• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.4
• /
• pp.86-93
• /
• 2008

A low-power, low-noise, highly-linear hybrid balun circuit is proposed for 2.4-GHz fully differential CMOS direct conversion receivers. The hybrid balun is composed of a passive transformer and loss-compensating auxiliary amplifiers. Design issues regarding the optimal signal splitting and coupling between the transformer and compensating amplifiers are discussed. Implemented in $0.18{\mu}m$ CMOS process, the 2.4 GHz hybrid balun achieves 2.8 dB higher gain and 1.9 dB lower noise figure than its passive counterpart and +23 dBm of IIP3 only at a current consumption of 0.67 mA from 1.2 V supply. It is also examined that the hybrid balun can remarkably lower the total noise figure of a 2.4 GHz fully differential RF receiver only at a cost of 0.82 mW additional power dissipation.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.6 no.1
• /
• pp.7-12
• /
• 2011

This paper proposes a differential Colpitts-VCO circuit suitable for low phase noise oscillation at the sub-1V supply voltage. Oscillation with low phase noise at the sub-1V supply voltage is facilitated by employing inductors as the current sources of the proposed circuit. One of the two feedback capacitors of the single-ended Colpitts oscillator in the proposed circuit is replaced with the MOS varactor in order to further reduce the resonator loss. Post-layout simulation results using a $0.18{\mu}m$ RF CMOS technology show that the phase noises at the 1MHz offset frequency of the proposed circuit oscillating at the sub-1V supply voltages of 0.6 to 0.9 V are at least 7 dBc/Hz lower than those of the well-known cross-coupled differential VCO.

• Journal of Korea Multimedia Society
• /
• v.5 no.2
• /
• pp.215-221
• /
• 2002

In high speed optical disc devices, the vibration caused by unbalanced displacement leads the focus and tracking servo systems to be unstable, and increases the data search time. In this paper, we propose a new scheme to solve the unbalanced displacement problem. The proposed method detects the unbalanced rate by differential amplifying optical power received at photo diode and converts it into an electrical signal. controlling the speed of spindle motor, according to the detected unbalanced rate, makes it possible to improve the performance of tracking and data searching tasks. Also, we analyze the dynamic characteristics of focus and tracking servo systems in high speed mode and provide the firmware and hardware architecture that the proposed method can be installed as an add-on- module in the existing system.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.39 no.9
• /
• pp.62-71
• /
• 2002

An intergral C-V converter is proposed to solve the nonlinearity problem of capacitive pressure sensors. The integral C-V converter consists of a switched-capacitor integrator and a switched-capacitor differential amplifier. It converts the sensor capacitance change which is inversely proportional to an applied pressure into a linear voltage output. Various PSPICE simulations prove that the convertor has excellent characteristics, such as low nonlinearity less than 0.01%/FS and low sensitivity to parallel offset capacitance and parasitic capacitance for the displacement range of sensor diaphragm set to 0 ${\sim}$ 90% of the initial distance between the electrodes in the simulation. We also show that the offset compensation and the gain trimming are easily achieved with the integral C-V converter.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.12A
• /
• pp.1948-1959
• /
• 1999

The error rate performance of the proposed $\pi$/4-differential quadructure phase shift keying( $\pi$/4-DQPSK) with nonredundant multiple error correction is analyzed for Nakagami fading channel. The scheme for differential detection of $\pi$/4-QPSK with nonredundant multiple error correction utilizes the output that employ the received signal delayed by more than two time slots. It was observed that the performance increased as the error correction capability increased.

• Journal of the Korea Computer Industry Society
• /
• v.8 no.2
• /
• pp.123-130
• /
• 2007

In this paper, the design requirement and the electrical circuit analysis are performed to construct the multi-channel cardiac activation pre-amplifier necessary for a signal conditioning circuit. The general 64 channel configuration is expanded into 128 channels to enhance the spatial resolution on the mapped surface of the heart. The 128 channels pre-amplifier consists of input circuit, differential amplifier, right leg driven circuit and main-amplifier with notch filter part.

• Proceedings of the KIEE Conference
• /
• 2001.07d
• /
• pp.2299-2301
• /
• 2001

광 디스크의 용량을 증가시기키 위해선, 레이저 다이오드의 단파장화와 렌즈의 개구수 증가가 수년 동안 시도되어왔다. 불행히도 이러한 노력들은 디스크 틸트(tilt)로 인해 야기되는 코마(coma) 수차로 인한 부작용을 유발하였다. 이런 문제를 해결하기 위해, 램(random access memory, RAM) 디스크의 경우 몇 가지 검출과 보상 방법이 제안되었다. 그러나, 롬(read only memory, ROM) 디스크의 경우 아직까지 뚜렷한 해결책이 제시되지 않고 있다. 본 논문에서는 8분할 광 검출기에 의해 생성되는 차동 위상 검출(differential phase detection, DPD) 신호를 이용한 고밀도 롬 디스크에서 래디얼(radial) 틸트를 검출하는 방법을 제안한다. 3축 렌즈 구동형 액츄에이터(actuator)를 이용하여 개발한 래디얼 틸트 서보로 검출된 래디얼 틸트를 보상한다. 액츄에이터의 회전이 트래킹(tracking) 서보(servo)에 미치는 영향을 소개한다. 끝으로 제안된 방법의 유용성을 고밀도 롬 드라이브에 대한 실험을 통해 검증한다.

• Journal of Advanced Navigation Technology
• /
• v.28 no.2
• /
• pp.246-249
• /
• 2024

In this paper, we present a miniaturized differential line (DL) using inductance-enhanced corrugated ground planes (LCGP) for effective common-mode (CM) noise suppression in high-speed packages and printed circuit boards. The LCGP-DL demonstrates the CM noise suppression in the frequency range from 2.09 GHz to 3.6 GHz. Furthermore, to achieve the same low cutoff frequency, the LCGP-DL accomplishes a remarkable 23.2% reduction in size compared to a reference DL.

• Journal of Biomedical Engineering Research
• /
• v.23 no.3
• /
• pp.217-225
• /
• 2002

The implantable middle ear(IME) system, which has good sound quality. superior sound intelligibility and wide frequency characteristics. can resolve the sound distortion and ringing effect by sound feedback at high gain operation those are the major problems of conventional hearing aid. In this paper, we have manufactured the IME system using differential electromagnetic transducer(DET) and verified the performance of the system by carrying out vibration and animal implanting experiment. The DET was manufactured using micro-machining technology and vibration experiment of the transducer was performed to inspect whether the transducer could vibrate in accordance with the applied sound signal or not. And the result of the loaded experiment using temporal bone sampled from cadaver showed that the transducer can drive the middle ear bone and transmit the signal to inner ear After the internal unit of IME system was implanted in a dog. the auditory brainstem response (ABR) test was carried out. The result of the test indicated the Proper behavior of the IME system in the living body From the results of the experiments, it is verified that the manufactured system ewll work well when it is applied to human and a basis of clinical experiment of IME system to real human hearing impaired was be arranged.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.43 no.10 s.352
• /
• pp.28-33
• /
• 2006

An integrated 3.125Gbps clock and data recovery (CDR) circuit is presented. The circuit does not need a reference clock. It has a phase and frequency detector (PFD), which incorporates a bang-bang type 4X oversampling PD and a rotational frequency detector (FD). It also has a ring oscillator type VCO with four delay stages and three zero-offset charge pumps. With a proposed PD and m, the tracking range of 24% can be achieved. Experimental results show that the circuit is capable of recovering clock and data at rates of 3.125Gbps with 0.18 um CMOS technology. The measured recovered clock jitter (p-p) is about 14ps. The CDR has 1.8volt single power supply. The power dissipation is about 140mW.