• Korean Journal of Food Science and Technology
• /
• v.37 no.6
• /
• pp.889-892
• /
• 2005

Standardized method based on extraction, filtration, and gas chromatography (GC) was developed far propylene glycol analysis to set hygienic norm of safety measure for foods under governmental control. Various columns were tested fur propylene glycol analysis by GC with flame ionization detector. Known amount of propylene glycol was spiked into wheat flour dough and analyzed by developed method. Results showed 101.60% recovery rate for propylene glycol with HP-5 column. Reproducibility test of standards recorded 0.30 for standard variation and 0,42% for relative variation. Using analytical method established, contents of propylene glycol in more than hundred different foods were monitored. Propylene glycol was detected in most foods, indicating propylene glycol is not only commonly added during food preparation, but also is contained naturally in food.

• Clean Technology
• /
• v.20 no.1
• /
• pp.7-12
• /
• 2014

Hydrogenolysis of glycerol to propylene glycol was performed over binary and ternary metal oxide catalysts. The conversion of glycerol and selectivity to propylene glycol were increased on Cu/Zn and Cu/Cr mixed oxides compared to pure CuO and ZnO oxides. The addition of alumina into Cu/Zn mixed oxide very highly increased the conversion of glycerol and selectivity to propylene glycol. The conversion of glycerol was increased with increasing the reaction temperature but the selectivity to propylene glycol was shown to have maximum value at $200^{\circ}C$ and then decreased at $250^{\circ}C$. The conversion of glycerol and selectivity to propylene glycol were decreased with increasing the glycerol concentration.

• Journal of Food Hygiene and Safety
• /
• v.32 no.5
• /
• pp.404-410
• /
• 2017

An analytical method for determination of propylene glycol alginate (PGA) in food products was developed by HPLC-size-exclusion chromatography. The GF-7M HQ column and LT-ELSD detector were determined by considering the instrumental analysis conditions for PGA analysis. The pretreatment method for the analysis of PGA was suitable for 3 hr extraction at $20^{\circ}C$ and 150 rpm according to the extraction temperature. Linearity ($R^2$) for the analysis of PGA was 0.9873 at calibration curve range of 300, 500, 700, 1,000, and 1,500 mg/kg (5 points). The limit of detection and limit of quantification of PGA on HPLC system was 171.43 and 519.50 mg/kg, respectively. The accuracy and coefficient of variation obtained by size-exclusion chromatography were 86.1~110.4% and 4.1~13.5%, respectively. By applying the HPLC-size-exclusion chromatography system, it was possible to analyze the contents of PGA in 134 different types of food products.

• Clean Technology
• /
• v.17 no.3
• /
• pp.244-249
• /
• 2011

We synthesized low molecular-weight polymers bearing hydrophobic and hydrophilic parts in a chain through $CO_2$/propylene oxide copolymerization. When hydrophilic poly (ethylene glycol) bearing -OH group (s) at the end group (s) was added as a chain transfer agent in the $CO_2$/propylene oxide copolymerization catalyzed by a highly active catalyst, block polymers were formed. If poly (ethylene glycol) (PEG) bearing -OH group only at an end was fed, PEG-block-PPC diblock copolymer was obtained. When PEG bearing -OH group at both ends was fed, PPC-block-PEG-block-PPC triblock copolymer was obtained. We confirmed formation of block copolymers by $^1H$-NMR spectroscopy and GPC studies.

• Journal of Energy Engineering
• /
• v.9 no.3
• /
• pp.221-227
• /
• 2000

본 논문은 냉각된 원관내에서 유동하는 프로필렌글리콜 수용액의 제빙에 관하여 실험한 것이다. 실험은 수용액의 질량농도, 수용액의 유속, 관벽의 온도, 펌프의 압력 등을 변화시키면서 행하였다. 그 결과 관내에서의 제빙량은 프로필렌글리콜 수용액의 관내유속, 벽면과 냉각도 및 수용액의 농도에 영향을 받고 있었고, 수용액의 질량농도가 낮을수록 또 시험수용액의 유속이 빠를수록 관내에서의 제빙량은 증가하는 경향을 띄었다. 그리고 관내제빙율에 영향을 미치는 인자들의 효과를 검토하여 관내제빙율에 관한 우차원식을 얻었다.

• 월간낙농육우
• /
• v.29 no.3
• /
• pp.128-129
• /
• 2009

• The Journal of the Acoustical Society of Korea
• /
• v.40 no.5
• /
• pp.408-416
• /
• 2021

In the ultrasonic dispersion, in order to avoid direct contact of the radiation surface of ultrasonic transducers with a liquid sample, the liquid sample is separated by a glass container and it receives ultrasonic energy through an acoustic medium. The transmission efficiency of the ultrasonic energy in the multi-layered ultrasonic system is an important factor. In this study, we suggested a method that can improve the ultrasonic energy transfer efficiency by using a propylene glycol solution as a liquid matching layer in the multi-layered acoustic system. In this method, a propylene glycol solution was filled between the Langevin-type ultrasonic transducer and the luminol solution and the sonoluminescence phenomena in the luminol solution, which is caused by nonlinear effect of high power ultrasound radiated from the transducer, was examined by using a Photo Multiplier Tube (PMT). The transmission efficiency depending on the concentration of propylene glycol solution was observed, and we can see that as the concentration of the propylene glycol solution increased, the matching effect increased while the acoustic attenuation increased. It was confirmed that there is an optimal concentration compromised these two conflicting conditions, and the optimum concentration of the propylene glycol solution was determined experimentally.

• Applied Chemistry for Engineering
• /
• v.30 no.3
• /
• pp.384-388
• /
• 2019

In winter season, the snow and ice accretion on the bottom of the high speed railway rolling stock and boogie part has fallen at a high speed from the ballast section (gravel section for the transmission of the rolling stock load received by sleepers and fixing sleepers), causing the gravel to be scattered, thereby damaging the railway rolling stock structures and facilities. In order to solve these problems, the gravel scattering prevention net, manual de-icing, and movable hot air machine were used, but their efficiency was low. For the more efficient de-icing than ever before, an optimum material for de-icing fluid for high speed railway rolling stock was developed by evaluating the ice melting capacity, kinematic viscosity, evaporation of the material used as a chemical de-icing fluid. Four kinds of organic acid salts (sodium formate, sodium acetate, potassium formate and potassium acetate) and two different alcohols (propylene glycol, glycerol) were used as evaluation materials. Potassium formate, potassium acetate, and propylene glycol had similar ice melting capacities in the indoor test, but the propylene glycol showed the best ice melting capacity in spraying the system simulation test. This is because the kinematic viscosity of propylene glycol was 2.989029 St, which is higher than those of other materials therefore, it could stay longer on the ice and de-icing. In addition, potassium formate and potassium acetate were difficult to be used since the crystals precipitated and adversely affected the appearance of the rolling stock. The propylene glycol is the most optimum as an de-icing fluid for the high speed railway rolling stock.

• Applied Chemistry for Engineering
• /
• v.34 no.1
• /
• pp.69-74
• /
• 2023

As a chemical de-icing method, propylene glycol de-icing fluid is applicable for melting ice caused by snow and ice adhering to the lower part of high-speed rail rolling stock and bogie parts in winter. By spraying propylene-glycol de-icing fluid on high-speed rail rolling stock and bogie parts in advance to minimize snow adhesion, ice-melting efficiency can be further improved. In the case of high-speed rail rolling stock, even if propylene-glycol de-icing fluid is sprayed, the anti-icing performance is poor because the fluid is almost lost on the surface of the vehicle when operating at high speed. In this study, in order to prevent freezing caused by snow and ice adhering to the lower part of high-speed rail rolling stock and bogie parts, we have investigated the properties of propylene-glycol de/anti-icing fluid containing water-repellent agents that prevent surface freezing. We tried to find the optimal component for de/anti-icing fluid for high-speed rail rolling stock by evaluating the ice melting performance, contact angle, and anti-icing performance according to the types of water-repellent agent. As a result of the evaluation, it was confirmed that an de/anti-icing fluid containing an ethoxysilane-type water repellent agent was most suitable.

• Journal of the Korean Applied Science and Technology
• /
• v.29 no.1
• /
• pp.54-62
• /
• 2012

In this experiment, the optimum concentration of polyols which were used for making transparent soaps was determined using design of experiment (DOE) method. Dipropylene glycol and 1,3 butylene glycol with short chains enhanced the transparency of soap, however, polyethylene glycol 400, glycerin and diglycerin made the soap opaque. The hardness of soap was increased as increasing the concentration of propylene glycol, diglycerin, dipropylene glycol and polyethylene glycol 400. The hardness, transparency, absorbance of water, and friction solubility could be optimized by controlling the concentration of dipropylene glycol, polyetylene glycol, sugar, and triethanolamine.