• Environmental Engineering Research
• /
• 제16권2호
• /
• pp.103-109
• /
• 2011

This work experimentally determined the effect of thermal and microwave pretreatments on the anaerobic digestion of mixtures of municipal primary and secondary sludges in semi-continuous mesophilic digesters at hydraulic retention times (HRT) of 20, 15, 10, 7, and 5 days. The ratio of soluble chemical oxygen demand (COD) to total COD in thermally pretreated and microwaved sludges at $80^{\circ}C$ was 2.7 and 3.2 times higher than that of raw sludge, respectively. The volatile solids (VS) and COD removal efficiencies in all three digesters fed with raw (control), thermally pretreated (TM), and microwaved (MW) sludges decreased as the HRT was reduced. The highest relative improvement in VS removal compared to the control occurred at the HRT of 5 days in the TM and MW (29 and 41% higher than the control, respectively). At this HRT, improvement in the COD removal efficiencies in the TM and MW compared to the control was 28 and 53%, respectively. Improvements in biogas production compared with the control increased in both the TM and MW as the HRT was reduced to 5 days. The relative improvement in daily biogas production compared to the control from the TM and MW was 33 and 53% higher than the control at the HRT of 5 days, respectively. The results show that microwave pretreatment is more effective than thermal pretreatment in increasing the solubilization degree and mesophilic anaerobic biodegradability of sewage sludge.

• 한국초전도ㆍ저온공학회논문지
• /
• 제10권3호
• /
• pp.36-42
• /
• 2008

The superconducting motor shows several advantages such as smaller size and higher efficiency against conventional motor especially utilized in ship propulsion application. However, this size reduction merit appears in large capacity more than several MW. We are going to develop a 5MW class synchronous motor with rotating High-Temperature Superconducting (HTS) coil. that is aimed to be utilized for ship propulsion so it has very low-speed, The ship propulsion motor must generate very high electromagnetic torque instead of low-speed. Therefore. the rotor (field) coils need very large magnetic flux that results in large amount of expensive HTS conductor for the field coil. In this paper a 5MW HTS motor for ship propulsion is considered to be designed with construction cost reduced via HTS field coil cost reduction because HTS conductor cost is critical factor in the construction cost of HTS motor. In order to reduce the HTS conductor amount. iron-cored rotor types are considered. so several cases with iron-core are compared one another and with an air-core case.

• 한국식품저장유통학회지
• /
• 제16권3호
• /
• pp.321-326
• /
• 2009

마이크로버블을 이용한 세척시간과 세척방법에 따라 처리한 상추의 세척효과와 저장 중 품질 변화를 살펴본 결과는 다음과 같다. 세척시간 설정을 위한 실험을 통해 마이크로버블로 1, 3, 5분간 세척하여 미생물변화, 관능검사, 세척된 정도를 측정한 결과 5분간 처리한 시료가 가장 좋은 결과를 나타냈다. 세척방법에 따라 전처리한 상추의 미생물 변화는 세척처리 한 직후 무세척(CT)구는 4.30 log CFU/g, 손세척(HW)구는 4.10 log CFU/g, 일반버블세척(BW)구는 3.98 log CFU/g, 마이크로버블세척(MW)구는 3.25 log CFU/g에서 저장 10일째에는 무세척(CT)구는 7.00log CFU/g, 손세척(HW)구는 6.19 log CFU/g, 일반버블세척(BW)구는 6.02 log CFU/g, 마이크로버블세척(MW)구는 5.89 log CFU/g로 마이크로버블처리구가 가장 적은 변화를 보였다. 관능검사에서는 일반버블세척(BW)구와 마이크로버블세척(MW)구가 무세척(CT)구와 손세척(HW)구보다 유의적으로 높게 평가되었으며, 일반버블세척(BW)구와 마이크로버블세척(MW)구는 유의적 차이를 보이지 않았다. 또한 잔류농약시험에서도 마이크로버블을 이용한 처리구가 대조구 보다 2-3배정도 제거효과를 보였다. 상추의 세척상태를 측정한 결과 손세척구와 일반버블처리구은 완전히 깨끗하게 세척되지 못한 반면 마이크로버블처리구는 이물질이 보이지 않아 세척효과가 큰 것으로 나타났다.

• Journal of Advanced Marine Engineering and Technology
• /
• 제38권3호
• /
• pp.253-261
• /
• 2014

본 연구에서는 스퍼 유성기어시스템 2단, 헬리컬기어 시스템 1단으로 구성되어 있고, 메인 축과 증속기가 플랜지 결합되어 있는 동력분기식 2.5MW 풍력발전기에 대해 진동해석을 수행하였다. 유성기어시스템, 헬리컬기어시스템, 메인 축 등은 MASTA 상용프로그램으로 모델링하고, 기어박스 케이스, 토크암, 유성캐리어, 플랜지 등은 유한요소법으로 모델링하였으며, 부분구조합성법으로 조합하여 진동해석을 수행하였다. 2.5MW 동력분기식 풍력발전기 기어트레인의 고유진동 특성 해석을 수행하였고, 블레이드 풍하중에 의한 가진, 질량불평형, 축 어긋남 등에 발생하는 가진원에 대해 위험속도 분석을 하였다.

• Food Science and Biotechnology
• /
• 제15권6호
• /
• pp.937-941
• /
• 2006

Chitosan has a wide range of applications in biomedical materials as well as in dietary supplements. Chitosan oligosaccharide with free-amine group (COFa) is an improvement over traditional chitosan that lacks the usual impurities and materials detrimental to the body. Based on a previous study of water soluble chitosan (WSC, chitosan lactate), we investigated the molecular weight (Mw) - dependent absorption phenomena of COFa in vitro and in vivo with various Mws. The absorption of CO Fa was significantly influenced by its molecular weight. As Mw increases, the absorption decreases. The absorption profiles for 5 K COFa (Mw=5 kDa) were observed to be more than 10 times higher than those of high molecular weight chitosan (100 K HWSC Mw=100 kDa) in both in vitro and in vivo transport experiments. Furthermore, the in vitro transport experiment suggested that transcellular transport of the COFa (Mw <10 kDa) through Caco-2 cell layer could occur with a negligible cytotoxic effect. The COFas showed a cytotoxic effect on Caco-2 cells that was dependent on dose and Mw. COFa could be transported transcellularly through the Caco-2 cell layer.

• 제어로봇시스템학회논문지
• /
• 제17권5호
• /
• pp.412-418
• /
• 2011

The scale of wind turbines has continuously increased over the last decade. Especially, the rapid growth of the rotor diameter has brought about the increase of the tower height and the load on the rotor blade, as can be seen in the case of a 5MW class wind turbine with 126m rotor diameter. This trend means the increasing possibility of system failure. In addition to that, it is impossible for human operators to stay and manage all the turbines in the case of a large-scale wind farm. For these reasons, the operation and maintenance technology is getting more importance. In this paper, we present an unmanned remote monitoring system for MW class wind turbines and its application to YeungHeung wind test bed.

• 한국가시화정보학회지
• /
• 제17권2호
• /
• pp.32-38
• /
• 2019

A comparison study between computational-fluid-dynamics simulation and wind tunnel test for a megawatt-class wind turbine is conducted. For the study, flow-field in wake, basic aerodynamic performance, and effect of the yaw error for a 1/86 scaled-down model of the NREL offshore 5 MW wind turbine are numerically calculated using commercial software "FloEFD" with $k-{\varepsilon}$ turbulence model. The computed results are compared to the wind tunnel test performed by the constant-velocity mode for the model. It is shown that discrepancy are found between the two results at lower tip-speed ratio and higher yaw angle, however, the velocity-defection distribution in the wake, the torque coefficient at moderated and high tip-speed ratios are in good agreement with the wind tunnel test.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2022년도 봄 학술논문 발표대회
• /
• pp.241-242
• /
• 2022

In this study, fire simualtion was performed to examine the necessity of smoke control system in the tunnel fire. The heat release rate was set to 5 MW and 20MW, and the visibility was measured at 1.8 m, which is the breathing limit, when there is no jet fan. Through this, it was confirmed that 5 MW did not affect the visibility even without the jet fan, and in the case of 20 MW, a jet fan was required to secure the visibility. The visibility was measured at the same location by installing the jet fan, and the simulation was performed by reducing the design volume flow rate of 8.5 m³/s by 80% and 50%, respectively. As a result, it was confirmed that sufficient visibility was secured when the design flow rate and 80% were reduced.

• 한국식품조리과학회지
• /
• 제20권6호
• /
• pp.643-649
• /
• 2004

돼지고기를 전기그릴($EG;\;260^{\circ}C$, 5분) 및 전자렌지(MW, 6분)를 이용하여 조리 한 후 일정기간 냉장(0-14일), 냉동(0-90일) 보존한 시료와 이를 MW(1 min)로 재가열한 시료의 변이원성, 지질과 산화도(TBA), 및 육조직(SEM)을 연구하였다. S9 mix를 첨가하지 않은 상태에서 냉장 및 냉동 저장 기간에 따른 변이원성 유발 정도는 저장 기간이 증가함에 따라 변이원성이 증가하였고, 대사활성물질을 첨가했을 때 더 높은 변이원성을 나타내어 간접변이원이 더 많이 존재함을 확인하였으며, MW 재가열 처리 시는 더 높은 변이원성을 나타내었다. MW(6 min)로 조리했을 때 EG로 조리한 것보다 변이원 유발 가능성 면에서 보다 안전하다고 할수 있으나 냉동저장하고 재가열시는 변이원성 유발 가능성이 보다 높다고 사료된다. 변이원성과 과산화지질 생성간의 상관관계는 대사활성물질을 첨가하지 않았을 때 냉장 저장시 r=0.85, 냉동 저장 시 r=0.86이었고, MW 재가열하였을 때 냉장 저장 시 r=0.98, 냉동 저장 시 r=0.83으로 냉장 저장이 더 높은 상관관계를 나타내었다. SEM을 이용하여 육조직을 관찰한 결과 MW로 조리한 시료 및 MW로 재가열한 시료에서 더 많은 수증기 통로가 관찰되었다.

• Journal of the Korean Wood Science and Technology
• /
• 제45권4호
• /
• pp.471-481
• /
• 2017

As the molecular weight (MW) of urea-formaldehyde (UF) resins had a great impact on their properties, this work was conducted to study effect of analytical parameters of gel permeation chromatography (GPC) on the MW measurement of UF resins. GPC parameters such as flow rate, column, detector temperature, and sample injection temperature were selected to compare number-average molecular weight (Mn), weight-average molecular weight (Mw), molecular weight distribution (MWD) and polydispersity index (PDI) of two UF resins with different viscosities. As expected, UF resin with higher viscosity resulted in greater Mn and Mw than those of low viscosity UF resin. When the flow rate increased, both Mn and Mw of UF resins decreased and MWD became narrower. By contrast, both Mn and Mw increased and MWD became wide when the column, detector, and sample injection temperature increased. The column, detector, and sample injection temperature of $50^{\circ}C$ at a flow rate of $0.5m{\ell}/min$ resulted in the highest MW and broadest MWD for the GPC analysis. These results suggest that the apparent molecular size or a hydrodynamic radius of UF resin molecules dissolved in the mobile phase affect to Mn, Mw and MWD.