• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.2
• /
• pp.9-18
• /
• 2004

OFDM is a special case of multicarrier transmission, where a high-rate datastream is transmitted over a number of lower rate subcarriers. In this paper, the structure of ORM system is studied, and causes of inter carrier interference (ICI) are analyzed. Based on analysis, this paper shows a technique to prevent a distortion due to nonlinearity of high power amplifier. The proposed scheme is a predistorter(PD) for high power amplifier linearization in OFDM system. This is verified by comparing BER characteristics of OFDM system, between used PD and not used PD, and superiority is shown by comparing BER characteristics of OFDM system, between used the proposed PD and used some other PDs.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.2
• /
• pp.11-17
• /
• 2009

This paper presents a new adaptive relay selection scheme for a regenerative orthogonal frequency division multiplexing access(OFDMA) relay network with fairness constrains. In the Proposed scheme, we select the best M relays out of a set of K potential relays to maximize system capacity. Among these selected relays, subcarriers are reallocated to satisfy fairness constraints as well as to minimize the degradation of the system performance. Afterwards, power allocation is performed for each subcarrier based on the water-filling method to enhance the performance improvement. By using the trade-off relationship between the system capacity and the fairness, the modified version of proposed scheme is also investigated.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.11
• /
• pp.26-32
• /
• 2014

Single-Carrier Frequency division multiplexing (SC-FDM) has been selected for the uplink transmission technique in 3GPP-LTE since it has an advantage of low peak-to-average power ratio (PAPR) in user's perspective. The receiver typically uses a frequency domain equalizer, which, however, suffers from noise boost and/or residual ISI especially when the channel has deep nulls. In this paper, we propose using turbo equalizer to mitigate such a problem. We provide link level performance comparison and an insight into how many iteration is needed for reasonable performance and complexity.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.37 no.10
• /
• pp.26-36
• /
• 2000

In this paper, we design the nonoverlapping multicarrier modulation (MCM) system for high rate paging system and evaluate the Performance by computer simulation. In conventional paging system, FSK was usually used, but we select QAM for high bandwidth efficiency. Transmitter structure adopts that of 4-16QAM of the iDEN$\^$TM/ and receiver consists of symbol timing recovery, carrier recovery and automatic gain control. In addition, pilot symbol aided modulation (PSAM) which can overcome the simulcast fading channel is considered and we also propose the optimum pilot symbol pattern. Finally, we show the performance of the overall 4-16QAM system by computer simulation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.6A
• /
• pp.465-473
• /
• 2005

In this paper, the reduction scheme of Interchannel Interference(ICI) caused by the phase noise in Orthogonal Frequency Division Multiplexing(OFDM) systems for archiving high data rates is proposed. The performance of conventional common phase error(CPE) compensation method is degraded by the phase noise with wide 3dB bandwidth in OFDM systems width a higher-order constellation. After estimating dominant ICI coefficients using pilot subcarriers and data subcarriers adjacent to pilot subcarriers, the proposed scheme compensates OFDM signals distorted by the phase noise using estimated coefficients in the time or frequency domain. Also, in order to determine the length of dominant ICI coefficients effectively, the estimation method of the 3dB bandwidth of the phase noise is proposed. The proposed phase noise reduction method is shown to improve the Bit Error Ratio(BER) performance compared with the conventional CPE compensation.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.4
• /
• pp.24-31
• /
• 2011

A high data rate Medical Implant Communications Service (MICS) transmitter for implantable medical devices (IMD) is proposed. An orthogonal frequency division multiplexing (OFDM)-based multicarrier scheme is used to overcome the data rate limitation caused by the narrow bandwidth of 300 kHz. The proposed transmitter utilizes multiple MICS channels simultaneously, supporting increased data rate. To satisfy the MICS regulation, various schemes are applied including optimized subcarrier allocation and inverse fast Fourier transform (IFFT) architecture, and additional sidelobe suppression technique. Simulation results show that the proposed transmitter can support a maximum data rate of 4.86 Mbps, which is more than ten times faster than the previous systems.

• 전자공학회논문지 IE
• /
• v.43 no.2
• /
• pp.80-86
• /
• 2006

The wireless communication based on LDPC and adaptive spatial-subcarrier coded modulation using MQAM for orthogonal frequency division multiplexing (OFDM) wireless transmission by using instantaneous channel state information and employing multiple antennas at both the transmitter and the receiver. Adaptive coded modulation is a promising idea for bandwidth-efficient transmission on time-varying, narrowband wireless channels. On power limited Additive White Gaussian Noise (AWGN) channels, low density parity check (LDPC) codes are a class of error control codes which have demonstrated impressive error correcting qualities, under some conditions performing even better than turbo codes. The paper demonstrates OFDM with LDPC and adaptive modulation applied to Multiple-Input Multiple-Output (MIMO) system. An optimization algorithm to obtain a bit and power allocation for each subcarrier assuming instantaneous channel knowledge is used. The experimental results are shown the potential of our proposed system.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2003.10a
• /
• pp.369-372
• /
• 2003

This paper describes a design of OFDM (Orthogoanl Frequency Division Multiplexing) based wireless LAN system receiver, defined in IEEE 802.11a standards. Because OFDM system uses several orthogonal sequence sets, it ran avoid selective fading of fast data transfer problem when it is used with error correction code. But if the receiver is not synchronized, the orthogonal of between sub-ralliers will be destroyed and the data interruption will be generated. So it makes error property get worse very murk. For improving the noise error, we use the relationship of phasor between sub-carriers and make system synchronization using one tab equalizer. The designed OFDM block is described by Verilog HDL for the efficient and small size hardware. And we preform the functional verification and evaluation using the vector of standards.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.4A
• /
• pp.402-411
• /
• 2006

In OFDMA system, multiple users transmit signal through the subcarriers assigned to the user. Capabilities of high data-rate transmission in OFDMA system come from the ability to compensate the ICI (Inter Carrier Interference) using a single-tap equalizer and to implement transmitter and receiver by employing high speed FFT circuitry. Issues of time and frequency synchronization in OFDM system is quite essential to preserve the orthogonality among subcarriers not to produce ICI. In this paper, we Int analyze the preamble used in 802.16 d/e and WiBro system. Then we propose an effective timing synchronization algorithm, which is more accurate than the conventional one in the sense of timing position, and integral frequency offset estimation scheme for the simultaneouse estimation of the fractional and integral frequency offset. Through the simulation utilizing the proposed synchronization algorithm and structure, we show that the performance degradation due to the adjacent channel interference can be mitigated for the than conventional ones.

• Journal of IKEEE
• /
• v.15 no.4
• /
• pp.281-286
• /
• 2011

DVB-T2 is a next generation DTV transmission standard, which supports various channel bandwidths. Since the symbol rate of the DVB-T2 signal is changed according to its bandwidth, the received signal needs to be sampled at a different frequency. The sampling frequency should be also adjusted depending on the sampling frequency offset due to the frequency error in the local oscillator. The sampling frequency can be locked into the symbol frequency by resampling the sampled data by ADC running at a fixed frequency. In this paper a resampler architecture for DVB-T2 is proposed. And the simulation results reveal the spectral characteristics of each subcarriers used in DVB-T2 system.