• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.11
• /
• pp.45-52
• /
• 2005

In this paper, we propose the PLL system of the local oscillator system for the millimeter wave band's radio astronomy receiving system. The development of the proposed local oscillator system based on the YIG oscillator VCO with $26.5\~40GHz$ specification. This system consists of the oscillator part including the YIG VCO, the harmonic mixer, and the isolator, the RF processing part including the triplexer, limiter, and RF discrimination processor, and the PLL system including YIG modulator and controller. Based on this configuration, we verify the frequency and power stability of the developed local oscillator system according to some temperature variation. From this test results we confirm the stable output frequency and power characteristic peformance of the developed LO system at constant temperature.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.40 no.6
• /
• pp.8-15
• /
• 2003

In this paper, the issue of the differential ring oscillator in designing low phase noise is linearity improvement of delay cell's load resistor. A novel differential delay cell that improves on the Maneatis load is proposed. The linearity improvement of load resistor results in lower phase noise in ring oscillator. For comparison of the phase noise characteristics, Ali Hajimiri's phase noise model is used. In order to have a low ISF(impulse sensitivity function), it is important to have a symmetry between rise time and fall time of oscillation waveform. The ISF value of ing oscillator based on the proposed delay cell is lower than that of the existing ring oscillators. Due to this result, the phase noise is improved by 2~3dBc/Hz for the same power dissipation and oscillation frequency.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.18 no.6
• /
• pp.1023-1030
• /
• 2023

FMCW LiDAR system with robust target detection capabilities even under adverse operating conditions such as snow, rain, and fog is addressed in this paper. Our focus is primarily on enhancing the performance of FMCW LiDAR by improving the characteristics of the frequency-modulated laser, which directly influence range resolution, coherence length, and maximum measurement range etc. of LiDAR. We describe the utilization of an unbalanced Mach-Zehnder laser interferometer to measure real-time changes of the lasing frequency and to correct frequency modulation errors through an optical phase-locked loop technique. To extend the coherence length of laser, we employ an extended-cavity laser diode as the laser source and implement a laser interferometer with an photonic integrated circuit for miniaturization of optical system. The developed FMCW LiDAR system exhibits a bandwidth of 10.045GHz and a remarkable distance resolution of 0.84mm.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.12
• /
• pp.16-21
• /
• 2007

In this paper, the dual-band voltage-controled oscillator (VCO) using the composite right/left-handed (CRLH) transmission line (TL) and the tunable negative resistance based on the fin diode is presented. It is demonstrated that the CRLH TL can lead to metamaterial transmission line with the dual-band tuning capability. The dual-band operation of the CRLH TL is achieved by the frequency offset and the phase slope of the CRLH TL, and the frequency ratio of the two operating frequencies can be a non-integer. Each frequency band of VCO has to operate independently, so we have used the tunable negative resistance based on the pin diode. When the forward bias has been into the pin diode, the phase noise of VCO is $-108.34\sim-106.67$ dBc/Hz @ 100 kHz in the tuning range, $2.423\sim2.597$ GHz, whereas when the reverse bias has been fed into the pin diode, that of VCO is $-114.16\sim-113.33$ dBc/Hz @ 100 kHz in the tuning range, $5.137\sim5.354$ GHz.

• Journal of Biomedical Engineering Research
• /
• v.21 no.4
• /
• pp.345-351
• /
• 2000

This study is to dvelop a radiotelemetry system to transmit and receive ECG (electrocardiograph) and event signals by using the frequency division multiplexing(FDM) technique. ECG signal sensed by the electrodes is amplified and added to the event signals acting in different frequency range for lead-off, nurse call and low level battery by using FDM. The sub-carrier oscillator using Colpitts circuits and main carrier frequency which is multiplied is frequency modulated by this superhetrodyne technique, and demodulated from the compose IF signal through the quadrature demodulator. A pulse counter demodulator and filtering circuits extract the original ECG and event signals.

• Proceedings of the Optical Society of Korea Conference
• /
• 2002.07a
• /
• pp.66-67
• /
• 2002

반도체 레이저는 가격이 저렴하고 크기가 작으며 주파수 조절이 용이하기 때문에 광통신, 분광학, 원자물리 등 다양한 분야에 사용되고 있다. 그러나, 반도체 레이저 자체는 수십 MHz 정도의 넓은 선폭을 갖고 주파수가 안정되지 않아 분광학이나 원자 냉각실험에 사용이 부적합하여 선폭 축소와 주파수 안정화가 필요하다. (중략)

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.7 s.337
• /
• pp.63-70
• /
• 2005

We investigated the phase noise of an oscillator with a extremely high-Q resonator used as the resonant element. A TE$_{011}$ mode rutile-loaded resonator with high-temperature superconductive (HTS) $YBa_2Cu_3O_{7-\delta}$(YBCO) films used as the endplates is prepared for this purpose. At 23.5 K, the unloaded Q and the loaded Q are 863000 and 180000, respectively. The phase noise of -104.8 dBc/Hz at 1 KHz offset was observed for the oscillator having a resonator with $Q_{L}$ =180000 at the $TE_{01\delta$ mode resonant frequency of 8.545 GHz at 23.5 K Such oscillators with very low phase noise are expected to be used for building up communication systems capable of efficient use of the frequency band and high-speed data transmission as well as for Doppler radars. Frequency tuning could be realized for the resonator by using a piezoactuator Applicability of the tunable rutile resonator for fabricating tunable oscillators of high performances is discussed.

• Korean Journal of Optics and Photonics
• /
• v.18 no.1
• /
• pp.56-65
• /
• 2007

The effect of gain dispersion on the self-pulsation (SP) characteristics due to the mode beating of two modes emitted in a multisection DFB laser composed of two complex-coupled DFB sections and a phase control section is investigated. When the peak wavelength, ${\lambda}_{p}$, of the gain spectrum of the DFB section is positioned in the center of the lasing wavelengths or the Bragg wavelengths of the two DFB sections, the maximum SP frequencies are higher and the modulation index has better characteristics compared to those cases for ${\lambda}_{p}$ fixed at the lasing wavelength or Bragg wavelength of one DFB section, when the difference between the Bragg wavelengths of the two DFB sections, ${\Dalta}{\lambda}_{B}$, is varied. When ${\lambda}_{p}$ is positioned in the renter of the Bragg wavelengths of the two DFB sections, the maximum SP frequency is higher and of the modulation index has better characteristics compared to those of the case for ${\lambda}_{p}$ positioned in the center of the lasing wavelengths of the two DFB sections.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.28 no.7
• /
• pp.540-549
• /
• 2017

A phase frequency detector(PFD) composed of logic circuits is widely used in a phase locked loop(PLL) due to the easy implementation for integrated circuits. A frequency locked loop(FLL) removes the reference oscillator in the PLL, and the resonator serves as a reference oscillator. A frequency detector(FD) is indispensable for the FLL configuration, and a FD, which is usually composed of a mixer is used to build an FLL. In this paper, instead of FD using mixer, a FD is constructed by using 1.175 GHz resonator composed of microstrip and PFD taking the versatility of PFD into consideration. Using the designed FD, FLL oscillating at a frequency of 1.175 GHz is composed. As a result of comparison with the FLL composed of FD using mixer, it was confirmed that the proposed FLL has better phase noise performance than FLL using mixer FD with FLL bandwidth.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.4
• /
• pp.629-635
• /
• 2009

The FSK duplex remote controlling wireless transmission units with a common local oscillator circuit for transmitter and receiver are designed and implemented in this paper. In the FSK full-duplex the channel frequency for Tx/Rx is allocated, a common switching oscillator circuit for Tx/Rx is designed in the FSK half-duplex scheme. Both of FSK units get functions of automatic channel detection for busy channels and channel configuration for an idle channel in order to reduce the RF channel interference and are designed as a remote controller with small-sized low power of 10mW and the 400MHz-colpitz type PLL configuration of 50kHz channel separation. The full-duplex Tx/Rx link frequency gets frequency difference of 42.8MHz, which is double of 21.4MHz IF frequency.