some degree in fact, and so the amount of pre-loading is selected as variable in this research. The amount of pre-loading is chosen in proportion to nominal strength of non-strengthened specimen with CFRP-Rod.

• Earthquakes and Structures
• /
• v.3 no.3_4
• /
• pp.365-381
• /
• 2012

Recent earthquakes have damaged some bridges located on the Pacific Coast of Mexico; these bridges have been retrofitted or rebuilt. Based on the fact that the Pacific Coast is a highly active seismic zone where most of the strong earthquakes in the country occur, one fertile and important area of research is the study of the vulnerability of both new and existent bridges located in this area that can be subjected to strong earthquakes. This work is focused on estimating the contribution of some parameters identified to have major influence on the seismic vulnerability of reinforced concrete bridges. Ten models of typical reinforced concrete (RC) bridges, and two existing bridges located close to the Pacific Coast of Mexico are considered. The group of structures selected for the study is based on two span bridges, two pier heights and two substructure types. The bridges were designed according to recent codes in Mexico. For the vulnerability study, the capacity of the structure was evaluated based on the FEMA recommendations. On the other hand, the demand was evaluated using a group of more than one hundred accelerograms recorded close to the subduction zone of Mexico. The results show that the two existent bridges analyzed show similar trends of behavior of the group of bridge models studied. In spite of the contribution that traditional variables (height and substructure type) had to the bridge seismic response, the bridge length was also found to be one of the parameters that most contributed to the seismic vulnerability of these RC medium-length bridges.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.3
• /
• pp.678-684
• /
• 2013

This paper describes a low-power baseband circuit for SAW-less LTE-Advanced transmitters. The proposed transmitter baseband circuit consists of a 2nd-order Tow-Thomas type active RC-LPF and a 1st-order passive RC LPF. It can provide a 7 multi-channel cut-off frequencies and wide gain control range of -41 dB ~ 0 dB with a 1-dB step. The proposed 2nd-order active RC-LPF adopts an op-amp in which three other sub-op amps are in parallel connected to reduce DC current for different cutoff frequency. In addition, each sub-op amp adopts both Miller and feed-forward phase compensation method to achieve an UGBW of more than 1-GHz with a small DC power consumption. The proposed baseband circuit is implemented in 65-nm CMOS technology, consuming DC power from 6.3 mW to 24.1 mW from a 1.2V supply voltage for each different cut-off frequency.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.34 no.10
• /
• pp.1498-1502
• /
• 2005

This study evaluated the isolation and identification of biologically active compounds from the ethyl acetate fraction of grape seed extract (Campbell early). Ethyl acetate fraction was further purified with sephadex LP-20 column chromatography. Each biologically active compound for free radical scavenging effect and lipid peroxidation inhibition was isolated and identified with ${1}^H$ and${12}^C$-NMR. Major compounds were identified as (+)-catechin and (-)-epicatechin respectively. The amounts of (+)-catechin and (-)-epicatechin in grape seed were 45.7$\%$ and 35.1$\%$, respectively. The purified (+)-catechin and (-)-epicatechin showed more strong free radical scavenging effects ($RC_{50}$= 11.1 $\mu$g/mL and 10.4 $\mu$g/mL) than ethyl acetate fraction ($RC_{50}$= 15.4 $\mu$g/mL). However, ethyl acetate fraction showed much stronger lipid oxidative inhibition effect than the purified (+)-catechin and (-)-epicatechin.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.60 no.1
• /
• pp.1-7
• /
• 2015

The photochemical characteristics were analyzed in the context of sowing time and different levels of fertilized nitrogen during the maize (Zea mays L.) growth. When maize was early sawn, the fluorescence parameters related with electron-transport, in photosystem II (PSII) and PSI, were effectively enhanced with the higher level of fertilized nitrogen. Highest values were observed in maize leaves grown in double N-fertilized plot. The photochemical parameters were declined in the progress of growth stage. In early growth stage, the fluorescence parameters were highest, and then reduced to about half of the parameters related with electron transport on PSII and PSI at middle and late growth stages. In 1/2 N plot, the photochemical energy dissipation was measured to 13% in term of active reaction center per absorbed photon resulting in decrease in performance index and driving force of electron. This decrease induced to lower the photochemical effectiveness. In 2 N plots, the electron transport flux from $Q_A$ to $Q_B$ per cross section and the number of active PSII RCs per cross section were considerably enhanced. It was clearly indicated that the connectivity between photosynthetic PSII and PSI, i.e. electron transport, was far effective.

• Archives of Pharmacal Research
• /
• v.26 no.11
• /
• pp.906-911
• /
• 2003

We previously reported that the butanol (BuOH) fraction of the head of Panax ginseng exhibited gastroprotective activity in peptic and chronic ulcer models. In order to identify the active constituent, an activity-guided isolation of the BuOH faction was conducted with a HCI$.$ethanol-induced gastric lesion model. The BuOH fraction was passed through a silica-gel column using a chloroform-methanol gradient solvent system, and six fractions (frs. 1-6) were obtained. The active fr. 5 was further separated by silica-gel column, to yield 6 subfractions (subfrs. a-f). Subfr. d was composed of ginsenosides Re, Rc and $Rb_1$. The most active constituent was ginsenoside $Rb_1$ ($GRb_1$), a protopanaxadiol glycoside, which was investigated for its anti-ulcer effect. Gastric injury induced by HCI$.$ethanol, indomethacin and pyloric ligation (Shay ulcer) was apparently reduced with oral $GRb_1$ doses of 150 and 300 mg/kg. $GRb_1$ at these dosage significantly increased the amount of mucus secretion in an ethanol-induced model. The anti-ulcer effects were consistent with the result of histological examination. These results suggest that the major active constituent in the head of Panax ginseng is $GRb_1$ and that anti-ulcer effect is produced through an increase in mucus secretion.

• Proceedings of the IEEK Conference
• /
• 2002.07b
• /
• pp.774-777
• /
• 2002

A systematic synthesis process is described for the simulation of current-controllable inductors using operational transconductance amplifiers (OTAs). The process is used to obtain three circuits; two are believed to be novel. The process is also applied to design current-controllable frequency-dependent negative resistances (FDNRs). Operation principles of designed circuits are presented and experimental results are used to verify theoretical predictions. The results show close agreement between predicted behavior and experimental performance.