• Particle and aerosol research
• /
• v.9 no.3
• /
• pp.127-132
• /
• 2013

Recently, Aerosol Deposition method has attracted considerable attention because of its advantages to produce ceramic coatings on various substrates at room temperature. This method is strongly dependent on the raw powder, which should have high mobility with carrier gas and moderate mechanical strength to be crushed onto the substrate. In this report, the effects of the ceramic granules' compressive strength on the ceramic coating formation are discussed. The ceramic granules were prepared by spray-drying method and heat treated at various temperatures. It was found that at the moderate mechanical strength of ceramic granules gave more effective film formation behavior during Aerosol Deposition method.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.16 no.2
• /
• pp.79-85
• /
• 1996

Prediction of fatigue life and monitoring of fracture process for adhesively bonded CFRP composites joint have been investigated by analysis of acoustic emission signals during the fatigue and tension tests. During fatigue test, generated acoustic emission is related to stored elastic strain energy. By results of monitoring of AE event rate, fatigue process could be divided into two regions, and boundaries of two regions, fatigue cycles of the initiation of fast crack growth, were 70-80% of fatigue life even though the fatigue life were highly scattered from specimen to specimen. The result shows the possibility of predicting catastrophic failure by acoustic emission monitoring.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.4
• /
• pp.739-743
• /
• 2006

In this paper, development of voice activated Universal Remote Control using the Neural Networks. A speaker dependent system is developed to operate for a single speaker. These systems are usually easier to develop, cheaper to buy and more accurate, but not as flexible as speaker adaptive or speaker independent systems. A speaker independent system is developed to operate for any speaker of a particular type (e.g. American English). These systems are the most difficult to develop, most expensive and accuracy is lower than speaker dependent systems. However, they are more flexible. A speaker adaptive system is developed to adapt its operation to the characteristics of new speakers. It's difficulty lies somewhere between speaker independent and speaker dependent systems. This paper is developed Speaker Adaptation using the Neural Networks.

• 한국약용작물학회:학술대회논문집
• /
• 2010.10a
• /
• pp.311-311
• /
• 2010

• Journal of the Korean Ceramic Society
• /
• v.46 no.5
• /
• pp.441-446
• /
• 2009

Dense crack-free yttria film with 10 $\mu m$ thickness was prepared on aluminum by aerosol deposition. X-ray diffraction pattern on the film showed that it contained the same crystalline phase as the raw powder. Transmission electron microscopy revealed a nanostructured yttria film with grains smaller than 100 nm. Tensile adhesion strength between the film and aluminum substrate was 57.8 $\pm$ 6.3MPa. According to the etching test with $CF_4-O_2$ plasma, the etching rate of the yttria film was 1/100 that of quartz, 1/10 that of sintered alumina and comparable to that of sintered yttria.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.26 no.6
• /
• pp.583-590
• /
• 2008

In construction work's design process, we must carry out a topographical survey for construction reserved land and to the basis of this, production of profile is indispensable factor for the purpose of every construction work such as road, rail way, canal and etc. From this research, the production of profile about construction reserved land, using topographical information of digital topographical map produced by NGIS project, construct precision 3D terrain model and from this, propose plans for utilizing by producing automatic profile. With the aim of this, extract every layers of main facilities and altitude from digital topographical map and while producing 3D terrain model by using this, we product automatic profile from precision 3D terrain model. And we was carried out to check whether the automatic produced profile's accuracy could be accepted at actual estimation by mutual analysis. It is considered that the result of the research could be suggested as a new techniques concept which can reduce the designing period and expenses and increase the efficiency of affair in the design process for the construction.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.20 no.1
• /
• pp.33-37
• /
• 2000

The 1-3 piezoelectric composite transducer with 75 volume percents PZT was fabricated by the dicing-filling method. The resonance modes of the 1-3 transducer have been studied with electric impedance measurement as a function of frequency. The fundamental frequencies of the planar and thickness mode were observed at 0.95MHz and 1.63MHz respectively, but the lateral mode was not observed. In the thickness mode, the electromechanical coupling coefficient of the 1-3 piezoelectric composite transducer, 0.54, was very closed to that of the single phase PZT(0.52). The pulse-echo response by exciting the 1-3 transducer with an electric pulse was observed from the water/reflector interface, and analyzed bandwidth by the spectrum of the impulse response. The quality factor Q for the 1-3 transducer was observed as 1.5 smaller than that of the single phase(80) and then the 1-3 transducer may be used to the broad band type transducer applications.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2008.05a
• /
• pp.1462-1466
• /
• 2008

본 연구에서는 청라지구 경제자유구역 개발사업의 일환으로 지구내 하천 및 공원에 최적의 주운시설을 도입하기 위한 방안을 모색하였다. 유역의 일반현황 및 국내외 사례조사를 통해 현재까지 진행된 주운관련 사례를 분석하여 적용가능성을 검토하였으며 이수, 치수, 환경 측면에서 주운시설 도입을 위한 종합적인 검토를 수행하였다. 물수지분석, 담수량 및 손실량 파악, 물갈이율 조사 등을 통해 필요수량을 파악하였으며, 산정된 필요수량 확보를 위해 하수처리장 고도처리수, 상수원수, 상수도, 유역관리 등의 다각도의 수량확보 방안을 검토하여 적용가능방안을 제시하였다. 또한 하천수질현황, 국내외 수질기준, 생태계 친수환경에 미치는 영향을 고려하여 목표수질을 설정하였으며, 유역, 하천, 호수공원 및 내부수로 등에 적용가능한 수질보전방안을 제시하였다. 인근하천, 중앙호수 공원, 내부수로를 동시에 고려하여 유역통합관리 차원의 치수안전성 확보 방안을 제시하였으며 주운시설 도입에 따른 추가적인 치수안전성 확보방안을 검토하였다. 특히 간척지라는 지역적 특수성을 고려하여 항구적인 치수 및 이수 대책의 필요성을 제시하였으며, 지속 가능한 개발을 위해 최첨단 유지관리 시스템의 도입 및 안전시설 확보를 통해 재해로 부터 안전한 주운계획을 제시하였다. 향후 청라지구-서해-굴포천 방수로-한강을 잇는 해상과 연계된 주운 개발을 통한 광역운하망 구축 방안을 제고하였다. 향후 주운시설의 도입에 따라 도시의 어매니티 증진과 친수도시 구현, 물순환 확보와 치수에 안전한 방재도시 수립이 가능할 것으로 판단되며 이를 통해 지속가능한 신도시 개발의 초석이 될 수 있을 것으로 사료된다.

• Journal of Appropriate Technology
• /
• v.6 no.2
• /
• pp.146-150
• /
• 2020

Assistive technologies for people with disabilities are often marginalized in the Fourth Industrial Revolution. In this paper, we intend to present the possibility of acquiring tactile information through the tactile display adapting an electromagnetic actuator. The multi-layered display designed for tactile communication has innovatively narrowed the size and spacing of cells in order to express pictures, maps, and graphics. This display has enabled the visually impaired to touch two-dimensional information combining with other assistive technologies so that. It would also provide a technical source of access to STEM education (Science, Technology, Engineering, and Mathematics) so that students will perform better and be better prepared for advanced education. Moreover, it can be applied to public infrastructure and transportation in smart-city projects on the globe. Hence, this paper introduces the principle of Electromagnetic-actuator and how it can be utilized in many diverse areas.

• Journal of Chest Surgery
• /
• v.33 no.11
• /
• pp.898-903
• /
• 2000

배경 및 목적: 최근 비디오 흉강경술은 최소 침습적인 수술 방법으로서 자연 기흉의 일반적 치료법으로 인정되고 있으나 비교적 높은 재발율과 비용-효용 관계에 대해서는 논란이 있다. 비디오 흉강경을 이용한 기포 절제술 후의 재발율은 평균 5-10%정도로 보고되고 있으며 이는 개흉술에 비해 상당히 높은 것이다. 또한 국내 의료 실정에서의 개흉술과 비디오 흉강경술의 비용효용에 대한 비교 통계는 없는 상황이다. 대상 및 방법: 1997년 1월부터 1999년 7월까지 일차성 자연기흉으로 성균관 의대 강북삼성병원 흉부외과에서 수술을 시행한 173예를 대상으로 후향적 조사하였다. 비디오 흉강경술로 시행한 104예와 개흉술로 시행한 69예를 양군으로 나누어 성별 및 연령, 발병부위, 수술의 적응증, 수술시간, 술 후 흉관 삽입기간 및 재원 일수, 술후 합병증, 재발율, 수술 경비 및 총치료경비 등을 비교하였다. 결과: 양군의 성별, 연령, 발병부위 등에는 차이가 없었다. 수술 시간은 흉강경군이 73.1$\pm$29.5분, 개흉군이 141$\pm$52분이었다.(p<0.05). 술 후 평균 흉관의 거치기간 및 재원일수는 흉강경군이 각각 3.93일 및 7.5일, 개흉군이 7.0일 및 13.4일이었다.(P<0.05, P<0.05). 술 후 재발한 경우가 비디오 흉강경군에서 6예(5.6%), 개흉군에서 1예(1.4%) 있었다(P<0.05). 본원에서 시행한 비디오 흉강경술과 개흉술의 비교에서 수술로 발생하는 비용은 비디오 흉강경군이 유의하게 높았으나 (1,202,192$\pm$178,992원, 1,005,669$\pm$311,531원; P<0.05) 총 치료비의 비교에서는 유의한 차이가 없었다.(1,946,110$\pm$487,440원, 1,793,912$\pm$308,079원; P=0.18). 결론: 비용 효용관계 및 재발율은 병원마다의 수술 수기 및 퇴원 정책등에 따라서 다소간의 차이가 있을 수 있으나 본원의 조사 결과에서는 비디오 흉강경술이 개흉술에 비해 비용-효과가 있다고 볼 수 없으며 재발율도 높았다.