• Journal of the Korean Chemical Society
• /
• v.49 no.6
• /
• pp.531-536
• /
• 2005

• Korean Journal of Optics and Photonics
• /
• v.34 no.3
• /
• pp.117-123
• /
• 2023

The size of an optical surface can significantly affect the performance of an optical system, and high spatial frequency errors have a greater impact. Therefore, it is crucial to measure the surface figure error with high frequency. To address this, a new method called rotational prism stitching interferometer (RPSI) is proposed in this study. The RPSI is a type of stitching interferometer that enhances spatial resolution, but it differs from conventional stitching interferometers in that it does not require the movement of either the mirror tested or the interferometer itself to obtain sub-aperture interferograms. Instead, the RPSI uses a beam expander and a rotating Dove prism to select particular sub-apertures from the entire aperture. These sub-apertures are then stitched together to obtain a full-aperture result proportional to the square of the beam expander's magnification. The RPSI's effectiveness was demonstrated by measuring a 40 mm diameter spherical mirror using a three-magnification beam expander and comparing the results with those obtained from a commercial interferometer. The RPSI achieved surface testing results with nine times higher sampling density than the interferometer alone, with a small difference of approximately 1 nm RMS.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.22 no.1
• /
• pp.63-71
• /
• 2004

This research is to reconstruction of railway alignment using GPS data, an investigation is made on the method of optimum simplification for reduction of unnecessary linear data, improve the accuracy by using four simplification algorithms among the methods. By applying two measured of displacement between observed data and it's simplification methods have been evaluated. The results showed that the complexities of lines is not practical to investigate simplification algorithms, the Douglas-Peucker method produced a little displacement between observed data and it's simplification. Its by using the Douglas-Peucker method to observed linear GPS data in railway track, design elements of horizontal alignment have been calculated. Then we could know that obtain the good results fur reconstruction of alignment elements through the methods and algorithns of this study.

• Korean Journal of Optics and Photonics
• /
• v.31 no.3
• /
• pp.125-133
• /
• 2020

An innovative method for separating overlapping latent fingerprints, using laser-induced plasma spectroscopy (LIPS) combined with multivariate analysis, is reported in the current study. LIPS provides the capabilities of real-time analysis and high-speed scanning, as well as data regarding the chemical components of overlapping fingerprints. These spectra provide valuable chemical information for the forensic classification and reconstruction of overlapping latent fingerprints, by applying appropriate multivariate analysis. This study utilizes principal-component analysis (PCA) and partial-least-squares (PLS) techniques for the basis classification of four types of fingerprints from the LIPS spectra. The proposed method is successfully demonstrated through a classification example of four distinct latent fingerprints, using discrimination such as soft independent modeling of class analogy (SIMCA) and partial-least-squares discriminant analysis (PLS-DA). This demonstration develops an accuracy of more than 85% and is proven to be sufficiently robust. In addition, by laser-scanning analysis at a spatial interval of 125 ㎛, the overlapping fingerprints were separated as two-dimensional forms.

• Journal of the Korea Society of Computer and Information
• /
• v.25 no.2
• /
• pp.49-58
• /
• 2020

In this study, we solve an online multi-object problem which finds object states (i.e. locations and sizes) while conserving their identifications in online-provided images and detections. We handle this problem based on a tracking-by-detection approach by linking (or associating) detections between frames. For more accurate online association, we propose novel online appearance learning with discrete fourier transform and partial least square analysis (PLS). We first transform each object image into a Fourier image in order to extract meaningful features on a frequency domain. We then learn PLS subspaces which can discriminate frequency features of different objects. In addition, we incorporate the proposed appearance learning into the recent confidence-based association method, and extensively compare our methods with the state-of-the-art methods on MOT benchmark challenge datasets.

• Transactions of the Korean Society of Machine Tool Engineers
• /
• v.15 no.5
• /
• pp.1-6
• /
• 2006

The purpose of this study is to develop to portable near infrared analyzer measuring the sugar content of the fruits on a tree before harvesting ones. The portable near infrared system consists of a tungsten lamp, a coaxial optical fiber bundle and a multi-channel detector, which has 256 pixels and a concave transmission grating. Reflectance NIR spectra of orange were recorded by using a coaxial optical fiber bundle. The spectra were collected over the spectral range $400{\sim}1100nm$. Partial least squares regression(PLSR) was applied for a calibration and validation for determination of sugar contents. The multiple correlation coefficient was 0.99 and standard errors of calibration(SEC) was 0.069 brix. The calibration model predicted the sugar content for validation set with standard errors of prediction(SEP) of 0.092 brix. The sugar content in fruits was successfully quantified using the portable near infrared analyzer.

• Journal of the Korean Society of Safety
• /
• v.34 no.4
• /
• pp.59-67
• /
• 2019

Since it is really hard to construct process models based on prior process knowledges, various statistical approaches have been employed to build fault diagnosis models. However, the crucial drawback of these approaches is that the solutions may vary according to the fault magnitude, even if the same fault occurs. In this study, the parameter monitoring approach is suggested. When a fault occurs in a chemical process, this leads to trigger the change of a process model and the monitoring parameters of process models is able to provide the efficient fault diagnosis model. A few important variables are selected and their predictive models are constructed by partial least square (PLS) method. The Euclidean norms of parameters of PLS models are estimated and a fault diagnosis can be performed as comparing with parameters of PLS models based on normal operational conditions. To improve the monitoring performance, cumulative summation (CUSUM) control chart is employed and the changes of model parameters are recorded to identify the type of an unknown fault. To verify the efficacy of the proposed model, Tennessee Eastman (TE) process is tested and this model can be easily applied to other complex processes.

• Resources Recycling
• /
• v.27 no.1
• /
• pp.84-91
• /
• 2018

In this study, a novel soft information based most probable classification scheme is proposed for sorting recyclable metal alloys with laser induced breakdown spectroscopy (LIBS). Regression analysis with LIBS captured spectrums for estimating concentrations of common elements can be efficient for classifying unknown arbitrary metal alloys, even when that particular alloy is not included for training. Therefore, partial least square regression (PLSR) is employed in the proposed scheme, where spectrums of the certified reference materials (CRMs) are used for training. With the PLSR model, the concentrations of the test spectrum are estimated independently and are compared to those of CRMs for finding out the most probable class. Then, joint soft information can be obtained by assuming multi-variate normal (MVN) distribution, which enables to account the probability measure or a prior information and improves classification performance. For evaluating the proposed schemes, MVN soft information is evaluated based on PLSR of LIBS captured spectrums of 9 metal CRMs, and tested for classifying unknown metal alloys. Furthermore, the likelihood is evaluated with the radar chart to effectively visualize and search the most probable class among the candidates. By the leave-one-out cross validation tests, the proposed scheme is not only showing improved classification accuracies but also helpful for adaptive post-processing to correct the mis-classifications.

• Proceedings of the Korean Society for Agricultural Machinery Conference
• /
• 2017.04a
• /
• pp.146-146
• /
• 2017

현대의 스마트폰 및 태블릿pc등을 가능하게 만든 집적 기술 중의 하나는 3차원 집적 회로(3D-IC)와 같은 패키징 기술이다. 이러한 첨단 3차원 집적 기술은 메모리집적을 통한 대용량 메모리 모듈 개발뿐만 아니라, 메모리와 프로세서의 집적, high-end FPGA, Back side imaging (BSI) 센서 모듈, MEMS 센서와 ASIC 집적, High Bright (HB) LED 모듈 등에 적용되고 있다. 3D-IC의 3차원 모듈 제작 시에는 기존에 발생하지 않았던 여러 가지 파괴 모드들이 발생하고 있는데 Thermal/Photonic Emission 장비 등 기존의 2차원 결함분리 (Fault Isolation) 기술로는 첨단의 3차원 적층 제품들에서 발생하는 불량을 비파괴적으로 혹은 3차원적으로 분리하는 것이 불가능하므로, 비파괴 3차원 결함 분리 기술은 향후 선행 제품 적기 개발에 매우 필수적인 기술이다. 본 연구는 3D-IC 반도체의 비파괴적 내부결함 검사를 위하여 가시광선-근적외선 대역(351nm~1770nm)의 InGaAs (Indium Galium Arsenide) 계열 영상검출기 (imaging detector)를 사용하여 분광 시스템 광학 설계를 통한 초분광 영상 기반 검출 모듈을 제작하였다. 제작된 초분광 영상 기반 검출 모듈을 이용하여 구리 회로 위에 실리콘 웨이퍼가 3단 적층 된 반도체 더미 샘플의 초분광 영상을 촬영하였으며, 촬영된 초분광 영상에 대하여 Chemometrics model 기반의 분석기술을 적용하여 실리콘 웨이퍼 내부의 집적 구조에 대한 검사가 가능함을 확인하였다.

• Journal of Industrial Convergence
• /
• v.21 no.8
• /
• pp.119-127
• /
• 2023

This study was conducted to investigate the structural relationship between depression, self-esteem, and social withdrawal that affect academic helplessness in adolescents. The study sample was 2,265 first-year students of high school in the fourth year (2021) data from the Korean Children and Youth Panel Survey 2018. In this study, data were analyzed by a structural equation model based on the partial least squares method using SmartPLS 3.0. Results indicated that depression and social withdrawal had a significant positive effect on adolescents' academic helplessness, and self-esteem had a significant negative effect. In addition, social withdrawal had a significant positive mediating effect on the relationship between depression and academic helplessness. Therefore, it is required strategies that consider the relationship between depression, self-esteem, and social withdrawal to approach adolescents' academic helplessness.