• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.1 s.116
• /
• pp.90-95
• /
• 2007

Chaotic OOK(On-Off Keying) modulation method can be used in LDR(Low Data Rate) UWB systems. The chaotic generator in one of the most important circuit in this system. The traditional chaotic generator circuits using analog feed back technique have low yield characteristic due to the process variation. A novel quasi-chaotic signal generator using digital PN-sequence in proposed in this paper and verified in 0.18um CMOS teleology.

• 한국정보통신설비학회:학술대회논문집
• /
• 2005.08a
• /
• pp.120-123
• /
• 2005

본 논문에서는 무선 홈 네트워크에 사용될 홈 내 무선 LAN(Local Area Network)용 안테나에 대해 연구하였다. 홈 내의 천장 부근에 안테나를 설치할 경우, 전파의 외부 노출을 피하고 최소한의 전력이 각 홈 별로 공급되어야하며, 각 홈 내에서의 전파를 홈 내 위치마다 균등하게 분배되어야 한다. 이를 위하여 모노폴 안테나와 다이폴 안테나 및 마이크로스트립 패치 안테나를 무선랜 주파수 2.4GHz를 중심으로 설계 제작하여 그 특성들을 고찰하였다. 그 결과 브로드사이드 방향으로 최대 또는 null 지점 발생, 좁은 빔폭 등 무선랜용 안테나로 사용하기 적합하지 않았다. 따라서, 구조적 변형 등을 통한 방사 빔의 개선 연구가 필요하다.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.1
• /
• pp.757-759
• /
• 2005

최근에 낮은 가격과 전력을 내세워 응용서비스를 제공할 수 있는 Bluetooth를 탑재한 많은 무선 제품들이 출시되고 있다. 그러나 1Mbps의 저속, 다른 무선 기기들과의 상호 간섭과 호환성 문제 그리고 보안 문제 등 많은 제약 조건이 따름에도 불구하고 이동전화, 컴퓨터, PDA 등 근거리 무선접속을 사용하고 있는 가정이나 회사의 전화나 컴퓨터들과 어떻게 서로 쉽게 연결될 수 있을까에 대한 꾸준한 연구가 활발히 진행되고 있다. Bluetooth 무선 기술은 음성 및 데이터 전송을 위한 단거리 일대다중 무선 주파수 통신을 위해 제안된 무선통신 기술이다. Bluetooth는 2.4GHz ISM Band에서 동작하며 약 10m 범위의 다양한 이동 장치와 휴대용 장치를 위한 저가격의 기저대역 무선 접속을 제공한다. 본 논문에서 Bluetooth의 기술적 측면을 알아보고 이를 이용해 현재 시장에 출시된 Bluetooth 기기중 하나인 One Phone을 소개하려 한다. 또한 Bluetooth의 발전 가능성에 대하여 알아본다.

• International Journal of Internet, Broadcasting and Communication
• /
• v.15 no.3
• /
• pp.122-128
• /
• 2023

This paper proposes two kinds of single-balanced direct conversion quadrature receivers using selfoscillating LMVs in which the voltage-controlled oscillator (VCO) itself operates as a mixer while generating an oscillation. The two LMVs are complementary coupled and series coupled to generate the quadrature oscillating signals, respectively. Using a 65 nm CMOS technology, the proposed quadrature receivers are designed and simulated. Oscillating at around 2.4 GHz frequency, the complementary coupled quadrature receiver achieves the phase noise of -28 dBc/Hz at 1KHz offset and -109 dBc/Hz at 1 MHz offset frequency. The other series coupled receiver achieves the phase noise of -31 dBc/Hz at 1KHz offset and -109 dBc/Hz at 1 MHz offset frequency. The simulated voltage conversion gain of the two single-balanced receivers is 37 dB and 45 dB, respectively. The double-sideband noise figure of the two receivers is 5.3 dB at 1 MHz offset. The quadrature receivers consume about 440 μW dc power from a 1.0-V supply.

• KOREAN JOURNAL OF PACKAGING SCIENCE & TECHNOLOGY
• /
• v.29 no.3
• /
• pp.211-221
• /
• 2023

This study was conducted as a basic study for the selection of tags suitable for logistics management in the palletized unit-load unit and the development of various technologies to activate the palletized unit-load shipment of agricultural products through local APCs. Three types of passive RFID tags of UHF 900 MHz and one type of active RFID tag of 2.4 GHz band designed and manufactured through this study were used to analyze the receiving strength according to the tag's attachment location and distance of the palletized unit-load of agricultural products. In the passive RFID tag, there was a large difference in receiving strength by the tag's attachment location and a large amount of data loss depending on the distance within 30 m, whereas, in the active RFID tag, it was superior to the passive tags in terms of both receiving strength and data loss. Therefore, active tags are desirable from the perspective of multiple identification of warehouses with large spaces in relation to the application of RFID tags for palletized unit-loads of agricultural products, but the development of low-power technologies such as software wakeup power management as well as hardware to minimize battery power consumption is necessary.

• Journal of Coastal Disaster Prevention
• /
• v.4 no.4
• /
• pp.189-196
• /
• 2017

Ocean Research Stations (ORSs) is the ocean platform type observation towers and measured oceanic, atmospheric and environmental data. These station located on the offshore area far from the coast, so they can produce the data without land effect. This study focused to improve the wave data quality of ORS station. The wave observations at ORSs are used by the C-band (5.8 GHz, 5.17 cm) MIROS Wave and Current Radar (MWR). MWR is convenient to maintenance and produce reliability wave data under bad weather conditions. MWR measured significant wave height, peak wave period, peak wave direction and 2D wave spectrum, so it's can provide wave information for researchers and engineers. In order to improve the reliability of MWR wave data, Datawell Waverider Buoy was installed near the one ORS (Socheoncho station) during 7 months and validate the wave data of MWR. This study found that the wave radar tend to be overestimate the low wave height under wind condition. Firstly, this study carried out the wave Quality Control (QC) using wind data, however the quality of wave data was limited. So, this study applied the four filters (Correlation Check, Direction Filter, Reduce White Noise and Phillips Check) of MWR operating software and find that the filters effectively improve the wave data quality. After applying 3 effective filters in combination, the RMSE of significant wave height decreased from 0.81m to 0.23m, by 0.58m and Correlation increased from 0.66 to 0.96, by 0.32, so the reliability of MWR significant wave height was significantly improved.

• Journal of the Korean institute of surface engineering
• /
• v.47 no.5
• /
• pp.263-268
• /
• 2014

Nanocrystalline diamond(NCD) coated SiC balls were applied in a ball-on-disk tribometer. After seeding in an ultrasonic bath containing nanometer diamond powders, $2.2{\mu}m$ thick NCD films were deposited on sintered 3 mm diameter SiC balls at $600^{\circ}C$ in a 2.45 GHz microwave plasma CVD system. Bare $ZrO_2$ and SiC balls were prepared for comparison as test balls. Tribology tests were performed in air with pairs of three different balls and mirror polished steel(SKH51) disk. The wear tracks on balls and disks were examined by optical microscope and alpha step profiler. Under the load of 3 N, the friction coefficients of steel against $ZrO_2$, SiC and NCD-coated balls were between 0.4 and 0.8. After a few thousands sliding laps, the friction coefficient of NCD-coated balls dropped from 0.45 to below 0.1 and maintained thereafter. Under a higher load of 10 N or 20 N with a long sliding distance of 2 km, $ZrO_2$ and SiC balls exhibited the similar friction coefficients as above. The friction coefficient of NCD-coated balls was less than 0.1 from the beginning and increased to above 0.1 steadily or with some fluctuations as sliding distance increased. NCD coating layers were found worn out after long duration and/or high load sliding test, which resulted in the friction coefficient higher than 0.1.

• Progress in Superconductivity
• /
• v.4 no.2
• /
• pp.137-143
• /
• 2003

In measuring the microwave surface resistance of high-Tc superconductor (HTS) films using the dielectric-loaded cavity resonator method, one of the most important factors that limit the measurement sensitivity is the measurement error in the loss tangent ($tan\delta$) of the dielectric rod placed inside the cavity. We have measured the effective surface resistance ( $R_{S}$ $^{eff}$) of$ YBa_2$$_Cu3$$_{7-{\delta}}$ (YBCO) films and the $tan\delta$ of rutile ($TiO_2$) using the 'two-tone'method suggested by Kobayashi et at. [IEEE, MTT-S Digest, 495, (2001)], which enables simultaneous measurements of both the $R_{S}$ $^{eff}$ fof HTS films and the $tan\delta$ of the rutile with high sensitivity. A rutile-loaded cavity resonator with the $TE_{012}$ and $TE_{021}$ resonant frequencies at 13.67 - 14.01 GHz is used for this purpose. At temperatures where the two modes do not couple with other modes, the $R_{S}$ $^{eff}$ of YBCO films and $tan\delta$ of rutile measured by the two-tone method appear to match well with the corresponding values measured using the reported $tan\delta$ values of sapphire within 10 %. Usefulness of the 'two-tone' method for microwave characterization of HTS films and dielectrics is discussed.d.ielectrics is discussed.ussed.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.34D no.3
• /
• pp.60-73
• /
• 1997

By introducing a compressive-strained quanternary InGaAsP quantum-wells instead of a conventional ternary InGaAs quantum-wells in 1.55.mu.m DFB-LD, the lasing performances canb e improved and the problems caused by the thickness non-uniformity and the compositional abruptness among the hetero-interpaces canb e relaxed. In this paper, we investigated an iptimum InGaAsP/InGaAsP multiple-quantum-well(MQW) structure as an active layer in a direct-modulated 1.55.mu. DFB-LD from the view point of threshold current, chirping charcteristics, and resonance frequency. The optimum compressive-strained MQW structure was revealed as InGaAsP/InGaAsP structure with strain amount of about 1.2%, number of wells $N_{w}$ of 7, well width $L_{w}$ of 58.agns.. The threshold current density J of 500A/c $m^{2}$, the linewidth enhancement factor a of 1.8, and differential resonance frequency of d $f_{r}$/d(I-I)$^{1}$2/=2GHz/(mA)$^{1}$2/(atI=2 $I_{th}$) were expected in 1.55.mu.m .gamma./4-shifted DFB-LD with the cavity length of 400.mu.m long and kL value of 1.25. These values are considerably improved ones compared to those of 1.55um DFB-LD with InGaAs/InGaAsP MQW which have enhancement factor and the resonance frequence frequency by the detuning of lasing wavelength and gain-peak wavelength. It was found that the linewidth enhancement factor of 20% and differential resonance frequency of 35% without the degradation of the threshold current density could be enhanced in the range of -15nm~-20nm detuning which can be realized by controlling the thickness and Incomposition of InGaAsP well. well.and Incomposition of InGaAsP well. well.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.37 no.2
• /
• pp.195-201
• /
• 2024

The low-temperature deposition of BaNi_(2-x)Co_xFe₁₆O₂₇ thin films with a Ba hexaferrite structure for electromagnetic shielding was studied. The BaNi_(2-x)Co_xFe₁₆O₂₇ thin films produced through the spin spray process were suitable for thin film deposition on a flexible substrate because it crystallized well at low temperature below 90℃. The change in shielding characteristics depending on the Co content of the BaNi_(2-x)Co_xFe₁₆O₂₇ thin film was investigated, and excellent shielding characteristics with S21 of -1 dB were obtained in a wide frequency range of 26~40 GHz when the Co content was 0.4 or more. The purpose of this study is to analyze changes in shielding properties caused by change in Co content in relation to phase changes in BaNi_(2-x)Co_xFe₁₆O₂₇ and obtain basic data for developing excellent flexible electromagnetic wave shielding materials.