• Geophysics and Geophysical Exploration
• /
• v.5 no.4
• /
• pp.299-308
• /
• 2002

We have derived an analytical expression for the sensitivity of the frequency domain small-loop electromagnetic (EM) surveys over a two-layer earth in order to estimate the depth of investigation with an instrument having the source-receiver separation of about 2 m. We analyzed the sensitivities to the lower layer normalized by those to the upper half-space and estimated the depth of investigation from the sensitivity analyses and the mutual impedance ratio. The computational results showed that the in-phase components of the sensitivity to the lower layer dominates those to the upper layer when the thickness of the upper layer is less than 20 m, while the quadrature components are not sensitive to the lower layer over the entire frequency range. Hence we confirmed that the accurate measurement of the in-phase component is essential to increase the depth of investigation in the multi-frequency small-loop EM survey. When conductive basement of 10 ohm-m underlies the upper layer of 100 ohm-m, an accurate measurement of the in-phase components ensures the depth of the investigation more than 10 m even accounting a noise effect, from which we conclude that the small-loop EM survey is quite effective in imaging the conductive plume down to a considerable depth. On the other hand, in the presence of the resistive basement of 1,000 ohm-m, the depth of investigation may not exceed 5 m considering the instrumental accuracy, which implies that the application of the small-loop EM survey is not recommended over the resistive environment other than detecting the buried conductor.

• Korean Journal of Soil Science and Fertilizer
• /
• v.35 no.4
• /
• pp.207-215
• /
• 2002

Changes in salinity, hydraulic conductivity and penetration resistance in a reclaimed tidal land reclaimed in 1986 were studied. The salinity monitoring based on electrical conductivity of saturated extract, ECe, was conducted from 1994, when the land use for experimental crop production started after tile drainage. The site was abandoned since 1999. The hydraulic conductivity was measured by a sand fill auger hole method, and the resistance was measured with a dynamic penetrometer in situ. The averaged ECe in 1994 was $33.7dS\;m^{-1}$ ranging from 25.5 to $44.8dS\;m^{-1}$, and was decreased to $25.7dS\;m^{-1}$ with large range from 0.8 to $70.3dS\;m^{-1}$ before experiment was $1.89{\times}10^{-7}m\;s^{-1}$. It increased to $1.32{\times}10^6m\;s^{-1}$ in the top 20-cm soil with large variability, while it showed $3.44{\times}10^7m\;s^{-1}$ beneath the 20-cm soil depth with less variability. The penetration resistance of the soil ranged from 0.05 to 9.99MPa. The vertical distribution of penetration resistance indicated the hardened layer was developed at the depth of 20~40 cm where the hydraulic conductivity was sharply decreased.

• Journal of Animal Environmental Science
• /
• v.15 no.2
• /
• pp.155-160
• /
• 2009

This study was carried out to investigate the feasibility of Multi Process of Aerobic Digestion (MPAD) for recycling of swine manure slurry as fertilizer. MPAD consisted of three kinds of difference process which are thermophilic aerobic oxidation (TAO) system, lime solidification system, and reverse osmosis (R/O) membrane system. TAO system was studied well previously for decade. The chemical composition of the lime-treated solid fertilizer was as like that organic matter 17.4%, moisture 34.1%, N 0.9%, P 1.7%, K 0.3%, Ca 12.7%, and which was expected to be useful as acid soil amendment material. The concentrated liquid material produced by R/O membrane system was also expected as a good fertilizer for crops production and soil fertility improvement.

• Resources Recycling
• /
• v.30 no.6
• /
• pp.61-67
• /
• 2021

This work investigated the cementation of iridium from iridium-containing hydrochloric acid leachate. Zinc powder was used as the reducing agent, and the effects of the stoichiometric ratio of Zn/Ir, initial Ir concentration, initial pH, reaction time, and ultrasound irradiation on iridium recovery were investigated. When only the stirrer was used for cementation, the iridium recovery increased with the addition amount of zinc, and the recovery of about 70% at 40 times the stoichiometric ratio of Zn/Ir. In contrast, when employing ultrasonic irradiation with stirring, the recovery of iridium decreased at 20 times or less the stoichiometric amount of zinc. The recovery of iridium increased at 40 times the stoichiometric ratio of Zn/Ir. This result may be due to the ionization of zinc and re-dissolution of iridium during the ultrasound irradiation treatment. When a combination of ultrasonic irradiation and stirring was used for cementation, the iridium recovery increased by more than 27% compared to that when using only the stirrer. It was possible to recover 99% of iridium under the following conditions: reaction time, 60 min; initial pH, 0.01; volume of leachate, 100 mL; 1770 ppm Ir, 40 times the stoichiometric ratio of Zn/Ir.

• Resources Recycling
• /
• v.30 no.5
• /
• pp.38-48
• /
• 2021

In this study, we determine the optimal process conditions for selectively recovering Si from a solar cell surface by removal of impurities (Al, Zn, Ag, etc.). To selectively recover Si from solar cells, leaching is performed using HCl solution and an ultrasonic cleaner. After leaching, the solar cells are washed using distilled water and dried in an oven. Decompression filtration is performed on the HCl solution, and ICP-OES (Inductively Coupled Plasma Optical Emission spectroscopy) full scan analysis is performed on the filtered solution. Furthermore, XRD (X-ray powder diffraction), XRF (X-ray fluorescence), and ICP-OES are performed on the dried solar cells after crushing, and the purity and recovery rate of Si are obtained. In this experiment, the concentration of acid solution, reaction temperature, reaction time, and ultrasonic intensity are considered as variables. The results show that the optimal process conditions for the selective recovery of Si from the solar cells are as follows: the concentration of acid solution = 3 M HCl, reaction temperature = 60℃, reaction time = 120 min, and ultrasonic intensity = 150 W. Further, the Si purity and recovery rate are 99.85 and 99.24%, respectively.

• Resources Recycling
• /
• v.32 no.3
• /
• pp.3-8
• /
• 2023

This study discussed production, demand, and future prospects of rubidium, which is an alkali group metal that is highly reactive to various media and requires carefulness in handling, but no significant environmental hazard of rubidium has been reported yet. Rubidium is used in various fields such as optoelectronic equipment, biomedical, and chemical industries. Because of difficulty in production as well as limited demand, the transaction price of rubidium is relatively high, but its detail information such as market status and potential growth is uncertain. However, if the mass production of versatile ultra-high-performance equipment such as quantum computers and the necessity of rubidium use in the equipment are confirmed, there is a possibility that the rubidium market will expand in the future. Rubidium is often found together with lithium, beryllium, and cesium, and may be present in granite containing minerals such as lepidolite and pollucite, as well as in seawater and industrial waste. Several technologies such as acid leaching, roasting, solvent extraction, and adsorption are used to recover rubidium. The maximum recovery efficiency of the rubidium from the sources and the processing above is generally high, but, in many practices, rubidium is not the main recovery target, and therefore the actual recovery effects should depend on presence of other valuable components or impurities, together with recovery costs, energy consumption, environmental issues, etc. In conclusion, although the current production and consumption of rubidium are limited, with consideration of the possible market fluctuations according to the emergence of large-scale demand sources, etc., further investigations by related institutions should be necessary.

• Applied Biological Chemistry
• /
• v.9
• /
• pp.111-118
• /
• 1968

A pot experiment with $P^{32}$ was carried out to investigate the soil phosphorus availability to four leguminous forage crops and three graminaceous, of black volcanic ash soil and red one. Soil phosphorus was extracted with 6 different extractants and also fractionated in Fe, Al and Ca phosphorus. The results were: 1) Soil phosphorus availability was in decreasing order of Italian rye grass${\gg}$ soybean> cassia> corn> weeping love grass${\gg}$ Korean lespedeza> Red clover and they might be grouped into three levels by A-value, over 1000, 200-500 and below 40 $p_{2}O_{5}\;kg/ha$. 2) The amount of various available phosphorus and phosoborus fraction in the black soil was higher than that in the red soil. No difference in phosphorus availabiliy to forage crops was shown between two soils. Therefore an extractant able to draw out similar amount of phosphorus from two soil will be suitable for determining the phosphorus availability index. 3) Two extractants, one extracting 20 ppm as maximum and the other extracting 100 ppm as minimum will be recommendable for determining the availability of phosphorus; the former for red clover and Lespedeza and the latter for others. Truog method may be good for the former but no appropriate method for the latter was found in the methods used. 4) T/R ratios of legumes were negatively correlated at 5% level with % phosphorus from fertilizer (% pdF). Legumes showed below 50 of % pdF over 5 of T/R ratio and over 80 of % pdF below 5 of T/R.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.12 no.3
• /
• pp.63-75
• /
• 2004

This research sought to determine the status of the installation and operation of domestic public resource-making facilities of resource-making facilities and come up with corresponding improvement measures. Currently compost is most numerous set-up out of facilties already established ever since, then the rest of them are feeds, anaerobic degradation, sewage combination, and combination of compost and feeds in order. As such, food waste is processed more into compost than into feeds, presumably because relevant facilities, which were originally designed for processing into feeds, were converted into composting facilities due to little demand for the processed feeds. The finding says that many related firms had yet to register their businesses in accordance with feeds and fertilizers management laws, and that food waste resources-making facilities used various basic facilities but few of them treated food waste in linkage with leaching water, bad odors, and energy. Some of current facilities were found to be 7 years old and thus outdated. Due to lack of skilled operational manpower, many facilities had less than 300 days of normal operation yearly, and some needed minor and serious repairs periodically. In overall facilities, 87% of the planned food waste was rolled in, thus requiring measures to treat the whole planned volume. For costs of resource-making facilities, some with a capacity of below 50 tons topped 100 million won, and facilities with a capacity of over 50 tons required less installation costs. Overall, installation costs ranged from 10 million to 20 million, and to 200 million won per ton, and this suggests a need to establish the installation cost calculation criteria, as well as to reshape the facility criteria. With operating costs varying greatly according to the size and treatment methods of facilities, the finding indicates a need to rationalize the operating costs, and to plan appropriate-size installation and operation of facilities to ensure economic operation.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.12 no.3
• /
• pp.217-233
• /
• 2014

Securing the radiological safety is a prerequisite for the safe management of the naturally occurring radioactive materials (NORM) which cannot be reused. This becomes a crucial focus of our R&D efforts upon the implementation of the Act on Protective Action Guidelines against Radiation in the Natural Environment. To secure the safety, the establishment of technical bases and procedures for securing radiological safety related to the disposal of NORM is required. Thus, it is necessary to analyze the characteristics, to collect the data, to have the radiological safety assessment methodologies and tools, to investigate disposal methods and facilities, and to study the effects of the input data on the safety for the NORM wastes. Here, we assess the environmental impact of the NORM waste disposal with respect to the major domestic and foreign NORM characteristics. The data associated with major industries are collected/analyzed and the status of disposal facilities and methodologies relevant to the NORM wastes is investigated. We also suggest the conceptual design concept of a landfill disposal facility and the management plan with respect to the major NORM wastes characteristics. The radionuclide pathways are identified for the atmospheric transport and leachate release and the environmental impact assessment methodology for the NORM waste disposal is established using a relevant code. The assessment and analysis on the exposure doses and excessive cancer risks for the NORM waste disposal are performed using the characteristics of the representative domestic NORM wastes including flying ash, phosphor gypsum, and redmud. The results show that the exposure dose and the excessive cancer risks are very low to consider any radiation effects. This study will contribute to development in the areas of the regulatory technology for securing radiological safety relevant to NORM waste disposal and to the implementation technology for the Act.

• Journal of Food Hygiene and Safety
• /
• v.31 no.2
• /
• pp.132-139
• /
• 2016

The purpose of this study was to investigate the contents of antioxidant compounds and antioxidant activities in teas. A total of 99 teas were tested for their antioxidant activities based on their ability to scavenge DPPH (1,1-diphenyl-2-picrylhydrazyl) free radical. Antioxidant activity was expressed as mg of ascorbic acid equivalents per 100 g tea sample (L-ascorbic acid equivalent antioxidant capacity, AEAC) and was expressed as mg per 1 serving size (free radical scavenging activity, $FSC_{50}$). The total polyphenol contents of the extracts was quantified using the Folin-Ciocalteu method and the total flavonoid contents of the extracts was determined using a modied method of Davis. Vitamin C was analyzed by HPLC method. According to the AEAC value, mate tea, green tea, black tea, oriental raisin tea, chamomile tea and burdock tea showed relatively high antioxidant activities. Polyphenolic compounds were the major naturally occurring antioxidant compounds found in teas and the high concentrations of total polyphenol compounds were observed in black tea, green tea and mate tea. The high concentrations of total flavonoid compounds were observed in mate tea, black tea and yam tea and the amount of vitamin C contents were found to be high in citron tea and green tea. As a result, steeping tea was much higher in antioxidant activity than either powdered tea or liquefied tea. According to the study, a high correlation was demonstrated between the total polyphenol contents and antioxidant activities in teas (r = 0.846) and correlations between the total flavonoid contents and antioxidant activities was statistically significant in teas (r = 0.625). It was found that also the proportional relationship established among the total polyphenol content and antioxidant activities. That is, antioxidant activity of teas has been confirmed to have been caused by the total polyphenol.