• Journal of the Society of Naval Architects of Korea
• /
• v.39 no.1
• /
• pp.1-7
• /
• 2002

As the existing noise measuring device was affected the flow-field and structural vibration directly, new experimental device was required. Two Hydrophone Boxes are designed and their performances are investigated. The noise level of the KRISO cavitation tunnel is compared with those of the other cavitation tunnels which have been designed for the noise study. The present experimental results show the possibility of the full-scale prediction for propeller cavitation noise and the improvement of the measurement performance at the range of low-frequency.

• The Journal of the Acoustical Society of Korea
• /
• v.14 no.5
• /
• pp.83-88
• /
• 1995

The common practice for the identification of piezoelectric properties is based on the use of immittance of a resonator with a certain geometry and poling direction. In this paper, a new method is suggested to identify the complex-valued piezoelectric material constants. This method Is based on the minimization of differences between the analytical immittance and the experimental measurement of resonator. Non-linear minimization problems are formulated to find out the unknown properties relevant to the resonators. The immittance data used for identification are measured at a number of frequencies which cover the vicinity of resonance frequency and the low frequency region. To illustrate the proposed technique, the complex-valued coefficients are identified for a typical PZT4 ceramic composition.

• Proceedings of the Korean Society of Marine Engineers Conference
• /
• 2011.10a
• /
• pp.41-41
• /
• 2011

국제해사기구(IMO)에서2016년에 건조되는 선박부터 Tier III 규제를 예고하고 있다. 이 규 제를 만족하기 위하여 엔진 전처리 기술 및 후처리 기술 개발과 실증 연구가 활발히 진행되고 있다. 이중 SCR(Selective Catalytic Reduction) 반응을 이용한 질소산화물 저감기술이 80% 이상의 Tier III NOx 규제치를 만족할 수 있는 유일한 기술이다. 육상 플랜트에서 실증과 검증이 확보된 SCR 기술의 선박 엔진에 대한 적용을 위해서는 선박의 급격한 운전조건 변화와 엔진에 의한 저주파 진동에 대한 촉매 내구성 확보가 중요하다. 본 연구에서 기공 분포면에서 마이크로 기공보다는 메죠 및 매크로 기공쪽으로 구조를 개선함으로써 촉매 사용시 우려되는 배기가스중의 Soot 또는 2차 합성물질에 의한 촉매기공 막힘을 최대한 방지한 상용 SCR 촉매를 개발하였다. 또한 촉매에 대한 내구성 실증을 위하여 현재 운항 선박(한진피츠버그호)에 장착하여 실증 실험을 수행하였다. 기존 corrugate 타입의 촉매보다 40% 정도의 부피 감소와 차압 감소를 달성하였고 이로 인하여 선박내 제한된 공간에 효율적으로 SCR 시스템 설치가 가능할 것으로 생각된다. 그리고 본 연구에서는 가이드 베인 설치 없이 유동 균일화를 달성하여 반응기 전체의 크기 축소가 가능하다. 이는 추가적인 비용 및 압력 손실 저감, 유지 보수 공간 확보 등의 장점이 있다.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.9 no.4
• /
• pp.148-156
• /
• 2001

Brake judder, one of low Sequency vibrations in brake system is determined by the excitation of Brake Torque Variation (BTV). The largest contributor to BTV is disc thickness variation. In this study, the static loads of brake torque at Suspension Mounting Points (SW) are obtained by the quasi-static analysis using DADS. The dynamic loads with frequency of BTV at SW are derived from correlation between forced vibration analysis with static loads and brake test results. And the accelerations at steering wheel were analyzed by forced vibration analysis with dynamic loads using commercial finite element program MSC/NASTRAN so that vibration characteristics of vehicle due to brake judder were investigated. Reliability of analysis results was verified through comparing the brake test results. Also, a parametric study with natural frequencies of frame, such as the 1st torsional mode and 1st bending mode, was conducted to reduce vibration amplitudes. As a result we could detect frame natural frequency conditions to improve vibration characteristics and obtained the frame model to reduce vibration amplitude.

• KEPCO Journal on Electric Power and Energy
• /
• v.6 no.3
• /
• pp.245-252
• /
• 2020

It is very important to evaluate on/off-line stability to operate the power system stably and economically. Until now, we have continuously secured the operation reliability of the power system through the evaluation of transient, voltage and small signal stability. This paper proposes that it is possible to operate in KWAMS by applying the multi-section analysis and subspace methods and verifying the reliability of the algorithms to directly estimate the dominant oscillation mode of the power system from the signal waveform acquired from the phasor measurement units. In addition, this paper shows that the dominant oscillation mode can be detected from real-time measurement data in power systems. Therefore, if we can monitor the state of the power system in real time, it is possible to avoid a large-scale power outage by knowing the possibility of the power system accident in advance.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.63 no.1
• /
• pp.1-9
• /
• 2014

The parameters of electromechanical modes offer considerable insight into the dynamic stability properties of a power system. This paper describes an initial result for extraction of dynamic parameters from synchrophasor measurements collected on the KEPCO system. Dominant modes of the system are estimated by oscillation detecting program in K-WAMS. The critical wide-area modes of KEPCO system have frequencies in the 0.4 to 0.7Hz range. And the local mode causing the low frequency oscillation of generators located on the west coast area has in the frequency 0.97 and 1.25 Hz, respectively. This results can serve as a reference in the future for reliable system operation in KEPCO system.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.11a
• /
• pp.218-218
• /
• 2007

고체 전해질로서 $CsH_2PO_4$결정은 $230^{\circ}C$ 이상에서 전기전도도가 $10^{-2}\;{\Omega}^{-1}cm^{-1}$의 값에 도달하는 초양성자(Superprotonic) 상태로 상전이를 한다. 이러한 이유로 $CsH_2PO_4$ 결정은 $230^{\circ}C$ 부근에서 사용할 수 있는 연료전지로 개발되어왔다. 실용적인 면에서 단결정의 경우보다 다결정의 물성 및 응용 연구가 많았는데, 입자 크기에 따른 체계적인 연구는 잘 이루어지지 않았다. 본 발표에서는 $CsH_2PO_4$ 다결정을 합성하여 SEM 및 micro Raman spectra를 조사하였다. SEM의 결과 입자들의 평균 크기는 100 nm 이었으며, micro Raman spectra는 Bulk $CsH_2PO_4$의 spectra 와 큰 차이를 보이지 않았다. $PO_4$의 내부진동은 거의 같은 주파수대를 보여주나, $300\;cm^{-1}$이하의 저주파 수 영역에서는 광학적 포논의 픽이 잘 보이지 않았다. 그 원인이 micro Raman 장치의 측정 특성인지, 물리적 변화인지는 확실치 않다.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2012.05a
• /
• pp.86-90
• /
• 2012

In this paper, the combustion instabilities which may occur in the hybrid rocket were studied. The rocket combustor where the vortexes can be generated was designed, and the experiments were performed. The investigations about characteristics on the presence of the diaphragm, the length of the fuel, the diameter of the fuel port, the diameter of the diaphragm, the diameter of the nozzle throat, and the variation of the Ox massflow rate were conducted. The main resonant frequency of the combustion pressure is regarded by the Vortex shedding mode, and it is considered that the other resonant frequency of the pressure fluctuation is hybrid low frequency, or helmholtz mode.

• Proceedings of the KSME Conference
• /
• 2003.11a
• /
• pp.1637-1641
• /
• 2003

Korea Gas Corporation(KOGAS) is a Liquified Natural Gas(LNG) supplier through out the Korea. LNG, which is imported wholly from foreign countries, is compressed 1/600 for easy transportation and is stored in a liquid state in the storage tanks at Incheon, Pyeongtaek and Tongyeong. At LNG receiving terminals, LNG is vaporized to natural gas before supplying to City Gas Consumer of Power Plant. The secondary pump is a equipment which compress LNG from 1- kgf/cm2 to 70 kgf/cm2. The secondary pump at Tongyeong LNG receiving terminal is consisted of two pumps in one underground PIT, and is connected to supporting structures. It is therefore expected that there is a vibration problem whit the pump and was found that high level vibration was occurred in a low frequency band($5^{\sim}10Hz$). In this paper, the vibration of secondary pump was analyzed, and the main cause of vibration was found out.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.11 no.7
• /
• pp.671-676
• /
• 2016

This study is about design for the Rotational Instrument of the Industry factory which is used management safety and maintenance. We developed the multichannel vibration monitering system of the self-diagnosis for middle level CMS(Condition Monitoring System) market, and that system are new features to the expandability and flexibility. Normally one channel is used for treating one signal, but developed instrument can treat four channel with one signal processing card. One rack have redundant power supply and displace and it can check vibration measurement value in field without computer. Bearing fault detection is fundamental of vibration surveillance, but sometimes can not check with vibration velocity and acceleration. So it need the filtering and the amplitude modulation on the acceleration enveloping technology when irregular vibration is happened. We developed the vibration analysis instrument which is applied such technology. And the development prototype shows activated within the vibration error limit.