• Carbon letters
• /
• v.10 no.2
• /
• pp.114-122
• /
• 2009

Crushed, depitted peach stones were impregnated activated with 50% $H_3PO_4$ followed by pyrolysis at $500^{\circ}C$. Two activated carbons were produced, one under its own evolved gases during pyrolysis, and the second conducted with air flow throughout the carbonization stage. Physicochemical properties were investigated by several procedures; carbon yield, ash content, elemental chemical analysis, TG/DTG and FTIR spectra. Porosity characteristics were determined by the conventional $N_2$ adsorption at 77 K, and data analyzed to get the major texture parameters of surface area and pore volume. Highly developed activated carbons were obtained, essentially microporous, with slight effect of air on the porous structure. Oxygen was observed to be markedly incorporated in the carbon matrix during the air treatment process. Cation exchange capacity towards Cu (II) and Cd (II) was tested in batch single ion experimental mode, which proved to be slow and a function of carbon dose, time and initial ion concentration. Copper was up taken more favorably than cadmium, under same conditions, and adsorption of both cations was remarkably enhanced as a consequence of the air treatment procedure. Sequestration of the metal ions was explained on basis of the combined effect of the oxygen functional groups and the phosphorous-containing compounds; both contributing to the total surface acidity character.

• Journal of Environmental Health Sciences
• /
• v.30 no.5 s.81
• /
• pp.402-409
• /
• 2004

I performed the research about the drinking water treatment by precoat filtration and activated carbon adsorption process in the D water treatment plant at Gwangju. D water treatment plant inlet water is supplied from Juam lake in Jeollanamdo. The results are as follows; 1. Element disk used in this experiment are R(pore size $10{\mu}m$), B(pore size $20{\mu}m$). And diatomaceous earth are A(cake pore size $3.5{\mu}m$), B(cake pore size $7{\mu}m$) and C(cake pore size $17{\mu}m$) 2. Filtrate of precoat filter during 30 min are B-C 10.2 > BB 5.7 > R-A 5.4 ($m^3/m^2$). 3. The water quality through B-C+AC and R-A+AC are DOC 1.76 mg/1, 1.288 m/l respectively. 4. total THMs produced by chlorination are $84.2{\mu}g/l$(B-C+AC), $66.11{\mu}g/l$ (R-A+AC), $97{\mu}g/l$ (rapid sand filtration water) respectively. 5. The R-A+AC and B-C+AC process can be substitute of CWTS.

• Membrane and Water Treatment
• /
• v.8 no.6
• /
• pp.517-528
• /
• 2017

This study evaluates the performance of membrane bioreactor (MBR) coupled with a modified walnut shell granular activated carbon (WSGAC) for tannery wastewater treatment. For this purpose, a pilot with overall volume of 80L and 12 hours hydraulic retention time (HRT) is operated in three scenarios. Here, the chemical oxidation demand (COD) of wastewater is reduced more than 98% in both C:N ratios of 13 (S1) and 6.5 (S2). This performance also remains intact when alkalinity depletes and pH reduces below 6 (S3). The ammonium removal ranges between 99% (S2) and 70% (S3). The reliability of system in different operating conditions is due to high solids retention time and larger flocs formation in MBR. The average breakthrough periods of WSGAC are determined between 15 minutes (S2) and 25 minutes (S1). In this period, the overall nitrate removal of MBR-WSGAC exceeds 95%. It is also realized that adding no chemicals for alkalinity stabilization and consequently pH reduction of MBR effluent (S3) can slightly lengthen the breakthrough from 15 to 20 minutes. Consequently, MBR can successfully remove the organic content of tannery wastewater even in adverse operational conditions and provide proper influent for WSGAC.

• Carbon letters
• /
• v.6 no.4
• /
• pp.243-247
• /
• 2005

Plasma polymerization of allylamine subsequently after plasma pre-treatment was conducted on the activated carbon fibers (ACFs) for the immobilization of amine groups in the surface of ACFs. The change of structural properties of ACFs with respect to different polymerization conditions was investigated through BET method. The change of surface morphologies of ACFs with respect to different plasma polymerization power was also studied through AFM. It was found that the structural properties such as specific surface area and micropore volume could be optimized under certain plasma deposition conditions. It was reckoned that treatment and deposition showed adverse effect on plasma polymerization, in which the former developed the micro-structures of the ACFs and the latter tended to block the micro pores. The Fourier transform infrared spectroscopy (FTIR) revealed that the poly(allylamine) was successfully immobilized on the surface of ACFs and the amount of the deposited polymer layer was related to the plasma polymerization power. SEM results showed that the plasma deposited polymer layer were small and homogenously distributed. The size and the distribution of particles deposited were closely related to the plasma polymerization power, too.

• Carbon letters
• /
• v.12 no.2
• /
• pp.112-115
• /
• 2011

The scope of this work investigates the relationship between the amount of oxygen-functional groups and hydrogen adsorption capacity with different concentrations of phosphoric acid. The amount of oxygen-functional groups of activated carbons (ACs) is characterized by X-ray photoelectron spectroscopy. The effects of chemical treatments on the pore structures of ACs are investigated by $N_2$/77 K adsorption isotherms. The hydrogen adsorption capacity is measured by $H_2$ isothermal adsorption at 298 K and 100 bar. In the results, the specific surface area and pore volume slightly decreased with the chemical treatments due to the pore collapsing behaviors, but the hydrogen storage capacity was increased by the oxygen-functional group characteristics of AC surfaces, resulting from enhanced electron acceptor-donor interaction at interfaces.

• Carbon letters
• /
• v.13 no.2
• /
• pp.61-72
• /
• 2012

Dye removal from waste water via adsorption by activated carbons (ACs) developed from agricultural wastes represents an ideal alternative to other expensive treatment options. Physical and chemical ACs were prepared from rice husks. The textural properties of the ACs were characterized by Brunauer-Emmett-Teller-$N_2$ adsorption and scanning electron microscopy. The chemistry of the carbon surface was investigated by Fourier transform infrared spectroscopy, base and acid neutralization capacities, pH of the active carbon slurry, and $pH_{pzc}$. The adsorption capacities of the ACs for the basic dye (methylene blue) and acid dye (acid green 25) were determined using parameters such as contact time, pH, and temperature. NaOH-ACs showed the highest surface area and total pore volume, whereas steam-ACs showed the lowest ones.

• Carbon letters
• /
• v.4 no.1
• /
• pp.21-23
• /
• 2003

In this work, the effect of anodic oxidation treatment on Cr(VI) ion adsorption behaviors of activated carbon fibers (ACFs) was investigated. The aqueous solutions of 10 wt% $H_3PO_4$ and $NH_4OH$ were used for acidic and basic electrolytes, respectively. Surface characteristics and textural properties of ACFs were determined by XPS and $N_2$ adsorption at 77 K. The heavy metal adsorption of ACFs was conducted by ICP. As a result, the adsorption amount of the anodized ACFs was improved in order of B-ACFs > A-ACFs > pristine-ACFs. In case of the anodized treated ACFs, the specific surface area was decreased due to the pore blocking or pore destroying by acidic electrolyte. However, the anodic oxidation led to an increase of the Cr(VI) adsorption, which can be attributed to an increase of oxygen-containing functional groups, such as, carboxylic, lactonic, and phenolic groups. It was clearly found that the Cr(VI) adsorption was largely influenced by the surface functional groups, in spite of the reduced specific surface area of the ACFs.

• Journal of Korean Society of Water and Wastewater
• /
• v.11 no.4
• /
• pp.71-79
• /
• 1997

Biological Activated Carbon (BAC) process is widely used for the advanced water treatment, but it's mechanisms have not been well understood, especially the relationship between biodegradation and carbon adsorption. Also the phenomenon of bioregeneration has been confused that previously occupied adsorption sites appear to be made available through the actions of microorganisms. Therefore, the objectives of this study examines closely the mechanism of bioregeneration by temperature variation, especially low temperature.

• Membrane Journal
• /
• v.24 no.1
• /
• pp.20-30
• /
• 2014

A membrane-coupled sequencing batch reactor (MSBR) was used for the advanced treatment of rural village sewage which is very low C/N ratio. The effect of powdered activated carbon, aeration rate, and external organic material loadings on the treatment efficiency and filtration performance were investigated in sequencing batch reactor, in which a flat-sheet type microfiltration membrane with a pore size of $0.4{\mu}m$ was submerged. At the initial operation (within 54 days) MLSS concentration, and the removal efficiencies of COD, T-N, and T-P were increased with the increase of C/N ratio. After 89 days the removal efficiencies of COD, T-N, and T-P were 97.1%, 75.0%, and 48.3%, respectively. Suspended solid-free effluent was obtained by membrane filtration. The T-P removal was relatively low because of depending on the amount of excess sludge wasting. During the operation of MSBR with powdered activated carbon, the particle size of the sludge reduced by the increase of collision frequency and mixing intensity. In comparison with MSBR without powdered activated carbon, TMP of MSBR with that was significantly elevated.

• Food Science of Animal Resources
• /
• v.22 no.3
• /
• pp.206-211
• /
• 2002

This study was conducted to investigate the influence of dietary activated carbon(0.9%) and fish oil(0, 1, 2, 4%) addition on the feed efficiency, blood-cholesterol, proximate composition, pH and minerals in breast and thigh of chicken meat. Broilers were randomly assigned to one of the five dietary treatment: 1) Control (commercial feed) 2) T1(commercial feed supplemented with 0.9% activated carbon) 3) T2 (commercial feed with 0.9% activated carbon and 1% fish oil) 4) T3 (commercial feed with 0.9% activated carbon and 2% fish oil) 5) T4 (commercial feed with 0.9% activated carbon and 4% fish oil). They were fed with one of the experimental diets for five weeks and slaughtered. After that, the meat samples were vacuum packaged and stored over a period of 10 days at 4$\pm$1$\^{C}$. When broilers were fed with dietary activated carbon and fish oil, the feed efficiency of birds were higher compared with that of control diet. The blood cholesterol was tended to decrease in dietary activated carbon and fish oil(p<0.05). However, effects of diets containing graded levels of activated carbon and fish oil on proximate composition were not found(p>0.05). The pH of all treatments significantly increased during the storage periods. The activated carbon and fish oil diet increased the calcium, potassium and sodium content of chicken meat, and tended to increase total mineral contents.