• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.5
• /
• pp.1215-1223
• /
• 2014

In multi-hop wireless networks, a message transmission path is set up on demand by a route discovery step, where a shortest path is used in general. The shortest path, however, normally uses the nodes near the center area, which causes a high traffic load in that area and reduces the message transmission reliability. We propose a stable routing protocol considering the remaining energy of nodes. Our protocol uses ETX as a link performance estimator and tries to avoid the nodes with smaller energy. By doing this, we can reduce the route failure probability and packet loss. We have evaluated the performance of the proposed protocol using QualNet and compared with AODV and MRFR protocols. The simulation result shows that our protocol has a similar performance as MRFR in terms of end-to-end message reception ratio, average message delay and delay jitter, but outperforms MRFR in terms of traffic load distribution.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.12B
• /
• pp.1259-1266
• /
• 2010

M2M communication is considered as a key enabling technology to monitor the status of objects, vehicles, humans through auto-configuring wireless networks. In M2M network, there are active research activities to enhance the reliability on data while being collected from wireless sensor network. The reliability issue becomes more important as wireless sensor networks carry multimedia data, which is delay sensitive. The interference caused by the adjacent neighbor sensor nodes is a major factor in network performance degradation, which becomes more severe in multi-hop routing environment. In this paper, we propose inerfernce-free multipath routing protocol for M2M wireless network for enhancement of packet delay performance. The simulation results show that the proposed routing algorithm outperforms the existing routing protocols in terms of packet delay and throughput.

• Proceedings of the Korean Society of Computer Information Conference
• /
• 2009.01a
• /
• pp.283-288
• /
• 2009

고정된 망을 가지지 않고, 이동 호스트로만 이루어져 통신되는 망인 Ad-hoc 네트워크에서 고속으로 이동 중인 차량들 간의 긴급한 정보를 주고받아 고속도로에서의 다중 충돌사고를 미연에 방지할 수 있는 차량 통신 프로토콜을 제안한다. 본 논문에서는 도로위의 차량들은 서로 연계성이 없기 때문에 위치추적시스템인 GPS에서 수신한 거리 값을 연계하여 클러스터를 구성한다. 클러스터를 IEEE 802.11 MAC 계층에서 구성하기 때문에 경로 설정으로 인한 과부하문제를 해소 하였다. 논문에서 제안한 액티브 네트워크 기반의 멀티 홉 라우팅 프로토콜은, Active 네트워크를 이용하여 안정된 통신이 이루어 질수 있도록 한다.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.10
• /
• pp.116-123
• /
• 2013

In mobile healthcare applications, the reliable transmission of the bio-data is very important. In this article, we present a reliable bio-data transmission technique for mobile healthcare monitoring service at 6LoWPAN multi-hop wireless networks. In particular, we expand IEEE 11073-20601 protocol, and propose the reliable path construction for 6LoWPAN aimed to reliably provide mobile healthcare service over wireless sensor network, using IPv6 network. 6LoWPAN is recognized possibility because it is agree with sensor network by raising Adaptation layer on the MAC layer to transmit IPv6 packets. In this article proposed minimize the algorithm complexity and reliability routing protocol because the 6LoWPAN devices are suitable for low cost, small size and battery that can be used to health care system environment. And detailed procedures and algorithms are presented. We the proposed method to prove the superiority of using NS-3 for compareing with AODV protocol.

• Journal of Digital Contents Society
• /
• v.15 no.6
• /
• pp.663-673
• /
• 2014

The WBAN technology means a short distance wireless network which provides each device interactive communication by connecting devices inside and outside of body. Standardization on the physical layer, data link layer, network layer and application layer is in progress by IEEE 802.15.6 TG BAN. Wireless body area network is usually configured in energy efficient using sensor and zigbee device due to the power limitation and the characteristics of human body. Wireless sensor network consist of sensor field and sink node. Sensor field are composed a lot of sensor node and sink node collect sensing data. Wireless sensor network has capacity of the self constitution by protocol where placed in large area without fixed position. In this paper, we proposed the efficient addressing scheme for improving the performance of routing algorithm by using ZigBee in WBAN environment. A distributed address allocation scheme used an existing algorithm that has wasted in address space. Therefore proposing x, y and z coordinate axes from divided address space of 16 bit to solve this problems. Each node was reduced not only bitwise but also multi hop using the coordinate axes while routing than Cskip algorithm. I compared the performance between the standard and the proposed mechanism through the numerical analysis. Simulation verified performance about decrease averaging multi hop count that compare proposing algorithm and another. The numerical analysis results show that proposed algorithm reduced the multi hop better than ZigBee distributed address assignment

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.7B
• /
• pp.1098-1104
• /
• 2010

Recently, a variety of research of multi-hop routing protocol have been done to balance the sensor node energy consumption of WSN(wireless sensor network) and to improve the node efficiency for extending the life of the entire network. Especially in multi-hop protocol, a variety of models have been concerned to improve energy efficiency and apply in the reality. In multi-hop protocol, we assumption that energy consumption can be adjusted based on the distance between the sensor nodes. However, according to the physical property of the actual WSN, it's hard to establish this assumption. In this dissertation, we propose low-power sub-cluster protocol to improve the energy efficiency based on the spread of distance. Compared with the previous protocols, this proposed protocol can be effectively used in the wireless sensing networks.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.1B
• /
• pp.48-57
• /
• 2008

Wireless sensor networks are composed of a lot of sensor nodes and they are used to monitor environments. Since many studies on wireless sensor networks have considered a stationary sink node, they cannot provide fully ubiquitous applications based on a mobile sink node. In those applications, routing paths for a mobile sink node should be updated while a sink node moves in order to deliver sensor data without data loss. In this paper, we propose a method to continuously update routing paths for a mobile sink node which can be extended on hierarchical multi-hop routing protocols in wireless sensor networks. The efficiency of the proposed scheme has been validated through comparing existing method using a location based routing protocol by extensive computer simulation.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2009.10a
• /
• pp.517-520
• /
• 2009

Healthcare application system has been actively researched to apply WSN technology to healthcare area with a mobile sensor node of low cost, low power, and small size. Sensor node has the problem for transmission range of RF power and time delay of the wireless routing connectivity between sensor nodes. In this paper, we proposes a new method utilizing mobile sensor nodes with relay sensor nodes for quick network routing changing using query technique in healthcare system. A query processor to control and manage the routing changing of sensor nodes in a wireless sensor network was designed and implemented. The user's PC transmits the beacon message which will change the quick link routing according to activity status of patient in wireless sensor network. We describe the implementation for query protocol that is very effective of power saving between sensor nodes.

• The KIPS Transactions:PartC
• /
• v.18C no.3
• /
• pp.167-178
• /
• 2011

As the growth of ubiquitous services, various types of ad hoc networks have emerged. In particular, wireless sensor networks (WSN) and mobile ad hoc networks (MANET) are widely known ad hoc networks, but there are also other kinds of wireless ad hoc networks in which the characteristics of the aforementioned two network types are mixed together. This paper proposes a variant of the Low Energy Adaptive Cluster Hierarchy (LEACH) routing protocol modified to be suitable in such a combined network environment. That is, the proposed routing protocol provides node detection and route discovery/maintenance in a network with a large number of mobile sensor nodes, while preserving node mobility, network connectivity, and energy efficiency. The proposed routing protocol is implemented with a multi-hop multi-path algorithm, a topology reconfiguration technique using node movement estimation and vibration sensors, and an efficient path selection and data transmission technique for a great many moving nodes. In the experiments, the performance of the proposed protocol is demonstrated by comparing it to the conventional LEACH protocol.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.8 no.4
• /
• pp.53-64
• /
• 2009

Inter-vehicular communication that propagates information without infrastructures has drawn a lot of interest. However, it is difficult to apply conventional ad-hoc routing protocols directly in inter-vehicular communication due to frequent changes in the network topology caused by high mobility of the vehicles. MMFP(Multi-hop MAC Forwarding) is a unicast forwarding protocol that transport packets based on the reachability information instead of path selection or position information. However, delivering public safety messages informing road conditions such as collision, obstacles and fog through inter-vehicular communication requires broadcast rather than unicast since these messages contain information valuable to most drivers within a close proximity. Flooding is one of the simplest methods for multi-hop broadcast, but it suffers from reduced packet delivery-ratio and high transmission delay due to an excessive number of duplicated packets. This paper presents two multi-hop broadcast protocols for inter-vehicular communication that extend the MMFP. UMHB(Unreliable Multi-Hop Broadcast) mitigates the duplicated packets of MMFP by limiting the number of nodes to rebroadcast packets. UMHB, however, still suffers from low delivery ratio. RMHB(Reliable Multi-Hop Broadcast) uses acknowledgement and retransmission in order to improve the reliability of UMHB at the cost of increase in transmission delay, which we show through simulation is within an acceptable range for collision avoidance application.