• Journal of the Korea Society of Computer and Information
• /
• v.15 no.6
• /
• pp.65-72
• /
• 2010

In ad-hoc network, the technique to efficiently consume the limited amounts of energy is an important issue since the wireless terminal node is operated on batteries as their energy resource. In order to extend the system lifetime, through a balanced energy consumption, we must delay the situation in which a particular terminal node's energy is depleted and results in system disconnection. Also, the link, which has low reliability due to the mobility of the node, should be avoided considering the key element when setting up the route. The proposed CMLR method in this paper enables to increase the efficiency of energy consumption with a new cost function considering the residue energy of node, error rate of link, and transmission energy consumption. This method is extending the network lifetime and increasing the energy efficiency by compromising the value between the minimization of the transmission energy consumption and maximization of the node's lifetime. Through the simulations the proposed CMLR algorithm was verified by showing better performance over the conventional methods in terms of network lifetime and path efficiency.

• Journal of IKEEE
• /
• v.21 no.4
• /
• pp.338-347
• /
• 2017

This paper describes the design and fabrication of a high power amplifier which is a component of TDL(Tactical Data Link) aircraft terminal. We applied high-speed frequency hopping technology, cognitive radio technology, and receive filter bank technology to efficiently use limited frequency resources with radar and other communication equipment using the same frequency band. The high-power amplifier is physically composed of a transmitter, a receiver, a mechanical part, and a cable assembly, and is designed to meet temperature characteristics and electrical characteristics such as maximum transmission distance and reception sensitivity. Modeling and simulator were used to satisfy the requirement of high power amplifier. The transmit power and the noise figure were measured at 50.02dBm and 2.682dB, respectively. It was confirmed that all the required specifications were satisfied in the electrical characteristics test and the environmental characteristic test.

• 한국HCI학회:학술대회논문집
• /
• 2008.02c
• /
• pp.150-151
• /
• 2008

With the proliferation of vehicles and advancement of Information Technology, the technology of Telematics, which provides valuable services to people by collecting and analyzing the information from drivers, vehicles and Telematics environments (e.g. traffic information, road condition, weather information, etc.), has been a hot research area in IT and automotive recently. As the information technology revolution brings more and more assistance for driver information processing becomes increasing important. Therefore, drivers' workload is very essential factor for safety driving in Telematics environment. For managing drivers' workload effectively, ETRI haven been developing vehicle and driver management system which can collect data from drivers and vehicle in realtime and analyze the data to manage drivers' and vehcles' status since 2007. This technology will apply to commercial vehicle telematics such as texi or truck management system in the future for increasing driving safety. In this presentation, I would like to explain what we had developed so far and discuss future direction.

• Convergence Security Journal
• /
• v.13 no.4
• /
• pp.11-17
• /
• 2013

All u-Health system has security vulnerabilities. This vulnerability locally(local) or network(network) is on the potential risk. Smart environment of health information technology, Ad-hoc networking, wireless communication environments, u-health are major factor to increase the security vulnerability. u-health care information systems user terminal domain interval, interval public network infrastructure, networking section, the intranet are divided into sections. Health information systems by separating domain specific reason to assess vulnerability vulnerability countermeasure for each domain are different. u-Healthcare System 5 layers of security risk assessment system for domain-specific security vulnerability diagnosis system designed to take the security measures are needed. If you use this proposed model that has been conducted so far vaguely USN-based health information network security vulnerabilities diagnostic measures can be done more systematically provide a model.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.7
• /
• pp.1131-1137
• /
• 1999

In this paper, a novel design method of an apertured coupled microstrip patch antenna with the single feeding structure is proposed for dual resonance frequencies with mutually perpendicular polarizations. The characteristics of this antenna are experimentally investigated. In order to achieve this goal, a new type of square patch with double notches is used as a radiator and the crossed slot and the bended mictrostrip feeder are adopted for the dual polarizations in the aperture-coupled structure. For the application of the proposed antenna, a Ku-band Tx/Rx $2\times$ subarray antenna is designed and manufactured. Also, the applicability of the antenna as a ground terminal is examined through performance analysis. According to the measurement, the gain of the antenna is 10dBi at the center frequencies of Tx and Rx, the side lobe level is lower than -13dB, and the cross polarization lebel is below 17 dB.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.7
• /
• pp.726-733
• /
• 2010

This paper propose the printed inverted-F antenna using the coupling feed for the mobile phone. The coupling feed can normally leads the additional capacitances in the antenna, so the high inductive reactance of the antenna can be partly compensated. In this paper, it is shown that the bandwidth of the proposed antenna using the coupling feed is improved at $824{\sim}960$ MHz and $1,710{\sim}2,390$ MHz. Then it is compared with the simple direct feed to confirm the improvement of the bandwidth. The proposed antenna covers GSM850/GSM950/DCS/USPCS/WCDMA/Wibro and has the maximum gain of －$4.794{\sim}1.648$ dBi and shows omnidirectional patterns over the operating bands.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.17 no.4
• /
• pp.485-491
• /
• 2014

An Antenna & RF system for a fly-away satcom terminal application on ka-band is presented in this paper. The Fly-away satellite terminal can be moved and operated by two person and adapt automatic satellite tracking system in order to decrease the tracking time. Additionally, for low-power consumption, compact size and light-weight, a dual reflector antenna is constructed using dual-offset gregorian antenna structure. For minimize weight, the reflector of the antenna is made of Magnesium. For low-power consumption and light-weight, the pHEMT MMIC compound devices is utilized. The Electronic Band-Gap(EBG) Low-Pass Filter(LPF) is designed for harmonic rejection. In the receiving part, Low-Noise Block converter(LNB) structure is designed for compact and lightweight. In this paper, fly-away satcom terminal with low-power consumption, compact size and light-weight is described with antenna system and RF system performances. Through the experimentation, fly-away terminal's EIRP is more than 50dBW, G/T is more than $17dB/^{\circ}K$.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.8 no.5
• /
• pp.1000-1006
• /
• 2007

This paper presents a power detector circuit which monitors the transmitting power for the application in CDMA cell phones. The proposed power detector are composed of coupler for coupling output power and detector fur monitoring output power. The designed coupler has low loss characteristic because it adopts the stripline structure which consists of two ground planes at both sides of signal plane. The design frequency is 824-849MHz which is the Tx band fur CDMA mobile terminal, and the coupling factor of the stripline coupler is -20dB. A schottky barrier diode is adopted for detector design because of its high speed operation with minimized loss. The required impedance matching is performed to improve the linearity and sensitivity of output voltage at relatively low detector input level where the nonlinear characteristic of diode exists. The package parasitics as well as intrinsic diode model are considered for simulation of the detector. The predicted performances agree well with the measured results.

• Journal of KIISE:Information Networking
• /
• v.36 no.3
• /
• pp.163-172
• /
• 2009

Various terminals equipped with multiple interfaces may receive services from wireless networks when they pass through the overlaid heterogeneous networks, and thus the vertical handovers across the wireless networks increases, which will become a big problem in the network resource management. This problem can be efficiently solved by common radio resource management (CRRM). In this paper, we propose two operation algorithms based on network selection jointly with vertical handover as the key CRRM strategies. When a new user tries to get services, the CRRM can choose the best target network according to the proposed Integrated Network Selection Algorithm. When the network cannot satisfy the request from the new users, the proposed Integrated Vertical Handover Algorithm moves existing users to neighborhood networks to accommodate new users. The performance of the proposed algorithms has been validated through extensive simulations.

• The KIPS Transactions:PartA
• /
• v.16A no.5
• /
• pp.389-394
• /
• 2009

Lately the usage of multimedia equipment with small LCD displays is rapidly increasing. Although many people use devices like this, videos intended for TV or HDTV are sent to these mobile devices. Therefore cases where it is hard for the user to view the desired scenes are growing more frequent. Currently, most services simply reduce the size of the content to fit the screen when they offer it for mobile devices. However, especially with sports broadcasts, there are many areas that cannot be seen very well because it was simply reduced in size. We therefore consider this weakness and are researching how to let the user choose an area of interest and then sending it to the user in a way that fits the device. In this paper, we address the problem of video delivery and personalization. For the delivered video content, we suggest the UP-SAM User Personalized Context-Aware Service Adaptation Middleware) model that uses the video content description and MPEG-21 multimedia framework.