• 전기학회논문지
• /
• 제67권1호
• /
• pp.29-37
• /
• 2018

Inrush current and fault current in a transformer need to be distinguished from one another. In order to do this, KEPCO uses a 2nd harmonic restraint/block method. We use two setting values for 2nd harmonic restraint; 15% and 10%. We also apply per-phase blocking method among various harmonic restraint methods. If the transformer is located at the radial system, we adjust 10% in the 2nd harmonic restraint, but this method is not enough to prevent mal-operations of the current differential relay and let us spend more time to change setting value again as the power system changes. In this paper, a more reasonable setting value for a 2nd harmonic blocking scheme in KEPCO is proposed. To present a proposed method, the fault data of the current differential relays which have occurred since 2009 are analyzed. To evaluate the performance of the proposed method, the results of the RTDS test for the current differential relay of the transformer by KEPCO are analyzed.

• Journal of Power Electronics
• /
• 제18권5호
• /
• pp.1513-1522
• /
• 2018

This paper proposes a new islanding detection method for inverter-based distributed generators by continuously injecting a negligible amount of 2nd order harmonic current. The proposed method adopts a proportional resonant (PR) controller for the output current control of the inverter, and a PR filter to extract the 2nd order harmonic voltage at the point of common coupling (PCC). The islanding state can be detected by measuring the magnitude ratio of the 2nd order harmonic voltage to the fundamental voltage at the PCC by injecting a 2nd order harmonic current with a 0.8% magnitude. The proposed method provides accurate and fast detection under grid voltage unbalance and load unbalance. The operation of the proposed method has been verified through simulations and experiments with a 5kW hardware set-up, considering the islanding test circuit suggested in UL1741.

• Journal of Electrical Engineering and Technology
• /
• 제8권3호
• /
• pp.507-515
• /
• 2013

This paper proposes a compensation method for the $2^{nd}$-order harmonic of single-phase grid-connected wind power generation systems. Theoretically, a single-phase grid-connected inverter system has no choice but to cause the $2^{nd}$-order harmonic to DC-link voltage. The reference active current is affected by the DC-link voltage. The output current from the reference active current is distorted by the $1^{st}$ and $3^{rd}$-order harmonic. The proposed method can compensate, conveniently, the reference active current with the $2^{nd}$-order harmonic. To reduce the $2^{nd}$-order ripple in the reference active current, proposed method takes a PR controller as a feed-forward compensator. PR controllers can implement selective harmonic compensation without excessive computational requirements; the use of these controllers simplifies the method. Both the simulation and experimental results agree well with the theoretical analysis.

• 전기학회논문지
• /
• 제61권10호
• /
• pp.1554-1560
• /
• 2012

In this paper, the even harmonic current(2nd, 4th, 6th, 8th) of the arc fault current and normal current were measured in computer load and analyzed. The BPF with GIC was developed to detection of harmonic, the exact center frequency and a high degree of sharpness could be easily obtained. The total even harmonic distortion due to series arc fault in computer load was 31.2%, this value was increased 3.9 times better than the total even harmonic distortion of normal current. The results of analysis of arc fault current RMS variation rate and Peak variation rate per half-cycle, The RMS average variation rate are as follows ; the 2nd harmonic was 0.24, the 4th harmonic was 0.15, the 6th harmonic was 0.19, the 8th harmonic was 0.25, respectively. The Peak average variation rate are as follows ; the 2nd harmonic was 0.19, the 4th harmonic was 0.12, the 6th harmonic was 0.13, the 8th harmonic was 0.15, respectively. The results of this analysis utilize data to detect of series arc fault on wiring of computer load.

• 비파괴검사학회지
• /
• 제32권4호
• /
• pp.376-387
• /
• 2012

비선형 스프링 모델과 섭동법을 기초로 비선형 균열면에 경사 입사된 초음파에 의해 발생되는 2차 고조파 초음파의 크기를 계산하였다. 비선형 균열계면에서 만들어지는 반사파와 굴절파의 기본주파수 성분과 2차 고조파 성분의 크기를 입사각과 균열계면의 계면강성을 변화키면서 조사하였다. 계면강성에 관계없이 균열계면이 초음파 진행 방향과 비슷한 경우 반사와 굴절파 모두에서 2차 고조파의 발생은 거의 없었지만, 그렇지 않은 경우에는 계면 입사각은 물론 계면 강성에 따라 2차 고조파의 크기는 크게 변화하였다. 투과파는 물론 반사파에서도 2차 고조파 성분이 유의성 있게 발생됨을 수치 해석을 통해 확인하였다.

• 전기학회논문지P
• /
• 제53권2호
• /
• pp.43-50
• /
• 2004

Percentage differential characteristic relaying(PDR) has been recognized as the principal basis for power transformer protection. Second harmonic restraint PDR has been widely used for magnetizing inrush in practice. Nowadays, relaying signals can contain 2nd harmonic component to a large extent even in a normal state, and 2nd harmonic ratio indicates a tendency of relative reduction because of the advancement of material. Further, as the power system voltage becomes higher and more underground cables are used, larger 2nd harmonic component in the differential current under internal fault is observed. And then, conventional 2nd harmonic restraint PDR exposes some doubt in reliability. It is, therefore, necessary to develop a new algorithm for performance improvement of conventional protective relaying. This paper proposes an advanced protective relaying algorithm by using voltage-current trend and flux-differential current slope characteristic. To evaluate the performance of the proposed algorithm, we have made comparative studies of PDR, fuzzy relaying and DWT relaying. The paper is constructed power system model including power transformer, utilizing the WatATP, and data collection is made through simulation of various internal faults and inrush. As the results of test, the new proposed algorithm was proven to be faster and more reliable.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1988년도 전기.전자공학 학술대회 논문집
• /
• pp.397-398
• /
• 1988

We report on the simulation results of 1)the second harmonic conversion with $1.053{\mu}m$ Nd:glass laser using monolithic KDP crystal and 2)the efficient conversion from $1.053{\mu}m$ to $0.35{\mu}m$ by the polarization-mismatch 3rd harmonic conversion in two Type-II crystals.

• 한국정보통신학회논문지
• /
• 제13권6호
• /
• pp.1141-1149
• /
• 2009

Pulse 펄스형 Nd:YAG 레이저는 피부재생치료에 적합하고, 램프에 의해서 연속발진은 물론 정상발진, Q-스위치 및 모드동기 발진까지 다양한 발전 형태가 가능하며 미세수술 및 피부재생 촉진에 널리 사용되어지고 있다. 치료목적에 따라 에너지 밀도를 제어하는 것이 매우 중요하다. 에너지 밀도의 제어는 레이저 출력의 펄스반복률을 제어하는 방법이 주로 사용된다. 본 연구에서는 펄스형 Nd:YAG 레이저의 펄스반복률을 제어할 수 있는 제 2고조파 발생(second harmonic generation: SHG)로 각주파수인 광파의 에너지 일부가 비선형 결정안을 전파하면서 각주파수인 광파의 에너지로 변환되는 현상을 적용하여 2차 비선형성에 의한 제2고조파 발생을 통해 피부심부까지 치료 가능하다는 것은 간단히 관찰할 수 있었다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1989년도 하계종합학술대회 논문집
• /
• pp.633-636
• /
• 1989

The simulation results of the third harmonic conversion with 1.064 um Nd :YAG laser using polarization mismatch method are reported. The third harmonic conversion efficiency was over 65% for the Gaussian incident pulse of $300{\sim}400MW/cm^2$ peak intensity, and over 80% for $3{\sim}4GW/cm^2$ peak intensity pulse. The dependence of the third harmonic conversion efficiency' on the variation of incident polarization angle ${\theta}_p$ and angular discrepancy ${\Delta}{\theta}$ of phase matched angle ${\theta}_m$ is discussed.

• 한국광학회지
• /
• 제10권4호
• /
• pp.301-305
• /
• 1999

Czocharlski pulling method에 의해 성장된 새로운 광학결정 YCOB($YCa_4O(BO_3)_3$)의 파장에 따른 위상 정합 조건을 제시하였으며, Nd:YAG 레이저의 1064nm의 출력을 기본파로 하였을 때 제2조화파 발생 효율을 조사하였다. 또한 $Yb^{3+}$이온과 $Nd^{3+}$ 이온이 도핑된 YCOB의 제2조화파 발생효율을 조사하여 희토류 이온 도핑에 따른 비선형성의 변화를 조사하였다.