• Polymer(Korea)
• /
• v.36 no.6
• /
• pp.756-760
• /
• 2012

In this work, the coal tar pitch-based activated carbons (ACs) were prepared by KOH activation for electrode materials of supercapacitor. The effects of activation temperature on electrochemical performance of the ACs were investigated with cyclic voltammogram (CV) measurement. The textural and morphological properties of the ACs were measured by adsorption isotherms and field emission scanning electron microscope (FE-SEM) analyses, respectively. The experimental results indicated that the specific capacitance of the ACs increased with developing the micropore volume by activation temperature. As a result the specific capacitance of the ACs increased, owing to the development of micro pore volume of the ACs.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.9
• /
• pp.1837-1845
• /
• 2015

The longitudinal velocity is necessary for accurate vehicular positioning in urban environment. The pitch angle, which is a road slope, should be calculated to acquire the longitudinal velocity. However, it is impossible to consider very accurate pitch, when using a sensor and an algorithm. That's why process noise and positioning stimation error of IMU should be adjusted to the driving environment and fuse GPS, OBD data with ACF which consist of AKF, CF in this paper. Then, final pitch angle which is appropriate for driving environment is estimated by IMMKF in order to optimize the system model according to road slope models.

• Applied Chemistry for Engineering
• /
• v.27 no.4
• /
• pp.415-420
• /
• 2016

To enhance electrochemical performances of anode materials, the surface of coal tar pitch (CTP) was modified by incorporating heteroatoms through chemical treatment with phosphoric acid ($H_3PO_4$). The prepared anode materials with modified CTP was analyzed by XRD, FE-SEM and XPS. The electrochemical performances of modified CTP were investigated by constant current charge/discharge test, rate performance, cyclic voltammetry and impedance tests using the electrolyte of $LiPF_6$ dissolved in the mixed organic solvents (ethylene carbonate : dimethyl carbonate = 1 : 1 vol% + vinylene carbonate 3 wt%). The coin cell using modified CTP ($H_3PO_4/CTP$ = 3 : 100 in weight) has better initial capacity and initial efficiency (489 mAh/g, 82%) than those of other composition coin cells. Also, it was found that the capacity retention was 86% after 30 cycles and the rate capability was 87% at 2 C/0.1 C.

• Applied Chemistry for Engineering
• /
• v.19 no.1
• /
• pp.73-79
• /
• 2008

An experimental study was conducted to investigate the effect of a tube row, a fin pitch and an inlet humidity on air-side heat and mass transfer performance of louvered fin-tube heat exchangers under wet conditions. Experimental conditions were varied by three fin pitches, two rows, two inlet relative humidities. Experimental results showed that the heat transfer performance decreased and the friction increased with the decrease of fin pitch, for 2 row heat exchanger. The effect of fin pitch on heat transfer performance was negligible with 3 row heat exchanger. The changes in relative humidity was not affected heat transfer and friction. However, the mass transfer performance was slightly decreased with the increase of relative humidity and with the decrease of fin pitch. The mass transfer performance of the louvered fin-tube heat exchanger decreased with the decrease of the fin pitch and was different according to the number of tube row.

• The KIPS Transactions:PartC
• /
• v.18C no.1
• /
• pp.7-14
• /
• 2011

Power analysis attack on low-power consumed security devices such as smart cards is very powerful, but it is required that the correlation between the measured power signal and the mid-term estimated signal should be consistent in a time instant while running encryption algorithm. The power signals measured from the security device applying the random clock do not match the timing point of analysis, therefore random clock is used as counter measures against power analysis attacks. This paper propose a new constant pitch based time alignment for power analysis with random clock power trace. The proposed method neutralize the effects of random clock used to counter measure by aligning the irregular power signals with the time location and size using the constant pitch. Finally, we apply the proposed one to AES algorithm within randomly clocked environments to evaluate our method.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.35 no.1
• /
• pp.11-15
• /
• 2011

In this paper, a methodology for the power control of a wind turbine, which is the variable-speed and variable-pitch (VSVP) control system, is introduced. This control methodology maximizes the capability of the turbine to extract maximum power from the wind in the regions with low wind speeds. Further, it regulates the wind-turbine power as the rated power in the case of the regions with high wind speeds. A simple drive train model is used to design the VSVP control system. The methodology for VSVP control is mechanized by controlling the generator torque and blade pitch. Finally, some simulation results for the VSVP control to a MW wind turbine are discussed in this paper.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.36 no.10
• /
• pp.1147-1154
• /
• 2012

In this study, a method for designing blade pitch and generator torque controllers for a wind turbine generator is presented. This method consists of two steps. First, the Lyapunov stability theory is used to obtain nonlinear control laws that can regulate the rotor speed and the power output at all operating ranges. The blade pitch controller is chosen such that it always decreases a positive definite function that represents the error in rotor speed control. Similarly, the generator torque controller always decreases a positive definite function that reflects the error in power output control. Then, the simulation-based optimization technique is used to tune the design parameters. The controller design procedure and simulation results are presented using the widely adopted two-mass model of the wind turbine.

• Composites Research
• /
• v.29 no.5
• /
• pp.262-268
• /
• 2016

In this work, the pitch-based carbon paper (P-CP) was prepared by re-impregnating of binder pitches and PAN-based milled carbon fibers (MCF) at low temperature carbonization process. The influence of MCF content on physicochemical properties of MCF/P-CP was investigated. As a result, the tensile strength of MCF/P-CP was increased sharply from 10 wt.% to 20 wt.% of MCF. Also, the increase of MCF content led to the decrease of interfacial contact resistivity and the improvement of electrical and thermal conductivity of MCF/P-CP. These results were probably due to the increase of density of MCF/P-CP, resulting in the formation of electrically and thermally conductive paths of the carbon paper.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.34 no.4
• /
• pp.63-69
• /
• 2006

Experimental tests have been done with swirl injector and helical grain configuration to increase the regression rate of hybrid rocket solid fuel. Two types of injector were designed to evaluate the swirl effect of oxidizer stream on the increase in the regression rate. Results showed Type II injector with swirl number of 3.61 induced the better regression rate than Type I injector. Meanwhile, fuels with two different pitch number of 6 and 100 were used to analyzes the flow characteristics on the enhancement of regression rate. Test with fuels of pitch 6 showed better increase in the regression rate than in the pitch 100 when no swirler was imposed. This is due to the generation of strong turbulences in the oxidizer stream along the pitch 6 configuration. However, the regression rate could be increased further in the fuel with pitch 100 than with pitch 6 when swirl flow was imposed by Type II injector. This result implied that the fuel with pitch 100 could take a role of sustainer of the imposed swirl by swirler II instead of turbulence generator.

• Journal of Biomedical Engineering Research
• /
• v.20 no.4
• /
• pp.427-433
• /
• 1999

The purpose of the study is to develop an improved pitch extraction method that can be used in a variety of speech applications such as high-puality compression and vocoding, and recognition and synthesis of speech. To do so, we develop a new electroglottograph (EGG) measurement system that is based on the four modulation-demodulation type spot electrodes for detecting the EGG signals. Then, the glottal closure instant(GCI) is determined from the EGG signals on a real-time basis. We can obtain the pitch contour using the information on the GCI. It turns out that the new pitch contour algorithm (PCA) operates more reliably as compared to the conventional speech-only-based algorithm. In addition, we study the speech source models and glottal vibratory patterns for Koreans by measuring and analyzing the diversified vibration patterns of the vocal from the EGG signals.