• 한국신재생에너지학회:학술대회논문집
• /
• 2005.06a
• /
• pp.622-625
• /
• 2005

본 연구의 목적은 동해 울릉분지 천부퇴적층의 공극수와 메탄의 특징 및 상호작용을 규명하는데 있다. 울릉분지에서 채취한 코어에서 공극수를 추출하여 분석한 결과, 공극수의 황산염 농도가 퇴적물의 심도가 증가할수록 감소하며, 감소하는 경향은 크게 세 가지 (직선성, concave down, upward kink)로 나뉨을 알 수 있었다. 이는 모든 코어에서 황산염 환원작용이 일어나고 있음을 지시한다 황산염 농도의 수직적 구배를 이용하여 SMI (sulfate-methane interface) 심도를 계산하면, 남부울릉분지가 북부울릉분지보다 낮은 값을 갖는다. 반면에 메탄 농도는 퇴적물의 심도가 증가할수록 전반적으로 증가하며, 공간적으로는 남부 울릉분지가 북부울릉보지보다 높다. 또한 남부울릉분지에서 메탄가스 농도는 SMI 심도 아래에서 급격히 증가한다 메탄가스의 탄소 안정동위원소$(\delta^{13}C)$ 분석 값들은 대부분 $-60\%_{\circ}$이하로서 이는 메탄가스가 열기원 보다는 박테리아기원임을 지시해준다 또한 남부 울릉분지에서 메탄의 탄소 안정동위원소 분석 값들은 메탄농도가 증가할수록 낮은 값을 보여 주는 데 이러한 결과들은 남부 울릉분지에서 무산소 메탄 산화작용이 일어나고 있음을 지시하고, 메탄의 상향 분산 (diffusion)량이 북부 울릉분지보다 많이 일어난다는 것을 의미한다. 공극수내 황산염 이온 농도 구배와 메탄가스 농도를 종합적으로 고려할 때, 울릉분지에서 가스하이드레이트의 부존가능성은 북부 울룽분지보다 남부 울릉분지가 높은 것으로 추정된다.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.5 no.4
• /
• pp.323-336
• /
• 2003

Recently, the development of tunnel reinforcement method has been required relating to the shallow tunnelling in soft ground. In this study, the improvement method on tunnel stability is proposed by evaluating the efficiency of face reinforcement which enables to control extrusion of advance core, however, it is often neglected in urban tunnelling under the poor ground conditions. Systematic pre-confinement ahead of the face improves the tunnel stability, subsequently, displacement of the crown and surface settlement can be restrained by proper method. 3-dimensional numerical analysis including horizontal reinforcement modelling on a face is applied to estimate the behaviour of a tunnel in relation to the ground and reinforcement conditions. Consequently, extrusion at the face decreases significantly after using the horizontal reinforcement and the effect of reinforcement is much increased in case of applying the supplemental reinforcement ahead of the face together. Especially, confinement effect around the tunnel and the core is proved by means of the core reinforcement in poor ground conditions.

• Tunnel and Underground Space
• /
• v.21 no.1
• /
• pp.20-32
• /
• 2011

Failure aspects of cut-slope, which induce the sequential collapses during the excavation stage, have been analyzed. Slope rock structures are investigated by examining the orientations and positions of discontinuity planes calculated based on the BIPS image inside the boreholes. Drilled core log has been also used to identify the structural defects. Clay minerals of swelling potentials are detected through XRD analysis. Numerical analysis for slope stability has been performed by utilizing the joint shear strength acquired from the direct joint shear test. Cut-slope collapse characteristics have been studied by investigating the posture of failure-prawn joint planes and the stability of tetrahedral blocks of different sizes. Cross-section analysis has been also performed to analyze the cut-slope behavior and to estimate the amount of reinforcement required to secure the stability of cut-slope. Behavior of reinforced cut-slope is also investigated by analyzing the slope monitoring data.

• Journal of dental hygiene science
• /
• v.14 no.1
• /
• pp.29-34
• /
• 2014

The purpose of this study was to evaluate the influence of low temperature degradation (LTD) on the bonding strength of yttria-stabilized tetragonal zirconia polycrystal (Y-TZP). The push-shear bond test method was used to investigate the core-veneer bonding strength of industrially manufactured Y-TZP core ceramic and manufacturer recommended veneering ceramic. Four groups from ceramic-zirconia specimens (n=28; n=7 per group) were assigned into four experimental aging conditions, namely storage in an autoclave at $134^{\circ}C$ for 0, 3, 5, 10 hours. Bonding strength was obtained using a universal testing machine with crosshead speed 0.5 mm/min. Data were statistically analyzed using one-way ANOVA and Tukey's test (${\alpha}=0.05$). In bonding strength test, the group which was treated with LTD showed lower bonding strength than no treated group. The ceramic-zirconia bonding strength was affected by LTD (p<0.05). Digital microscope examination of the fracture surface showed mixed failures with adhesive and cohesive types in LTD with treated Y-TZP groups.

• Journal of the Institute of Convergence Signal Processing
• /
• v.11 no.1
• /
• pp.53-62
• /
• 2010

Recently, various industrial embedded systems including vehicles controlled electronically are evolving to distributed multi-micro controller system. Accordingly, there is a need for standard CAN(Controller Area Network) protocol that ensures high stability and reliability of communication and is simple to construct object-oriented system with high control efficiency. CAN communication interface used general-purpose processor doesn't have many limitations in various application development because of fixed hardware architecture. This paper design and implement a CAN communication interface system based on FPGA. It is verified function and performance of system through monitoring communication with existing AT90CAN128 controller. Implemented CAN communication interface can be reused in development of application systems based on FPGA. And it provides low-cost, small-size and low-power design advantages.

• The Journal of Engineering Geology
• /
• v.19 no.3
• /
• pp.287-294
• /
• 2009

To be design the slope, the area distributed the mica schist which was metamorphosed by shale or mudstone must carefully consider the stability. Mica schist is another unstable rock for slope by schistosity, cleavage, axial plane of a fold etc. In general mica schist contains the swelling clay minerals such as smectite, vermiculite and montmorillonite. These minerals make the slope unstable. At OO tunnel construction area for the rail way of the Kyungbu high speed train, the slope of mica schist is very unstable by the distribution phenomena of the discontinuous plane such as joints which are 1-5 cm spacing and thrust and strike-slip fault. By the drilling core of this area, most RQD have 0-20%.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.7 no.4
• /
• pp.349-357
• /
• 2019

Controlled low strength material(CLSM) has been developed using variety of material such as excavated soil, industrial by-product and industrial waste. But theses research limited at laboratory test and failed at commercialization. So in this paper evaluates CLSM used excavated soil characteristics such as flowability, bleeding rate, early strength for following process and 28day strength for re-excavatability. Also, various mix proportion of CLSM by water-binder ratio and soil-binder ratio were evaluated in laboratory. And derive the optimized CLSM mix proportion for using at field application test by movable batch plant. After applying CLSM at trench, evaluate core sample strength and excavatability by shovel, pickax and excavator for verify re-excavation. Furthermore, measure the level change after casting CLSM to inspect subsidence stability. As results of these assessments, not only confirmed the characteristics of CLSM at field but the fillability around pipe and subsidence stability.

• Journal of the Korean Society of Physical Medicine
• /
• v.8 no.3
• /
• pp.417-424
• /
• 2013

PURPOSE: We investigated the relationship between the segment of erector spinae during a core stability exercise according to visual control. METHODS: The subjects of this study were 20 healthy students. An 8-channel electromyograph was used to measure muscle activities of the erector spinae by segment(cervical, thoracic and lumbar) during a core stability exercise according to visual control. The collected data were analyzed using the independent t-test and Pearson-test. RESULTS: The activity of the erector spinae for all segment was higher without the vision than with. The activity of right cervical erector spinae was significantly increased by increasing the activity of the left thoracic erector spinae during a core stability exercise with vision (r= .555). The activity of left thoracic erector spinae was significantly increased by increasing the activity of the left lumbar erector spinae during a core stability exercise without vision (r= .472). CONCLUSION: There was a positive correlation between the cervical and thoracic segment of erector spinae during a core stability exercise with vision. There was a positive correlation between the thoracic and lumbar segment of erector spinae during a core stability exercise without vision.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.08a
• /
• pp.196-196
• /
• 2012

염료감응 태양전지는 실리콘 태양전지에 비해 단가가 낮고 반투명하며 친환경적 특성으로 차세대 태양전지로 주목을 받았으나 염료의 안정성의 문제와 특정 파장대의 빛만 흡수하는 단점을 가지고 있다. 이러한 문제점을 해결하기 위하여 양자구속 효과에 의해 크기에 따라 밴드갭 조절이 용이하여 다양한 파장대의 빛을 흡수 할 수 있는 양자점 감응태양전지가 많은 관심을 받고 있다. 하지만 양자점 감응 태양 전지의 활성층으로 사용되는 반도체 산화물인 이산화티타늄의 두께는 $13{\sim}18{\mu}m$로 짧은 확산거리로 인해 전하수집의 한계를 가지고 있다. 이를 극복하기 위해 인듐 주석 산화물 나노선을 합성하여 전자가 광전극에 직접유입이 가능하도록 해 빠른 전하이동 및 전하수집을 가능하게 한다. 인듐 주석 산화물 나노선은 증기수송 방법(VTM)을 이용하여 인듐 주석 산화물 유리 기판 위에 $5{\sim}30{\mu}m$ 길이로 합성하였다. 전해질과 전자가 손실되는 것을 방지하기 위해 원자층 증착법(ALD)을 이용하여 이산화 티타늄 차단층을 20 nm 두께로 코팅한 후 화학증착방법(CBD)을 이용하여 인듐 주석 산화물 나노선-이산화 티타늄 코어-쉘 구조를 만든다. 마지막으로 황화카드뮴, 카드늄셀레나이드, 황화아연을 증착시킨 후 다황화물 전해질을 이용하여 양자점 감응 태양전지를 제작하였다. 특성 평가를 위해 전계방사 주사전자현미경, X-선 회절, 고분해능 투과 전자 현미경을 이용하며 intensity modulated photocurrent spectroscopy (IMPS), intensity modulated voltage spectroscopy (IMVS)를 이용하여 전하수집 특성평가를 하였다.

• Korean Journal of Applied Biomechanics
• /
• v.20 no.1
• /
• pp.101-108
• /
• 2010

Recently, core and neuromuscular training(CNT) is emerging as a clinically relevant tool to improve neuromuscular control and to prevent sports injuries. The purpose of this study was to examine the effect of a 12 weeks CNT program on the dynamic stability after drop landing. The subjects attempted drop landing onto the force platform on single foot from a 40 cm height distance. The collected data was used to calculate the dynamic stability index. The Dynamic stability index was derived by measuring the medial-lateral stability index(MLSI), anterior-posterior stability index(APSI), and the vertical stability index(VSI). In comparison to the control group, the MLSI and APSI showed no difference, yet, it resulted in higher VSI. The results of this study suggest that CNT is worthwhile to be considered as a way to improve neuromuscular control and to prevent traumatic injuries. However, the results are taking into consideration to discuss the limitations of CNT and suggested future approaches.