• Journal of Adhesion and Interface
• /
• v.19 no.2
• /
• pp.60-67
• /
• 2018

In the present study, when the surface of kenaf, which is an environmentally friendly natural fiber, was treated by using adhesive solution containing Chemlok 402, the effects of fiber surface treatment, fiber content and fiber length on the cure characteristics, hardness, tensile modulus and abrasion resistance of kenaf/natural rubber composites were investigated. The kenaf fiber contents consisting of the composites were varied with 0, 5, 10, 15, and 29 phr at a fixed fiber length of 2 mm and also the fiber length was varied with 2, 35, and 70 mm at a fixed fiber content of 5 phr. The Tmax and tc90 values, Shore A hardness, tensile modulus, and abrasion resistance of natural rubber composites strongly depended on the kenaf fiber content and length. The characteristics of the composite with kenaf fibers treated with the adhesive solution containing Chemlok 402 were higher than those untreated. This is ascribed to the improved interfacial adhesion between the treated kenaf fiber and the rubber matrix. This study suggests that an appropriate use of adhesive solution may be possible to increase the properties of natural fiber-reinforced composites.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.31 no.12
• /
• pp.1682-1688
• /
• 2007

The effects of cultivar and DAPs on the lignin content and dyeability of the kenaf fibers were investigated. Four kenaf fiber samples were prepared from two cultivars, Tainung 2 and Everglades 41, and their 60 and 120 DAPs(days after planting) for the experiments. The lignin contents of the kenaf fibers of Tainung 2(T2) and Everglades 41(E41) were $11.29{\sim}12.78%$. Both T2 and E41 kenaf fibers had comparable amount of lignin, and klason lignin of the fibers was $2.5{\sim}3$ times as much as much as acid-soluble lignin. In both T2 and E41, 120 DAPs kenaf have 1% more lignin than 60 DAPs kenaf. The moisture regains of the four kenaf fiber samples were almost the same as $10.25{\pm}0.05%$. The absorbances of residual solution after dyeing for $1{\sim}180$ minutes with Red 81 at maximum wavelength 520 nm and Green 26 at 600 nm were measured. Comparing to Green 26, the dyeing rate of Red 81 was rapid and equilibrium state was reached in 12 minutes. The CIE $L^*,\;a^*, \;b^*,\;{\Delta}E$ and K/S values of the kenaf fibers dyed with Red 81 and Green 26 were measured as well. The dye exhaustion ratio of 60 DAPs kenaf was higher than that of 120 DAP.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.66 no.1
• /
• pp.87-96
• /
• 2021

Information and Communication Technology (ICT) remote soil moisture control system including soil sensing, automatic water supply chain, and remote alarming system was established on reclaimed land and operated stably. The system was operated using river water around the reclaimed land without fertilizer. On applying this system to control soil moisture, the kenaf germination rate was improved up to two times. Kenaf biomass was 4,748 kg/10a and was higher than that of untreated soil moisture management. When the nutritious liquid fertilizer was used, kenaf yield reached 8,390 kg/10a, which was lower than 10,848 kg/10a of the non-reclaimed land treated with standard chemical fertilizers. As the soil moisture was managed stably through the ICT remote soil moisture control system, the quality of the kenaf crop was improved, resulting in a 7% increase in dry weight, and a 11.5% increase in plant hardness. The estimated kenaf yield was 5,039 kg/10a when 800 tonnes of water were supplied by the ICT remote soil moisture control system with the stream water around Saemangeum reclaimed land without chemical fertilizers and organic matter.

• Korean Chemical Engineering Research
• /
• v.58 no.3
• /
• pp.362-368
• /
• 2020

Syngas can be used as raw material for chemical and fuel production. Currently, many studies on syngas production from gasification of biomass have been conducted. Kenaf is a promising renewable resource with high productivity and CO₂ immobilization. This study developed a large-scale kenaf gasification process based on the experimental data, and evaluated the techno-economic feasibility, which consists of three steps (integrated process design, heat exchanger network design, techno-economic assessment). The minimum selling price of syngas is US$ 9.55/GJ, and it is lower than current market price of syngas.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.59 no.4
• /
• pp.511-520
• /
• 2014

Kenaf (Hibiscus cannabinus L.) was recognized as a potential source of forage. To reduce the production cost, we should insure large cultivation area. The one of the best candidate places to expand the useful kenaf production was 'Saemangeum' reclaimed land. To confirm the possibility of kenaf growth in reclaimed land, we seeding and cultivated the kenaf in 'Saemangeum'. The germination percentage of kenaf on 5.0 dS/m soil salinity was 18%. It is less 66% than that of 4.0 dS/m soil salinity and at 6.0 dS/m, the germination percentage of kenaf was under 10%. The growth and development of kenaf in reclaimed land grew worse with increasing soil salinity. The stem diameter which the most important factor that decide the value and yield of product was upper 2.6 cm when soil salinity maintained under 4.0 dS/m, but if soil salinity marked over 4.0 dS/m, the stem diameter of kenaf was drop under 2.0 cm and it deteriorate the number of leaves per plant by 20~46%. The necrosis on older tip and marginal leaves were noted approximately first month after seeding which was correlated directly with the salinity levels of reclaimed soil. Reduction of total yield was coincide with increasing levels of EC. If soil salinity over 5.0 dS/m, the amount of decreased by soil salinity was 51% than that of non-reclaimed region. The allowable soil salinity level of which could be maintained within 20% reduction rate was 4.2 dS/m. Consequently kenaf can be grown successfully with moderately saline soil condition. However, salt levels in excess of 4.2 dS/m severely have restricted plant growth and development and will result in significant yield reduction.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.67 no.4
• /
• pp.274-284
• /
• 2022

To use kenaf (Hibiscus cannabinus L.) as a fiber and livestock feed, a high-yielding variety needs to be identified. For this, accurate phenotyping of plant height is required for this breeding purpose due to the strong relationship between plant height and yield. Plant height can be estimated using RGB images from unmanned aerial vehicles (UAV-RGB) and photogrammetry based on Structure from Motion (SfM) algorithms. In kenaf, accurate measurement of height is limited because kenaf stems have high flexibility and its height is easily affected by wind, growing up to 3 ~ 4 m. Therefore, we aimed to identify a method suitable for the accurate estimation of plant height of kenaf and investigate the feasibility of using the UAV-RGB-derived plant height map. Height estimation derived from UAV-RGB was improved using multi-point calibration against the five different wooden structures with known heights (30, 60, 90, 120, and 150 cm). Using the proposed method, we analyzed the variation in temporal height of 23 kenaf cultivars. Our results demontrated that the actual and estimated heights were reliably comparable with the coefficient of determination (R²) of 0.80 and a slope of 0.94. This method enabled the effective identification of cultivars with significantly different heights at each growth stages.

• Fiber Technology and Industry
• /
• v.9 no.2
• /
• pp.177-187
• /
• 2005

• Journal of the Korean Society of Clothing and Textiles
• /
• v.31 no.8
• /
• pp.1286-1296
• /
• 2007

Hanji, the korean traditional papers were mostly made from mulberry paper. But the production and demand of hanji have decreased rapidly because mulberry paper yields were insufficient and handworked hanji procedures were complicated. Recently, the researches on hanji were carried out to improve the properties of hanji. Kenaf fibers have been interested as a substitute resource of mulberry paper for hanji production. In this research, Kenai pulps were manufactured with removal methods of lignin or hemicellulose from kenaf fibers and paper mulberry pulps with traditional alkali methods. Kenaf papers, paper mulberry, and kenaf/paper mulberry mixed papers were manufactured with their pulps. The crystallinity, fiber length, color of the pulps and tensile strength, tear strength, water absorption of the papers were investigated. The results were as follow: The removal rates of lignin of chemical retted kenaf fibers with sodium chlorite reaction for 40 minutes were 70% and were higher than 40% of double retted fibers. Paper mulberry pulps has less lignin and hemicellulose than kenaf differently. The crystallinity of paper mulberry pulps were very low with 60%, but kenaf pulps were 90%. The chemical retted CR-40-1 pulps were similar with paper mulberry pulps on fiber length & fibrilation of fibers. Tensile strength of paper mulberry were higher than kenaf papers because of fibrilation of paper mulberry, but tear strength were lower. Tensile strength and tear strength were improved on kenaf/paper mulberry 30/70 mixed papers.

• Journal of Life Science
• /
• v.31 no.3
• /
• pp.305-313
• /
• 2021

This study verified the antioxidant and whitening activities of a Pinus koraiensis extract (PK) and a Hibiscus cannabinus L. extract (HC), and further evaluated the interaction of the extract ingredients when mixed at a 1:1 ratio (PKHC). The electron-donating and ABTS+ radical scavenging activities of the PKHC extract at 1,000 ㎍/ml concentration were 93.7% and 94%, respectively, indicating a higher efficacy than achieved with either extract alone. Measurements of the tyrosinase the activities in response to PK, HC, and PKHC extracts at 1,000 ㎍/ml concentrations showed inhibitions of 40%, 27.5%, and 43%, respectively, confirming a higher efficacy of the mixture due to the synergistic action of the ingredients. The cell toxicity values in melanoma cells treated with PK, HC, and PKHC at 1,000 ㎍/ml concentration were 87.4%, 80.2%, and 98%, confirming a higher viability in cells treated with the mixture due to antagonism. The expression of microphthalmia-associated transcription factor (MITF), tyrosinase-related protein-1 (TRP-1), tyrosinase-related protein-2 (TRP-2), and tyrosinase protein expression determined by Western blotting decreased by 53.9%, 64.8%, 67.3%, and 56.1%, respectively, when PKHC was administered at a concentration of 100 ㎍/ml. Reverse transcription-polymerase chain reaction (RT- PCR) results also showed that PKHC at a concentration of 100 ㎍/ml inhibited the mRNA expression of MITF, TRP-1, TRP-2, and tyrosinase mRNA by 54.4%, 64.9%, 66.6%, and 63.1%, respectively. Taken together, the data confirmed the antioxidant and whitening effect of the PKHC extract and verified the possibility that this extract mixture has great potential as a cosmetic ingredient.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.59 no.3
• /
• pp.375-384
• /
• 2014

Kenaf (Hibiscus cannabinus L.) was recognized as a potential source of forage. But the domestic cultivation techniques are not set standards yet. So we tested the basic culture techniques during 2012~2013 for getting a high yield and good grade forage production system. The best seeding method for mechanized planting (corn planter used) was hill seeding with $20{\times}20cm$ seeding distance. When we treated hill seeding with $20{\times}20cm$, the yield what we could get was 13,641 kg/10a and it was 32% more than that of conventional practice hill seeding with $20{\times}30cm$ seeding distance. The proper seeding date for getting high yield was May 1. In May 1, the yield per 10a was reached 13,423 kg, and it was 30% more than that of seeding at May 30. More over the crude protein content which was important factor for determinating forage nutritive value was 12.7% and it was higher 1.8% (relatively 16.5% high) than that of May 30 seeding. The most effective herbicide for kenaf was Fluazipof-p-butyl. It's herbicidal rate was 97% and phyto-toxicity was less than 5%. Regional adaptability for Jeollabuk-Do including Imsil Gun, Kochang Gun and Sunchang Gun were identified that the stable cultivation were possible in these area with average yield 12,400 kg/10a and it was about 1.7 times as compared to corn harvest.