• Journal of the Korean Society of Marine Environment & Safety
• /
• v.5 no.1
• /
• pp.29-36
• /
• 1999

A field experiment of the leeway of person-in-water(man with wetsuit) was conducted during October 1997∼ April 1998. The experiment area was northeast side of Cho Do island in Pusan. The college students whose weight ranges 60∼87 kg, height 170∼178 cm were actually drifted for the experiment. The person-in-water wore 5 mm neoprene diving wetsuit to prevent heat loss of the body. The current near the target was measured using a colored vinyl bag. To compare the result a scuba diver equipped with scuba gear and with his BC(buoyancy compensator) fully inflated was drifted alongside. The average leeway speed of man with wetsuit and that of scuba diver were about 0.4 percent and 1.3% of the 10 m wind speed above the water respectively.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.8
• /
• pp.117-124
• /
• 2009

This paper describes a 3 to 5 GHz frequency synthesizer for MB-OFDM (Multi-Band OFDM) UWB (Ultra- Wideband) application using 0.13 ${\mu}m$ CMOS process. The frequency synthesizer operates in the band group 1 whose center frequencies are 3432 MHz 3960 MHz, and 4488 MHz. To cover the overall frequencies of group 1, an efficient frequency planning minimizing a number of blocks and the power consumption are proposed. And, a high-frequency VCO and LO Mixer architecture are also presented in this paper. A new mixed coarse tuning scheme that utilizes the MIM capacitance, the varactor arrays, and the DAC is proposed to expand the VCO tuning range. The frequency synthesizer can also provide the clock for the ADC in baseband modem. So, the PLL for the ADC in the baseband modem can be removed with this frequency synthesizer. The single PLL and two SSB-mixers consume 60 mW from a 1.2 sV supply. The VCO tuning range is 1.2 GHz. The simulated phase noise of the VCO is -112 dBc/Hz at 1 MHz offset. The die area is 2 ${\times}$ 2mm$^2$.

• Journal of Korean Society of Forest Science
• /
• v.109 no.2
• /
• pp.157-168
• /
• 2020

The sensitivity of forest soil to acidification in the Republic of Korea (ROK) was evaluated based on pH_H2O, cation exchange capacity (CEC), and base saturation (BS). Sensitivity to acidification was categorized into three grades: adequate level (AL, pH ≧ 4.2, CEC ≧ 15cmol/kg, BS ≧ 15%), caution level (CL, at least one indicator is below AL), and severe Level (SL, all three indicators are below AL). Soil samples were collected from the 65 stationary monitoring plots (40 × 40 ㎢), distributed throughout ROK. Only 19% of soil samples were classified as AL, while 66% and 15% were CL and SL, respectively. The median of pH_H2O, CEC, BS, and Ca/Al indicator in AL soils was pH 4.64, 20.7cmol/kg, 29%, and 6.3, respectively. Moreover, BC_ex (K⁺, Mg²⁺, Ca²⁺) and available phosphorus (AP) concentration compared with a threshold value and molar ratio of BC_ex and AP to total nitrogen (TN) was high. This indicates that AL soils have a good nutrient condition. The molar Ca/Al ratio, an indicator for toxicity of exchangeable aluminum (Al_ex), was more than 1, indicating no negative impact of Al_ex on plant growth. On the contrary, the median of pH_H2O, CEC, and BS in SL soils was pH 4.02, 13.2cmol/kg, and 10%, respectively. The Ca/Al index was less than 0.6, which indicates that negative impacts of Al_ex on plants were high. Furthermore, both the concentration of BC_ex in SL soils and the BC_ex/TN ratio were the lowest among the three acidity degrees. This shows that SLsoils can be degraded by soil acidification compared with less acidic soils.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.4
• /
• pp.1-8
• /
• 1998

An MMIC single-balanced upconverting mixer for PCS application has been successfully developed using an MMIC process employed by 1 .mu. ion implanted GaAs MESFET and passive lumped elements consisting of spiral inductor, Si3N4 MIM capacitors and NiCr resistors. The configuration of the mixer presented in this paper is two balanced cascode FET mixers with common-source self-bias circuits for single power supply operation. The dimension of the fabricated circuit including two active baluns intermodulation characteristic with two-tone excitation are also measured, showing -28.17 dBc at IF power of -30 dBm.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.30 no.3
• /
• pp.1-11
• /
• 2007

The purpose of this study is to predict promising Location Based Services under an ubiquitous environment based on their technical characteristics, which is strongly required in rapidly changing circumstances with ubiquitous computing and Broadband Convergence Network (BcN). To begin with, this study proposes a classification scheme of ubiquitous services and defines five technology factors required for ubiquitous services. Next, this study collects a number of ubiquitous services from previous researches and classified them according to the classification scheme of ubiquitous services. And then, technical importance of the collected ubiquitous services are evaluated in terms of technology factors by using service-technology metrics. Finally, a set of important Location Based Services under ubiquitous environments and the correlations between technology factors are identified by using the evaluation results.

• Journal of electromagnetic engineering and science
• /
• v.15 no.4
• /
• pp.232-238
• /
• 2015

This work describes the development of a D-band (110-170 GHz) signal source based on a SiGe BiCMOS technology. This D-band signal source consists of a V-band (50-75 GHz) oscillator, a V-band amplifier, and a D-band frequency doubler. The V-band signal from the oscillator is amplified for power boost, and then the frequency is doubled for D-band signal generation. The V-band oscillator showed an output power of 2.7 dBm at 67.3 GHz. Including a buffer stage, it had a DC power consumption of 145 mW. The peak gain of the V-band amplifier was 10.9 dB, which was achieved at 64.0 GHz and consumed 110 mW of DC power. The active frequency doubler consumed 60 mW for D-band signal generation. The integrated D-band source exhibited a measured output oscillation frequency of 133.2 GHz with an output power of 3.1 dBm and a phase noise of -107.2 dBc/Hz at 10 MHz offset. The chip size is $900{\times}1,890{\mu}m^2$, including RF and DC pads.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.47 no.2
• /
• pp.25-34
• /
• 2010

This paper proposed a high-speed voltage-controlled ring-oscillator(VCRO) using a frequency doubling technique. The design of the proposed oscillator has been based on TSMC 0.18um 1.8V CMOS technology. The frequency doubling technique is achieved by AND-OR operations with 4 signals which have $90^{\circ}$ phase difference one another in one cycle. The proposed technique has been implemented using a 4-stage differential oscillator compose of differential latched inverters and NAND gates for AND and OR operations. The differential ring-oscillator can generate 4 output signals, which are $90^{\circ}$ out-of-phase one another, with low phase noise. The ANP-OR operations needed in the proposed technique are implemented using NAND gates, which is more area-efficient and provides faster switching speed than using NOR gates. Simulation results show that the proposed, VCRO operates in the frequency range of 3.72 GHz to 8 GHz with power consumption of 4.7mW at 4GHz and phase noise of ~-86.79dBc/Hz at 1MHz offset. Therefore, the proposed oscillator demonstrates superior performance compared with previous high-speed voltage-controlled ring-oscillators and can be used to build high-performance frequency synthesizers and phase-locked loops for radio-frequency applications.

• Journal of Advanced Marine Engineering and Technology
• /
• v.33 no.5
• /
• pp.756-761
• /
• 2009

In this paper, a X band voltage controlled oscillator is proposed. The oscillator uses a transistor as an oscillating element and its oscillating frequencies are controlled by the tuning voltage of varactor diode. Using the circuit simulation tools, the matching circuits between the transistor and varactor diode, its input and output matching circuits, and a feedback circuits are designed. The measured results of the fabricated oscillator show that its oscillation frequencies are from 10.50GHz to 10.88GHz according to the turning voltages of 1V to 18V, its output power levels are about 4.3dBm, and its phase noise is around -43.5dBc/Hz at 100kHz offset frequency of 10.5GHz.

• Asian Journal of Turfgrass Science
• /
• v.9 no.1
• /
• pp.75-80
• /
• 1995

In eight golf courses of southern area fair way soil profile was investigated for soil physical, chemical properties, and root distribution. These were carried out only A horizon(lScm depth) in one golf course. Soil series was all different, Leaching to lower horizon was greator in order of Mg=$NO_3$> $NH_4$=Ca> K. Organic matter content was higher in B horizon than A in three golf courses. Soil phosphorus appeared to more down greatly in two golf courses. Soil pH was higher in lower horizon of all places. Such pH increase with depth seemed to he related with mineral leaching, Among the horizons of all golf courses BC showed significant correlation with K (EC =0.1025K +0.0157, r=0. 8012 p=0. 001 n=20). Both Fe and Mn were higher in A horizon.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.64 no.3
• /
• pp.433-437
• /
• 2015

We have designed and fabricated a low power and high linearity up down convertor for wireless repeaters using $0.35{\mu}m$ SiGe Bipolar CMOS technology. Repeater is composed of a wideband up/down converting mixer, programmable gain amplifiers (PGA), input buffer, LO buffer, filter driver amplifier and integer-N phase locked loop (PLL). As of the measurement results, OIP3 of the down conversion mixer and up conversion mixer are 32 dBm and 17.8 dBm, respectively. The total dynamic gain range is 31 dB with 1 dB gain step resolution. The adjacent channel leakage ratio (ACLR) is 59.9 dBc. The total power consumption is 240 mA at 3.3 V.