• Journal of electromagnetic engineering and science
• /
• 제8권3호
• /
• pp.96-99
• /
• 2008

This paper describes a $0.13-{\mu}m$ CMOS RF switch for $3{\sim}5$ GHz UWB band(mode 1). It can improve isolation characteristics between ports by using deep n-well RF devices while their source and body terminals are separated. From the measurement results, the proposed T/R switch is comparative to the on-wafer probing measurement results of the series-shunt T/R switches. When the proposed T/R switch operates as Tx mode, measured insertion loss from Tx to output port is less than 1.5 dB and isolation between Tx and Rx is more than 27 dB for $3{\sim}5$ GHz. Return loss for the Tx port is more than -10 dB and input P1dB is +10 dBm.

• 한국해양공학회지
• /
• 제7권2호
• /
• pp.131-140
• /
• 1993

To study the corrosion fatigue begavior of T.M.C.P. steel, the rotary bending fatigue test with the change of concentration of NaCl solution was carried out. Fatigue life in the corrosion environment is decreased markedly in comparision with that in the air. Fatigue limit in the air was about 225 MPa. In case of 3.5% NaCl solution fatigue life could be expressed as .sigma./sub f/=10,392 * (N/sub f/)/sup -o.2923 . According to the paris's rule, crack growth rates could be expressed as da/dN=2.62.*10/sup -7/ .DELTA. K/sup 1.09/(3.5% NaCl solution), da/dN=1.95 *10/sup -7 .DELTA. K/sup 1.05/(1% NaCl solution), da/dN=2.62 * 10/sup -7/.DELTA./sup 0.72/(0.01% NaCl solution) with da/dN expressed in mm/cycle and .DELTA.K in MPa.GAMMA.m. The crack growth rate in the corrosion environment was highest under 3.5% NaCl solution.

• 말소리와 음성과학
• /
• 제8권3호
• /
• pp.21-29
• /
• 2016

This study examined how native Korean speakers realize the acoustic characteristics of /d, t/ flaps in American English. Fourteen subjects, who had lived in foreign countries for less than one year, read words containing the alveolar stops in flapping environments. /d/ (91%) became flaps more frequently than /t/ (42%). The closure durations for /d/ flaps were significantly longer than /t/ flaps, and the durations of the preceding vowels were not significantly different between /d/ and /t/ flaps. Female learners demonstrated a higher percentage of /t/ flapping than their male counterparts. Differences in flap patterns were observed among individual learners.

• Journal of Chest Surgery
• /
• 제14권3호
• /
• pp.235-240
• /
• 1981

A total of 102 patients who had an Open Heart Surgery from April 1976 to July 1981 were reviewed. 55 paeitnts were congenital heart disease and 47 patients were acquired heart disease. Among SS patients of congenital heart disease, 18 T 0 F, 18 V S D, 8 A S D, and each one case of l\ulcorner 0 R V, Truncus arteriosus, Ebstein anomaly, Single ventricle, P D A, P 5, A S D + P 5, E C D, V 5 D + P D A, A - P window, D C R V were noted respectively. In 47 patients of acquired heart disease and one Ebstein patient, 46 prosthetic values were implanted: 17 had M V R, 4 had A V R, 2 had M V R + A V R, and 4 had M V R + T V R and one T V R. The operative mortality was 8.S% in acquired heart disease and 17% in congenital heart disease. The follow up period was between 6 months and 6 years. There were 3 cases of late mortality in acquired heart disease and one case in congenital heart disease.

• 산업경영시스템학회지
• /
• 제44권3호
• /
• pp.248-261
• /
• 2021

Scientific and technological performances (e.g., patents and publications) made through R&D play a pivotal role for national economic growth. National governments encourage academia-industry cooperation and thereby pursue continuous development of science technology and innovation. Increasing R&D-related investments and manpower are crucial for national industrial development, but evidence of poor performance in business performance, efficiency, and effectiveness has recently been found in Korea. This study evaluates performance efficiency of the 6T sector (Information Technology, Bio Technology, Nano Technology, Space Technology, Environment Technology, Culture Technology), which is considered a high-potential promising industry for the next generation growth and currently occupies two thirds of the national R&D projects. The study measures the relative efficiency of R&D in a comparative perspective by employing the Data Envelopment Analysis (DEA) method. The result reveals overall low efficiency in basic R&D (0.2112), applied R&D (0.2083), development R&D (0.2638), and others (0.0641), confirming that economic performance and efficiency were relatively poor compared to production efficiency. Efficient R&D needs policy makers to create strategies that can increase overall efficiency by improving productivity performance and quality while increasing economic performance.

• 한국자동차공학회논문집
• /
• 제1권3호
• /
• pp.1-11
• /
• 1993

An experimental study was carried out to evaluate the characteristics of transient performance of carburettered gasoline engine under rapid accelerating transient driving conditions. In order to evaluate the characteristics of transient performance quantitatively, the concept of dead time $t_d$ response delay time $t_r$ are introduced. Performance parameters such as air mass fiowrate Gat, engine speed N, manifold boost pressure Pb, and output torque T are measured simultaneously during the rapid opening of the throttle valve by the stepping motor. During the rapid opening of the throttle valve, air mass fiowrate Gat is increased immediately without delay time, but response of engine revolution N, and output torque T are delayed. Therefore hesitation, and stumble phenomena are occurred. Dead time $t_d$ and response delay time $t_r$ of engine revolution N, which is extremely delayed comparing to other performance parameters, are respectively 0.2-0.3sec., 3.0-4.6sec., and dead time rate $t_d/{\Delta}t$ and response delay time rate $t_r/{\Delta}t$ are linearly increased with the throttle valve opening rate ${\theta}$ during the acceleration from 12 degree to 20 degree at 1250rpm.

• 한국환경과학회지
• /
• 제8권1호
• /
• pp.75-81
• /
• 1999

In recent years increasing production and disposal of wastewater have caused an accelerated eutrophication of receiving waters. Therefore, in order to alleviate the detrimental impact of wastewater discharge, there is an increasing demand for removing the main nutrients, nitrogen and phosphorus, as well as the organic content of the waste water prior to disposal. This is effectively achieved by extended conventional treatment technology. However, the working expenses and energy requirements of such advanced treatment systems are rather high. So in a sparsely populated rural community is required development of wastewater treatment system combined with the regional characteristics. In this study, the systems are planted with Reeds and Amaryllis In A.C and estimated purification potential of system. The results obtained are as follows. BOD removal rate is 20% in the early stage, the last removal rate is 35% in A.C process and is 65% in Amaryllis+A.C process and is 50% in Reed+A.C process. T-N removal rate by Amaryllis is average 2.6g/$m^3$ㆍd, T-N removal rate by Reed is average 1.76g/$m^3$ㆍd. T-P removal rate by Amaryllis is average 0.27g/$m^3$ㆍd, T-P removal rate by Reed is average 0.25g/$m^3$ㆍd. BOD removal rate constant with retention time is 1.4494(1/d), T-N removal rate constant is 0.5428(1/d), T-P removal rate constant is 0.5287(1/d).

• 사물인터넷융복합논문지
• /
• 제6권3호
• /
• pp.75-80
• /
• 2020

최근의 IoT 센서의 소형화와 센서의 소형화로 인하여 다른 센서 및 구조물들과의 간섭 및 견고성을 고려하여 더욱 복잡해 지고 있다. 최근 3D 프린팅 기술은 센서 직접 제작이나, 센서 소자를 포함하는 기구를 만드는 분야에 다양하게 적용이 되고 있다. 그 중에서, fused deposition modeling(FDM) 기술은 장비 및 소재의 가격이 상당히 저렴하며, IoT 기기의 제작이 활용이 가능한 가장 유력한 기술중에 하나이다. 그런 FDM 프린팅 기술은 플라스틱 소재 기반의 필라멘트를 녹여서 적층하여 3D 형상을 만들어 내는 기술이며, 최근에 특허 종료와 아울러 오픈 소스 기반의 저가형 프린터가 개발됨으로 일반인들에게도 널리 사용되고 있다. 이런 FDM 기술을 이용하여 출력된 출력물에 있어서 기계적 물성치는 소재의 종류와 다양한 공정 변수들에 의해서 영향을 받는다. 그 중에서도 내부 채움(infill)은 기계적 물성치에도 큰 영향을 주면, 출력 시간에도 영향을 준다. 따라서 본 논문에서 내부 채움과 기계적 물성치 및 출력 시간 사이의 관계를 규명하여, 기계 기구물을 제작할 때 출력 시간과 기계적 물성치를 고려한 최적의 내부 채움 조건 선정 방법을 제시하고자 한다. 제시된 방법을 증명하고자, 다른 공정은 모두 고정하고, 내부 채움 조건만을 변경한 인장 시편을 제작하고, 제작된 시편을 인장 실험을 통하여 내부 채움에 따른 출력물의 기계적 물성치를 비교 분석하였다.

• Clinical and Experimental Pediatrics
• /
• 제62권3호
• /
• pp.85-89
• /
• 2019

Purpose: We compared thyroid hormone profiles in children with nephrotic syndrome (NS) during the nephrotic phase and after remission. Methods: This study included 31 pediatric NS patients. The thyroid hormone profiles included serum levels of triiodothyronine (T3), thyroxine (T4), thyroid-stimulating hormone (TSH), and free T4. Results: Of the 31 patients, 16 (51.6%) showed abnormal thyroid hormone profiles: 6 had overt hypothyroidism, 8 had subclinical hypothyroidism, and 2 had low T3 syndrome. The mean serum T3, T4, and free T4 levels in the nephrotic phase and after remission were $82.37{\pm}23.64$ and $117.88{\pm}29.49ng/dL$, $5.47{\pm}1.14$ and $7.91{\pm}1.56{\mu}g/dL$, and $1.02{\pm}0.26$ and $1.38{\pm}0.23ng/dL$, respectively; the levels were significantly lower in the NS nephrotic phase (P=0.0007, P<0.0001, and P=0.0002). The mean serum TSH levels during the nephrotic phase and after remission were $8.05{\pm}3.53$ and $4.08{\pm}2.05{\mu}IU/mL$, respectively; they were significantly higher in the nephrotic phase (P=0.0005). The urinary protein/creatinine ratio during the nephrotic phase was significantly correlated with serum T3, T4, and free T4 levels (r=-0.5995, P=0.0032; r=-0.5797, P=0.0047; r=-0.5513, P=0.0078) as well as with TSH levels (r=0.5022, P=0.0172). A significant correlation was found between serum albumin and serum T3 levels during the nephrotic phase (r=0.5385, P=0.0018) but not between serum albumin and T4, TSH, or free T4 levels. These significant correlations all disappeared after remission. Conclusion: Abnormal thyroid hormone profile findings were observed in 51.6% of pediatric patients with NS. Thyroid hormone levels normalized after remission, regardless of levothyroxine therapy.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2003년도 춘계학술대회
• /
• pp.2054-2059
• /
• 2003

3D-PTV measurement was conducted on the wake of a goldfish in order to understand its swimming motions. The measurement system consisted of three CCD cameras, an image grabber, an Ar-Ion laser and a host computer. The flow properties of the wake of the goldfish were measured under three different velocities of the currents. Unsteady flow structures around the goldfish were quantitatively clarified using the time-consecutive instantaneous three-dimensional vectors obtained by the constructed 3D-PTV system.