• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.6
• /
• pp.788-801
• /
• 1998

Meteor Burst Communication can provide effective and economical means of communication where long distance VHF NLOS data transmission is needed ; often ranges more than 1000 km. It has been, however, so far considered unsuitable for short distance application because of phenomenal decrease in burst durations, which leads to decreation of total duty rate of the system. This paper extensively analyzes characteristics of shot distance MB(Meteor Burst) path and shows the low duty rate may be improved by increasing burst rate through adapting antennal beam width to cover entire hot-spot region in the space and, by compensating effective burst length throughcutting down man-made noises introduced by antennal. Based on the analysis, we are developed a small-opening-cavity antennal, especially designed for short distance MB path. In operation, the antenna is to be buried under ground surface so as to improve directivity and reduces noise introduction. The antennal exhibits power gain of 3 dB with 90 degree beam width and thus enables to illuminate entire hot-spot regions with the elevation angle of 8-90 degree which is the case of transmission less than 100 km. Directivity horizontal to earth surface is suppressed to minimum which enables to cut man-made noises from near-by sources down to more than 3 dB from the level reported with conventional 4 element Yagi. A series of experiments performed on 100km MB paths have conformed that, with the antenna installed at receiving site, the burst rate and duration time have been noticed to increase by 10 and 20 percent respectively from the values obtained by conventional 4-element Yagi antennal under same testing condition.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.16 no.11
• /
• pp.1054-1062
• /
• 1991

In this paper a communication system using direct sequence spread spectrum (DS/SS) technique is constructed to transmit burst format data over power line channel with impulsive noise and narrowband interferences. Fast code synchronization is acquired by digital matched filter and data decision is accomplished by sampling pulses. In order to examine the performance of the power line communication system, but error rate and packet loss rate are measured over the simulation channel with various noise sources. When the packet composed of 1-bit preamble and 63-bit data is transmitted under very high burst impulsive noise, the bit error rate is about 10$^3$-10$^4$ and the packet loss rate is below 0.07.

• The Journal of the Acoustical Society of Korea
• /
• v.21 no.3
• /
• pp.323-329
• /
• 2002

This paper proposes a frame reliability weighting method to compensate for a time-selective noise that occurs at random positions of speech signal contaminating certain parts of the speech signal. Speech frames have different degrees of reliability and the reliability is proportional to SNR (signal-to noise ratio). While it is feasible to estimate frame Sl? by using the noise information from non-speech interval under a stationary noisy situation, it is difficult to obtain noise spectrum for a time-selective noise. Therefore, we used statistical models of clean speech for the estimation of the frame reliability. The proposed MFR (model-based frame reliability) approximates frame SNR values using filterbank energy vectors that are obtained by the inverse transformation of input MFCC (mal-frequency cepstral coefficient) vectors and mean vectors of a reference model. Experiments on various burnt noises revealed that the proposed method could represent the frame reliability effectively. We could improve the recognition performance by using MFR values as weighting factors at the likelihood calculation step.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1998.06a
• /
• pp.1017-1020
• /
• 1998

• Proceedings of the Korean Information Science Society Conference
• /
• 1999.10c
• /
• pp.247-249
• /
• 1999

본 논문은 복사전력에 제한을 받고 많은 잡음 채널로 전송채널이 심한 영향을 받는 이동통신망이나 위성통신망과 같은 무선 전송채널에서 버스트 오류로 인해 발생하는 통신불능 현상을 해결하기 위해 암호문에 인터리빙 기법을 제안하고 이 기법을 통해 전송성능을 개선한다. 전송성능을 개선하기 위해서는 송신되는 암호문을 암호문의 구조에 적합하도록 인터리빙기법을 설계하여 전송함으로써 버스트 오류가 발생할 경우에 안전하게 암호문을 수신함으로써 robust한 암호통신을 가능하도록 하였다. 본 논문은 무선채널에서 적합한 스트림암호 체계를 설계하였고 스트림암호를 통해 전송시 발생되는 동기패턴, 세션키, 암호문을 인터리빙 기법을 통하여 전송함으로써 버스트 오류로부터 암호문을 보호하고 전송성능을 개선하였다.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 1999.05a
• /
• pp.254-260
• /
• 1999

Meteor Burst Communication can provide effective and economical means of communication where long distance VHF NLOS data transmission is needed; often ranges more than 1000 km. It has been, however, so far considered unsuitable for short distance application because of phenomenal decrease in burst durations, which leads to decreation of total duty rate of the system. This paper extensively analyzes characteristics of shot distance MB(Meteor Burst) path and shows the low duty rate may be improved by increasing burst rate through adapting antenna beam width to cover entire hot-spot region in the space and, by compensating effective burst length through cutting down man-made noises introduced by antenna. Based on the analysis, we are developed a small-opening-cavity antenna, especially designed for short distance MB path. In operation, the antenna is to be buried under ground surface so as to improve directivity and reduces noise introduction. The antenna exhibits power gain of 3 dB with 90 degree beam width and thus enables to illuminate entire hot-spot regions with the elevation angle of 8-90 degree which is the case of transmission less than 100 km. Directivity horizontal to earth surface is suppressed to minimum which enables to cut man-made noises from near-by sources down to more than 3 dB from the level reported with conventional 4 element Yagi. A series of experiments performed on 100 km MB paths have conformed that, with the antenna installed at receiving site, the burst rate and duration time have been noticed to increase by 10 and 20 percent respectively from the values obtained by conventional 4-element Yagi antenna under same testing condition.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 1999.05a
• /
• pp.243-247
• /
• 1999

For the purpose of LAN or data transmission line design with high speed and reliability using power lines, in this paper, we present CSK/SS-DS signal transmission characteristics simulations with changing channel characteristics due to impedance fluctuation. And we also simulated the signal transmissions with a strong impulsive burst noise and with a gaussian random noise. We introduce a simple channel equalization filtering method that solves the synchronization problem of CSK/SS-DS with fluctuating channel characteristics or low S/N ratio.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.4
• /
• pp.470-476
• /
• 2008

In this paper, we describe the cause of TDMA noise and distinction method of TDMA noise source in a GSM mobile phone. The causes of TDMA noise are composed of RF(Radio Frequency) energy coupling and low frequency energy coupling by burst ripple. We propose the distinction method of TDMA noise source from output(TDMA noise measurement) and frequency response of a system(audio path). Especially we propose a method of insertion loss($S_{21}$) analysis and the improvement method for RF energy coupling. Capacitor(40 pF) is a solution to reduce RF energy coupling and therefore TDMA noise was reduced by 10 dB.

• The Transactions of the Korea Information Processing Society
• /
• v.7 no.6
• /
• pp.1923-1931
• /
• 2000

In this paper, e analyze the performance of the PSS-type Viterbi decoder which can reduce calculations and power consumption using the Monte Carlo simulations. Gaussian and burst noise channels are considered in this simulation, and we achieve that convolutional interleaver can reduce complexity and power consumption in burst noise channel. In order to implement the high-speed PSS-type Viterbi decoder, the architectures of decoder are presented, and we implemented the PSS-type Viterbi decoder for r=1/2, k=3 using the VHDL tool, and prove the decoding process.

• Proceedings of the Korea Society for Industrial Systems Conference
• /
• 1997.11a
• /
• pp.435-449
• /
• 1997

In this paper, a new metric, universal metric, is Proposed for sequential decoding of convolutional decoding. The complexity of Fano metric for Fano's sequential decoding algorithm is compared with that of the proposed universal metric. Since the Fano metric assumes that it has previous knowledge of channel transition probability, the complexity of Fano metric increases as the assumed channel error probability does not coincide with the true channel error probability. However, the universal metric dose not require the previous knowledge of the channel transition probability since it is estimated on a branch by branch basis. It is shown that the complexity of universal metric is much less than that of the Fano metric for bursty noisy channel.