• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.33 no.6
• /
• pp.321-332
• /
• 2021

The crown wall with parapet on top of the rubble mound breakwater represents a relatively economic and efficient solution to reduce the wave overtopping discharge. However, the inclusion of parapet leads to increased wave pressure on the crown wall. The wave pressure on the crown wall is investigated by physical model test. To design the crown wall the wave loads should be available, and the horizontal wave pressure is still unclear. Regarding to the horizontal wave pressure on the crown wall, a series of experiments were conducted by changing the rubble mound type structure and the wave conditions. Based on these results, pressure modification factors of Goda's (1974, 2010) formula have been suggested, which can be applicable for the practical design of the crown wall of the rubble-mound breakwater covered by tetrapods.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.42 no.4
• /
• pp.469-480
• /
• 2022

To design the crown wall of rubble-mound breakwaters, the horizontal wave load should be available, but determining this load remains difficult. Lee et al. proposed modification factors for Goda's formula for the horizontal wave pressures on acrown wall. The empirical formula by Lee et al. was based on a two-dimensional model test with a relatively narrow armour crest width in front of the crown wall. In this study, a series of experiments at the same facility were conducted on the horizontal wave pressures on the crown wall of a rubble-mound breakwater with a wide armour crest width. As a result, the pressures of the unprotected part of the crown wall were nearly identical to the narrow crest width. However, the pressures of the protected part tended to decrease with a change in the armour crest width. From the experimental results, the horizontal pressure modification factors of Goda's formula including the armour crest width effect are suggested here and are likely applicable to practical designs of the crown walls of rubble-mound breakwaters covered with tetrapods.

• 어항어장
• /
• s.32
• /
• pp.56-58
• /
• 1995

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.29 no.4
• /
• pp.198-205
• /
• 2017

Two-dimensional hydraulic model experiments on rubble mound structure armoring with the tetrapods and the superstructure were conducted to investigate wave transmission characteristics under irregular wave conditions. The previous studies about the wave transmission coefficients dealt with the low crested structures, therefore the rock was the main armor units and the superstructure was not constructed. In this study, the new empirical design formula for the wave transmission coefficient about rubble mound structure with the tetrapods and the superstructure was suggested and the effects of wave steepness and the row of the tetrapods in front of the superstructure could be considered.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.27 no.3
• /
• pp.175-181
• /
• 2015

In this study, two dimensional wave overtopping tests for vertical wall were performed and overtopping formulas were suggested for impulsive and non-impulsive wave conditions. The test results from this study were compared with those from EurOtop(2007). The wave overtopping formulas were derived and suggested considering the recent research trends, while the existing method used the diagram. The wave overtopping formulas have the form of exponential and power functions using non-dimensional variables for wave overtopping and freeboard heights for non-impulsive and impulsive condition, respectively. The wave overtopping formula and effective parameters for inclined superstructure were also suggested. It is analyzed that the locations of inclined superstructure do not have the significant effects on wave overtopping, that is, the wave overtopping rate were almost same for each locations.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.35 no.5
• /
• pp.102-108
• /
• 2023

In this study, hydraulic model tests were performed to investigate the stability of armor units at harbor side slope for rubble mound structures. The armor units on the rear slope were rocks. The Korean design standard for harbor and fishery port suggested the design figures that showed the ratio of the armor weight for each location of rubble mound structures and it could be known that the same weight ratio was needed to the sea side and rear side slope of rubble mound structures. The crest elements were commonly applied to the design process of rubble mound structures in Korea and the investigation of the effects of super structures would be needed. The damage rate (S =2) was applied and the stable wave height was measured for each test condition. The results were suggested as the armor weight ratio of the rear side slope(armor rock) to the sea side slope (tetrapod) in relation to the relative crest height.

• Magazine of the Korea Concrete Institute
• /
• v.12 no.4
• /
• pp.77-82
• /
• 2000

• Proceedings of the Korean Society of Coastal and Ocean Engineers Conference
• /
• 2003.08a
• /
• pp.98-102
• /
• 2003

지금까지 실무에서는 경사식 방파제 적정 단면 결정시 피복재 산정 및 설계파에 대한 파력을 산정하여 상치콘크리트 구조물의 안정성을 검토하는 것이 전부였다 하지만 현장에서 발생하는 상황은 더 많은 변수들이 작용하는 것을 보여 주고 있다. 예를 들면 파에 의하여 발생하는 투과파 및 월파로 제체의 내부 및 배면 석재의 이탈이 발생하는 경우는 익히 보아 왔던 일이지만, 반대로 월파가 발생하지 않았는데도 불구하고 제체의 침하와 배면의 석재에 이탈 즉 세굴이 발생하는 경우도 있다. (중략)

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.33 no.6
• /
• pp.357-366
• /
• 2021

In this study, hydraulic model tests were performed to investigate the stability of armor units at harbor side slope for rubble mound structures. The Korean design standard for harbor and fishery port suggested the design figures that showed the ratio of the armor weight for each location of rubble mound structures and it could be known that the same weight ratio was needed to the sea side and harbor side (within 0.5H from the minimum design water level) slope of rubble mound structures. The super structures were commonly applied to the design process of rubble mound structures in Korea and the investigation of the effects of super structures would be needed. The stability number (N_od = 0.5) was applied (van der Meer, 1999) and it showed that the armor (tetrapod) weight ratio for harbor side slope of rubble mound structures needed 0.8 times of that for sea side slope.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.35 no.6
• /
• pp.155-163
• /
• 2023

A two-dimensional numerical analysis was performed on the depth of pile embedment, the magnitude of the residual water level, and the condition of the presence or absence of cap concrete to understand the behavior of the block-type quay wall with piles. The results showed the control effect of the lateral displacement of the quay wall depending on the embedment of the pile. When the piles were not embedded, the lateral displacement of the quay wall increased proportionally as the residual water level difference increased. In contrast, when the piles were embedded into the ground, the control of the lateral displacement of the quay wall was greatly exerted even if the residual water level difference increased. There was little difference in the lateral displacement of the block-type quay wall regardless of the presence or absence of cap concrete. Under the condition where the piles were embedded down to the rubble mound layer, the piles exhibited the rotational behavior seen in the short piles. As the embedment depth of the piles increased, the piles showed the same bending behavior as the intermediate piles. Thus, the piles significantly contribute to the control of lateral displacement in the block-type quay wall with piles.