• Journal of Energy Engineering
• /
• v.24 no.4
• /
• pp.89-96
• /
• 2015

Recently, much research has been put into finding the causes and solutions of slagging/fouling problems that occur at the end of the boiler. This slagging/fouling, caused by low-rank coal's ash, disturbs the thermal power and greatly reduces efficiency. In environmental aspects, such as NOx pollution, governments have been implementing restrictions on the quantity of emission gases that can be released into the atmosphere. To solve these problems, research on Ash Free Coal (AFC), which eliminates ash from low-rank coal, is in progress. AFC has advantages over similar high-rank coals because it increases the heating value of the low grade coal, reduces the contaminants that are emitted, and decreases slagging/fouling problems. In this study, using a DTF, the changes of NOx emissions, unburned carbon, and the characteristics of ash deposition were identified. KCH raw coal, AFC extracted from KCH, residue coal, Glencore, and Mixed Coal (Glencore 85wt% and residue coal 15wt%) were studied. Results showed that AFC had a significantly lower emission of NOx compared to that of the raw coal and residue coal. Also, the residue coal showed a higher reactivity compared to raw coal. And finally, In the case of the residue coal and mixed coal, they showed a lower ash deposition than that of low-rank coal.

• The Journal of Natural Sciences
• /
• v.8 no.2
• /
• pp.119-127
• /
• 1996

The effect of sodium hydroxide treatment on some physicochemical properties of zeolite mordenite mineral was studied with chemical analyses, powder X-ray diffraction, thermal analyses, infrared analysis, measurement of carbon dioxide adsorption and gas chromatography. Mordenite mineral from tuffaceous rocks in Yeongil and Wolsung area was used as a starting material and treated with 0.1-5N NaOH aqueous solution at about $95^{\circ}C$ in the water bath for three hours.At the concentration of sodium hydroxide below 0.5N, all chemical compositions in the tuff were virtually insoluble and the mordenite structure did not change. At the concentration above 1N, the chemical compositions such as silica, alumina, etc., were dissolved. The dissolution ratio of silica was lager than that of alumina, and the ratio of silica to alumina in the tuff decreased sharply in the concentration range of 2 to 3N. Intensity of X-ray diffraction peak of mordenite (202) plane and the adsorbed amount of carbon dioxide also decreased with the increasing concentration of sodium hydroxide above 1N. These decreases corresponded to the degree of mordenite structure collapsed.The separation of gas chromatography of nitrogen, oxygen and carbon monoxide was not affected by the sodium hydroxide treatment, but elution peaks of methane and krypton tended to be broadened and their retention time was shortened. The elution peaks of both methane and krypton tended to be overlapped with those of nitrogen and oxygen.

• Clean Technology
• /
• v.23 no.2
• /
• pp.133-139
• /
• 2017

Bio-based plastics containing the biomass content higher than 25 wt% have been considered as environment-friendly materials due to their effects on the reduction in the $CO_2$ emission and petroleum consumption as well as biodegradability after use. In this study, poly vinyl chloride, plant-derived plasticizers, by adding a biodegradable catalyst was observed a change in the biodegradability and physical properties. To produce the oxidative decomposition transparent bio film, which is broken down in the initial percent elongation and physical properties such as tensile strength, it was to test the safety of the product as a food packaging material. Poly vinyl chloride, primary plasticizer, secondary plasticizer, anti fogging agent, the combined stabilizer were mixed in a high speed mixer, then extruded using an extrusion molding machine, after cooling, winding, to produce a oxidative decomposition transparent bio film and the control film, with a thickness of $12{\mu}m$ through winder role. Mechanical properties tensile strength, elongation, and the maximum load elongation and biodegradation test. Transparent bio film produced by biodegradation catalyst is compared with the control film. Tensile strength and elongation of films were found to be no significant difference. Further, as a result of the biodegradation test for 45 days based on the ASTM D6954-04 method, biodegrability of film is 61.4%.

• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.7
• /
• pp.757-763
• /
• 2006

In our previous studies, we have isolated bacteria from BTEX-contaminated sediment, which utilized BTEX as a sole carbon source and $NO_3$-N as an electron acceptor. For the possibility of field application, we have applied co-culture of those isolates in the BTEX-contaminated soil and evaluated their biodegradation efficiencies. To investigate the relationship between the isolates and indigenous microorganism in soil, changes of microbial community structure in soil samples with respect to time were monitored. To examine this, soil samples were artificially contaminated with benzene, toluene, ethylbenzene and o-xylene. BTEX-degrading bacteria such as Pseudomonas stutzeri strain 15(DQ 202712), Klebsiells sp. strain 20(DQ 202715) and Citrobacter sp. strain A(DQ 202713) were injected into the soil samples in the ratio of 2:1:1. Our results showed that the highest BTEX biodegradation efficiency was achieved when both BTEX and $NO_3-N$ existed simultaneously. The change in soil microbial community structure was characterized by PCR-DGGE analysis comparing the relative DGGE band intensities. The band intensities of indigenous microorganisms in the soil were reduced by injecting co-culture of the three isolates. On the contrary, the relative band intensities of the isolates were increased. Among the three isolates, Pseudomonas stutzeri strain 15 rendered the highest band intensity. This indicates that the Pseudomonas stutzeri was the dominant microbial species found in the soil samples.

• Composites Research
• /
• v.27 no.5
• /
• pp.190-195
• /
• 2014

This paper predicts the complex permittivity of MWNT added epoxy depending on agglomeration by numerical analysis. 1wt% MWNT added epoxy specimen is prepared using 3-roll-mill method and its complex permittivity is measured in X-band (8.2~12.4 GHz) using freespace measurement system. The analytic model is comprised of cube epoxy and perfect sphere agglomeration. The complex permittivity of the agglomeration model is predicted by complex permittivity mixing rule using the measured complex permittivity of epoxy and 1 wt% MWNT added epoxy. Commercial electromagnetic analysis software, CST, is used to obtain S-parameter of the analytic model and MATLAB code is used to calculate complex permittivity from the S-parameter. It is confirmed that the complex permittivity increases when the agglomeration size decreases.

• KSBB Journal
• /
• v.9 no.3
• /
• pp.325-331
• /
• 1994

PGA is formed in a route of CO2 fixation of RuBP catalyzed by RuBPCase, followed by reduction of the PGA by NADH to GAP This reduction is enhanced in an anionic micellar solution(SDS), in which NADH is distributed in the aqueous and the micellar pseudophases in a given ratio. This micellar bounded NADH reacts to PGA, and in higher micellar concentration than $1.25{\times}10^{-2}M$, most of NADH is oxidized to NAD+ by PGA. On the other hand, in the solutions of the positive ionic(CTABr), zwitter ionic(Chaps) and nonionic (Brij and Triton X-100) micelles, the reactions are also enhanced and the concentrations of NADH reach minima with micellar concentrations. Such minima are typical of micellar catalyzed bimolecular reactions, and the fall in concentrations of the reductant followed by a gradual increase is charataristic of reactions of hydrophobic substrates: that is, the reductions of PGA by NADH are sharply enhanced in a range of the lower micellar concentrations, and NADH amounts in ca. $1.25-2.50{\times}10^{-3}M$ micellar solutions are reached to minima, followed by gradual increases of the reductant concentration.

• Journal of Life Science
• /
• v.13 no.6
• /
• pp.865-870
• /
• 2003

Opuntia ficus-indica is widely used as folk medicine for burned wound, edema and indigestion, etc. After the adaptation of rats for seven days, OF (200mg/kg) was administered into rats intraperitoneally every day for two weeks. On the 14th day, $3.3m\ell$ of $CCl_4$ (50% $CCl_4$ : Olive oil = 1 : 1) was treated to rats and on the 15th day, they were operated. We measured the levels of total cholesterol, HDL-cholesterol, LDL-cholesterol, total lipid and triglyceride (TG) in serum and Malondialdehyde (MDA) in liver tissue. Opuntia ficus-indica and $CCl_4$-treated group (OFC) significantly decreased lipid peroxidation by 32.6% compared to $CCl_4$-treated abnomal group (CTA). Total lipid and TC of OFC administered group were lower than those of CTA group. Cholesterol levels showed significant effect in OFC group. Total cholesterol and LDL-cholesterol in OFC administered group were decreased by 12.7% and 17.4%, respectively, compared to those of CTA group. HDL-cholesterol in OFC administration group was increased by 19.7% compared to CTA group. This finding suggests that lipid peroxidation was inhibited in the significant level when $CCl_4$-induced rats were treated with OF. Based on this analysis, further study to identify the active components in this sample is warranted.

• Korean Journal of Microbiology
• /
• v.33 no.2
• /
• pp.142-148
• /
• 1997

Mrthylov~orits sp. starin SSl, a restricted facultative methylotrophic bacterium. growing on methanol was found to produce small amount of extracellular polysaccharide (EPS) under the optimal growth conditions, while it produced large amount of the polysaccharide under nitrogen limihtion. The optimal ratio of carbon to nitrogen for EPS production were found to be 5.2. The optimal temperature and pH for EPS production were 30^{\circ}C.$ and 6.5, spectively. The EPS consisted of carbohydrate, protein and small amount pyruvic acid. The reducing sugars in the EPS consisted mainly of glucose and a small amount of mannose. The EP!; treated with ethanol (EPSae) was found to have several properties different from those of the EPS which was not treated with ethanol (EPSbe); the EPSae contained no pyruvic acid. It also contained less protein and showed much lower viscosity than the EPSbe. The viscosity of EPSbe was very sensitive to NaCl and decreased t;harply upon exposure of the polysaccharide to even 0.5% (wiv) NaCl solution. The viscosity, however, was increased irreversibly upon exposure of the saccharide to high temperature. The molecular weight of EPS was estimiited to be $2.5{\times}$10^6$ - $3.5{\times}*$10^6$ using Sepharose hB column chromatography. Scanning electron microscopy revealed that the lyophilized EPSbe and EPSae have a structure of thread-like fibers and a mesh-like structure resembling bee-hive, respectively.

• Journal of the Korean earth science society
• /
• v.29 no.4
• /
• pp.328-340
• /
• 2008

To discriminate the provenance of shelf sediments in the western part off Jeju Island, the textual and elemental compositions were analyzed and compared with the sediments originating from Changjiang and Huanghe Rivers of China and the Korean (Keum) River. The sediments in the study area are composed of coarse silt with a mean pain size of $3.6{\sim}8.5{\phi}$ and their $CaCO_3$ contents ranged from 0.92 to 9.75 wt.%. The ratios of TOC over total nitrogen (TN) showed that the study area sediments contained more organic matters of marine origin than those of terrigenous origin. The high concentration of Fe/Al, Ti/Al and Mn/Al figures were found in the southwestern part near the Changjiang esturay, indicating that it seemed to result from the influence of the Changjiang River. The discrimination diagrams including Sc/Al vs Cr/Th, Th/Sc vs Nb/Co and Ti/Nb vs Th/Sc were thus used as provenance indicators to identify the sediment origins of the western part off Jeju Island. Based on these discriminated diagrams it clearly showed that most of the sediment in the western part were originated from the Huanghe River, but the sediments in the southwestern part near the Changjiang esturay might come from the Changjiang River. In contrast, the sediment samples of the northeastern part showed the higher figures than those of the river sediments and other regions, suggesting that the sediments in the western part off Jeju Island must be originated from diverse sources.

• Korean Chemical Engineering Research
• /
• v.51 no.3
• /
• pp.394-402
• /
• 2013

The new complex catalysts were synthesized by the reaction of titanium compounds (titanium chloride or titanium butoxide) and diamines in this work, and they showed very high catalytic activities for the cyclododecatriene (CDT) synthesis from 1,3-butadiene through trimerization. CDT synthetic reaction was performed in an autoclave reactor, and the effects of reaction temperature, type of catalyst, catalyst amount added into the system, the mole ratio of Al/Ti and immobilization method were investigated on the yield of product CDT. The titanium complex catalyst combined to diamine with 1:1 ratio showed high selectivity to CDT more than 90%. The ratio of TTT-CDT/TTC-CDT isomers in the product revealed as different values, depending on the type of diamine combined to titanium and Ti/diamine ratios. Those homogeneous complexes could be used as a heterogenized catalyst after anchoring on the supports, and the immobilized titanium catalyst retained the catalytic activities for several times in the recycled reactions without leaching. The carbon support containing titanium has exhibited superior activity to the silica support. Especially, when the titanium complex was anchored on the support which was fabricated by the hydrolysis of tripropylaminosilane itself, the resulting titanium catalyst showed the highest BD conversion and CDT selectivity.