• Proceedings of the KSR Conference
• /
• 2008.06a
• /
• pp.2130-2138
• /
• 2008

The present study investigates the ventilation effects on smoke spreading characteristics in railway tunnels with the rescue stations. Experiments were carried out for n-heptane pool fires with a square length 4 cm at different fire locations, and the heat release rates (HRR) were obtained by the measurement of burning rates. In addition, using the commercial code (FLUENT), the present article presents numerical results for smoke behavior in railway tunnels with rescue station, and it uses the MVHS (Modified Volumetric Heat Source) model for estimation of combustion products resulting from the fire source determined from the HRR measurement. As a result, it is found that smoke propagation is prevented successfully by the fire doors located inside the cross-passages and especially, the smoke behavior in the accident tunnel can be controlled through the ventilation system because of substantial change in smoke flow direction in the cross-passages.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.61 no.7
• /
• pp.966-973
• /
• 2012

In microgrid demonstration site, distributed generations can make bidirectional power flows on the system. If an accident occurs, the fault current from the inverter based distributed generation is small. However, the conventional protection scheme in distribution network is designed to operate at high fault current. This means that the traditional protection of distribution network is no longer applicable and new protection methods must be developed. In this paper, for two cases, algorithms for protection coordination of demonstration site is proposed and verified through PSCAD/EMTDC simulation. In first case, protection devices are assumed to have the abilities of directional relaying and communication. In second case, protection devices do not have those abilities. Proposed protection coordination algorithms detect the fault locations and protect the microgrid fairly well.

• The Magazine of the Society of Air-Conditioning and Refrigerating Engineers of Korea
• /
• v.17 no.4
• /
• pp.499-507
• /
• 1988

The pressure suppression pool of BWR(Boiling Water Reactor) is subjected to hydrodynamic impact in the event of a LOCA(Loss of Coolant Accident). The pressure increase in the reactor dry cell would force the existing water of a vent pipe into the suppression pool. When the water is ejected through the pipe opening into the suppression pool, an abrupt downward force is transmitted to the suppression pool floor. Consequently, many structures installed within the pool must be able to withstand these forces. In order to determine the optimum safe locations of the pool structures, numerical analysis have been carried out to investigate the hydrodynamic behavior of the water jet. In the present analysis, a two-dimensional numerical model is utilized to solve transient flow equations.

• Safety and Health at Work
• /
• v.12 no.4
• /
• pp.544-545
• /
• 2021

The article by Tae-Gu Kim et al. conducted elastic FE modeling, which was inappropriate for fracture of elastic-plastic chain material (11.3% of elongation). FE analysis results and the findings in the fracto-graphic analysis did not tally but contradicted each other. The article identified "incorrect installation"/bending forces as the root cause while FE results of the chain under bending forces showed very low stresses at fracture locations but the highest stress in the middle of shank of the chain. The article's "step-like topographies indicating the fracture due to bending moment rather than uniaxial tension" lacked scientific support. The load value carried by each chain section under bending/incorrect installation was only half of that under tension, thus the article using same load value in FE simulation comparison for bending and tension was incorrect. The real cause of the chain fracture was likely improper checking the lifted load or/and using the wrong chain with much lower safety working load.

• Journal of the Society of Disaster Information
• /
• v.19 no.4
• /
• pp.806-814
• /
• 2023

Purpose: According to the Occupational Safety and Health Act of the Ministry of Employment and Labor, in order to prevent industrial accidents, the right to stop work must be exercised in the event of an imminent danger. This study conducted a fact-finding survey on whether employers fulfilled the right to suspend work in the workplace when an imminent danger, such as a typhoon, was encountered. Method: For two days from August 9 to October, when the impact of Typhoon Khanun No. 6 was significant, it was confirmed by wire whether or not the work suspension was carried out at the workplace, and the subjects of the survey were 1,649 construction sites, 830 manufacturing sites, and 278 other industries, for a total of 2,757 sites. Result: As a result of the fact-finding survey, 56% (1,555 locations) on August 9th and 77% (2,142 locations) on August 10th carried out full or partial work suspension. In particular, on August 10, when the typhoon landed, 40% of all workplaces completely stopped work. Conclusion: Through this study, it was confirmed that the right to suspend work by employers is being used in actual workplaces. In the future, when there is an imminent danger, in addition to the right to suspend work, flexible and telecommuting, working hour adjustments, etc. must be actively used to ensure the safety of workers and protect their lives.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.20 no.6
• /
• pp.39-45
• /
• 2012

More than 80 percent of traffic accidents related with lane departure believed to be the result of crossing the lane due to either negligence or drowsiness of the driver. Lane-departure related accident in the highway usually involve high fatality. Even though LDWS is believed to prevent accident 25% and reduce fatalities by 15% respectively, its effectiveness in performance is yet to be confirmed in many aspects. In this study, the vehicle lateral locations relative to warning zone envelop (earliest and latest warning zone) defined in ISO standard, ECE and NHTSA regulations are compared with respect to various factors including delays, vehicle speed and vehicle heading angle with respect to the lane. Since LDWS is designed to be activated at the speed over 60 km/h, vehicle speed range for the study is set to be from 60 to 100 km/h. The vehicle heading angle (yaw angle) is set to be up to 5 degree away from the lane (abrupt lane change) considering standard for lane change test using double lane-change test specification. The TLC is calculated using factors like vehicle speed, yaw angle and reaction time. In addition, the effect of vehicle type has been considered to assess LDWS safety.

• International Journal of Highway Engineering
• /
• v.18 no.5
• /
• pp.63-73
• /
• 2016

PURPOSES : The objective of this study was to analyze variations in the vehicle driving behavior characteristics on signalized intersections according to the use of traffic enforcement camera (red light camera). METHODS : In order to analyze the driving behavior characteristics on signalized intersections when red light camera are installed, the target sites for investigation were selected depending on whether the red light camera is installed and accident rates increased after the installation. In particular, to analyze the characteristics of dilemma zones in signalized intersections, approach speed and deceleration speed of 3 type vehicles (passing vehicles during a yellow light, stopping at a yellow light, passing vehicles during a green light) were examined. Based on these data, the starting point, ending point, and distance of the dilemma zones were calculated. Also, the locations of increased traffic accidents and decreased accidents after the installation of the equipment were distinguished when analyzing the traffic accident characteristics. RESULTS : Analysis results revealed that there was a tendency for the dilemma zone distance to decrease after the installation of equipment(red light camera) in most sites. This tendency was found to be due to the decrease in the approaching speed of vehicles at intersections after the installation of equipment, resulting in the starting and ending points of dilemma zone to become closer to the stop line. Moreover, analysis showed that the number of traffic accidents decreased for most intersections after the installation of equipment and safety of the intersections increased somewhat. CONCLUSIONS : In general, installation of equipment(red light camera) caused the intersections approaching speed and dilemma zone distance to decrease. Decision-making is difficult for drivers in the dilemma zone, so the decrease in the dilemma zone distance implies an improvement in traffic safety. Furthermore, the number of accidents within intersections significantly decreased after the equipment was installed, leading to the conclusion that installation of the equipment affected the decrease in traffic accidents.

• Journal of Korean Society of Transportation
• /
• v.26 no.2
• /
• pp.25-33
• /
• 2008

This study was practiced in order to analyze the effect of concentrative lighting that is set up at night in some districts. For practicing this study, It was analyzed first, to study the past papers, second, to analyze the condition of the traffic accidents and the characteristics of the accidents, third, to study on the improvements of the high accident locations, finally to study the characteristics about the pedestrians' traffic accidents. The effects of road lighting improvements was analysed. The result of the analysis on concentrative lighting of crosswalk said that the night accidents was decreased to average 16.13% and the Net Present Value(NPV) on the analysis of the effect during using period is 25,648 million won, The B/C is 12.85. So, It was analysed that it is very effective.This study was practiced on the some districts and equipping time is different, and the number of samples is small. Because of this facts, This sample doesn't represent all of the concentrative lightings. But through the systematic analysis, this study can present the alternatives that can be materialized.

• Journal of the Korean Society of Safety
• /
• v.33 no.5
• /
• pp.101-108
• /
• 2018

This study was carried out to obtain baseline data on the causes of industrial accidents and their prevention by investigating structural models between the Shipyard workers' egogram ego-states (CP: Critical Parent, NP: Nurturing Parent, A: Adult, FC: Free Child, AC: Adapted Child), safe and unsafe behaviors, and industrial accidents (frequency/severity). In order to achieve this goal, 378 workers from 3 locations of major corporations in Geojedo Island and Ulsan took a questionnaire, which was then analyzed with a structural equation model using the SPSS 23.0 and AMOS 24 statistics package, and the main results of the study are as follows. First, NP and A's ego-states had a positive influence on safe behavior, AC's ego-state had a negative influence on safe behavior, and A's ego-state had the largest influence on safe behavior. Second, CP and AC's ego-states had a positive influence on unsafe behavior, and A's ego-state had a negative influence on unsafe behavior. AC's ego-state had the largest influence on unsafe behavior. Third, safe behavior did not have a significant influence on industrial accidents. However, unsafe behavior had a positive influence on industrial accident frequency and industrial accident severity, both sub-factors of industrial accidents. This study, despite its limitations, such as sampling limitations, has the following significance. First, this study verified that ego-state, a psychological characteristic, is an important factor for predicting unsafe behavior that induces industrial accidents. Second, in order to reduce industrial accidents, there is a need to stimulate the A ego-states, and promote continuous safety management and safety education to neutralize the AC ego-state. Third, previous studies were limited in the area of practical methods for reducing unsafe behaviors, but this study presents practical methods for reducing unsafe behaviors by verifying the structural relationship between safe/unsafe behaviors and industrial accidents by selecting ego-gram ego-states, variable personality theory, as an independent variable.

• International Journal of Highway Engineering
• /
• v.16 no.6
• /
• pp.149-158
• /
• 2014

PURPOSES : The bridge section of the expressway has a worse driving environment than the general section. However, traffic safety countermeasures are focused only on the bridge section. Traffic safety countermeasures on the section before entry to the bridge and the section after exit from the bridge are applied only when the bridge has a long-span section. Accordingly, this study will verify the necessity of extending the application of traffic safety countermeasures to areas that are affected by the bridge. METHODS : This study determines the areas that are affected by the bridge as well as the areas that are affected by locations with frequent traffic accidents and suggests the risk factors by affected areas through canonical discriminant analysis. For the analysis, traffic accident data for 3 years, which occurred on bridge sections in six major expressway lines, were used. RESULTS : The numbers of traffic accidents were 469 before the bridge, 281 on the bridge, and 468 after the bridge. The variables that have impact on the seriousness of accidents are as follows: speeding, excess manipulation of the steering wheel, and failure to secure safety distance for accidents that occurred before the bridge section; speeding, excess manipulation of the steering wheel, and dozing off for accidents that occurred on the bridge; and speeding and failure to secure safety distance for accidents that occurred after the bridge section. CONCLUSIONS : Areas affected by the bridge show higher accident rates than the bridge section; therefore, imposing traffic safety countermeasures on the integrated section of the bridge and the affected areas is required. It is believed that the results suggested in this study could be effectively used in the prevention of traffic accidents by imposing custom-made safety countermeasures for each section.