• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.28 no.5
• /
• pp.497-502
• /
• 2015

In this paper, a stress function-based approach was proposed to analyze the reduction of free-edge peeling stress in smart composite laminates using piezoelectric actuator under bending load. Electro-mechanically coupled governing equation was obtained by complimentary virtual work principle. The stress state was solved by the generalized eigenvalue procedure. The free-edge peeling stress of smart composite laminates was reduced by the piezoelectric actuation. The reduction rate of peeling stress in cross-ply composite laminate is larger than that in angle ply composite laminate.

• Korean Journal of Optics and Photonics
• /
• v.12 no.5
• /
• pp.389-393
• /
• 2001

A wavemeter is realized using the fact that the coupling coefficient of a WDM coupler is a function of wavelength. Prototype devices with 1500 nm/1600 nm and 1510 nm/1550 nm WDM couplers are successfully fabricated and tested in the laboratory. The measurement resolutions are $\pm$0.27 nm over a wavelength range of 1515 nm~1576 nm for the device with 1500 nm/1600 nm WDM coupler and $\pm$0.103 nm over a wavelength range of 1520 nm~1543 nm for th4e device with 1510 nm/1550 nm WDM coupler. The dependence of operating characteristics on the input signal power is insignificant. However the temperature dependence is ~0.06 nm/$^{\circ}C$.

• Journal of the Korean Geotechnical Society
• /
• v.29 no.11
• /
• pp.73-84
• /
• 2013

When a slope failure or a debris flow occurs, a shear strength on failure plane becomes nearly zero and soil begins to flow like a non-cohesive liquid. A consistency of cohesive soils changes as a water content increases. Even a cohesive soil existing at liquid limit state has a small amount of shear strength. In this study, a water content, at which a shear strength of cohesive soils is zero and then cohesive soils will start to flow, was proposed. Three types of clays (kaolinite, bentonite and kaolinite (50%)+bentonite (50%)) were mixed with three different solutions (distilled water, sea water and microbial solution) at liquid limit state and then their water contents were increased step by step. Then, their undrained shear strength was measured using a portable vane shear device called Torvane. The ranges of undrained shear strength at liquid and plastic limits are 3.6-9.2 kPa and 24-45 kPa, respectively. On the other hand, the water content that corresponds to the value of the undrained shear strength changing most rapidly is called flow water content. The flow limit refers to the water content when undrained shear strength of cohesive soils is zero. In order to investigate the relationship between liquid limit and flow limit, the cohesive index was defined as a value of the difference between flow limit and liquid limit. The new plasticity index was defined as the value of difference between flow limit and plastic limit. The new liquidity index was also defined using flow limit. The values of flow limit are 1.5-2 times higher than those of liquid limit. At the same time, the values of new plasticity index are 2-5.5 times higher than those of original plasticity index.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2004.05b
• /
• pp.888-892
• /
• 2004

농지, 임야지역에서의 강우유출수 수질의 파악은 수자원 수질관리에 있어서 바탕수질(Background water quality)이기 때문에 물관리에 있어 매우 중요한다. 본 연구는 농지와 임야가 혼합된 도시외곽지역에서 강우시에 발생하는 강우유출수의 수질 및 오염부하량에 대하여 유역특성이 다른 두 지역에서 분석을 실시하였다. 연구 대상 유역은 임야와 농경지가 주를 이루는 지역으로 농지의 비율이 자자 $0.4\%$와 $35.9\%$인 유역이다. 측정은 건기에서부터 강우기 때까지 각 유역 당 10개의 강우 사상에 대하여 실시하였다. 측정 대상 항목으로는 pH, SS, TCOD, SCOD, BOD, TP, TN, $NH_3-N$, $NO_3-N$, $PO_4-P$, Total coliform, Escherchia Coli를 측정하였고, pollutograph, loadgraph을 작성하였다. 분석 결과 농지의 비율이 큰 유역에서 발생하는 오염부하량이 모든 수질 항목에서 높게 나타났으며, SS, 유기물, 미생물 항목에서 초기강우세척철상(first flush)을 보이고 있었다. 또한 측정 자료에 내한 동계분석결과 SS항목과 유기물 항목은 높은 상관관계를 나타내고 있었으며, 강우에 따른 오염부하량은 누승함수, 2차함수의 형태로 증가하였다.

• Korean Journal of Food Science and Technology
• /
• v.31 no.1
• /
• pp.164-170
• /
• 1999

Cracking of rice caused by moisture migration during storage under different relative humidity conditions was investigated for the establishment of safe storage condition of rice. Rice was cracked when a large difference in equilibrium relative humidity $({\Delta}ERH)$ between the rice and the environment was present. External and internal cracks were generated as the results of moisture desorption and adsorption, respectively. The external cracks by moisture desorption generated in all directions and shaped irregularly, while the internal cracks by moisture adsorption did in radial direction and showed a typical shape. The cracking trend could be analyzed by the Weibull function, and the cracking constant increased with ${\Delta}ERH$. The frequency of cracked rice increased linearly with In $({\Delta}ERH)$. The critical crack-inducing ${\Delta}ERH$ was $11.3{\sim}16.4%$ during desorption and $10.8{\sim}17.1%$ during adsorption. A diagram for the safe storage of rice was developed with respect to the initial moisture content and the water activity of rice.

• The Journal of Engineering Geology
• /
• v.20 no.4
• /
• pp.425-436
• /
• 2010

We established a stochastic 3-D fracture network system for fractured rock masses located in Il-Gwang Mine, Busan, to explore the relationship between the acidity of mine drainage and fracture geometry. A field scanline survey and borehole image processing were performed to estimate the best probability distributions of fracture geometry parameters. The stochastic 3-D fracture network system constructed for the rock masses was validated and deemed to be successful. The 3-D fracture network model was suitable for developing conceptual ideas on fluid flow in fractures at a field experimental site. An injection well and three observation wells were drilled at the field experimental site to monitor the acidity of mine drainage induced by the injection of fresh water. The field experiment, which was run for 29 days, yielded a significant relationship (with a high coefficient of determination) between the fracture geometry parameters and the acidity of mine drainage. The results show that pH increased with increasing relative frequency of fracture strike, and decreased with increasing fracture density. The concentration of $SO^{2-}_4$ decreased with increasing relative frequency of fracture strike, and increased with increasing fracture density.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.4 no.4
• /
• pp.349-356
• /
• 1999

This paper presents an instantaneous voltage control scheme of au킹liary power supply system for the electric railway v vehicles, The resonance problem of the LC filter and the existing steady state error are more serious as the use of l instantaneous voltage control techniques for the fast transient response at the nonlinear load, A filter capacitor current f feedback loop is considered to increase the damping ratio of the voltage transfer function for the suppression of the resonance problem of the LC inverter output filter. To eliminate the steady state en‘or existing in case of the AC l instantaneous voltage control. the high gain transfer function is added to the conventional PI controller. The theoretical a analysis is well described with the simulation results. The validity of the proposed schemes is well verified through the s simulation and expelimental results for the 5 kVA prototype.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.15 no.1
• /
• pp.131-137
• /
• 2015

This paper relates with the VSS-MMA (Variable Step Size-Multiple Modulus Algorithm) adaptive equalization algorithm which is possible to improving the equalization performance by use the nonlinear fuction of error signal in the MMA adaptive equalization algorithm that are used for the minimization of the intersymbol interference due to the distortion which occurs in the time dispersive channel for the transmission of QAM signal in the system.. In the conventional MMA, we obtains the tap coefficient of adaptive equalizer using the fixed step size, but in the VSS-MMA, we obtains the tap coefficient of adaptive equalizer using the variable step size based on a nonlinear function of error signal. By adapting the variable step size, it was confirmed that the improved equalization performance were obtained by computer simulation. For this, the equalizer output signal constellation, residual isi, maximum distortion, MSE and SER were used in the performace index.

• Journal of the Korean Society for information Management
• /
• v.25 no.4
• /
• pp.227-243
• /
• 2008

This study investigates an event detection method with the aim of generating an event-focused news summary from a set of news articles on a certain event using a multi-document summarization technique. The event detection method first classifies news articles into the event related topic categories by employing a SVM classifier and then creates event clusters containing news articles on an event by a modified single pass clustering algorithm. The clustering algorithm applies a time penalty function as well as cluster partitioning to enhance the clustering performance. It was found that the event detection method proposed in this study showed a satisfactory performance in terms of both the F-measure and the detection cost.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.16 no.6
• /
• pp.41-47
• /
• 2012

It is very important to predict the nonlinear behavior of combustion instability such as transition phenomena and limit cycle amplitude for fully understanding and controlling the instabilities. These nonlinear instability characteristics are highly dependent upon the flames' nonlinear dynamics in a gas turbine premixed combustor. In this study, nonlinear instability TA(Thermo-acoustic) models were introduced by applying the concept of flame describing function to the thermoacoustic analysis method. As a result of model development, for a given combustor length, the growth rate of instability was greatly affected by the change in amplitude, although the instability frequency was not. Further researches under various operating conditions and model validation on limit cycle amplitude are required.