• Journal of the Korea society of information convergence
• /
• v.7 no.1
• /
• pp.71-81
• /
• 2014

Paper inquire into centering around the judical precedent, futher more refer the literature on this subject by combination documentary method of study and that of law-interpretation and this aims to examine the basis and legitimacy of the legal superficies in customary law, the right of the tomb and present relevant precedents in an orderly manner.

• Journal of Korea Society of Industrial Information Systems
• /
• v.18 no.5
• /
• pp.39-44
• /
• 2013

In this paper, a Relaxation Oscillator with temperature compensation using BGR and ADC is presented. The current to determine the frequency of Relaxation Oscillator can be controlled. By adjusting the current according to the temperature using the code that is output from the ADC and BGR, was to compensate the output frequency of the temperature. It is fabricated in a 0.35 ${\mu}m$ CMOS process with an active area of $240{\mu}m{\times}210{\mu}m$. Current consumption is 600 ${\mu}A$ from a 5 V and the rate of change of the output frequency with temperature shows about ${\pm}1%$.

• Journal of the Korean GEO-environmental Society
• /
• v.12 no.1
• /
• pp.51-60
• /
• 2011

Electrical resistivity is applied for understanding details about layers and obtaining basic properties of soils to various measurement devices. The objective of this study is development of TRP(Temperature-compensated Resistivity Probe), analysis about effects of temperature changes during cone penetration test, and observation of characteristics of cone penetration. In order to observation of temperature changes according to a diameter difference of resistivity cone probe, the cone which has wedge type cone tip is made to two types, 2mm and 5mm. Temperature sensor is attached at 15mm below from cone tip because of an electrical interference with elecrical resistance probe. Delectrical connector is used to prevent electric disturbance between motor type penetrating machine and electrical resistivity cone probe. Application tests are carried out in acrylic cell whose diameter is 30cm with uniform Jumunjin sand according to densification caused by blows. The test results indicate that the temperature is increased uniformly during penetration and a tendency, characteristics of cone penetration, is discovered during altering state of soils. This study suggests that the temperature effects and characteristics of penetration should be considered in penetrating tests in order to conduct an accurate ground investigation using TRP(Temperature-compensated Resistivity Probe).

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.43 no.12 s.354
• /
• pp.1-7
• /
• 2006

An on chip voltage down converter (VDC) using the self temperature-compensation techniques is proposed. At a different gate bias voltage, PMOSFET shows different source to drain current characteristic according to the temperature variation. The proposed VDC can reduce its temperature dependency by the source to drain current ratio of two PMOSFET with different gate bias respectively. Proposed circuit is fabricated in Dongbu-anam $0.18{\mu}m$ CMOS process and experimental results show its temperature dependency of $-0.49mV/^{\circ}C$ and external supply dependency of 6mV/V. Total current consumption is only $1.1{\mu}A@2.5V$.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1992.10a
• /
• pp.396-399
• /
• 1992

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1995.06a
• /
• pp.737-740
• /
• 1995

• Proceedings of the Optical Society of Korea Conference
• /
• 2009.10a
• /
• pp.347-348
• /
• 2009

• Journal of Sensor Science and Technology
• /
• v.4 no.2
• /
• pp.29-36
• /
• 1995

A constant solid state flow velocity/mass sensor has been fabricated and its characteristics were measured according to flow velocity and fluid temperature. Parameters of the sensor circuit were obtained by simulation using finite difference method. Sensitivity was 10mW/(cm/sec) in the range of flow velocity 0-45cm/sec and response time was within two seconds. For the experiment of fluid temperature variation, the sensor output was compensated at the rate of temperature variation $0.1^{\circ}C/min$, however, with the rate of $0.2^{\circ}C/min$ it took two minutes to be compensated. Since it is not quite often to have such a rate of temperature variation of $0.2^{\circ}C/min$ or more, the developed sensor output can be used for most applications to detect small amount of flow-rate.

• Journal of KIISE:Information Networking
• /
• v.37 no.5
• /
• pp.403-408
• /
• 2010

The sensor nodes can be installed in the environment in which the temperature change is considerable, such as desert, urban, and data center. Particularly, because the output power becomes less than the targeted power if a temperature is increasing, link quality is degraded and packet losses are occurred. In order to compensate the temperature changes, existing schemes detect the change of the link quality between nodes and control transmission power through a series of feedback process. However, these approaches can cause heavy overhead by additional control packets. In this paper, we propose the T2PC(Temperature-aware Transmission Power Control) to keep up the link quality despite temperature variation. At each node, T2PC compensates the attenuated link quality by controlling the transmission power based on the local temperature measurement. In addition, the packet reception ratio can be improved with less control packets than ones required in existing transmission power control methods based on the feedback control.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.20 no.4
• /
• pp.129-133
• /
• 2020

In this paper, a temperature compensation circuit is presented in order to mitigate gain variability due to temperature in the W-band low-noise amplifier (LNA). The proposed cascode temperature compensation bias circuit automatically controls gate bias voltages of the common-source LNA in order to suppress variations of small-signal gain. The designed circuit was realized in a 100-nm GaAs pHEMT process. The simulated voltage gain of W-band LNA including the proposed bias circuit is >20 dB with gain variability less than ±0.8 dB in the range of temperatures between -35 to 71℃. We expect that the proposed circuit contributes to millimeter-wave receivers for stable performances in radar applications.