• Polymer(Korea)
• /
• v.27 no.4
• /
• pp.385-391
• /
• 2003

Lithium p-［Methoxyoligo(ethyleneoxy)］ benzenesulfonates (LiEOnBS) with different repeating unit of ethylene oxide were synthesized and were used for preparing gel-polymer electrolytes. The conductivities and lithium ion transference number were measured as a function of Li-salt concentration and repeating unit of ethylene oxide of the LiEOnBS. The maximum conductivity of the resulting gel-polymer electrolyte was found to be 4.89${\times}$10$\^$－4/ S/cm (LiEO7.3BS, 0.5 M) at 30$^{\circ}C$. The lithium ion transference number (t$\sub$Li$\sub$＋//) measurement were performed by means of the combination do polarization and ac impedance methods in gel-polymer electrolytes. Lithium ion transference number was measured to be in the range of 0.75∼0.92 for the LiEOnBS containing gel-polymer electrolytes. The maximum t$\sub$Li$\sub$＋// was obtained to be 0.92 for the 0.1 M LiEOnBS containing polymer electrolytes. The synthesized LiEOnBS showed single ion transport like characteristics when n was large than 3.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.1
• /
• pp.189-195
• /
• 2008

The OFDMA Physical layer in the WiMAX standard of IEEE 802.16e adopts 114 LDPC codes with various code rates and block sizes as a channel coding scheme to meet varying channel environments and different requirements for transmission performance. In this paper, the performances of the LDPC codes are evaluated according to various code rates and block-lengths throueh simulation studies using min-sum decoding algorithm in AWGN chamois. As the block-length increases and the code rate decreases, the BER performance improves. In the cases with code rates of 2/3 and 3/4, where two different codes ate specified for each code rate, the codes with code rates of 2/3A and 3/4B outperform those of 2/3B and 3/4A, respectively. Through the statistical analyses of the number of decoding iterations the decoding complexity and the word error rates of LDPC codes are estimated. The results can be used to trade-off between the performance and the complexity in designs of LDPC decoders.

• Journal of Embryo Transfer
• /
• v.19 no.2
• /
• pp.81-87
• /
• 2004

This study was designed to determine whether repeated superovulation is beneficial for recovery and quality of oocytes in Korean native goats. Seventy-six mature goats, maintained in a pen under natural day length and fed hay ad libitum, were pretreated with progestagen impregnated CIDR for 10 days and then the goats were divided into two groups. One group of the goats received a single intramuscular injection of 1,000 IU PMSG on Day 8 of CIDR insertion. The other group of the goats received twice daily intramuscular injections of a total of 70 mg FSH for 3 days from Day 8 of CIDR. All the gonadotropin treated goats were injected with 10 mg $PGF2{\alpha}on$ Day 8 and 400 IU hCG in the afternoon on Day 10. For oocyte recovery, donor goats were fasted 24 h before operation. Anesthesia was induced by intravenous injection of 2% xylazine(0.2 mg/kg body weight) and ketamin(11 mg/kg body weight). In vivo oocytes were recovered by follicle aspiration or oviduct flushing at 35 to 40 hours after hCG injection through mid-ventral incision. The mean number of CL and oocytes recovered and recovery rate of oocytes by oviduct flushing were greater(P<0.05) in the first treatment than those in the second treatment. Contrary to our assumption, PMSG treatment significantly (P<0.05) increased the number of CL formed and recovery rate of oocytes compared to FSH. However, the same effect was not observed in recovery of follicular oocytes. There was no significant difference in oocyte quality between FSH and PMSG or first and second treatments. The present results indicate that repeated superovulation and repeated use of donor animals may be inefficient for obtaining oocytes in good qualities.

• Journal of the Korean Geosynthetics Society
• /
• v.14 no.3
• /
• pp.43-51
• /
• 2015

In seasonal frozen areas which have a temperature difference in the winter and spring season like south korea, if stiffness reduction by repeated freezing and thawing occurs to slopes adjacent to private facilities or mountain slopes, safety factor is insufficient to design criteria and landslide could be occurs due to rainfall or snowfall. It can lead to large damage of human life and property. In this study, in order to examine the safety changes of mountain slopes by repeated freezing and thawing, soil samples series of SP and SM by USCS distributed in surface soil of mountain slopes were collected for specimens. Through the direct shear test, the characterestics of frozen soil shear strength were analyzed and by utilizing numerical methods, chracteristics of strength reduction of weathered granite soil according to repeated action of freezing and thawing, changes in the stability of the slopes when applying freezing and thawing of the soil samples were examined. As a result, the maximum shear stress decreased approximately 10%, and slope stability analysis confirmed that required safety factor is less than compare with the non-frozen samples.

• Tunnel and Underground Space
• /
• v.21 no.2
• /
• pp.145-150
• /
• 2011

Variations of physical properties such as weight loss rate, wave velocity and uniaxial compressive strength after performing freeze-thaw cyclic test were measured in order to define weathering characteristics of sandstone and andesite. Weight change in specimens of the two rocks decreased with increasing the repetition number of freeze-thaw cyclic test. In particular, weight loss of andesite specimens was very irregular. P-wave velocity of sandstone specimens decreased more than 5%. On the other hand, P-wave velocity of andesite specimens do not vary up to 500 cycles and decreased more than 5% after 1000 cycles. This implies that the sandstone are easily weakened and loosened by weathering processes, while the andesite are relatively strong. In addition, the wave velocity changes of the andesite specimens coincident with the weight change. Uniaxial compressive strengths of the sandstone specimens slightly decreased at the early stage of the freezing-thawing cyclic test, then tended to be irregular after 64 cycles. In conclusion, the rock specimens showed smaller weight loss, less had lower strength reduction rate.

• Journal of Broadcast Engineering
• /
• v.18 no.2
• /
• pp.297-310
• /
• 2013

In this paper, we present a model-based video bit rate estimation scheme for reducing the bit rate while maintaining a subjective quality in many video streaming services limited by network bandwidth, such as IPTV services. First, we extract major parameters which serve as an indirect measurement of frame's bits. Using those parameters, the proposed bit rate estimation scheme can extract candidate frames. Finally, the bit rate of each segment is estimated by statistical analysis and a mathematical model based on a given target quality. In experimental results, we show that the proposed scheme can reduce the bit rate on average by 43% in low-complexity video while maintaining the subjective quality. To find the appropriate bit rate based on video contents, the proposed schemes can estimate the bit rate with neither the repeated full encoding nor subjective quality test. On average, the bit rate can be automatically estimated by encoding the candidate frames of 4%.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.9 no.1
• /
• pp.89-95
• /
• 1989

In this study, it is attempted to examine (1) the residual deformation and elastic deformation induced from the repeated loads (up to the maximum of 100,000 times) on fully compacted soil specimen, the relation between stress and strain by performing the unconfined compressive test, after repeated loads and (2) the effect of water content, dry density, number of cycle, repeated loads, etc. on the effect of the stress-strain relation. The rate of deformation caused by repeated loads greatly depends on to the condition whether the water content is above or below the plastic limit. It is possible to estimate the initial tangent modulus of soil by means of modulus of elastic deformation obtained by putting repeated loads on the clay soil.

• Journal of Broadcast Engineering
• /
• v.4 no.1
• /
• pp.44-58
• /
• 1999

In this paper, a rate-distortion based image segmentation algorithm is presented using a recursive merging with region adjacency graph (RAG). In the method, the dissimilarity between a pair of adjacent regions is represented as a Lagrangian cost function considered in rate-distortion sense. Lagrangian multiplier is estimated in each merging step, a pair of adjacent regions whose cost is minimal is searched and then the pair of regions are merged into a new region. The merging step is recursively performed until some termination criterion is reached. The proposed method thus is suitable for region-based coding or segmented-based coding. Experiment results for 256x256 Lena show that segmented-based coding using the proposed method yields PSNR improvement of about 2.5 - 3.5 dB. 0.8 -1.0 dB. 0.3 -0.6 dB over mean-difference-based method. distortion-based method, and JPEG, respectively.

• Journal of the Korean Geotechnical Society
• /
• v.28 no.7
• /
• pp.31-40
• /
• 2012

In most design codes, soils are classified as either sandy or clayey soils, and appropriate design equations for each soil type are used to estimate their soil behaviour. However, sand-fine mixtures, which are typically referred to as intermediate soils, are somewhere at the middle of sandy or clayey soils, and therefore a unified interpretation of soil behaviour is necessary. In this paper, a series of cyclic shear tests were carried out for three different combinations of sand-fine mixtures with various fines content. Silica-sand mixture and fines (Iwakuni natural clay, Tottori silt, kaolinite) were mixed together with various mass ratios, while paying attention to the changes of void ratios expressed in terms of sand structure. The cyclic shear strengths of the mixtures below the threshold fines content were examined with the increasing fines contents. As a result, as the fines contents increased, their cyclic deviator stress ratios decreased for dense samples while it increased for loose samples. Additionally, cyclic deviator stress ratio of the mixtures was estimated using the concept of equivalent granular void ratio.

• Journal of Animal Science and Technology
• /
• v.50 no.6
• /
• pp.747-752
• /
• 2008

This study was carried out to calculate genetic trends on racing speed traits of Thoroughbred racehorses, using a total 208,043 racing records of 9,934 heads collected from January, 1990 to December, 2006 in Gwacheon racecourse. Repeated time, winning time and annual best time were used racing speed traits. The estimated heritabilities and repeatabilities for repeated time, winning time and annual best time were 0.288, 0.275, 0.341 and 0.502, 0.475, 0.496, respectively. Average phenotypic improvement per race year for racing speed traits were ranged from －0.115 to 0.148 second. The other side, the genetic improvement per race year for repeated time was －0.027 second but winning time and annual best time were not shown consistent trends. Therefore, we concluded that repeated time is recommended improvement trait of Thoroughbred racehorses.