• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.11
• /
• pp.2594-2603
• /
• 1997

A novel method of adaptive beam forming is presented in this paper. The proposed technique provides for a suboptimal beam pattern that increases the Signal to Noise/Interference Ratio (SNR/SIR), thus, eventually increases the capacity of the communication channel, under an assumption that the desired signal is dominant compared to each component of interferences at the receiver, which is precoditionally achieved in Code Division Multiple Access (CDMA) mobile communications by the chip correlator. The main advantages of the new technique are:(1)The procedure requires neither reference signals nor training period, (2)The signal interchoerency does not affect the performance or complexity of the entire procedure, (3)The number of antennas does not have to be greater than that of the signals of distinct arrival angles, (4)The entire procedure is iterative such that a new suboptimal beam pattern be generated upon the arrival of each new data of which the arrival angle keeps changing due tot he mobility of the signal source, (5)The total amount of computation is tremendously reduced compared to that of most conventional beam forming techniques such that the suboptimal beam pattern be produced at vevery snapshot on a real-time basis. The total computational load for generating a new set of weitht including the update of an N-by-N(N is the number of antenna elements) autocovariance matrix is $0(3N^2 + 12N)$. It can further be reduced down to O(11N) by approximating the matrix with the instantaneous signal vector.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.7B
• /
• pp.598-612
• /
• 2004

Client requests have increased with the improvement of network resources at client side, whereas network resources at server side could not keep pace with the increased client request. Therefore, it is primary factor of the Qos that efficiently utilize network resources at server side. In this paper, we proposed a new model that peer-to-peer transfer scheme for partial multimedia stream based on CIWP which it decrease server network bandwidth by utilizing client disk resources saves additional server network resources. Especially, adapting Threshold_Based Multicast scheme guarantees to do that data transfer within clients never exceed service time of previous peer by restriction of which data size transferring from previous peer less than data size transferring from server. Peer-to-peer transfer within clients is limited in same group classified as ISPs. Our analytical result shows that proposed scheme reduces appling network resources at server side as utilizing additional client disk resource. furthermore, we perform various simulation study demonstrating the performance gain through comparing delay time and proportion of waiting requesters. As a result, when we compared to Threshold_Based Multicast scheme, the proposed scheme reduces server network bandwidth by 35%.

• Geophysics and Geophysical Exploration
• /
• v.20 no.1
• /
• pp.43-48
• /
• 2017

The applicability of refraction survey has been tested using a wave glider widely used in long-term ocean observations around the world. To record seismic refractions, a single channel streamer with metal weight and a seismic recording system were mounted on the wave glider. We used GPS precise time synchronization signal and radio frequency (RF) communication to synchronize shot and recorder triggers and to control acquired data quality in real time. When the wave glider is positioned close to the set point, a 2,000 J sparker is exploded along the designed track at 2 second intervals. Through the test survey, we were able to successfully acquire refractions from the subsurface.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.12 s.103
• /
• pp.1171-1178
• /
• 2005

Multi-code code division multiple access(MC-CDMA) has been proposed for providing the various service rates with different quality of service requirement by assigning multiple codes and increasing the capacity. However, it suffers from the serious problem of high peak to average power ratio(PAPR). So, it requires large input back-off, which causes poor power consumption in high power amplifier(HPA). In this paper, we propose a new method that can reduce PAPR efficiently by constraint codes based on the opposite correlation to the incoming information data in MC-CDMA. PAPR reduction depends on the length and indices of constraint codes in MC-CDMA system. There is a trade-off between PAPR reduction and the length of constraint codes. From the simulation results, we also investigate the BER improvement in AWGN channel with HPA. The simulation results show that BER performance can be similar with linear amplifier in two cases: 1) Using exact constraint codes without input back-off and 2) a few constraint codes with small input back-off.

• Journal of Broadcast Engineering
• /
• v.13 no.6
• /
• pp.941-950
• /
• 2008

The quality of projector output image is influenced by the surrounding conditions such as the shape and color of screen, and environmental light. Therefore, techniques that ensure desirable image quality, regardless of such surrounding conditions, have been in demand and are being steadily developed. Among the techniques, radiometric compensation is a representative one. In general, radiometric compensation is achieved by measuring the color of the screen and environmental light based on an analysis of camera image of projector output image and then adjusting the color of projector input image in a pixel-wise manner. This process is not time-consuming for small sizes of images but the speed of the process drops linearly with respect to image size. In large sizes of images, therefore, reducing the time required for performing the process becomes a critical problem. Therefore, this paper proposes a fast radiometric compensation method. The method uses color filters for eliminating the color mixing between projector and camera because the speed of radiometric compensation depends mainly on measuring color mixing between projector and camera. By using color filters, there is no need to measure the color mixing. Through experiments, the proposed method improved the compensation speed by 44 percent while maintaining the projector output image quality. This method is expected to be a key technique for widespread use of projectors for large-scale and high-quality display.

• Journal of the Korea Society of Computer and Information
• /
• v.17 no.10
• /
• pp.185-192
• /
• 2012

Call Center requires an ability of agents a lot more than face-to-face contact due to being achieved communication by non face-to face channel for contact with customers. In order to improve the ability of agents, Call Center carries out various educational training according to their work experience and function and with the accomplishment of educational training, Call Center is going to fulfill to develop its quality of counseling and productivity. On the other hand, due to investment of a lot of time and budget to educational training, it is needed to grasp and manage about its effectiveness that how helpful the training is for performance of work-site operations through evaluation of educational training. Having Seen researches about evaluation of educational training until these days, most researches have mainstream to measure satisfaction and a level of learning or degree that how the learning transfers to actions. It is found that a research about an entire evaluation model should be required. This study aims to investigate effectiveness of Call Center educational training from the level of recognition by reflecting Kirkpatrick's the four levels of learning evaluation. By the four levels, reaction, learning, behavior and results, the study found out a connection with standards of evaluation about each levels. In addition, by using structural equation modeling, it was examined goodness of fit about the entire model. Furthermore, by an alternative model, considering a direct relation between a factor of reaction and behavior, it was compared and examined goodness of fit of overall model of the study model and the alternative one.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.14 no.1
• /
• pp.179-187
• /
• 2014

The underlay protocol is a cognitive radio method in which secondary or cognitive users use the same frequency without affecting the quality of service (QoS) for the primary users. In addition, because of the broadcast characteristics of the wireless environment, some nodes, which are called eavesdropper nodes, want to illegally receive information that is intended for other communication links. Hence, Physical Layer Security is applied considering the achievable secrecy rate (ASR) to prevent this from happening. In this paper, a performance analysis of the amplify-and-forward scheme under an interference constraint and Physical Layer Security is investigated in the cooperative communication mode. In this model, the relays use an amplify-and- forward method to help transmit signals from a source to a destination. The best relay is chosen using an opportunistic relay selection method, which is based on the end-to-end ASR. The system performance is evaluated in terms of the outage probability of the ASR. The lower and upper bounds of this probability, based on the global statistical channel state information (CSI), are derived in closed form. Our simulation results show that the system performance improves when the distances from the relays to the eavesdropper are larger than the distances from the relays to the destination, and the cognitive network is far enough from the primary user.

• Journal of Distribution Research
• /
• v.16 no.5
• /
• pp.123-140
• /
• 2011

This study analyzed large distributors' trade features with local suppliers and their direct purchase features through the survey and the interview targeting some MDs(Merchandisers) in large retailers responsible for buying fresh foods (agricultural, fishery, livestock and proceeded products). As the result of conducting the survey targeting the large purchase MDs, it was found that when they select local suppliers, they importantly consider the factors of stable products supply, the quality management, the aggressive management attitude, the affordable (cheap) price, and the suggestion of differentiated goods in order. Concerning their direct purchases in local places, their preference toward the direct-purchase traders were higher than that toward vendors and whole markets as their existing major traders. Among the traders for direct purchase, they preferred farm corporations (including agricultural corporations) the most, and followed the National Agricultural Cooperative, and the unit agricultural cooperative in order. Regarding to the trades with suppliers, when they set the trade price, the merchandisers (MDs) of large distributors preferred long-term trades over 2 years, and utilized the factors of market rate(50.9%), production cost(31.2%) and sale price in the same industry(18.0%). For the local distribution organizations to aggressively counteract the changes of distribution environment in the consumption places, it needs some strategies to organize the agricultural production, to expand the production size and to specialize the distribution channels. And the supply system's continuality and stability are required, so it needs to establish the counteract system enabling to supply all year round through the link of production organizations. Additionally, as an effort to intensify the market negotiation ability, it should collect various market information from the consumption places.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.6
• /
• pp.709-714
• /
• 2018

This study researched the reasons for changing polarity in accordance with junction properties in an interface of semiconductors. The contact properties of semiconductors are related to the effect of the semiconductor's device. Therefore, it is an important factor for understanding the junction characteristics in the semiconductor to increase the efficiency of devices. For generation of various junction properties, carbon-doped silicon oxide (SiOC) was deposited with various argon (Ar) gas flow rates, and the characteristics of the SiOC was varied based on the polarity in accordance with the Ar gas flows. Tin-doped zinc oxide (ZTO) as the conductor was deposited on the SiOC as an insulator to research the conductivity. The properties of the SiOC were determined from the formation of a depletion layer by the ionization reaction with various Ar gas flow rates due to the plasma energy. Schottky contact was good in the condition of the depletion layer, with a high potential barrier between the silicon (Si) wafer and the SiOC. The rate of ionization reactions increased when increasing the Ar gas flow rate, and then the potential barrier of the depletion layer was also increased owing to deficient ions from electron-hole recombination at the junction. The dielectric properties of the depletion layer changed to the properties of an insulator, which is favorable for Schottky contact. When the ZTO was deposited on the SiOC with Schottky contact, the stability of the ZTO was improved by the ionic recombination at the interface between the SiOC and the ZTO. The conductivity of ZTO/SiOC was also increased on SiOC film with ideal Schottky contact, in spite of the decreasing charge carriers. It increases the demand on the Schottky contact to improve the thin semiconductor device, and this study confirmed a high-performance device owing to Schottky contact in a low current system. Finally, the amount of current increased in the device owing to ideal Schottky contact.

• The KIPS Transactions:PartB
• /
• v.10B no.2
• /
• pp.143-150
• /
• 2003

Error concealment plays an important role in combating transmission errors. Methods of error concealment which produce better quality are generally of higher complexity, thus making some of the more sophisticated algorithms is not suitable for real-time applications. In this paper, we develop temporal and spatial error resilient video encoding and data hiding approach to facilitate the error concealment at the decoder. Block interleaving scheme is introduced to isolate erroneous blocks caused by packet losses for spatial area of error resilience. For temporal area of error resilience, data hiding is applied to the transmission of parity bits to protect motion vectors. To do error concealment quickly, a set of edge features extracted from a block is embedded imperceptibly using data hiding into the host media and transmitted to decoder. If some part of the media data is damaged during transmission, the embedded features are used for concealment of lost data at decoder. This method decreases a complexity of error concealment by reducing the estimation process of lost data from neighbor blocks. The proposed data hiding method of parity bits and block features is not influence much to the complexity of standard encoder. Experimental results show that proposed method conceals properly and effectively burst errors occurred on transmission channel like Internet.