• The Journal of Engineering Geology
• /
• v.11 no.2
• /
• pp.215-227
• /
• 2001

The Okchon Formation and the Mesozoic granite of the Boeun, Chungbuk are compared in terms of seismic wave velocities estimated from the field experiment, and seismic wave velocities in 3-D measured from the rock specimen. P-wave velocity for the field data ranges from 861 m/s (Guryongsan-2 Formation) to 2697m/s (Bulguksa Granite). P-wave anisotropy also ranges from 46% (Changri Formation) to 81% (Bulguksa Granite), with an average value of 68.5%. P-wave velocities for the rock specimens from Guryongsan-1, Guryongsan-2, Changri, and Munjuri Formations are greater than 5000m/s. S-wave velocities for those specimens are approximately 3500m/s, which is 3-5 times grater than the ones estimated from the field experimental data. P-wave anisotropy for the specimens from Bulguksa Granite and Guryongsan-1 Formation exceeds 60%, which is compared to 30% for the other specimens. This value is much smaller than average P-wave anisotropy (69.5%) for the field data. It is suggested that velocity difference, associated with the propagation direction, is much greater for the field data than for the specimens.

• Korean Journal of Mineralogy and Petrology
• /
• v.33 no.3
• /
• pp.259-272
• /
• 2020

The seismic properties in the crust are affected by the lattice preferred orientation(LPO) of major minerals in the crust. Therefore, in order to understand the internal structure of the crust using seismic data, information on the LPO of the major constituent minerals and the seismic properties of major rocks in a specific region are needed. However, there is little research on the LPOs of minerals in the crust in Korea. In this study, we collected amphibolites from two outcrops in Wigokri, Gapyeong, located in the nothern portion of Gyeonggi Massif, and we measured the LPOs of major minerals of amphibolite, especially amphibole and plagioclase through EBSD analysis, and calculated seismic properties of amphibolite. Two types of LPOs of amphibole, which are defined as type I and type IV, were observed in the two outcrops of Gapyeong amphibolites, respectively. In the case of amphibolites with the type I LPO of amphibole, large seismic anisotropy of both P- and S-wave was observed, while in the amphibolites with the type IV LPO of amphibole, small seismic anisotropy was observed. This is consistent with previous experimental results. The polarization direction of the fast S-wave was aligned subparallel to the lineation regardless of the LPO types of amphibole. The seismic anisotropy observed in Gapyeong is expected to be helpful to interpret the structure and seismic data within the crust in Gyeonggi Massif.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.12 no.4
• /
• pp.591-597
• /
• 1999

본 연구에서는 비 균질 퇴적층으로 인한 지진파의 증폭에 대한 경계/유한요소 해석을 수행하였다. 수치해석을 위해, 비 균질 퇴적층은 8절점 등 매개 변수 유한요소 사용하여 모델링하였고, 그 주위의 균질 반무한 지반은 3절점 등매개 변수 경계요소를 사용하여 모델링하였다. 경계요소와 유한요소의 접촉면에서, 표면 력의 평형조건과 변위의 적합 조건에 의해 두 개의 요소를 결합하는 알고리듬을 개발하였다. 수치해석의 영향인자로서 SH파, P파와 SV파의 입사각, 무 차원 진동수 그리고 반무한 지반과 퇴적층사이의 전단 파 속도 비와 질량밀도 비를 고려하였다.

• Journal of the Korean earth science society
• /
• v.32 no.6
• /
• pp.640-653
• /
• 2011

We simulate the propagation of earthquake waves in the continental margin of Antarctica using the elastic wave modeling algorithm, which is modified to be suitable for acoustic-elastic coupled media and earthquake source. To simulate the various types of earthquake source, the staggered-grid finite-difference method, which is composed of velocity-stress formulae, can be more appropriate to use than the conventional, displacement-based, finite-difference method. We simulate the elastic wave propagation generated by earthquakes combining 3D staggered-grid finite-difference algorithm composed of displacement-velocity-stress formulae with double couple mechanisms for earthquake source. Through numerical tests for left-lateral strike-slip fault, normal fault and reverse fault, we could confirm that the first arrival of P waves at the surface is in a good agreement with the theoretically-predicted results based on the focal mechanism of an earthquake. Numerical results for a model made after the subduction zone in the continental margin of Antarctica showed that earthquake waves, generated by the reverse fault and propagating through the continental crust, the oceanic crust and the ocean, are accurately described.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.11 no.2 s.54
• /
• pp.1-9
• /
• 2007

The method of generating the artificial acceleration time histories for seismic analysis based on genetic algorithms is presented. For applying to the genetic algorithms, the frequencies are selected as the decision variables eventually to be genes. An arithmetic average crossover operator and an arithmetic ratio mutation operator are suggested in this study. These operators as well as the typical simple crossover operator are utilized in generating the artificial acceleration time histories corresponding to the specified design response spectrum. Also these generated artificial time histories are checked whether their outward features are to be coincident with the recorded earthquake motion or not. The features include envelope shape, correlation condition between 2 horizontal components of motion, and the relationship of max. acceleration, max. velocity and max. displacement of ground.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2009.10a
• /
• pp.28-33
• /
• 2009

Methane hydrates are considered important in terms of their effect on global warming and as potential energy resources. Now, mainly the presence of a BSR and seismic velocity are used for estimation of methane hydrate concentration in the seismic reflection survey. But recent studies on seismic attenuation show that it can be used also to estimate methane hydrates concentration. In this study, we tried to estimate attenuation from 2D seismic reflection data acquired at Nankai Trough in Japan and analyzed attenuation properties in methane hydrate bearing sediments. Seismic attenuation estimated by QVO method in an offset range $125{\sim}1,575m$. We observed high attenuation in methane hydrate bearing sediments over BSR in a frequency range of 30-70Hz. Thus, this result demonstrates that seismic reflection wave within this frequency range are affected significantly by the existence of methane hydrate concentration zone.

• Geophysics and Geophysical Exploration
• /
• v.13 no.2
• /
• pp.153-158
• /
• 2010

To investigate the velocity structure in the central and southern parts of the Korean peninsula, a 299-km NW-SE seismic refraction profile KCRT-2008was obtained across major tectonic boundaries. Seismic waves were generated by detonating 250 ~ 1500 kg explosives at depths of 50 ~ 100 m in eight drill holes located at intervals of 21 ~ 113 km. The seismic signals were detected by 4.5 Hz geophones at a nominal interval of 500 m. The first-arrival times were inverted to derive a velocity tomogram. The raypaths indicate several mid-crust interfaces including those at approximate depths of 2 ~ 3, 11 ~ 13, and 20 km. The Moho discontinuity with refraction velocity of 7.7 to 8.1 km/s has a maximum depth of 34.5 km under the central portion of the peninsula. The Moho becomes shallower as the Yellow Sea and the East Sea are approached on the west and east coasts of the peninsula, respectively. The depth of the 7.6 km/s velocity contour varies from 31.3 km to 34.4 km. The velocity tomogram shows the existence of a 129 km wide low-velocity zone centered at 7.2 km depth under the Okchon fold belt and Gyeonggi massif and low-velocity(< 5.4 km/s) rocks in the Gyeongsang sedimentary basin with a maximum thickness of 2.6 km

• Journal of the Earthquake Engineering Society of Korea
• /
• v.15 no.5
• /
• pp.35-44
• /
• 2011

PGA (Peak Ground Acceleration) is the parameter which indicates the peak value for strong ground motion and is mainly due to the intensity of the seismic wave. Usually, seismic waves can consist of different characteristics and can have different effects on structures. Therefore, it may be undesirable that the effects of a seismic wave are evaluated only based on the PGA. In this study, time history analysis was executed with a single degree of freedom model for inelastic seismic analysis. The numerical model was assumed to be a perfect elasto-plastic model. Input accelerations were made with El Centro NS (1940), other earthquake records and artificial earthquakes. The displacement ductility demand and cumulative dissipated energy, which were calculated from other artificial earthquakes, were compared. As a result, different responses from other seismic waves which have the same PGA were identified. Therefore, an index which could reflect both seismic and structural characteristics is needed. The SI (Spectrum Intensity) scale which could be obtained from integration by parts of the velocity response spectrum could be an index reflecting the inelastic seismic response of structures. It can be possible to identify from correlation analysis among the SI scale, displacement ductility demand and cumulative dissipated energy that the SI scale is sufficient to be an index for the inelastic response of structures under seismic conditions.

• The Korean Journal of Petroleum Geology
• /
• v.1 no.1 s.1
• /
• pp.47-52
• /
• 1993

A method and results of computations are presented for the 2-D seismic migration process in the frequency-wavenumber domain for the laterally and vertically inhomogeneous medium. In order to take the intrinsic attenuation effect into account in the migration process the complex-valued wave velocity is used in the wavefield extrapolation operator, improving the generalized frequency-wavenumber migration technique. The imaginary part of the complex-valued wave velocity includes the seismic quality factor Q value. In derivation of the solution of the wave equation for the medium of inhomogeneous wave velocity and anelasticity, the inhomogeneous medium is mathematically converted to an equivalent system which consists of a homogeneous medium of averaged slowness and an inhomogeneous distribution of hypothetical wave source. The strength of the hypothetical wave source depends on the deviation of squared slowness from the averaged value of the medium. Results of numerical computation using the technique show more distinct geologic images than those using the convensional generalized frequency-wavenumber migration. Especially, the obscured images due to the wave attenuation by anelasticity are restored to show sharp boundaries of structures. The method will be useful in the imaging of the reflection data obtained in the regions of possible petroleum or natural gas reservoir and of fractured zone.

• Geophysics and Geophysical Exploration
• /
• v.20 no.2
• /
• pp.96-99
• /
• 2017

Virtual source data were produced by applying the seismic interferometry to the 2002 experimental seismic refraction data. Using the data, moveout velocities and effective anellipticity were experimentally computed for the crust at eight sites in the Korean peninsula. The moveout velocities of reflection events at approximate Moho depths were yielded to be $6.30{\pm}0.25km/s$ using near-offset traveltimes. Expanding the Taylor approximation to the $3^{rd}$ term for far-offset traveltimes, the effective anellipticity parameters were computed to be $0.18{\pm}0.07$ for the crust material.